Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physical Review Letters

Experimental Determination of the Quantum-Mechanical State of a Molecular Vibrational Mode Using Fluorescence Tomography

Thomas J. Dunn, Ian A. Walmsley, Shaul Mukamel

Published Feb 6, 1995• 324 citations
Publisher

Abstract

We present a spectroscopic method for the complete characterization of the quantum state of the vibrational mode of a molecule in terms of a phase-space quasiprobability distribution. The distribution for a molecular vibrational mode excited by a short optical pulse is reconstructed from measurements of its time-dependent spectrum of fluorescence.

DOI
10.1103/physrevlett.74.884

Related papers

Quantum state measurement for molecules

Leon J. Waxer

Measuring the density operator of a quantum system provides complete state information. This thesis concerns quantum state measurement in diatomic molecules. We have developed techniques to reconstruct the density operator of a vibrational wave packet excited by an ultrafast laser pulse. These techniques can be used to reconstruct the quantum state of a wave packet without making any assumptions about the initial state of the molecule or the amplitude and phase of the excitation pulse. Molecular emission tomography measures a phase space quasi-probability distribution of a vibrational wave packet. We introduce tomographic state measurement, and we discuss the requirements for successful reconstruction of quantum states with complicated phase space distributions. Molecular tomographic state reconstruction relies on measurements of the time-dependent spectrum (TDS) of molecular fluorescence. Accurate state measurement requires quality TDS data. We describe the experimental implementation of molecular emission tomography, emphasizing the important parameters for optimization of the TDS signal. We present phase space quasi-probability distributions, reconstructed from experimental data. We introduce a new state reconstruction technique for directly measuring elements of the density matrix for a wave packet evolving in an anharmonic potential. We establish a direct relationship between elements of the density matrix and the TDS of molecular fluorescence. Taking advantage of this relationship, we analyze three methods for direct density matrix reconstruction from measurements of the TDS. The initial state of our molecular sample is described by a large mixture of ro-vibrational levels. We consider the effects of molecular rotations and a mixed initial state. We develop simulations to explain the form of the TDS signals measured in the laboratory, and we find that tomographic state reconstruction provides measurements of vibrational quantum states which are relatively insensitive to large distributions of initial rotational levels. We have measured the TDS of the coherent component of the emission from a vibrational wave packet. We present a model for this emission which is in excellent agreement with the measured data. We examine the effects of both polarization and quantum interference on the coherent signal, and we discuss how this signal can be used for state reconstruction.

•Jan 1, 1999•0 citations

Emission tomography for quantum state measurement in matter

Ian A. Walmsley, Leon J. Waxer

Emission tomography provides a method for the characterization of quantum states of those degrees of freedom of material quantum systems that are coupled to electronic states of the system. In such systems, the time-dependent fluorescence spectrum contains complete information about the non-electronic degree of freedom. Phase-space or, in certain cases, density matrix representations of the state can be reconstructed from the spectrum using standard methods of computer-assisted tomography or linear algebra. The principles and implementation of this procedure are described in detail and applied to the specific example of the reconstruction of the quantum state of the vibrational mode of a diatomic molecule excited into a non-stationary wavepacket state.

Journal of Physics B Atomic Molecular and Optical Physics•May 14, 1998•39 citations

Molecular emission tomography of anharmonic vibrations

Leon J. Waxer, Ian A. Walmsley, W. Vogel

We describe a method for the determination of the quantum state of molecular vibrations in a regime where the anharmonicities are significant. The method is based on the direct analysis of the observed time-resolved spectrum of resonance fluorescence of the molecular sample.

Physical Review A•Oct 1, 1997•17 citations

Complete experimental characterization of the quantum state of a light mode via the Wigner function and the density matrix: application to quantum phase distributions of vacuum and squeezed-vacuum states

D. T. Smithey, M. Beck, J. Cooper +2 more

We have used the recently demonstrated method of optical homodyne tomography (OHT) to measure the Wigner quasiprobability distribution (Wigner function) and the density matrix for both a squeezed-vacuum and a vacuum state of a single spatial-temporal mode of the electromagnetic field. This method consists of measuring a set of probability distributions for many different Hilbert-space representations of the field-quadrature amplitude, using balanced homodyne detection, and then using tomography to obtain the Wigner function. Once the Wigner function is obtained, one can acquire the density matrix, including its complex phase. In the case of a pure state, this technique yields an experimentally determined complex wavefunction, as demonstrated here for the vacuum. The density matrix represents a complete quantum mechanical characterization of the state. From the measured density matrix we have obtained the Pegg–Barnett optical phase distribution, and from the Wigner function, the Wigner optical phase distribution.

Physica Scripta•Jan 1, 1993•156 citations

Quantum State Holography

C. Leichtle, Wolfgang P. Schleich, Ilya Sh. Averbukh +1 more

We introduce a method for reconstructing quantum superposition states excited in molecules or atoms by short laser pulses. The technique is based on mixing the unknown object state with a known reference state generated in the same system by an additional delayed laser pulse, and detecting the total time- and frequency-integrated fluorescence as a function of the delay. We demonstrate the feasibility of the method by reconstructing various vibrational wave packets in sodium dimers.

Physical Review Letters•Feb 16, 1998•97 citations

Reconstructing vibrational states in warm molecules using four-wave mixing with femtosecond laser pulses

Anders S. Mouritzen, Olga Smirnova, Stefanie Gräfe +2 more

We propose a method to reconstruct the vibrational quantum state of molecules excited by a general excitation laser pulse. Unlike existing methods, we do not require the molecules before excitation to be in a pure state, allowing us to treat the important case of initially thermally excited molecules. Even if only a single initial level is appreciably populated, initial levels with small populations can still give major contributions to the unknown vibrational state, making it essential to take them into account. In addition to the excitation pulse, the method uses two incident, short laser pulses in a non-co-linear geometry to create four-wave mixing in the molecules. The measurements used in the reconstruction are spectra of the outgoing four-wave mixing pulse at different time delays of the excitation laser pulse. An important point is that the method does not require detailed knowledge of molecular transition moments between excited states nor of any of the incoming laser pulses, but circumvents this requirement by using one or more calibration laser pulses in a separate experiment either before or after the main data are recorded. The only requirements for the calibration laser pulses are that the constant parts of their spectrums should together cover the spectral range of the excitation laser pulse, and the constant part of each should have sufficient spectral overlap with one other calibration pulse to populate two of the same levels. Finally, we discuss the extension of the reconstruction method in this paper to more general situations, hereby presenting the new idea of quantum state reconstruction through perturbations with calibration.

arXiv:0706.1452•Jun 11, 2007•0 citations
We present a spectroscopic method for the complete characterization of the quantum state of the vibrational mode of a molecule in terms of a phase-space quasiprobability distribution. The distribution for a molecular vibrational mode excited by a short optical pulse is reconstructed from measurements of its time-dependent spectrum of fluorescence.
Measuring the density operator of a quantum system provides complete state information. This thesis concerns quantum state measurement in diatomic molecules. We have developed techniques to reconstruct the density operator of a vibrational wave packet excited by an ultrafast laser pulse. These techniques can be used to reconstruct the quantum state of a wave packet without making any assumptions about the initial state of the molecule or the amplitude and phase of the excitation pulse. Molecular emission tomography measures a phase space quasi-probability distribution of a vibrational wave packet. We introduce tomographic state measurement, and we discuss the requirements for successful reconstruction of quantum states with complicated phase space distributions. Molecular tomographic state reconstruction relies on measurements of the time-dependent spectrum (TDS) of molecular fluorescence. Accurate state measurement requires quality TDS data. We describe the experimental implementation of molecular emission tomography, emphasizing the important parameters for optimization of the TDS signal. We present phase space quasi-probability distributions, reconstructed from experimental data. We introduce a new state reconstruction technique for directly measuring elements of the density matrix for a wave packet evolving in an anharmonic potential. We establish a direct relationship between elements of the density matrix and the TDS of molecular fluorescence. Taking advantage of this relationship, we analyze three methods for direct density matrix reconstruction from measurements of the TDS. The initial state of our molecular sample is described by a large mixture of ro-vibrational levels. We consider the effects of molecular rotations and a mixed initial state. We develop simulations to explain the form of the TDS signals measured in the laboratory, and we find that tomographic state reconstruction provides measurements of vibrational quantum states which are relatively insensitive to large distributions of initial rotational levels. We have measured the TDS of the coherent component of the emission from a vibrational wave packet. We present a model for this emission which is in excellent agreement with the measured data. We examine the effects of both polarization and quantum interference on the coherent signal, and we discuss how this signal can be used for state reconstruction.
Emission tomography provides a method for the characterization of quantum states of those degrees of freedom of material quantum systems that are coupled to electronic states of the system. In such systems, the time-dependent fluorescence spectrum contains complete information about the non-electronic degree of freedom. Phase-space or, in certain cases, density matrix representations of the state can be reconstructed from the spectrum using standard methods of computer-assisted tomography or linear algebra. The principles and implementation of this procedure are described in detail and applied to the specific example of the reconstruction of the quantum state of the vibrational mode of a diatomic molecule excited into a non-stationary wavepacket state.
We have used the recently demonstrated method of optical homodyne tomography (OHT) to measure the Wigner quasiprobability distribution (Wigner function) and the density matrix for both a squeezed-vacuum and a vacuum state of a single spatial-temporal mode of the electromagnetic field. This method consists of measuring a set of probability distributions for many different Hilbert-space representations of the field-quadrature amplitude, using balanced homodyne detection, and then using tomography to obtain the Wigner function. Once the Wigner function is obtained, one can acquire the density matrix, including its complex phase. In the case of a pure state, this technique yields an experimentally determined complex wavefunction, as demonstrated here for the vacuum. The density matrix represents a complete quantum mechanical characterization of the state. From the measured density matrix we have obtained the Pegg–Barnett optical phase distribution, and from the Wigner function, the Wigner optical phase distribution.
We propose a method to reconstruct the vibrational quantum state of molecules excited by a general excitation laser pulse. Unlike existing methods, we do not require the molecules before excitation to be in a pure state, allowing us to treat the important case of initially thermally excited molecules. Even if only a single initial level is appreciably populated, initial levels with small populations can still give major contributions to the unknown vibrational state, making it essential to take them into account. In addition to the excitation pulse, the method uses two incident, short laser pulses in a non-co-linear geometry to create four-wave mixing in the molecules. The measurements used in the reconstruction are spectra of the outgoing four-wave mixing pulse at different time delays of the excitation laser pulse. An important point is that the method does not require detailed knowledge of molecular transition moments between excited states nor of any of the incoming laser pulses, but circumvents this requirement by using one or more calibration laser pulses in a separate experiment either before or after the main data are recorded. The only requirements for the calibration laser pulses are that the constant parts of their spectrums should together cover the spectral range of the excitation laser pulse, and the constant part of each should have sufficient spectral overlap with one other calibration pulse to populate two of the same levels. Finally, we discuss the extension of the reconstruction method in this paper to more general situations, hereby presenting the new idea of quantum state reconstruction through perturbations with calibration.