Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Magnetics

Microwave mixing and direct detection using SIS and SIS' quasiparticle tunnel junctions

A. D. Smith, William R. McGrath, P. L. Richards, R. Harris, Frances L. Lloyd, D. E. Prober, Padmanabhan Santhanam

Published May 1, 1983• 15 citations
Publisher

Abstract

Quasiparticle mixers have shown strong quantum effects, conversion gain, and noise levels approaching the quantum limit, but only in tunnel junctions with very low sub-gap "leakage" conductance. It has been suggested that SIS' tunnel junctions, made from two different conductors with unequal gaps, will function as high gain mixers since the dynamic conductance below the gap is negative. We report results of the first SIS' mixing and direct detection experiments. At 36 GHz, a conversion efficiency of -4 dB with a noise temperature of 33 K (SSB) has been obtained. A novel gain mechanism for SIS' direct detectors is predicted. A direct detector responsivity of 250 A/W was measured. We compare our results to quantum theory models. In addition, we demonstrate quasiparticle harmonic mixing of a 36 GHz signal with an 18 GHz local oscillator in tin SIS junctions. Harmonic mixers can have important advantages at high microwave frequencies where insufficient local oscillator power is available.

DOI
10.1109/tmag.1983.1062405

Related papers

Quasiparticle Harmonic Mixing with SIS Junctions

A. D. Smith, R. A. Batchelor, William R. McGrath +4 more

We have demonstrated quasi particle harmonic mixing of a 36 GHz signal with an 18 GHz local oscillator in tin SIS junctions. Harmonic mixers can have important advantages at high microwave frequencies where insufficient LO power is available.

International Conference on Submillimeter Waves and Their Applications•Dec 1, 1981•0 citations

Investigation of the Harmonic Mixer and Low-Frequency Converter Regimes in a Superconducting Tunnel Junction

K. V. Kalashnikov, Anton A. Artanov, Gert J. de Lange +1 more

We experimentally investigate different mixing regi-mes in Nb/AlOx/Nb and Nb/AlN/NbN tunnel superconductor-insulator-superconductor (SIS) junctions. The SIS mixers were studied with regard to the following modes of operation: in an extremely low-frequency range (0.1-20 GHz) and as high harmonic mixers; n ≈ 20-30 at signal frequencies of about 500 GHz that requires high power of a local oscillator. The quasiparticle and Josephson mixing regimes have been compared. We demonstrate that, in some applications requiring high conversion efficiency, the Josephson regime can be more preferable than the quasiparticle regime due to a larger output signal and better signal-to-noise ratio. As an example of such an application, we consider the phase locking of a THz oscillator using a cryogenic harmonic phase detector, which only ought to realize all of its benefits under the Josephson mixing regime. In addition, we demonstrate that the presence of the Josephson effect results in considerable increase in conversion efficiency at the expense of the dynamic range decrease; it was measured for low-frequency up- and down-convertors, which are promising for cryogenic multiplexing systems.

IEEE Transactions on Applied Superconductivity•Feb 6, 2018•6 citations

Superconductive devices for millimeter wave detection, mixing, and amplification

P. L. Richards, Tek-Ming Shen

Single-particle (quasi-particle) tunneling through an insulating barrier between two superconductors or between a superconductor and a normal conductor is being used to make very-low-noise detectors and mixers for millimeter wavelengths. The nonlinearity of theI-Vcurve obtained from tunneling between two superconductors can be so strong that classical theory breaks down and photon-assisted tunneling theory must be used to understand device performance. Quantum theory predicts that a quasi-particle tunnel junction can be operated as a microwave photon detector with quantum efficiency close to unity or as a heterodyne mixer with conversion gain and with mixer noise temperature comparable with the quantum noise limitT_{M} =\bar{h}\omega/k. Both of these predictions have been experimentally realized at 36 GHz using superconductor-insulator-superconductor (SIS) junctions. It appears probable that these quasi-particle detectors and mixers will supercede the corresponding Josephson-effect devices at millimeter wavelengths.

IEEE Transactions on Electron Devices•Oct 1, 1980•61 citations

Noise properties of a mixer with SIS NbN quasi-particle tunnel junctions

Alexandre Karpov, B. Plathner, K. H. Gundlach +2 more

We present the noise properties of a mixer with the NbN-MgO-NbN quasiparticle tunnel junctions. Our work is based on experiment in the 120-180 GHz range with the NbN tunnel junctions in the mixer. Mixer printed circuit is totally made of NbN. The mixer operates at 5.4 K temperature unacceptable with Nb junctions. The minimum DSB receiver noise temperature is about 65 K at 162 GHz and approaches the Nb SIS mixer performance in mm band. It has been found that the noise sources in the NbN junctions are comparable to the Nb junctions and that the receiver noise with the NbN SIS mixer may be only few times more than the quantum limit of noise in the frequency range below the gap frequency. Output noise of the SIS mixer has been found constant in a wide frequency band and within an important range of the local oscillator amplitudes.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Oct 13, 1995•3 citations

High-frequency limits of superconducting tunnel junction mixers

Dag Winkler, T. Claeson

We have investigated high-frequency limits of superconducting quasiparticle mixers from experiments on Al/Al-oxide-In/Al (or Ag) tunnel junctions, and from calculations based on Tucker’s quantum theory of mixing (QTM). The small superconducting energy gap of Al enabled us to study mixer performance at around the junction gap frequency, fg =(Δ1+Δ2)/h≊87 GHz, of superconductor-insulator-superconductor (SIS) mixers, and at twice the junction gap frequency for S-I-normal metal (SIN) mixers ( fg =Δ1/h) with available millimeter wave sources. Because of the low transition temperature of Al (Tc ≊1.3 K), a dilution refrigerator was used for providing temperatures below 1 K. The best mixer conversion efficiency was obtained for a low-resistance (∼34 Ω) six-junction array SIS mixer operated at f/fg ≊1 (in this case 73 GHz). The coupled single sideband conversion gain (with no image rejection) was −13.8 dB and the available conversion gain was estimated to −8.4 dB. Complicating nonequilibrium phenomena made it difficult to compare the performance of these relatively high-current-density mixers to the QTM. However, good agreement between calculated and corresponding measured conversion efficiencies and dynamic resistance values was obtained for the low-current-density mixers. Noise due to switching between rf-induced Josephson steps and interference from Josephson mixing could be quenched by a magnetic field. Several high-frequency limits are considered in this paper (such as Josephson switching noise, nonequilibrium phenomena, pair breaking, and energy gap limitations). Our results indicate that submillimeter wave SIS mixer receivers are likely to perform well, at least up to their gap frequencies, i.e., the THz region for large gap superconductors. Our QTM calculations showed that conversion gain larger than unity should be possible up to twice the gap frequency. Above this frequency the conversion loss will increase rapidly.

Journal of Applied Physics•Dec 1, 1987•35 citations

Performance of heterodyne mixers using arrays of SIS junctions

Denis Crété, William R. McGrath, P. L. Richards +1 more

The SIS quasiparticle tunnel junction has been demonstrated to be the most sensitive mixing element for millimeter wave receivers [1,2]. Conversion gain greater than 1 and noise temperature approaching the quantum limit [3,4] has been observed. The required local oscillator power, which can be as small as 10−8W, leads to a low saturation threshold for these mixers [5,6]. The practical benefits, including higher saturation power, of using series arrays are sufficiently important that a substantial number of experiments using arrays have been reported [2,6,7,8,9]. It has not been clear, however, whether there has been any sacrifice in mixer conversion efficiency (gain) or noise. We present a systematic experimental investigation of mixing performance in series arrays of N junctions, where N = 1, 5, 10, 25 and 50.

International Conference on Infrared, Millimeter, and Terahertz Waves (IRMMW-THz)•Dec 1, 1985•0 citations
Quasiparticle mixers have shown strong quantum effects, conversion gain, and noise levels approaching the quantum limit, but only in tunnel junctions with very low sub-gap "leakage" conductance. It has been suggested that SIS' tunnel junctions, made from two different conductors with unequal gaps, will function as high gain mixers since the dynamic conductance below the gap is negative. We report results of the first SIS' mixing and direct detection experiments. At 36 GHz, a conversion efficiency of -4 dB with a noise temperature of 33 K (SSB) has been obtained. A novel gain mechanism for SIS' direct detectors is predicted. A direct detector responsivity of 250 A/W was measured. We compare our results to quantum theory models. In addition, we demonstrate quasiparticle harmonic mixing of a 36 GHz signal with an 18 GHz local oscillator in tin SIS junctions. Harmonic mixers can have important advantages at high microwave frequencies where insufficient local oscillator power is available.
We experimentally investigate different mixing regi-mes in Nb/AlOx/Nb and Nb/AlN/NbN tunnel superconductor-insulator-superconductor (SIS) junctions. The SIS mixers were studied with regard to the following modes of operation: in an extremely low-frequency range (0.1-20 GHz) and as high harmonic mixers; n ≈ 20-30 at signal frequencies of about 500 GHz that requires high power of a local oscillator. The quasiparticle and Josephson mixing regimes have been compared. We demonstrate that, in some applications requiring high conversion efficiency, the Josephson regime can be more preferable than the quasiparticle regime due to a larger output signal and better signal-to-noise ratio. As an example of such an application, we consider the phase locking of a THz oscillator using a cryogenic harmonic phase detector, which only ought to realize all of its benefits under the Josephson mixing regime. In addition, we demonstrate that the presence of the Josephson effect results in considerable increase in conversion efficiency at the expense of the dynamic range decrease; it was measured for low-frequency up- and down-convertors, which are promising for cryogenic multiplexing systems.
Single-particle (quasi-particle) tunneling through an insulating barrier between two superconductors or between a superconductor and a normal conductor is being used to make very-low-noise detectors and mixers for millimeter wavelengths. The nonlinearity of theI-Vcurve obtained from tunneling between two superconductors can be so strong that classical theory breaks down and photon-assisted tunneling theory must be used to understand device performance. Quantum theory predicts that a quasi-particle tunnel junction can be operated as a microwave photon detector with quantum efficiency close to unity or as a heterodyne mixer with conversion gain and with mixer noise temperature comparable with the quantum noise limitT_{M} =\bar{h}\omega/k. Both of these predictions have been experimentally realized at 36 GHz using superconductor-insulator-superconductor (SIS) junctions. It appears probable that these quasi-particle detectors and mixers will supercede the corresponding Josephson-effect devices at millimeter wavelengths.
We present the noise properties of a mixer with the NbN-MgO-NbN quasiparticle tunnel junctions. Our work is based on experiment in the 120-180 GHz range with the NbN tunnel junctions in the mixer. Mixer printed circuit is totally made of NbN. The mixer operates at 5.4 K temperature unacceptable with Nb junctions. The minimum DSB receiver noise temperature is about 65 K at 162 GHz and approaches the Nb SIS mixer performance in mm band. It has been found that the noise sources in the NbN junctions are comparable to the Nb junctions and that the receiver noise with the NbN SIS mixer may be only few times more than the quantum limit of noise in the frequency range below the gap frequency. Output noise of the SIS mixer has been found constant in a wide frequency band and within an important range of the local oscillator amplitudes.
We have investigated high-frequency limits of superconducting quasiparticle mixers from experiments on Al/Al-oxide-In/Al (or Ag) tunnel junctions, and from calculations based on Tucker’s quantum theory of mixing (QTM). The small superconducting energy gap of Al enabled us to study mixer performance at around the junction gap frequency, fg =(Δ1+Δ2)/h≊87 GHz, of superconductor-insulator-superconductor (SIS) mixers, and at twice the junction gap frequency for S-I-normal metal (SIN) mixers ( fg =Δ1/h) with available millimeter wave sources. Because of the low transition temperature of Al (Tc ≊1.3 K), a dilution refrigerator was used for providing temperatures below 1 K. The best mixer conversion efficiency was obtained for a low-resistance (∼34 Ω) six-junction array SIS mixer operated at f/fg ≊1 (in this case 73 GHz). The coupled single sideband conversion gain (with no image rejection) was −13.8 dB and the available conversion gain was estimated to −8.4 dB. Complicating nonequilibrium phenomena made it difficult to compare the performance of these relatively high-current-density mixers to the QTM. However, good agreement between calculated and corresponding measured conversion efficiencies and dynamic resistance values was obtained for the low-current-density mixers. Noise due to switching between rf-induced Josephson steps and interference from Josephson mixing could be quenched by a magnetic field. Several high-frequency limits are considered in this paper (such as Josephson switching noise, nonequilibrium phenomena, pair breaking, and energy gap limitations). Our results indicate that submillimeter wave SIS mixer receivers are likely to perform well, at least up to their gap frequencies, i.e., the THz region for large gap superconductors. Our QTM calculations showed that conversion gain larger than unity should be possible up to twice the gap frequency. Above this frequency the conversion loss will increase rapidly.
The SIS quasiparticle tunnel junction has been demonstrated to be the most sensitive mixing element for millimeter wave receivers [1,2]. Conversion gain greater than 1 and noise temperature approaching the quantum limit [3,4] has been observed. The required local oscillator power, which can be as small as 10−8W, leads to a low saturation threshold for these mixers [5,6]. The practical benefits, including higher saturation power, of using series arrays are sufficiently important that a substantial number of experiments using arrays have been reported [2,6,7,8,9]. It has not been clear, however, whether there has been any sacrifice in mixer conversion efficiency (gain) or noise. We present a systematic experimental investigation of mixing performance in series arrays of N junctions, where N = 1, 5, 10, 25 and 50.