Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Superconductor Science and Technology

Analogue demonstration of a high temperature superconducting sigma-delta modulator with 27 GHz sampling

Martin G. Forrester, B. D. Hunt, Donald L. Miller, John Talvacchio, Robert M. Young

Published Nov 1, 1999• 11 citations
Publisher

Abstract

We have successfully fabricated and tested a high temperature superconducting (HTS) sigma-delta modulator for analogue-to-digital conversion. This is the first demonstration of a GHz sampling A-to-D in HTS. The 15-junction single-flux-quantum (SFQ) circuit, fabricated using an epitaxial multilayer HTS process with YBCO/Co-YBCO/YBCO edge junctions, was internally clocked at 27 GHz and used to convert a 5.01 MHz signal. The modulator demonstrated a spur-free dynamic range of more than 75 dB. Two-tone measurements with 5.01 MHz and 5.51 MHz signals demonstrated third-order intermodulation products to be lower than -59 dBc. Demonstration of a functional HTS modulator represents a significant milestone in the development of high dynamic range ADCs suitable for such applications as surveillance radar.

DOI
10.1088/0953-2048/12/11/302

Related papers

Superconducting bandpass delta-sigma modulator

John F. Bulzacchelli, H.-S. Lee, James A. Misewich +1 more

Bandpass delta-sigma modulators digitize narrowband signals with high dynamic range and linearity. The required sampling rate is only a few times higher than the centre frequency of the input. This paper presents a superconducting bandpass delta-sigma modulator for direct analogue-to-digital conversion of RF signals in the GHz range. The input signal is capacitively coupled to one end of a microstrip transmission line, and a single flux quantum balanced comparator quantizes the current flowing out of the other end. Quantization noise is suppressed at the quarter-wave resonance of the transmission line (about 2 GHz in our design). Circuit performance at a 20 GHz sampling rate has been studied with several long JSIM simulations. Full-scale (FS) input sensitivity is 20 mV (rms), and in-band noise is -53 dBFS and -57 dBFS over bandwidths of 39 MHz and 19.5 MHz, respectively. In-band intermodulation distortion is better than -69 dBFS.

Superconductor Science and Technology•Nov 1, 1999•12 citations

Dc-characteristics of a high-Tcsuperconducting sigma–delta modulator using interface-engineered Josephson junctions

K. Saitoh, Yoshihisa Soutome, Tokuumi Fukazawa +1 more

We fabricated and tested a high-temperature superconducting (HTS) sigma–delta modulator using interface-engineered Josephson junctions. Proper dc-characteristics were obtained with a sampling frequency of 100 GHz at 20 K. To achieve high-speed sampling, Josephson junctions with a higher critical-current normal-resistance product were used. Circuit simulations with thermal noise were performed for the analysis of switching characteristics and SFQ dynamics.

Superconductor Science and Technology•Jan 18, 2002•9 citations

Superconducting modulators for high dynamic range delta-sigma analog-to-digital converters

A. Hodge Worsham, Donald L. Miller, Paul D. Dresselhaus +2 more

Superconducting digital circuits are capable of producing high dynamic range analog-to-digital converters (ADCs). We present sigma-delta architectures using large (>100) oversampling ratios to give signal-to-noise ratios of greater than 100 dB in simulation. Three distinct designs, using two distinct mechanisms for feedback, are presented. All of the designs use only shunted junctions, and are therefore compatible with HTS SNS junctions. Simulations are presented for a modulator which creates feedback pulses by SQUID lobe-crossings, a modulator which uses the transresistance of a SQUID for feedback, and a modulator which uses threshold crossings in both the first and second loops for feedback.

IEEE Transactions on Applied Superconductivity•Jun 1, 1999•26 citations

Superconducting bandpass ΔΣ modulator with 2.23-GHz center frequency and 42.6-GHz sampling rate

John F. Bulzacchelli, Hae-Seung Lee, James A. Misewich +1 more

This paper presents a superconducting bandpass /spl Delta//spl Sigma/ modulator for direct analog-to-digital conversion of radio frequency signals in the gigahertz range. The design, based on a 2.23-GHz microstrip resonator and a single flux quantum comparator, exploits several advantages of superconducting electronics: the high quality factor of resonators, the fast switching speed of the Josephson junction, natural quantization of voltage pulses, and high circuit sensitivity. The modulator test chip includes an integrated acquisition memory for capturing output data at sampling rates up to 45 GHz. The small size (256 b) of the acquisition memory limits the frequency resolution of spectra based on standard fast Fourier transforms. Output spectra with enhanced resolution are obtained with a segmented correlation method. At a 42.6-GHz sampling rate, the measured SNR is 49 dB over a 20.8-MHz bandwidth, and a full-scale (FS) input is -17.4 dBm. At a 40.2-GHz sampling rate, the measured in-band noise is -57 dBFS over a 19.6-MHz bandwidth. The modulator test chip contains 4065 Josephson junctions and dissipates 1.9 mW at T=4.2 K.

IEEE Journal of Solid-State Circuits•Dec 1, 2002•21 citations

Multilayer HTS SFQ analog-to-digital converters

James D. McCambridge, Martin G. Forrester, Donald L. Miller +4 more

We have fabricated and measured high T/sub c/ superconductor single flux quantum 1-bit flux-counting analog-to-digital converters (ADCs). The ADCs were made with a multilayer all-epitaxial process which incorporates 10 edge SNS (superconductor-normal-superconductor) or step-edge grain boundary (SEGB) Josephson junctions with a YBa/sub 2/Cu/sub 3/O/sub 7-/spl delta// groundplane. The ADC consists of a quantizer connected to a Toggle flip-flop through a buffer-like stage. Direct readout of the flux state of the T flip-flop was made with a Read SQUID inductively coupled through a hole in the groundplane. The circuits were operated at 65 K and low speeds. The SNS circuits outperformed the SEGB circuits because of their higher readout voltages and tighter critical current spreads.

IEEE Transactions on Applied Superconductivity•Jun 1, 1997•21 citations

A Quantum-Accurate Two-Loop Data Converter

Quentin Herr, Donald L. Miller, Aaron A. Pesetski +1 more

High performance oversampling delta-sigma data converters require high clock rates and accurate feedback of the digital output to the analog regime. Superconductor modulators offer the unique advantages of clock rates in the tens-of-gigahertz, comparator switching energy below attoJoules, and quantum-accurate digital-to-analog feedback. We have designed a two-loop baseband modulator whose noise transfer function was calculated using a simple, linear circuit model. The circuit was fabricated in a commercial superconductor IC process with 4.5 kA-per-square cm Josephson junctions and 1.5 micron minimum feature size. The circuit was tested at a derated sample rate of 5 GHz. Measured signal-to-noise dynamic range was 81 dB over a 10 MHz band. Third-order intercept was measured to be +24 dBsat in two-tone test. The measured noise transfer function was in excellent agreement with our linear model. The linear model indicates that with appropriate parameter values, this family of modulators extrapolates to significantly higher performance.

IEEE Transactions on Applied Superconductivity•Jun 1, 2009•6 citations
We have successfully fabricated and tested a high temperature superconducting (HTS) sigma-delta modulator for analogue-to-digital conversion. This is the first demonstration of a GHz sampling A-to-D in HTS. The 15-junction single-flux-quantum (SFQ) circuit, fabricated using an epitaxial multilayer HTS process with YBCO/Co-YBCO/YBCO edge junctions, was internally clocked at 27 GHz and used to convert a 5.01 MHz signal. The modulator demonstrated a spur-free dynamic range of more than 75 dB. Two-tone measurements with 5.01 MHz and 5.51 MHz signals demonstrated third-order intermodulation products to be lower than -59 dBc. Demonstration of a functional HTS modulator represents a significant milestone in the development of high dynamic range ADCs suitable for such applications as surveillance radar.
Bandpass delta-sigma modulators digitize narrowband signals with high dynamic range and linearity. The required sampling rate is only a few times higher than the centre frequency of the input. This paper presents a superconducting bandpass delta-sigma modulator for direct analogue-to-digital conversion of RF signals in the GHz range. The input signal is capacitively coupled to one end of a microstrip transmission line, and a single flux quantum balanced comparator quantizes the current flowing out of the other end. Quantization noise is suppressed at the quarter-wave resonance of the transmission line (about 2 GHz in our design). Circuit performance at a 20 GHz sampling rate has been studied with several long JSIM simulations. Full-scale (FS) input sensitivity is 20 mV (rms), and in-band noise is -53 dBFS and -57 dBFS over bandwidths of 39 MHz and 19.5 MHz, respectively. In-band intermodulation distortion is better than -69 dBFS.
Superconducting digital circuits are capable of producing high dynamic range analog-to-digital converters (ADCs). We present sigma-delta architectures using large (>100) oversampling ratios to give signal-to-noise ratios of greater than 100 dB in simulation. Three distinct designs, using two distinct mechanisms for feedback, are presented. All of the designs use only shunted junctions, and are therefore compatible with HTS SNS junctions. Simulations are presented for a modulator which creates feedback pulses by SQUID lobe-crossings, a modulator which uses the transresistance of a SQUID for feedback, and a modulator which uses threshold crossings in both the first and second loops for feedback.
This paper presents a superconducting bandpass /spl Delta//spl Sigma/ modulator for direct analog-to-digital conversion of radio frequency signals in the gigahertz range. The design, based on a 2.23-GHz microstrip resonator and a single flux quantum comparator, exploits several advantages of superconducting electronics: the high quality factor of resonators, the fast switching speed of the Josephson junction, natural quantization of voltage pulses, and high circuit sensitivity. The modulator test chip includes an integrated acquisition memory for capturing output data at sampling rates up to 45 GHz. The small size (256 b) of the acquisition memory limits the frequency resolution of spectra based on standard fast Fourier transforms. Output spectra with enhanced resolution are obtained with a segmented correlation method. At a 42.6-GHz sampling rate, the measured SNR is 49 dB over a 20.8-MHz bandwidth, and a full-scale (FS) input is -17.4 dBm. At a 40.2-GHz sampling rate, the measured in-band noise is -57 dBFS over a 19.6-MHz bandwidth. The modulator test chip contains 4065 Josephson junctions and dissipates 1.9 mW at T=4.2 K.
We have fabricated and measured high T/sub c/ superconductor single flux quantum 1-bit flux-counting analog-to-digital converters (ADCs). The ADCs were made with a multilayer all-epitaxial process which incorporates 10 edge SNS (superconductor-normal-superconductor) or step-edge grain boundary (SEGB) Josephson junctions with a YBa/sub 2/Cu/sub 3/O/sub 7-/spl delta// groundplane. The ADC consists of a quantizer connected to a Toggle flip-flop through a buffer-like stage. Direct readout of the flux state of the T flip-flop was made with a Read SQUID inductively coupled through a hole in the groundplane. The circuits were operated at 65 K and low speeds. The SNS circuits outperformed the SEGB circuits because of their higher readout voltages and tighter critical current spreads.
High performance oversampling delta-sigma data converters require high clock rates and accurate feedback of the digital output to the analog regime. Superconductor modulators offer the unique advantages of clock rates in the tens-of-gigahertz, comparator switching energy below attoJoules, and quantum-accurate digital-to-analog feedback. We have designed a two-loop baseband modulator whose noise transfer function was calculated using a simple, linear circuit model. The circuit was fabricated in a commercial superconductor IC process with 4.5 kA-per-square cm Josephson junctions and 1.5 micron minimum feature size. The circuit was tested at a derated sample rate of 5 GHz. Measured signal-to-noise dynamic range was 81 dB over a 10 MHz band. Third-order intercept was measured to be +24 dBsat in two-tone test. The measured noise transfer function was in excellent agreement with our linear model. The linear model indicates that with appropriate parameter values, this family of modulators extrapolates to significantly higher performance.