Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Applied Physics

Photon Avalanches from a Population Inversion

Lewi Tonks

Published Apr 1, 1964• 23 citations
Publisher

Abstract

High-power lasers encounter increasing losses of stored energy from stimulated emission by once-through avalanches of photons as higher powers are sought. This occurs even without resonance buildup. Even in the simple geometry of a thin rod, a satisfactory analysis would require elaborate machine calculation. A very crude model has, however, produced rough results from which some guidance is obtainable. The model exhibits the expected linear increase of outgoing photon flux near the end of the rod and the huge depletion of excited atom population away from the rod equator. A criterion has been developed for the maximum useful excitation relative to emission parameters, rod length and rod cross section. It is concluded that this excitation level is fairly insensitive to aspect ratio (radius/length) but that internal reflection from the rod cylindrical surface can markedly lower this level by increasing the effective aspect ratio enormously.

DOI
10.1063/1.1713580

Related papers

Size-Dependent Spontaneous Energy Loss in Lasers due to Self-Stimulated Emission

Tom Waite

Laser amplifiers when pumped to a significant degree of population inversion undergo decay via (1) natural spontaneous emission of radiation from individual excited atoms, and (2) a size-dependent decay due to self-amplification of the spontaneously emitted radiation which passes through a large fraction of the amplifier length before escaping. This latter effect has a definite size threshold near which the decay rate changes several orders of magnitude. The decay rate is roughly independent of size except near the threshold.

Journal of Applied Physics•Jun 1, 1964•14 citations

Researchers Report Evidence for Lasing Without Inversion

Barbara Goss Levi

We have come to think that lasing requires an inversion of population between atoms in an excited state and those in a lower state: Normally the probability of absorption from the lower state equals the probability of emission from the higher state, so that the only way to have more photons coming out than going in is to start with more atoms in the upper state. It would be useful to decouple the probabilities of emission and absorption, so that one could lower the loss associated with absorption without reducing the emission.

Physics Today•Sep 1, 1995•2 citations

1D LASING AT THE NANOSCALE: METHOD AND BEHAVIOR

Andre John Brewer

abstract: The importance of lasing cannot be overstated – from improving medicine through surgery uses and industry through laser cutting and micro-wielding (just to name a few), to the development of laser cooling to isolate the first Bose-Einstein condensate in 1995. Not only do the technological benefits encourage research but, as could probably be deduced, lasers are expensive devices. From Ruby crystals to Rubidium gasses, the materials required to construct lasers can be rare and highly specialized. Since the advancement of computer technology, computational physics has proved exceedingly useful. As a combination of both theoretical and experimental physcis, computational physics proves itself invaluable for allowing the testing of various theories and running of experiments in a time efficient and far less expensive way. For the purpose of this paper, having a clear understanding of the computational lasing system allows for simulations that are incredibly expensive or might not even be possible yet, to be conducted and the groundwork to be laid for future theory, experiment, or product.\nThe response of a molecular sheet with varying densities of simple, two-level system without lasing due to an ultra-short, wideband pulse centered at 2 eV is first investigated. The Fabry-Pérot modes rising from interference are observed, as well as the expected redshift in the transmission and reflection frequencies in the thin molecular sheet regime. Cautions regarding numerical instability and implementation of the Fast Fourier Transform are discussed. Upon activating the lasing levels of the molecules (creating a four-level system), the transmission and refection responses are measured for four combinations of molecular density and molecular sheet thickness. Lasing threshold and saturation phenomenon are observed and a clear lasing region is seen in the Power input/output analysis.\nPopulation inversion is driving force that triggers lasing through stimulated emission. To investigate this, the populations of each of the four molecular energies levels are tracked for the same combinations of parameters in the previous tests. The population inversions and the threshold/saturation phenomena do not correspond to within reasonable limits. Inspection of the population data reveals a highly varied distribution within the molecular, suggesting that the system does not reach steady-state, and therefore and alternate method of analysis will need to be developed.\nHaving experimented with the simulations above, both the development of appropriate population analysis framework and the investigation of higher order dimensions (2-D and 3-D) will be pursed.

•May 1, 2016•0 citations

ON THE POSSIBILITY OF MASER ACTION BETWEEN NUCLEAR STATES

George C. Baldwin, J.P. Neissel, J. H. Terhune +1 more

The possibility of a stimulated emission device, analogous to the laser, which can generate radiation at gammaray wavelengths is examined. Lacking reflectors, its operation would consist of multiplication during single passage of photon avalanches initiated by spontaneous emission. The required high concentration of excited states may be obtainable in many nuclides by radiochemical procedures. The maximum possible resonant cross section exceeds ordinary absorption by several orders of magnitude. Only a fraction of the resonant cross-section can be effective, because of line-broadening interactions with the nuclear environment. Singular effects in solids (optical branch excitation, localization of lattice disturbance, or Bragg-angle effects) are suggested that may allow operation at a recoil-displaced energy without population inversion, as alternatives to the Mossbauer effect. An experimental technique for directly measuring the stimulated-emission cross-section by detection of a coherent component in the total radiation is described in some detail. It is concluded that the question of gammamaser feasibility can be conclusively answered only by experiment. (auth)

Transactions of the American Nuclear Society•Jun 15, 1963•0 citations

Laser oscillations

E. Rosencher, B. Vinter

We were able to show in Chapter 3 that a medium in which we can obtain a population inversion (i.e. a situation in which the population density in the excited state is greater than that in the fundamental level) allows for optical gain of an electromagnetic wave having a frequency near to the resonant frequency of the system. By introducing feedback of the amplified signal into the medium, the system can be made to oscillate naturally, resulting in laser oscillations. To obtain this population inversion, we must introduce at least a third (and perhaps even a fourth) energy level into the system. (We saw how a two-level system under the influence of an intense pump beam will saturate with no resulting population inversion.) The aim then of this chapter is to introduce the concepts necessary to extend our two-level system into a working model capable of illustrating the phenomenon of laser oscillation. We will not spend too much time discussing atomic transition lasers as they do not figure readily in our treatment of quantum electronic properties of semiconductors. An exception will be made, however; we brush upon the particular topics of a diode pumped laser in Complement 4.E and a quantum cascade laser in Complement 13.H.

Cambridge University Press eBooks•May 30, 2002•0 citations

Some features of a photon avalanche phenomenon

William E. Case, Mark E. Koch

We have made an unexpected discovery of highly nonlinear optical behavior in certain praseodymium-doped lanthanum halides. When a LaCl3 or LaBr3 crystal containing Pr3+ ions is exposed to green laser radiation slightly in excess of a certain critical intensity, Pr fluorescence increases by orders of magnitude. Infrared output near 4.5-μm wavelength is associated with the large visible output, and pump power is strongly absorbed. We call this new phenomenon a photon avalanche. Critical pump power density is in the 1–15 W/cm2 range. At higher pump rates, a population inversion and lasing action take place between the lowest infrared levels of the Pr ion. Experimental results are presented and compared to predictions of a photon avalanche model based on resonant energy transfer.

Annual Meeting Optical Society of America•Jan 1, 1985•0 citations
High-power lasers encounter increasing losses of stored energy from stimulated emission by once-through avalanches of photons as higher powers are sought. This occurs even without resonance buildup. Even in the simple geometry of a thin rod, a satisfactory analysis would require elaborate machine calculation. A very crude model has, however, produced rough results from which some guidance is obtainable. The model exhibits the expected linear increase of outgoing photon flux near the end of the rod and the huge depletion of excited atom population away from the rod equator. A criterion has been developed for the maximum useful excitation relative to emission parameters, rod length and rod cross section. It is concluded that this excitation level is fairly insensitive to aspect ratio (radius/length) but that internal reflection from the rod cylindrical surface can markedly lower this level by increasing the effective aspect ratio enormously.
Laser amplifiers when pumped to a significant degree of population inversion undergo decay via (1) natural spontaneous emission of radiation from individual excited atoms, and (2) a size-dependent decay due to self-amplification of the spontaneously emitted radiation which passes through a large fraction of the amplifier length before escaping. This latter effect has a definite size threshold near which the decay rate changes several orders of magnitude. The decay rate is roughly independent of size except near the threshold.
We have come to think that lasing requires an inversion of population between atoms in an excited state and those in a lower state: Normally the probability of absorption from the lower state equals the probability of emission from the higher state, so that the only way to have more photons coming out than going in is to start with more atoms in the upper state. It would be useful to decouple the probabilities of emission and absorption, so that one could lower the loss associated with absorption without reducing the emission.
abstract: The importance of lasing cannot be overstated – from improving medicine through surgery uses and industry through laser cutting and micro-wielding (just to name a few), to the development of laser cooling to isolate the first Bose-Einstein condensate in 1995. Not only do the technological benefits encourage research but, as could probably be deduced, lasers are expensive devices. From Ruby crystals to Rubidium gasses, the materials required to construct lasers can be rare and highly specialized. Since the advancement of computer technology, computational physics has proved exceedingly useful. As a combination of both theoretical and experimental physcis, computational physics proves itself invaluable for allowing the testing of various theories and running of experiments in a time efficient and far less expensive way. For the purpose of this paper, having a clear understanding of the computational lasing system allows for simulations that are incredibly expensive or might not even be possible yet, to be conducted and the groundwork to be laid for future theory, experiment, or product.\nThe response of a molecular sheet with varying densities of simple, two-level system without lasing due to an ultra-short, wideband pulse centered at 2 eV is first investigated. The Fabry-Pérot modes rising from interference are observed, as well as the expected redshift in the transmission and reflection frequencies in the thin molecular sheet regime. Cautions regarding numerical instability and implementation of the Fast Fourier Transform are discussed. Upon activating the lasing levels of the molecules (creating a four-level system), the transmission and refection responses are measured for four combinations of molecular density and molecular sheet thickness. Lasing threshold and saturation phenomenon are observed and a clear lasing region is seen in the Power input/output analysis.\nPopulation inversion is driving force that triggers lasing through stimulated emission. To investigate this, the populations of each of the four molecular energies levels are tracked for the same combinations of parameters in the previous tests. The population inversions and the threshold/saturation phenomena do not correspond to within reasonable limits. Inspection of the population data reveals a highly varied distribution within the molecular, suggesting that the system does not reach steady-state, and therefore and alternate method of analysis will need to be developed.\nHaving experimented with the simulations above, both the development of appropriate population analysis framework and the investigation of higher order dimensions (2-D and 3-D) will be pursed.
The possibility of a stimulated emission device, analogous to the laser, which can generate radiation at gammaray wavelengths is examined. Lacking reflectors, its operation would consist of multiplication during single passage of photon avalanches initiated by spontaneous emission. The required high concentration of excited states may be obtainable in many nuclides by radiochemical procedures. The maximum possible resonant cross section exceeds ordinary absorption by several orders of magnitude. Only a fraction of the resonant cross-section can be effective, because of line-broadening interactions with the nuclear environment. Singular effects in solids (optical branch excitation, localization of lattice disturbance, or Bragg-angle effects) are suggested that may allow operation at a recoil-displaced energy without population inversion, as alternatives to the Mossbauer effect. An experimental technique for directly measuring the stimulated-emission cross-section by detection of a coherent component in the total radiation is described in some detail. It is concluded that the question of gammamaser feasibility can be conclusively answered only by experiment. (auth)
We were able to show in Chapter 3 that a medium in which we can obtain a population inversion (i.e. a situation in which the population density in the excited state is greater than that in the fundamental level) allows for optical gain of an electromagnetic wave having a frequency near to the resonant frequency of the system. By introducing feedback of the amplified signal into the medium, the system can be made to oscillate naturally, resulting in laser oscillations. To obtain this population inversion, we must introduce at least a third (and perhaps even a fourth) energy level into the system. (We saw how a two-level system under the influence of an intense pump beam will saturate with no resulting population inversion.) The aim then of this chapter is to introduce the concepts necessary to extend our two-level system into a working model capable of illustrating the phenomenon of laser oscillation. We will not spend too much time discussing atomic transition lasers as they do not figure readily in our treatment of quantum electronic properties of semiconductors. An exception will be made, however; we brush upon the particular topics of a diode pumped laser in Complement 4.E and a quantum cascade laser in Complement 13.H.
We have made an unexpected discovery of highly nonlinear optical behavior in certain praseodymium-doped lanthanum halides. When a LaCl3 or LaBr3 crystal containing Pr3+ ions is exposed to green laser radiation slightly in excess of a certain critical intensity, Pr fluorescence increases by orders of magnitude. Infrared output near 4.5-μm wavelength is associated with the large visible output, and pump power is strongly absorbed. We call this new phenomenon a photon avalanche. Critical pump power density is in the 1–15 W/cm2 range. At higher pump rates, a population inversion and lasing action take place between the lowest infrared levels of the Pr ion. Experimental results are presented and compared to predictions of a photon avalanche model based on resonant energy transfer.