Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Quantum Electronics

Optimal detection of partially spatial coherent radiation by using optical quantum amplifiers

G I Kozin, А. P. Kuznetsov

Published Nov 30, 2005• 0 citations
Publisher

Abstract

Conditions for the efficient detection of reflected laser radiation by means of optical quantum amplifiers are considered theoretically. It is shown that in the case of a strongly disturbed spatial coherence, there is no need to take it into account and a simple geometrical consideration is sufficient. The expressions relating the effective radius of the input aperture and the angular magnification of a projecting optical system with the laser radiation divergence and amplifier parameters are obtained. The theoretical results are confirmed by experiments.

DOI
10.1070/qe2005v035n11abeh002860

Related papers

Reception of scattered radiation by optical quantum amplifiers

V. E. Belonuchkin, N I Eskin, Stanislav M. Kozel +2 more

A theory is devloped of the propagation of a spatially random signal, resulting from the scattering of coherent radiation, through a single-pass optical quantum amplifier. Attention is drawn to the need to allow for the channeling of the radiation by the walls of a gas-discharge cell. The spatial selectivity of optical quantum amplifiers is discussed. It is shown that the optimal size of the aperture of a receiver system with a single-pass amplifier may be considerably greater than the spatial coherence radius. Estimates are obtained for the scattered-radiation gain. The theoretical conclusions are confirmed by an experimental study.

Soviet Journal of Quantum Electronics•Jun 30, 1977•1 citation

Use of a regenerative optical quantum amplifier in photodetection of scattered coherent radiation

V. E. Belonuchkin, N I Eskin, Stanislav M. Kozel +2 more

An experimental investigation was made of the efficiency of a regenerative optical quantum amplifier in detection of scattered laser radiation. In agreement with theoretical estimates, the experimental results demonstrated that the average energy of the scattered field amplified in this amplifier did not exceed the energy in the spatial coherence area. The relative variance of the output signal, which was distributed exponentially under linear conditions, was close to unity and was independent of the relationship between the correlation radius of the spatially random field and the receiver aperture radius.

Soviet Journal of Quantum Electronics•Sep 30, 1975•1 citation

Theory of the inverted-population cavity amplifier

G. L. Mander, R. Loudon, Terence J. Shepherd

We calculate the input-output characteristics of an optical amplifier that consists of an inverted-population medium placed inside a high-Q Fabry-P\'erot cavity. Expressions are derived for the output second- and fourth-order spectral and temporal correlation functions, and more generally for the output characteristic functional, in terms of the corresponding input quantities. The photocount first and second factorial moments are obtained for both homodyne and direct detection of the amplifier input and output. The general results are applied to several cases of practical interest, including inputs that have coherent or chaotic coherence properties. Particular attention is paid to the effects of amplification on specific nonclassical varieties of input light. It is shown that a maximum of only twofold amplification is permitted if any squeezing present in the input is to survive as squeezing in the output light. Similarly, for the preservation of photon antibunching in amplification, we show, by consideration of a kind of free-space number-state input, that only small gains are allowed. The amplifier model treated here provides a detailed example of the limitations imposed by quantum mechanics on the minimum noise generated by a multimode linear amplifier. In particular, we show that minimum noise occurs in a cavity that is asymmetric with respect to mirror reflectivities, for which we derive the corresponding conditions. In addition, we demonstrate the ability of the amplifier to improve upon signal-to-noise ratio, otherwise limited by low detector quantum efficiency.

Physical Review A•Nov 1, 1989•14 citations

Lasers and Amplifiers

Hans‐A. Bachor, Timothy C. Ralph

The laser is the key component in any quantum optics experiment. The performance of a laser can be described by the following parameters: optical power, spatial mode structure, output wavelength, frequency spectrum, and noise spectrum. The spatial properties of the laser beams are determined by the properties of the optical resonator. Lasers are available that produce output beams, which are very close to the theoretical limit. In order to determine the dynamics of the fluctuations of the laser system, a quantum model is required. Diode lasers use the band gap in doped semiconductor materials to produce optical gain directly from an electrical current. The chapter focuses on continuous-wave lasers since they are very common in quantum optics experiments, in precision metrology. It considers the theoretical limits to amplification of quantum limited light and discusses the theory of the non-linear interaction. The chapter discusses the measurement-based quantum amplifiers based on electro-optic feed forward and heralded devices based on photon counting.

Wiley eBooks•Jul 5, 2019•0 citations

Coherent effects in lasers and amplifiers

É. M. Belenov, Peter G. Kryukov, A. Nazarkin +2 more

A review of basic analytical results on coherent propagation of optical pulses through nondegenerate amplifying media is presented. Original numerical results concerning pulse coherent amplification by degenerate media and, in particular, by the amplifying medium of an iodine laser are described also. Furthermore, some analytical results on coherent effects in the pulsed mode of laser generation are given. We have pointed out that the stochastic mode of laser radiation is related also to the coherency of interaction of a laser field with matter.

Journal of the Optical Society of America B•May 1, 1988•10 citations

Coherent laser detection by frequency-shifted optical feedback

Éric Lacot, R. Day, F. Stoeckel

The dynamical response of a laser to frequency-shifted optical feedback is investigated both theoretically and experimentally. The ultrahigh sensitivity of a class-B laser (i.e., a laser with a cavity damping rate ${\ensuremath{\gamma}}_{c}$ higher than the population damping rate ${\ensuremath{\gamma}}_{1})$ to external light injection is demonstrated by the optical detection of weak optical feedback. Compared to a conventional optical beating, the intensity modulation induced by the coherent interaction between the laser electric field and the frequency-shifted reinjected electric field can be several orders of magnitude higher. This method permits high sensitive interferometry and hence imaging. We call this laser detection technique laser optical feedback imaging (LOFI). When the optical frequency shift is resonant with the laser relaxation frequency, the intracavity amplification of the beating is maximum and the enhancement is given by the laser damping rate ratio ${\ensuremath{\gamma}}_{c}/{\ensuremath{\gamma}}_{1}.$ This amplification is of the order of ${10}^{6}$ for a microchip laser. We also show that without optical feedback the strong fluctuations of the laser output power are well described by the Langevin noise process. In a broad range around the laser relaxation frequency the laser quantum noise is also resonantly amplified and is then several orders of magnitude higher than the detector noise. In these conditions, the LOFI is a shot noise limited detection technique. Reflectivity as low as ${10}^{\ensuremath{-}13}$ is then easily detectable with a laser output power of a few milliwatts with a detection bandwidth of 1 kHz. Experimentally, for weak optical feedback the laser fluctuations are principally composed of the LOFI modulation signal at the shifted frequency and of the laser quantum noise amplified at the relaxation frequency. For strong optical feedback, nonlinear effects appear in the laser dynamics. In these conditions, harmonics and parametrics peaks appear in the power spectrum. The LOFI detection system is then saturated.

Physical Review A•Sep 19, 2001•136 citations
Conditions for the efficient detection of reflected laser radiation by means of optical quantum amplifiers are considered theoretically. It is shown that in the case of a strongly disturbed spatial coherence, there is no need to take it into account and a simple geometrical consideration is sufficient. The expressions relating the effective radius of the input aperture and the angular magnification of a projecting optical system with the laser radiation divergence and amplifier parameters are obtained. The theoretical results are confirmed by experiments.
A theory is devloped of the propagation of a spatially random signal, resulting from the scattering of coherent radiation, through a single-pass optical quantum amplifier. Attention is drawn to the need to allow for the channeling of the radiation by the walls of a gas-discharge cell. The spatial selectivity of optical quantum amplifiers is discussed. It is shown that the optimal size of the aperture of a receiver system with a single-pass amplifier may be considerably greater than the spatial coherence radius. Estimates are obtained for the scattered-radiation gain. The theoretical conclusions are confirmed by an experimental study.
An experimental investigation was made of the efficiency of a regenerative optical quantum amplifier in detection of scattered laser radiation. In agreement with theoretical estimates, the experimental results demonstrated that the average energy of the scattered field amplified in this amplifier did not exceed the energy in the spatial coherence area. The relative variance of the output signal, which was distributed exponentially under linear conditions, was close to unity and was independent of the relationship between the correlation radius of the spatially random field and the receiver aperture radius.
We calculate the input-output characteristics of an optical amplifier that consists of an inverted-population medium placed inside a high-Q Fabry-P\'erot cavity. Expressions are derived for the output second- and fourth-order spectral and temporal correlation functions, and more generally for the output characteristic functional, in terms of the corresponding input quantities. The photocount first and second factorial moments are obtained for both homodyne and direct detection of the amplifier input and output. The general results are applied to several cases of practical interest, including inputs that have coherent or chaotic coherence properties. Particular attention is paid to the effects of amplification on specific nonclassical varieties of input light. It is shown that a maximum of only twofold amplification is permitted if any squeezing present in the input is to survive as squeezing in the output light. Similarly, for the preservation of photon antibunching in amplification, we show, by consideration of a kind of free-space number-state input, that only small gains are allowed. The amplifier model treated here provides a detailed example of the limitations imposed by quantum mechanics on the minimum noise generated by a multimode linear amplifier. In particular, we show that minimum noise occurs in a cavity that is asymmetric with respect to mirror reflectivities, for which we derive the corresponding conditions. In addition, we demonstrate the ability of the amplifier to improve upon signal-to-noise ratio, otherwise limited by low detector quantum efficiency.
The laser is the key component in any quantum optics experiment. The performance of a laser can be described by the following parameters: optical power, spatial mode structure, output wavelength, frequency spectrum, and noise spectrum. The spatial properties of the laser beams are determined by the properties of the optical resonator. Lasers are available that produce output beams, which are very close to the theoretical limit. In order to determine the dynamics of the fluctuations of the laser system, a quantum model is required. Diode lasers use the band gap in doped semiconductor materials to produce optical gain directly from an electrical current. The chapter focuses on continuous-wave lasers since they are very common in quantum optics experiments, in precision metrology. It considers the theoretical limits to amplification of quantum limited light and discusses the theory of the non-linear interaction. The chapter discusses the measurement-based quantum amplifiers based on electro-optic feed forward and heralded devices based on photon counting.
A review of basic analytical results on coherent propagation of optical pulses through nondegenerate amplifying media is presented. Original numerical results concerning pulse coherent amplification by degenerate media and, in particular, by the amplifying medium of an iodine laser are described also. Furthermore, some analytical results on coherent effects in the pulsed mode of laser generation are given. We have pointed out that the stochastic mode of laser radiation is related also to the coherency of interaction of a laser field with matter.
The dynamical response of a laser to frequency-shifted optical feedback is investigated both theoretically and experimentally. The ultrahigh sensitivity of a class-B laser (i.e., a laser with a cavity damping rate ${\ensuremath{\gamma}}_{c}$ higher than the population damping rate ${\ensuremath{\gamma}}_{1})$ to external light injection is demonstrated by the optical detection of weak optical feedback. Compared to a conventional optical beating, the intensity modulation induced by the coherent interaction between the laser electric field and the frequency-shifted reinjected electric field can be several orders of magnitude higher. This method permits high sensitive interferometry and hence imaging. We call this laser detection technique laser optical feedback imaging (LOFI). When the optical frequency shift is resonant with the laser relaxation frequency, the intracavity amplification of the beating is maximum and the enhancement is given by the laser damping rate ratio ${\ensuremath{\gamma}}_{c}/{\ensuremath{\gamma}}_{1}.$ This amplification is of the order of 106{10}^{6}106 for a microchip laser. We also show that without optical feedback the strong fluctuations of the laser output power are well described by the Langevin noise process. In a broad range around the laser relaxation frequency the laser quantum noise is also resonantly amplified and is then several orders of magnitude higher than the detector noise. In these conditions, the LOFI is a shot noise limited detection technique. Reflectivity as low as ${10}^{\ensuremath{-}13}$ is then easily detectable with a laser output power of a few milliwatts with a detection bandwidth of 1 kHz. Experimentally, for weak optical feedback the laser fluctuations are principally composed of the LOFI modulation signal at the shifted frequency and of the laser quantum noise amplified at the relaxation frequency. For strong optical feedback, nonlinear effects appear in the laser dynamics. In these conditions, harmonics and parametrics peaks appear in the power spectrum. The LOFI detection system is then saturated.