We reexamine mass flow in a superfluid gyroscope containing a superfluid Josephson weak link. We introduce a frequency-dependent hydrodynamic inductance to account for an oscillatory flow of the normal fluid component in the sensing loop. With this hydrodynamic inductance, we derive the thermal phase noise, and hence the thermal rotational noise of the gyroscope. We examine the thermodynamic stability of the system based on an analysis of the free energy. We derive a quantum phase noise, which is analogous to the zero-point motion of a simple harmonic oscillator. The configuration of the studied gyroscope is analogous to a conventional superconducting RF SQUID. We show that the gyroscope has very low intrinsic noise $(1.9\ifmmode\times\else\texttimes\fi{}{10}^{\ensuremath{-}13}\phantom{\rule{0.3em}{0ex}}\mathrm{rad}\phantom{\rule{0.2em}{0ex}}{\mathrm{s}}^{\ensuremath{-}1}∕\sqrt{\mathrm{Hz}})$, and it can potentially be applied to study general relativity, Earth science, and to improve global positioning systems (GPS).
We reexamine mass flow in a superfluid gyroscope containing a superfluid Josephson weak link. We introduce a frequency-dependent hydrodynamic inductance to account for an oscillatory flow of the normal fluid component in the sensing loop. With this hydrodynamic inductance, we derive the thermal phase noise, and hence the thermal rotational noise of the gyroscope. We examine the thermodynamic stability of the system based on an analysis of the free energy. We derive a quantum phase noise, which is analogous to the zero-point motion of a simple harmonic oscillator. The configuration of the studied gyroscope is analogous to a conventional superconducting RF SQUID. We show that the gyroscope has very low intrinsic noise (1.9\ifmmode×\else\texttimes\fi10\ensuremath−13rads\ensuremath−1∕Hz), and it can potentially be applied to study general relativity, Earth science, and to improve global positioning systems (GPS).
Thermal noise is closely related with steady state and resolution of superfluid gyroscope.In this paper,the thermal noise model of superfluid gyroscope was established by using the standard deviation of superfluid's phase difference across the weak link.Based on this model,the impacts of thermal noise on Josephson oscillation effect and gyroscope's resolution were analysed,and the ways to suppress the thermal noise were studied.Simulation results show that,by increasing the number of aperture to thousands and setting the temperature and aperture's diameter to 2.169 K and 70 nm respectively,the thermal noise can be suppressed to the order of 10-9 rad/(s?Hz1/2),then the gyroscope has the ability to detect very small angular velocity.
The electrical equations of a resonant circuit fed with a radio-frequency current and inductively coupled to a weakly superconducting loop have been derived. The current-voltage characteristic of the rf superconducting quantum interference device can then be calculated and studied as a function of the junction resistance or of the resonance frequency, enabling its behavior to be better understood. As shown by Kurkijärvi, the large positive slope of the steps and the rounding of the characteristic result from thermal noise. However, in order to explain quantitatively the experimental results concerning, namely, point contact weak links which are generally oxidized or which have several contact points, it is useful to remark that the connection between the two superconductors constituting the Josephson junction may be made from n resistive paths. The mean thermal energy of the fluctuating flux is then close to nkbT instead of kbT if the inductances linking the contact points are large enough, that is, on the order of 10−11 H.
Properties of white noise of a high-Tc dc superconducting quantum interference device (SQUID) have been studied using numerical simulation. It is shown that thermal noise at T=77 K significantly affects the noise properties of the SQUID. As a result, dependencies of noise properties on inductance become quite different from conventional results at T=4.2 K. In contrast to the case T=4.2 K, the voltage noise of the SQUID at T=77 K depends very weakly on the inductance, while the transfer function degrades rapidly with inductance. Consequently, rapid degradation of flux noise with inductance, as compared with the case T=4.2 K, is caused mainly by that of the transfer function. These simulation results explain reasonably experimental results reported recently. Therefore, it is necessary to improve the transfer function for the improvement of noise properties in the case of large inductances. Numerical simulation shows that a method for improving the transfer function using resistively shunted inductance or three Josephson junctions, which was proposed by the authors, is also useful for improving noise properties in the case of large inductances.
The gyroscopic motion of a trapped Bose gas containing a vortex is studied. We model the system as a classical top, as a superposition of coherent hydrodynamic states, by solution of the Bogoliubov equations, and by integration of the time-dependent Gross–Pitaevskii equation. The frequency spectrum of Bogoliubov excitations, including quantum frequency shifts, is calculated and the quantal precession frequency is found to be consistent with experimental results, although a small discrepancy does exist. The superfluid precession is found to be well described by the classical and hydrodynamic models. However, the frequency shifts and helical oscillations associated with vortex bending and twisting require a quantal treatment. In gyroscopic precession, the Kelvin modes m = ±1 are the dominant features giving a vortex kink or bend, while the m = +2 mode is found to be the dominant Kelvin wave associated with vortex twisting.
We measured the amplitude–frequency characteristics of radio frequency superconducting quantum interference devices (rf SQUIDs) over a temperature range between 65 and 79 K. Using the expressions derived from the recently developed rf SQUID theory, valid also at large thermal fluctuations, we determined from these data the basic parameters of high-transition-temperature superconductor (HTS) rf SQUIDs. These parameters were: (a) the high-frequency coupling coefficient between the rf SQUID and the tank circuit resonator, k, (b) the SQUIDs hysteretic parameter, β, (c) the critical current of the Josephson junction, Ic, (d) its normal resistance, Rn, and (e) its noise parameter, Γ. We found a good agreement with the values of β(Ic) and Rn determined directly after destructively opening the SQUID loop. In accordance with the theoretical predictions, our experimental results show that at large thermal fluctuation levels (T≅77 K), rf SQUIDs with large loop inductance operate in nonhysteretic mode up to β values exceeding 3. Furthermore, we have shown that the optimal energy sensitivity is attained in the nonhysteretic mode at a value of β distinctly higher than 1. A quantitative comparison of white noise predicted by the theory with that obtained from the experiment showed a reasonable agreement. We also discussed the contribution of the phase information to the SQUID’s signal and noise at optimum operation conditions, when a mixer was used as a signal detector.
A technique for the analysis of complex superconducting circuits containing one or more current biased inductively coupled Josephson junction interferometers is described. The equations of motion for the system are shown to separate into a set of non-linear junction equations relating the voltage drops across the junctions to the currents passing through the junctions, and a set of linear equations expressing the quantization of the fluxoid around the superconducting loops and the corresponding linear circuit equations for the normal loops. In many cases, the linear equations can be integrated, resulting in an effective elimination of the normal circuit loops from the problem. The circuit is thus reduced to that of an equivalent set of coupled SQUIDs whose device parameters are a function of the original circuit parameters and the inductive coupling strengths. The dc SQUID tuned linear amplifier is analyzed to display the method. As a result of this analysis, the optimal noise temperature of a tuned SQUID amplifier is derived as a function of the current and voltage noise spectral densities, Svand Sj, and forward transfer function, Vφ. The results obtained demonstrate that the behavior of the SQUID cannot be isolated from that of the rest of the circuit in the manner assumed in previous analyses. The existence of a quantum noise limit on the noise temperature of any phase preserving linear amplifier is used to infer that the noise figures must satisfy the constraint[(S_{v}/2LV_{\phi}^{2})(LS_{j}/2)-S_{vj}^{2}]^{1/2}>\hbarThe behavior of several simple circuits containing a pair of inductively coupled current biased interferometers is discussed to display the extension of the method to circuits containing more than one interferometer.