We explore an efficient method for preparing large samples of ultracold calcium atoms. An optimized conventional (Doppler-limited) magneto-optical trap collects atoms from a Zeeman cooled atomic beam using a strong dipole transition within the singlet system. This transition is not completely closed thus yielding an intense flux of atoms into the metastable triplet state
3P2. A second magneto-optical trap sharing the same magnetic-field gradient is superimposed which captures and further cools the metastables using the narrow-band infrared transition ${}^{3}{\stackrel{\ensuremath{\rightarrow}}{{P}_{2}}}^{3}{D}_{3}.$ In our present experiment we were able to prepare $3\ifmmode\times\else\texttimes\fi{}{10}^{8}$ atoms at temperatures below 20 microkelvin within 250 ms. Minor technical improvements of our setup promise to yield above
1010 atoms at submicrokelvin temperatures within 1 s.
We report the construction and characterization of an experimental setup for producing a cold gas of
40Ca atoms and excite them to high Rydberg states with a resonant three-photon-excitation scheme. The apparatus comprises four stages, each designed in-house. An oven heated to
∼500∘C generates an atomic beam that is collimated by a capillary stack. The beam is sent into a passive, permanent-magnet-based Zeeman slower that reduces the atomic velocity to
30 m/s. The slow atoms are captured in a magneto-optical trap (MOT) and cooled to
1.0(3) mK with a trapping time of
16(2) ms. Ground-state atoms in the cold gas are excited to high Rydberg states via resonant excitation through the intermediate
4s4p1P1 and
4s4d1D2 states. The MOT is operated at the center of an electrode stack, which serves to apply continuous and pulsed electric fields and field-ionize the Rydberg atoms for detection. We benchmark our MOT against previous implementations and find its performance consistent with state-of-the-art results in terms of temperature and trapping lifetime. Finally, we demonstrate Rydberg spectroscopy of calcium, confirming the system's suitability for ultracold Rydberg physics experiments.
We demonstrate an efficient scheme for continuous trap loading based upon spatially selective optical pumping. We discuss the case of
1S0 calcium atoms in an optical dipole trap (ODT), however, similar strategies should be applicable to a wide range of atomic species, which do not permit efficient conventional trap loading. Our starting point is a moderately cold $(\ensuremath{\approx}300\phantom{\rule{0.3em}{0ex}}\ensuremath{\mu}\mathrm{K})$ and dense $(\ensuremath{\approx}9\ifmmode\times\else\texttimes\fi{}{10}^{9}\phantom{\rule{0.3em}{0ex}}{\mathrm{cm}}^{\ensuremath{-}3})$ reservoir of metastable
3P2 atoms in a magneto-optic trap (triplet MOT). A focused
532nm laser beam produces a strongly elongated optical potential for
1S0 atoms with up to $350\phantom{\rule{0.3em}{0ex}}\ensuremath{\mu}\mathrm{K}$ well depth. A weak focused laser beam at
430nm, carefully superimposed upon the ODT beam, selectively pumps the
3P2 atoms inside the capture volume to the singlet state, where they are confined by the ODT. The triplet MOT perpetually refills the capture volume with
3P2 atoms, thus providing a continuous stream of cold atoms into the ODT at a rate of ${10}^{7}\phantom{\rule{0.3em}{0ex}}{\mathrm{s}}^{\ensuremath{-}1}$. Limited by evaporation loss, in
200ms we typically load $5\ifmmode\times\else\texttimes\fi{}{10}^{5}$ atoms with $3.5\ifmmode\times\else\texttimes\fi{}{10}^{10}\phantom{\rule{0.3em}{0ex}}{\mathrm{cm}}^{\ensuremath{-}3}$ peak density and axial and radial temperatures of 300 and $85\phantom{\rule{0.3em}{0ex}}\ensuremath{\mu}\mathrm{K}$, respectively. After terminating the loading we observe evaporation during
50ms, typically leaving us with
105 atoms with nearly equal radial and axial temperatures close to $40\phantom{\rule{0.3em}{0ex}}\ensuremath{\mu}\mathrm{K}$ and a peak density of $5\ifmmode\times\else\texttimes\fi{}{10}^{11}\phantom{\rule{0.3em}{0ex}}{\mathrm{cm}}^{\ensuremath{-}3}$. A simple model is presented, which identifies the relevant physical mechanisms of the loading and decay dynamics. We point out that a comparable scheme could be employed to load a dipole trap with
3P0 atoms.
We describe a new system for laser cooling and trapping of neutral Calcium atoms employing the ¹S0 -¹ P1 resonant transition at 423 nm. An on-axis magneto-optical trap (MOT) is loaded from a Zeeman decelerated atomic beam. When a single laser is used, in order to avoid perturbation of the trap by the deceleration laser beam, this one has been tightly focused near the MOT center, with a waist size much smaller than the atomic cloud. In order to test the efficiency of this novel technique, we have then employed a second, independent decelerating laser, with a profile mode matched to the atomic beam. For an oven temperature of 580±C this system can load 1.2 (2) x 10(7) atoms in 16 (1) ms. By the spatial extension of the atomic cloud the one dimension rms velocity was estimated to be 136 (12) cm/s, corresponding to a temperature of 9 (2) mK. The variation of the number of trapped atoms as a function of laser detuning and intensity, trap magnetic field gradient and oven temperature is analyzed. Spatial structures of the trapped atoms, like stable rings created by vortex forces, have been observed. This is the first time that these structures, already observed in alkali-metal elements, are reported in MOTs of alkaline-earth elements.
Metastable calcium atoms, produced in a magneto-optic trap (MOT) operating within the singlet system, are continuously loaded into a magnetic trap formed by the magnetic quadrupole field of the MOT. At MOT temperatures of 3 mK and 240 ms loading time, we observe $1.1\ifmmode\times\else\texttimes\fi{}{10}^{8}$ magnetically trapped
3P2 atoms at densities of $2.4\ifmmode\times\else\texttimes\fi{}{10}^{8}{\mathrm{cm}}^{\ensuremath{-}3}$ and temperatures of 0.61 mK. In a modified scheme, we first load a MOT for metastable atoms at a temperature of 0.18 mK and subsequently release these atoms into the magnetic trap. In this case, 240 ms of loading yields $2.4\ifmmode\times\else\texttimes\fi{}{10}^{8}$ trapped
3P2 atoms at a peak density of $8.7\ifmmode\times\else\texttimes\fi{}{10}^{10}{\mathrm{cm}}^{\ensuremath{-}3}$ and a temperature of 0.13 mK. The temperature decrease observed in the magnetic trap for both loading schemes can be explained only in part by trap size effects.
This thesis reports on the first steps towards an experimental setup capable of realizing an ultracold three-component Fermi gas in an optical lattice: the construction of an apparatus that captures and cools 6Li -atoms inside a magneto optical trap (MOT). The focus of this thesis was the implementation of the Zeeman slower, the laser system and hard- and software controlling the experiment. Since these provide the starting point for all future developments it was especially important to ensure that they do not limit future experiments. With a MOT loading rate of L ~ 3 x 108 atoms/second at an oven temperature of 350 °C it is possible to capture enough atoms for further experiments in about one second allowing fast cycle times of the experiment. The achieved background pressure in the vacuum chamber, essential for the next experimental steps, is excellent as indicated by the background gas collision limited MOT lifetime of τ ~ 23 minutes. The next step will be to implement a dipole trap to further cool the 6Li -atoms.