Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

AIP conference proceedings

Frequency and quality factor of NbTiN∕Au bilayer superconducting resonators

R. Barends, Werner Karl-Gustav Daalman, Akira Endo, S. Zhu, T. Zijlstra, T. M. Klapwijk, Betty Young, Blas Cabrera, Aaron Miller

Published Jan 1, 2009• 11 citations
Publisher

Abstract

We have measured the temperature dependence of the resonance frequency and quality factor of superconducting resonators made of a 300 nm thick NbTiN and 10 nm thick Au bilayer down to a temperature of 350 mK. At low temperatures we find a strong temperature dependence compared to bare NbTiN resonators: when increasing the temperature from 350 mK to 2 K the quality factor drops from a value of 105 down to 103 and the frequency decreases by about 1%. This while for bare NbTiN the quality factor remains on the order of 106 and the fractional frequency change remains below 10−4. These results indicate that the proximitised thin Au layer dominates the low temperature properties. Using the Usadel equations and Nam’s expression for the complex conductivity we can accurately describe the data assuming an interface transparency of 0.15.

DOI
10.1063/1.3292303

Related papers

Contribution of dielectrics to frequency and noise of NbTiN superconducting resonators

R. Barends, H. L. Hortensius, T. Zijlstra +4 more

We study NbTiN resonators by measurements of the temperature dependent resonance frequency and frequency noise. Additionally, resonators are studied covered with SiOx dielectric layers of various thicknesses. The resonance frequency develops a nonmonotonic temperature dependence with increasing SiOx layer thickness. The increase in the noise is independent of the SiOx thickness, demonstrating that the noise is not dominantly related to the low temperature resonance frequency deviations.

arXiv:0804.3499•Applied Physics Letters•Jun 2, 2008•108 citations

A Superconducting Resonator with a Hafnium Microbridge at Temperatures of 50–350 mK

Alexey V. Merenkov, S. V. Shitov, Vladimir I. Chichkov +3 more

A high-quality superconducting resonator with a microbridge of hafnium film for use in a circuit for readout a terahertz-band imaging array with frequency division multiplexing is demonstrated experimentally. The variability of the impedance of the bridge at a frequency of 1.5 GHz, which is a key factor in the control of the quality of the resonator, is studied. The bridge, having a thickness of about 50 nm, a critical temperature T C ≈ 380 mK, and a plan size of 2.5 × 2.5 μm, was connected as a load of a resonator made of niobium film with a thickness of about 100 nm ( T C ~ 9 K). It is shown that the bridge smoothly changes its impedance proportionally to the bias power in the entire temperature range. The effective thermal insulation of the bridge was measured in a dilution cryostat at temperatures of 50–300 mK. Thermal conductivity G of the bridge was calculated and found to be ~4 × 10 –13 W/K, which gives an estimate of the sensitivity of the structure in the bolometric mode NEP ≈ 8 × 10 –19 W/Hz 1/2 at a temperature of 150 mK.

Technical Physics Letters•Jul 1, 2018•8 citations

Anomalous Temperature Dependence of the Quality Factor in a Superconducting Coplanar Waveguide Resonator

Pin-Jia Zhou, Yiwen Wang, Lian-Fu Wei

We present the measurements of the temperature dependence of the internal quality factor ( Q i ) of a microwave resonator, well below the superconducting transition temperature. The device is a quarter-wavelength niobium ( T c = 9.2 K) coplanar waveguide resonator. The measured | S 21 | parameter shows typically the skewed Lorentzian distributions, from which the fitted quality factor monotonically decreases with the temperature increasing from 30 mK to 900 mK. It is observed that for the lower temperature range (i.e., at T < 700 mK) the temperature dependence of the fitted Q i deviates significantly from the predictions of the usual Mattis—Bardeen theory. The measured 3 dB internal quality factor Q ′ i also verifies such an anomalous temperature dependence. Physically, this phenomenon could be attributed dominantly to the effects of the two-level systems in the device, rather than the usual temperature-dependent complex conductance.

Chinese Physics Letters•Jun 1, 2014•2 citations

Noise in NbTiN, Al, and Ta Superconducting Resonators on Silicon and Sapphire Substrates

R. Barends, H. L. Hortensius, T. Zijlstra +4 more

We present measurements of the frequency noise and resonance frequency temperature dependence in planar superconducting resonators on both silicon and sapphire substrates. We show, by covering the resonators with sputtered SiOxlayers of different thicknesses, that the temperature dependence of the resonance frequency scales linearly with thickness, whereas the observed increase in noise is independent of thickness. The frequency noise decreases when increasing the width of the coplanar waveguide in NbTiN on hydrogen passivated silicon devices, most effectively by widening the gap. We find up to an order of magnitude more noise when using sapphire instead of silicon as substrate. The complete set of data points towards the noise being strongly affected by superconductor-dielectric interfaces.

IEEE Transactions on Applied Superconductivity•Jun 1, 2009•45 citations

Effects of the thin-film thickness on superconducting NbTi microwave resonators for on-chip cryogenic thermometry

André Chatel, Roberto Russo, Luca Mazzone +5 more

Abstract Superconducting microwave resonators have recently gained a primary importance in the development of cryogenic applications, such as circuit quantum electrodynamics, electron spin resonance spectroscopy and particles detection for high-energy physics and astrophysics. In this work, we investigate the influence of the film thickness on the temperature response of microfabricated Nb 50 Ti 50 superconducting resonators. S-shaped split ring resonators (S-SRRs), approximately 20 nm to 150 nm thick, are designed to be electromagnetically coupled with standard Cu coplanar waveguides (CPWs) and their microwave properties are characterised at temperatures below 10 K . The combined contributions of the kinetic inductance L K ( T ) increase and the decreasing loaded quality factor Q L , for thinner films, induce an optimum condition on the temperature sensitivity and resolution of the resonators. A noise equivalent temperature as low as ( 0.53 ± 0.09 ) μ K Hz − 1 / 2 , at 1 Hz , is reported for 100 nm thick resonators at 4.2 K . We also asses the possibility of implementing a multiplexed frequency readout, allowing for the simultaneous temperature tracking of several sensors along a single CPW. Such results demonstrate the possibility to perform a distributed cryogenic temperature monitoring, with a sub- μ K resolution. Thus, the application of superconducting S-SRRs, eventually benefiting from an even higher

arXiv:2503.20416•Superconductor Science and Technology•Dec 1, 2025•1 citation

Power and temperature dependent model for high Q superconductor resonators

Ashish Alexander, Christopher Weddle, Christopher J. K. Richardson

Measuring the internal quality factor of coplanar waveguide superconducting resonators is an established method of determining small losses in superconducting devices. Often, resonator losses are attributed to two-level system (TLS) defects using a power dependent model for the quality factor. However, excess non-equilibrium quasiparticles can also limit the quality factor of superconducting resonators. Here, a two-temperature, power and temperature dependent model is used to evaluate resonator losses for titanium nitride and aluminum coplanar waveguide resonators with loss tangents of 10−5–10−6. This model enables a set of parameters to describe both the internal quality factor and fractional frequency shift of the resonator across a broad range of average cavity photon numbers, from 1 to 106, and temperatures between those limited by the experimental apparatus near 50 mK and thermal quasiparticle dominated. The presented model also offers potential insight into observing the temperature and power dependence of TLS–TLS interactions in these resonators.

arXiv:2205.06291•APL Quantum•Jul 23, 2025•9 citations
We have measured the temperature dependence of the resonance frequency and quality factor of superconducting resonators made of a 300 nm thick NbTiN and 10 nm thick Au bilayer down to a temperature of 350 mK. At low temperatures we find a strong temperature dependence compared to bare NbTiN resonators: when increasing the temperature from 350 mK to 2 K the quality factor drops from a value of 105 down to 103 and the frequency decreases by about 1%. This while for bare NbTiN the quality factor remains on the order of 106 and the fractional frequency change remains below 10−4. These results indicate that the proximitised thin Au layer dominates the low temperature properties. Using the Usadel equations and Nam’s expression for the complex conductivity we can accurately describe the data assuming an interface transparency of 0.15.
A high-quality superconducting resonator with a microbridge of hafnium film for use in a circuit for readout a terahertz-band imaging array with frequency division multiplexing is demonstrated experimentally. The variability of the impedance of the bridge at a frequency of 1.5 GHz, which is a key factor in the control of the quality of the resonator, is studied. The bridge, having a thickness of about 50 nm, a critical temperature T C ≈ 380 mK, and a plan size of 2.5 × 2.5 μm, was connected as a load of a resonator made of niobium film with a thickness of about 100 nm ( T C ~ 9 K). It is shown that the bridge smoothly changes its impedance proportionally to the bias power in the entire temperature range. The effective thermal insulation of the bridge was measured in a dilution cryostat at temperatures of 50–300 mK. Thermal conductivity G of the bridge was calculated and found to be ~4 × 10 –13 W/K, which gives an estimate of the sensitivity of the structure in the bolometric mode NEP ≈ 8 × 10 –19 W/Hz 1/2 at a temperature of 150 mK.
We present the measurements of the temperature dependence of the internal quality factor ( Q i ) of a microwave resonator, well below the superconducting transition temperature. The device is a quarter-wavelength niobium ( T c = 9.2 K) coplanar waveguide resonator. The measured | S 21 | parameter shows typically the skewed Lorentzian distributions, from which the fitted quality factor monotonically decreases with the temperature increasing from 30 mK to 900 mK. It is observed that for the lower temperature range (i.e., at T < 700 mK) the temperature dependence of the fitted Q i deviates significantly from the predictions of the usual Mattis—Bardeen theory. The measured 3 dB internal quality factor Q ′ i also verifies such an anomalous temperature dependence. Physically, this phenomenon could be attributed dominantly to the effects of the two-level systems in the device, rather than the usual temperature-dependent complex conductance.
We present measurements of the frequency noise and resonance frequency temperature dependence in planar superconducting resonators on both silicon and sapphire substrates. We show, by covering the resonators with sputtered SiOxlayers of different thicknesses, that the temperature dependence of the resonance frequency scales linearly with thickness, whereas the observed increase in noise is independent of thickness. The frequency noise decreases when increasing the width of the coplanar waveguide in NbTiN on hydrogen passivated silicon devices, most effectively by widening the gap. We find up to an order of magnitude more noise when using sapphire instead of silicon as substrate. The complete set of data points towards the noise being strongly affected by superconductor-dielectric interfaces.
Abstract Superconducting microwave resonators have recently gained a primary importance in the development of cryogenic applications, such as circuit quantum electrodynamics, electron spin resonance spectroscopy and particles detection for high-energy physics and astrophysics. In this work, we investigate the influence of the film thickness on the temperature response of microfabricated Nb 50 Ti 50 superconducting resonators. S-shaped split ring resonators (S-SRRs), approximately 20 nm to 150 nm thick, are designed to be electromagnetically coupled with standard Cu coplanar waveguides (CPWs) and their microwave properties are characterised at temperatures below 10 K . The combined contributions of the kinetic inductance L K ( T ) increase and the decreasing loaded quality factor Q L , for thinner films, induce an optimum condition on the temperature sensitivity and resolution of the resonators. A noise equivalent temperature as low as ( 0.53 ± 0.09 ) μ K Hz − 1 / 2 , at 1 Hz , is reported for 100 nm thick resonators at 4.2 K . We also asses the possibility of implementing a multiplexed frequency readout, allowing for the simultaneous temperature tracking of several sensors along a single CPW. Such results demonstrate the possibility to perform a distributed cryogenic temperature monitoring, with a sub- μ K resolution. Thus, the application of superconducting S-SRRs, eventually benefiting from an even higher
Measuring the internal quality factor of coplanar waveguide superconducting resonators is an established method of determining small losses in superconducting devices. Often, resonator losses are attributed to two-level system (TLS) defects using a power dependent model for the quality factor. However, excess non-equilibrium quasiparticles can also limit the quality factor of superconducting resonators. Here, a two-temperature, power and temperature dependent model is used to evaluate resonator losses for titanium nitride and aluminum coplanar waveguide resonators with loss tangents of 10−5–10−6. This model enables a set of parameters to describe both the internal quality factor and fractional frequency shift of the resonator across a broad range of average cavity photon numbers, from 1 to 106, and temperatures between those limited by the experimental apparatus near 50 mK and thermal quasiparticle dominated. The presented model also offers potential insight into observing the temperature and power dependence of TLS–TLS interactions in these resonators.