Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Symposium on Frequency Standards and Metrology

COMPACT MICROWAVE FREQUENCY REFERENCE BASED ON COHERENT POPULATION TRAPPING

John E. Kitching, H. G. Robinson, Leo W. Hollberg, Svenja A. Knappe, R. Wynands

Published May 1, 2002• 8 citations
Publisher

Abstract

A simple, compact and low-power microwave frequency reference based on CPT resonances in Cs vapor is described. The 14 cm 3 physics package exhibits a resonance width of 620 Hz at 4.6 GHz, a short-term fractional frequency instability of , and dissipates less than 30 mW, not including temperature control. We discuss the prospects for extreme miniaturization to sub-millimeter dimensions.

DOI
10.1142/9789812777713_0020

Related papers

Microwave frequency reference based on VCSEL-driven dark-line resonances in Cs vapor

John E. Kitching, N. Vukičević, Leo W. Hollberg +3 more

Dark-line resonances in Cs vapor are studied for potential use in a compact, low-power microwave frequency reference. The resonance is excited using light from a VCSEL and detected using the change in DC absorption, resulting in an extremely simple physics package with very high tolerance to misalignment and potentially low acceleration sensitivity. We anticipate engineering the package developed into a device with a volume less than 1 cm/spl times/1 cm/spl times/2 cm and a power dissipation of much less than 100 mW, depending on the thermal environment.

Joint Conference of the European Frequency and Time Forum and IEEE International Frequency Control Symposium (EFTF/IFCS)•Nov 7, 2002•82 citations

Characterization of coherent population-trapping resonances as atomic frequency references

Svenja A. Knappe, R. Wynands, John E. Kitching +2 more

A low-cost, potentially compact and robust microwave frequency reference can be constructed by use of vertical-cavity surface-emitting lasers and coherent population-trapping resonances in Cs vapor cells. Fractional frequency instabilities of 2×10-11/τ/s have been achieved with a minimum of 7×10-13 at τ=1000 s. The performance of this device as a function of external parameters such as light intensity, optical detuning, and cell temperature is discussed. The dependence of the dark-line resonance signal on these parameters can be understood largely by means of a simple, three-level model. The short-term stability depends critically on the optical detuning, whereas the long-term stability is limited currently by line shifts due to drifts in cell temperature.

Journal of the Optical Society of America B•Nov 1, 2001•151 citations

CPT atomic clock based on rubidium 85

C. Schori, G. Mileti, B. Leuenbeger +1 more

We present a compact physics package based on coherent population trapping (CPT) in rubidium 85. The architecture of the package is described along with results obtained using optical- and microwave spectroscopy. We also report the stability of the CPT resonance to variations in operating parameters such as microwave modulation power and vapour cell temperature. With this package we obtain a short term frequency stability σy(τ) = 7·10-11·τ-1/2(τy(τ) ~ 1·10-11( 100 sec4sec).

European Frequency and Time Forum•Apr 1, 2010•12 citations

Compact atomic clock based on coherent populationtrapping

J. Kitching, Leo W. Hollberg, S. Knappe +1 more

A simple, compact, low-power physics package for a vapour-cell atomic clock is described. The device measures 6.6 × 1.6 × 1.3 cm and dissipates less than 30 mW of electrical power without thermal control. The instability is 1.3 × 10-10/√[τ/(s)] for integration times τ below 100 s. Applications for this device include distributed telecommunications systems, advanced global positioning system (GPS) receivers and laboratory instrumentation.

Electronics Letters•Nov 22, 2001•57 citations

A frequency reference based in VCSEL-driven dark line resonances in Cs vapor

John E. Kitching, N. Vukičević, Weidermann +5 more

Summary form only given. We report on recent experiments to use dark line coherent population trapping (CPT) resonances in cesium vapor as the basis for a compact frequency reference. The resonance is excited by directly modulating the injection current of a VCSEL at one-half the ground state hyperfine transition of Cs (4.6 GHz) to produce RF sidebands on the optical carrier. The laser output is then passed through a room-temperature cell containing Cs at its vapor pressure together with 8.7 kPa of Neon buffer gas and the transmitted optical power is detected in a photodiode. When the laser carrier is tuned half way between the two hyperfine components of the D/sub 2/ line at 852 nm, and the RF modulation frequency is adjusted to be equal to one-half the hyperfine splitting, the absorption of the sidebands through the cell is slightly reduced due to the CPT effect. As the RF frequency is scanned over the resonance, lock-in detection is used to produce a /spl sim/1 kHz wide dispersive error signal which is in turn used to stabilize the modulation frequency. The narrow signal is the result of the buffer gas, which reduces the time-of-flight broadening of the transition.

Quantum Electronics and Laser Science Conference•Jan 1, 2000•1 citation

Microwave phase detection of coherent population trapping resonance in a Cs vapor cell

Michael Petersen, Moustafa Abdel Hafiz, Emeric de Clercq +1 more

We report a phase-sensitive microwave detection setup for spectroscopy of coherent population trapping (CPT) resonance in a Cs vapor cell. In this scheme, the optically carried microwave interrogation signal that interacts with atoms is detected by a fast photodiode at the cell output and is then mixed with the local oscillator microwave signal itself. This detection scheme produces at the output of the microwave mixer a dispersive CPT signal that can be directly used for correction of the local oscillator frequency onto the atomic resonance. The evolution of the dispersive CPT resonance signal with the laser power is briefly reported. With this detection scheme, we demonstrate the operation of a CPT atomic clock with a short-term fractional frequency stability of 1 × 10 − 11 at 1 s, which is in good agreement with the slope of the frequency discriminator and the residual microwave phase noise of the setup.

Journal of the Optical Society of America B•Feb 3, 2022•3 citations
A simple, compact and low-power microwave frequency reference based on CPT resonances in Cs vapor is described. The 14 cm 3 physics package exhibits a resonance width of 620 Hz at 4.6 GHz, a short-term fractional frequency instability of , and dissipates less than 30 mW, not including temperature control. We discuss the prospects for extreme miniaturization to sub-millimeter dimensions.
Dark-line resonances in Cs vapor are studied for potential use in a compact, low-power microwave frequency reference. The resonance is excited using light from a VCSEL and detected using the change in DC absorption, resulting in an extremely simple physics package with very high tolerance to misalignment and potentially low acceleration sensitivity. We anticipate engineering the package developed into a device with a volume less than 1 cm/spl times/1 cm/spl times/2 cm and a power dissipation of much less than 100 mW, depending on the thermal environment.
A low-cost, potentially compact and robust microwave frequency reference can be constructed by use of vertical-cavity surface-emitting lasers and coherent population-trapping resonances in Cs vapor cells. Fractional frequency instabilities of 2×10-11/τ/s have been achieved with a minimum of 7×10-13 at τ=1000 s. The performance of this device as a function of external parameters such as light intensity, optical detuning, and cell temperature is discussed. The dependence of the dark-line resonance signal on these parameters can be understood largely by means of a simple, three-level model. The short-term stability depends critically on the optical detuning, whereas the long-term stability is limited currently by line shifts due to drifts in cell temperature.
Summary form only given. We report on recent experiments to use dark line coherent population trapping (CPT) resonances in cesium vapor as the basis for a compact frequency reference. The resonance is excited by directly modulating the injection current of a VCSEL at one-half the ground state hyperfine transition of Cs (4.6 GHz) to produce RF sidebands on the optical carrier. The laser output is then passed through a room-temperature cell containing Cs at its vapor pressure together with 8.7 kPa of Neon buffer gas and the transmitted optical power is detected in a photodiode. When the laser carrier is tuned half way between the two hyperfine components of the D/sub 2/ line at 852 nm, and the RF modulation frequency is adjusted to be equal to one-half the hyperfine splitting, the absorption of the sidebands through the cell is slightly reduced due to the CPT effect. As the RF frequency is scanned over the resonance, lock-in detection is used to produce a /spl sim/1 kHz wide dispersive error signal which is in turn used to stabilize the modulation frequency. The narrow signal is the result of the buffer gas, which reduces the time-of-flight broadening of the transition.
We report a phase-sensitive microwave detection setup for spectroscopy of coherent population trapping (CPT) resonance in a Cs vapor cell. In this scheme, the optically carried microwave interrogation signal that interacts with atoms is detected by a fast photodiode at the cell output and is then mixed with the local oscillator microwave signal itself. This detection scheme produces at the output of the microwave mixer a dispersive CPT signal that can be directly used for correction of the local oscillator frequency onto the atomic resonance. The evolution of the dispersive CPT resonance signal with the laser power is briefly reported. With this detection scheme, we demonstrate the operation of a CPT atomic clock with a short-term fractional frequency stability of 1 × 10 − 11 at 1 s, which is in good agreement with the slope of the frequency discriminator and the residual microwave phase noise of the setup.