Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Improving the Delay Efficiency of SBS Slow Light by Using Highly Nonlinear Photonic Crystal Fiber

Xiufeng Yang, Zhengrong Tong, Junfa Zhao, Yuan Li, Yange Liu

Published Apr 1, 2010• 0 citations
Publisher

Abstract

An efficient stimulated Brillouin scattering slow light system based on a highly nonlinear photonic crystal fiber is presented. Up to 30 ns time delay could be achieved by using 70-m long fiber under the pump power 101 mW. The figure of merit (FOM) of this kind fiber is 0.0035 dB/mW/m, which is about 4.8 times larger than the single mode fiber (SMF).

DOI
10.1109/cmc.2010.288

Related papers

Slow light generation using SBS in a liquid-core photonic crystal fiber

Wenbin An, Haiming Jiang, Yinjia Fang +3 more

Based on stimulated Brillouin scattering (SBS), the slow light effect in photonic crystal fibre (PCF), which is filled with highly nonlinear liquid-carbon disuphide in the core region, is investigated. Maximum allowable pump power for undistorted output pulse, minimum value of pump power required to initiate the SBS effect, Brillouin gain and time-tonic delay experienced by the pulse in the designed liquid-core photonic crystal fibre, are all calculated numerically. We have found that the maximum time-delay up to ∼134.4 ns at 1.064 μm can be obtained using 1 m long liquid-core PCF pumped with only 65.8 mW, which is lower than the value reported in the literature for achieving such a high delay time. The results indicate that liquid-core PCF is capable of generating tunable time-delay that is adjusted by the pump power and structural parameters of the proposed liquid-core PCF.

Journal of Modern Optics•Nov 11, 2016•4 citations

SBS Slow Light in High Nonlinearity Photonic Crystal Fiber

Yin Wang, Wei Zhang, Yidong Huang +1 more

Up to 14-ns delay is achieved by the SBS slow light in a 25-m long high nonlinearity photonic crystal fiber. The high delay efficiency improves the control rate of SBS slow light systems.

Optical Fiber Communication Conference•Mar 1, 2007•5 citations

Slow light with a swept-frequency source

Rui Zhang, Yunhui Zhu, Jing Wang +1 more

ct: We introduce a new concept for stimulated-Brillouin-scattering-based slow light in optical fibers that is applicable for broadly-tunable frequency-swept sources. It allows slow light to be achieved, in principle, over the entire transparency window of the optical fiber. We demonstrate a slow light delay of 10 ns at 1.55 μm using a 10-m-long photonic crystal fiber with a source sweep rate of 400 MHz/μs and a pump power of 200 mW. We also show that there exists a maximal delay obtainable by this method, which is set by the SBS threshold, independent of sweep rate. For our fiber with optimum length, this maximum delay is ~38 ns, obtained for a pump power of 760 mW.

arXiv:1010.3179•Optics Express•Dec 10, 2010•8 citations

Slow light based on stimulated Brillouin scattering in microstructured fiber

Wei Wei, Xia Zhang, Hui Yu +6 more

All-optical tunable slow light technology has promising applications in all-optical network and optical information process. Tunable slow light based on stimulated Brillouin scattering is experimentally investigated, using highly nonlinear microstructured fiber which is designed and drawn by ourselves. The experiment setup is composed of single pump and a single-stage delay. When the pump power reaches 162.6 mW, a maximum delay of 76 ns, equal to 0.76 pulse width, is achieved in the highly nonlinear microstructured fiber of 120 m in length. In addition, by adjusting the pump power, the tunable slow light can be realized. This scheme of slow light has advantages such as large delay, being all-optical tunable and compatible with optical communications systems.

Acta Physica Sinica•Jan 1, 2013•5 citations

Nearly transparent SBS slow light in an optical fiber

Zhaoming Zhu, Daniel J. Gauthier

Slow-light delay via stimulated Brillouin scattering (SBS) in optical fibers is usually achieved with delay-dependent amplification that degrades system performance. To address this problem, we propose a SBS slow-light method that makes use of two widely separated anti-Stokes absorption resonances, and achieve nearly transparent slow light in an optical fiber. We demonstrate the method in a highly nonlinear optical fiber, and achieve a slow-light bandwidth of approximately 150 MHz and a relative of delay of approximately 0.3 for approximately 9-ns pulses with a signal attenuation of approximately 4.8 dB.

arXiv:physics/0607169•Optics Express•Jan 1, 2006•41 citations

Slow-light delay enhancement in small-core pure silica photonic crystal fiber based on Brillouin scattering

Sigang Yang, Hongwei Chen, Ciyuan Qiu +5 more

We demonstrate that we realize large-delay slow light based on stimulated Brillouin scattering in a short length of our fabricated small-core photonic crystal fiber (PCF). The cavity effect from the partially reflective splices in the end of the PCF enhances slow-light delay significantly. Our experiments show that large slow-light delay can be easily realized in a very short length of the PCF with a moderate pump power. Up to a one-half pulse-width delay is achieved in only 50 m of PCF in a single pump segment.

Optics Letters•Jan 3, 2008•29 citations
An efficient stimulated Brillouin scattering slow light system based on a highly nonlinear photonic crystal fiber is presented. Up to 30 ns time delay could be achieved by using 70-m long fiber under the pump power 101 mW. The figure of merit (FOM) of this kind fiber is 0.0035 dB/mW/m, which is about 4.8 times larger than the single mode fiber (SMF).
Based on stimulated Brillouin scattering (SBS), the slow light effect in photonic crystal fibre (PCF), which is filled with highly nonlinear liquid-carbon disuphide in the core region, is investigated. Maximum allowable pump power for undistorted output pulse, minimum value of pump power required to initiate the SBS effect, Brillouin gain and time-tonic delay experienced by the pulse in the designed liquid-core photonic crystal fibre, are all calculated numerically. We have found that the maximum time-delay up to ∼134.4 ns at 1.064 μm can be obtained using 1 m long liquid-core PCF pumped with only 65.8 mW, which is lower than the value reported in the literature for achieving such a high delay time. The results indicate that liquid-core PCF is capable of generating tunable time-delay that is adjusted by the pump power and structural parameters of the proposed liquid-core PCF.
ct: We introduce a new concept for stimulated-Brillouin-scattering-based slow light in optical fibers that is applicable for broadly-tunable frequency-swept sources. It allows slow light to be achieved, in principle, over the entire transparency window of the optical fiber. We demonstrate a slow light delay of 10 ns at 1.55 μm using a 10-m-long photonic crystal fiber with a source sweep rate of 400 MHz/μs and a pump power of 200 mW. We also show that there exists a maximal delay obtainable by this method, which is set by the SBS threshold, independent of sweep rate. For our fiber with optimum length, this maximum delay is ~38 ns, obtained for a pump power of 760 mW.
All-optical tunable slow light technology has promising applications in all-optical network and optical information process. Tunable slow light based on stimulated Brillouin scattering is experimentally investigated, using highly nonlinear microstructured fiber which is designed and drawn by ourselves. The experiment setup is composed of single pump and a single-stage delay. When the pump power reaches 162.6 mW, a maximum delay of 76 ns, equal to 0.76 pulse width, is achieved in the highly nonlinear microstructured fiber of 120 m in length. In addition, by adjusting the pump power, the tunable slow light can be realized. This scheme of slow light has advantages such as large delay, being all-optical tunable and compatible with optical communications systems.
Slow-light delay via stimulated Brillouin scattering (SBS) in optical fibers is usually achieved with delay-dependent amplification that degrades system performance. To address this problem, we propose a SBS slow-light method that makes use of two widely separated anti-Stokes absorption resonances, and achieve nearly transparent slow light in an optical fiber. We demonstrate the method in a highly nonlinear optical fiber, and achieve a slow-light bandwidth of approximately 150 MHz and a relative of delay of approximately 0.3 for approximately 9-ns pulses with a signal attenuation of approximately 4.8 dB.
We demonstrate that we realize large-delay slow light based on stimulated Brillouin scattering in a short length of our fabricated small-core photonic crystal fiber (PCF). The cavity effect from the partially reflective splices in the end of the PCF enhances slow-light delay significantly. Our experiments show that large slow-light delay can be easily realized in a very short length of the PCF with a moderate pump power. Up to a one-half pulse-width delay is achieved in only 50 m of PCF in a single pump segment.