Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Physics B Atomic Molecular and Optical Physics

Emission tomography for quantum state measurement in matter

Ian A. Walmsley, Leon J. Waxer

Published May 14, 1998• 39 citations
Publisher

Abstract

Emission tomography provides a method for the characterization of quantum states of those degrees of freedom of material quantum systems that are coupled to electronic states of the system. In such systems, the time-dependent fluorescence spectrum contains complete information about the non-electronic degree of freedom. Phase-space or, in certain cases, density matrix representations of the state can be reconstructed from the spectrum using standard methods of computer-assisted tomography or linear algebra. The principles and implementation of this procedure are described in detail and applied to the specific example of the reconstruction of the quantum state of the vibrational mode of a diatomic molecule excited into a non-stationary wavepacket state.

DOI
10.1088/0953-4075/31/9/004

Related papers

Quantum state measurement for molecules

Leon J. Waxer

Measuring the density operator of a quantum system provides complete state information. This thesis concerns quantum state measurement in diatomic molecules. We have developed techniques to reconstruct the density operator of a vibrational wave packet excited by an ultrafast laser pulse. These techniques can be used to reconstruct the quantum state of a wave packet without making any assumptions about the initial state of the molecule or the amplitude and phase of the excitation pulse. Molecular emission tomography measures a phase space quasi-probability distribution of a vibrational wave packet. We introduce tomographic state measurement, and we discuss the requirements for successful reconstruction of quantum states with complicated phase space distributions. Molecular tomographic state reconstruction relies on measurements of the time-dependent spectrum (TDS) of molecular fluorescence. Accurate state measurement requires quality TDS data. We describe the experimental implementation of molecular emission tomography, emphasizing the important parameters for optimization of the TDS signal. We present phase space quasi-probability distributions, reconstructed from experimental data. We introduce a new state reconstruction technique for directly measuring elements of the density matrix for a wave packet evolving in an anharmonic potential. We establish a direct relationship between elements of the density matrix and the TDS of molecular fluorescence. Taking advantage of this relationship, we analyze three methods for direct density matrix reconstruction from measurements of the TDS. The initial state of our molecular sample is described by a large mixture of ro-vibrational levels. We consider the effects of molecular rotations and a mixed initial state. We develop simulations to explain the form of the TDS signals measured in the laboratory, and we find that tomographic state reconstruction provides measurements of vibrational quantum states which are relatively insensitive to large distributions of initial rotational levels. We have measured the TDS of the coherent component of the emission from a vibrational wave packet. We present a model for this emission which is in excellent agreement with the measured data. We examine the effects of both polarization and quantum interference on the coherent signal, and we discuss how this signal can be used for state reconstruction.

•Jan 1, 1999•0 citations

Tomography and its role in Quantum Computation

William J. Munro, Daniel F. V. James, Andrew G. White +1 more

Quantum computation depends on quantum entanglement, a correlation between subsystems that cannot occur classically. A variety of theoretical measures exist for quantifying the degree entanglement in such schemes, all of which are functions of the system density matrix. How can the entanglement be measured experimentally? Using quantum tomography techniques developed for two photon entangled states, the density matrix can be reconstructed from the appropriate experimental data. In this case the state tomography gives the complete characterization of the physical system (for the relevant degree of freedom, such as spin or polarization). It gives information on both the degree of nonclassical correlation, that is entanglement, as well as the amount of decoherence in the system. In this proceedings we discuss the general state tomography procedure required to characterize a few qubit quantum computer, for any architecture.

•Mar 21, 2001•3 citations

Threshold Quantum State Tomography

Diego Maragnano, Daniele Binosi, Giovanni Garberoglio +3 more

Quantum state tomography aims at reconstructing the state of a quantum system. The standard approach is based on a tomographically complete set of observables and a maximum likelihood estimation of the density matrix. However, the number of measurements scales exponentially with the number of qubits or qudits of the system. By leveraging some properties of any physical density matrix, we propose a method in which the number of necessary measurements depends on the state under investigation but without the need for any a priori information. In some cases, this can lead to a significant reduction of the resources necessary for state characterization.

International Conference on Transparent Optical Networks•Jul 2, 2023•2 citations

Experimental Determination of the Quantum-Mechanical State of a Molecular Vibrational Mode Using Fluorescence Tomography

Thomas J. Dunn, Ian A. Walmsley, Shaul Mukamel

We present a spectroscopic method for the complete characterization of the quantum state of the vibrational mode of a molecule in terms of a phase-space quasiprobability distribution. The distribution for a molecular vibrational mode excited by a short optical pulse is reconstructed from measurements of its time-dependent spectrum of fluorescence.

Physical Review Letters•Feb 6, 1995•324 citations

Qudit quantum-state tomography

Rob Thew, Kae Nemoto, Andrew G. White +1 more

Recently quantum tomography has been proposed as a fundamental tool for prototyping a few qubit quantum device. It allows the complete reconstruction of the state produced from a given input into the device. From this reconstructed density matrix, relevant quantum information quantities such as the degree of entanglement and entropy can be calculated. Generally, orthogonal measurements have been discussed for this tomographic reconstruction. In this paper, we extend the tomographic reconstruction technique to two new regimes. First, we show how nonorthogonal measurements allow the reconstruction of the state of the system provided the measurements span the Hilbert space. We then detail how quantum-state tomography can be performed for multiqudits with a specific example illustrating how to achieve this in one- and two-qutrit systems.

arXiv:quant-ph/0201052•Physical Review A•Jul 16, 2002•353 citations

Quantum state tomography of single photons in the spectral degree of freedom

Peter P. Rohde

Quantum State Tomography (QST) of optical states is typically performed in the photon number degree of freedom, a procedure which is well understood and has been experimentally demonstrated. However, optical states have other degrees of freedom than just photon number, such as the spatial and temporal/spectral ones. Full characterization of photonic states requires state reconstruction in these additional degrees of freedom. In this paper we present a technique for performing QST of single photon states in the spectral degree of freedom. This is of importance, for example, in quantum information processing applications, which typically impose strict requirements on the purity and distinguishability of independently produced single photons. The described technique allows for full reconstruction of the spectral density matrix, allowing the purity and distinguishability of different sources to be readily calculated.

arXiv:quant-ph/0609005•Sep 1, 2006•4 citations
Emission tomography provides a method for the characterization of quantum states of those degrees of freedom of material quantum systems that are coupled to electronic states of the system. In such systems, the time-dependent fluorescence spectrum contains complete information about the non-electronic degree of freedom. Phase-space or, in certain cases, density matrix representations of the state can be reconstructed from the spectrum using standard methods of computer-assisted tomography or linear algebra. The principles and implementation of this procedure are described in detail and applied to the specific example of the reconstruction of the quantum state of the vibrational mode of a diatomic molecule excited into a non-stationary wavepacket state.
Measuring the density operator of a quantum system provides complete state information. This thesis concerns quantum state measurement in diatomic molecules. We have developed techniques to reconstruct the density operator of a vibrational wave packet excited by an ultrafast laser pulse. These techniques can be used to reconstruct the quantum state of a wave packet without making any assumptions about the initial state of the molecule or the amplitude and phase of the excitation pulse. Molecular emission tomography measures a phase space quasi-probability distribution of a vibrational wave packet. We introduce tomographic state measurement, and we discuss the requirements for successful reconstruction of quantum states with complicated phase space distributions. Molecular tomographic state reconstruction relies on measurements of the time-dependent spectrum (TDS) of molecular fluorescence. Accurate state measurement requires quality TDS data. We describe the experimental implementation of molecular emission tomography, emphasizing the important parameters for optimization of the TDS signal. We present phase space quasi-probability distributions, reconstructed from experimental data. We introduce a new state reconstruction technique for directly measuring elements of the density matrix for a wave packet evolving in an anharmonic potential. We establish a direct relationship between elements of the density matrix and the TDS of molecular fluorescence. Taking advantage of this relationship, we analyze three methods for direct density matrix reconstruction from measurements of the TDS. The initial state of our molecular sample is described by a large mixture of ro-vibrational levels. We consider the effects of molecular rotations and a mixed initial state. We develop simulations to explain the form of the TDS signals measured in the laboratory, and we find that tomographic state reconstruction provides measurements of vibrational quantum states which are relatively insensitive to large distributions of initial rotational levels. We have measured the TDS of the coherent component of the emission from a vibrational wave packet. We present a model for this emission which is in excellent agreement with the measured data. We examine the effects of both polarization and quantum interference on the coherent signal, and we discuss how this signal can be used for state reconstruction.
Quantum computation depends on quantum entanglement, a correlation between subsystems that cannot occur classically. A variety of theoretical measures exist for quantifying the degree entanglement in such schemes, all of which are functions of the system density matrix. How can the entanglement be measured experimentally? Using quantum tomography techniques developed for two photon entangled states, the density matrix can be reconstructed from the appropriate experimental data. In this case the state tomography gives the complete characterization of the physical system (for the relevant degree of freedom, such as spin or polarization). It gives information on both the degree of nonclassical correlation, that is entanglement, as well as the amount of decoherence in the system. In this proceedings we discuss the general state tomography procedure required to characterize a few qubit quantum computer, for any architecture.
Quantum state tomography aims at reconstructing the state of a quantum system. The standard approach is based on a tomographically complete set of observables and a maximum likelihood estimation of the density matrix. However, the number of measurements scales exponentially with the number of qubits or qudits of the system. By leveraging some properties of any physical density matrix, we propose a method in which the number of necessary measurements depends on the state under investigation but without the need for any a priori information. In some cases, this can lead to a significant reduction of the resources necessary for state characterization.
Recently quantum tomography has been proposed as a fundamental tool for prototyping a few qubit quantum device. It allows the complete reconstruction of the state produced from a given input into the device. From this reconstructed density matrix, relevant quantum information quantities such as the degree of entanglement and entropy can be calculated. Generally, orthogonal measurements have been discussed for this tomographic reconstruction. In this paper, we extend the tomographic reconstruction technique to two new regimes. First, we show how nonorthogonal measurements allow the reconstruction of the state of the system provided the measurements span the Hilbert space. We then detail how quantum-state tomography can be performed for multiqudits with a specific example illustrating how to achieve this in one- and two-qutrit systems.
Quantum State Tomography (QST) of optical states is typically performed in the photon number degree of freedom, a procedure which is well understood and has been experimentally demonstrated. However, optical states have other degrees of freedom than just photon number, such as the spatial and temporal/spectral ones. Full characterization of photonic states requires state reconstruction in these additional degrees of freedom. In this paper we present a technique for performing QST of single photon states in the spectral degree of freedom. This is of importance, for example, in quantum information processing applications, which typically impose strict requirements on the purity and distinguishability of independently produced single photons. The described technique allows for full reconstruction of the spectral density matrix, allowing the purity and distinguishability of different sources to be readily calculated.