Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Frontiers in Optics

Passive stabilization of slow light delays in SBS-based system using a Faraday rotator mirror

Mark Bashkansky, D. R. Walker, ARMEN M. GULIAN, Michael Steiner, Fredrik K. Fatemi

Published Jan 1, 2008• 0 citations
Publisher

Abstract

Stimulated Brillouin scattering in non-polarization maintaining single mode fibers is often used for slow light. Due to polarization sensitivity in the fibers the delay may vary as a function of time. We demonstrate a technique that can be used to stabilize the delay.
DOI
10.1364/fio.2008.fwr6

Related papers

Phase Locking of SBS Slow Light in a 2.2-km Single-Mode Fiber

Joseph E. Vornehm, Aaron Schweinsberg, Zhimin Shi +1 more

A stimulated Brillouin scattering (SBS) slow light system in a 2.2-km single-mode fiber is phase locked to a reference signal. Optical pulses of 6.5 ns duration are delayed 0.9 pulse width while maintaining lock.

Advanced Photonics•Jan 1, 2011•1 citation

Enhancement of maximum time delay in one fiber segment slow light systems based on stimulated Brillouin scattering

Ronny Henker, Thomas Schneider, Markus Junker +3 more

An effective method to enhance the time delay in SBS-based slow-light systems by decoupling the delay from the Brillouin gain is shown. A drastic improvement of the time delay in one fiber segment was achieved.

Conference on Lasers and Electro-Optics•May 1, 2007•2 citations

Stimulated Brillouin scattering slow light in optical fibers [Invited]

Avi Zadok, Avishay Eyal, Moshe Tur

Stimulated Brillouin scattering (SBS) has become a favorable underlying mechanism in many demonstrations of all-optical variable delay in standard fibers, often referred to as slow and fast light. Over 100 journal papers and numerous conference sessions have been dedicated to SBS slow light since 2005. In this paper, recent research in this area is reviewed. Following a short introduction to the topic, several specific trends in contemporary work are highlighted: the optimization of the SBS pump spectrum for extended slow light delay and reduced pulse distortion; SBS slow light demonstrations in nonstandard, highly nonlinear fibers; applications of SBS slow light to the delay of analog waveforms; and the role of polarization. Finally, a brief concluding perspective is provided.

Applied Optics•Jun 30, 2011•102 citations

Nearly transparent SBS slow light in an optical fiber

Zhaoming Zhu, Daniel J. Gauthier

Slow-light delay via stimulated Brillouin scattering (SBS) in optical fibers is usually achieved with delay-dependent amplification that degrades system performance. To address this problem, we propose a SBS slow-light method that makes use of two widely separated anti-Stokes absorption resonances, and achieve nearly transparent slow light in an optical fiber. We demonstrate the method in a highly nonlinear optical fiber, and achieve a slow-light bandwidth of approximately 150 MHz and a relative of delay of approximately 0.3 for approximately 9-ns pulses with a signal attenuation of approximately 4.8 dB.

arXiv:physics/0607169•Optics Express•Jan 1, 2006•41 citations

Optimisation of optical signal delay in slow-light systems based on stimulated brillouin scattering

Ronny Henker, Thomas Schneider, Andrzej Wiatrek +4 more

Different Slow-light systems have been discussed and developed as a powerful tool to reduce the group velocity of optical signals during the last years. It has enjoyed much recent interest because of the potential system applications in optical telecommunication and information systems. Especially the nonlinear effect of stimulated Brillouin scattering (SBS) has become important for fiber based Slow-light systems. But, the SBS also has two challenges. First, the maximum time delay is limited due to the saturation of the Brillouin amplification process and second, the delay of the pulses is accompanied by pulse distortions (pulse shape broadening). For these aspects the shape of the Brillouin spectrum is of special interest. In this article a system is presented which allows the optimisation of the Brillouin spectrum. Simulations and first measurements show how the time delay can be enhanced with a simultaneous reduction of the pulse distortions.

Irish Signals and Systems Conference•Jan 1, 2008•3 citations

Improving the Delay Efficiency of SBS Slow Light by Using Highly Nonlinear Photonic Crystal Fiber

Xiufeng Yang, Zhengrong Tong, Junfa Zhao +2 more

An efficient stimulated Brillouin scattering slow light system based on a highly nonlinear photonic crystal fiber is presented. Up to 30 ns time delay could be achieved by using 70-m long fiber under the pump power 101 mW. The figure of merit (FOM) of this kind fiber is 0.0035 dB/mW/m, which is about 4.8 times larger than the single mode fiber (SMF).

•Apr 1, 2010•0 citations
Stimulated Brillouin scattering (SBS) has become a favorable underlying mechanism in many demonstrations of all-optical variable delay in standard fibers, often referred to as slow and fast light. Over 100 journal papers and numerous conference sessions have been dedicated to SBS slow light since 2005. In this paper, recent research in this area is reviewed. Following a short introduction to the topic, several specific trends in contemporary work are highlighted: the optimization of the SBS pump spectrum for extended slow light delay and reduced pulse distortion; SBS slow light demonstrations in nonstandard, highly nonlinear fibers; applications of SBS slow light to the delay of analog waveforms; and the role of polarization. Finally, a brief concluding perspective is provided.
Slow-light delay via stimulated Brillouin scattering (SBS) in optical fibers is usually achieved with delay-dependent amplification that degrades system performance. To address this problem, we propose a SBS slow-light method that makes use of two widely separated anti-Stokes absorption resonances, and achieve nearly transparent slow light in an optical fiber. We demonstrate the method in a highly nonlinear optical fiber, and achieve a slow-light bandwidth of approximately 150 MHz and a relative of delay of approximately 0.3 for approximately 9-ns pulses with a signal attenuation of approximately 4.8 dB.
Different Slow-light systems have been discussed and developed as a powerful tool to reduce the group velocity of optical signals during the last years. It has enjoyed much recent interest because of the potential system applications in optical telecommunication and information systems. Especially the nonlinear effect of stimulated Brillouin scattering (SBS) has become important for fiber based Slow-light systems. But, the SBS also has two challenges. First, the maximum time delay is limited due to the saturation of the Brillouin amplification process and second, the delay of the pulses is accompanied by pulse distortions (pulse shape broadening). For these aspects the shape of the Brillouin spectrum is of special interest. In this article a system is presented which allows the optimisation of the Brillouin spectrum. Simulations and first measurements show how the time delay can be enhanced with a simultaneous reduction of the pulse distortions.