Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Physics A

Production of a highly polarized sodium atomic beam

Dieter Hils, Wolfgang Jitschin, Hans Kleinpoppen

Published May 1, 1981• 46 citations
Publisher
DOI
10.1007/bf00935390

Related papers

The production of a highly polarized atomic cesium beam

Richard N. Watts, Carl Wieman

Optics Communications•Feb 1, 1986•26 citations

Cooling and polarization of a sodium atomic beam by a two mode laser

H. Nölle, A. Horn, Jana Hüve +5 more

Zeitschrift für Physik D Atoms Molecules and Clusters•Jun 1, 1994•1 citation

Efficiency of optical pumping of an atomic-sodium beam by linearly polarized radiation

I. V. Zhurkin, L. Yu. Khryaschev

Optics and Spectroscopy•Aug 1, 1992•0 citations

Effect of experimental parameters on resonance fluorescence of a polarized atomic-sodium beam

I. V. Zhurkin, L. Yu. Khryashchev

Optics and Spectroscopy•Jan 1, 1992•0 citations

Spin-polarizing cold sodium atoms in a strong magnetic field

K. M. R. van der Stam, Anke Kuijk, R. Meppelink +2 more

The efficiency of evaporative cooling, which is used for the creation of a Bose-Einstein condensate, depends strongly on the number of particles at the start of the evaporation. A high efficiency can be reached by filling the magneto-optical trap with a large number of atoms and subsequently transferring these atoms to the magnetic trap as efficiently as possible. In our case (for sodium) this efficiency is limited to $1∕3$, because the magnetic substates of the $F=1$ state, which is used in the trapping process, are equally populated. This limit can be overcome by spin-polarizing the sample before the transfer. For sodium atoms, however, the improvement is very small when it is done in a small magnetic field due to the large number of optical transitions in combination with the high optical density. In this paper, we describe spin-polarizing sodium atoms in a high magnetic field. The transfer efficiency is increased by a factor of 2. The high magnetic field makes the process also more robust against variations in the magnetic field, the laser frequency, and the polarization of the laser beam.

arXiv:physics/0603255•Physical Review A•Jun 28, 2006•12 citations

Resonance fluorescence line polarization studies of laser excited sodium transitions

Xian-Kun Meng

The resonant excitation of the sodium D2 transition by laser radiation was investigated experimentally in this thesis. Line polarization measurement of the resonance fluorescence was employed to investigate the excitation process. The sodium atoms, which were collimated in a very narrow beam, were excited by a monochromatic laser beam with the frequency tuned to resonance with the 32S 112(F=2) - 32P312 hyperfine transition. The direction of the laser beam was perpendicular to the atomic beam and the fluorescence photons were detected along a direction perpendicular to both the laser and atomic beams. The experimental measurements were performed to determine the effect due to the variation of the laser intensity and frequency on the line polarization. A theoretical expression of the line polarization as a function of density matrix elements of the upper excited hyperfine sub -states was derived. A full quantum electrodynamic theory was used to derive an atomic operator equation of motion which was needed to calculate atomic operator elements. These elements then yielded the corresponding density matrix elements. The experimental results and the theoretical modelling were in a good agreement. The first experimental results for the line polarization of the highly excited states, 42D512 and 42D312, are also presented. The use of two lasers enabled these highly excited states to be excited. The line polarization of the fluorescence for transitions from the 4D level down to lower states is derived in terms of the density matrix elements of the upper excited states. Two limiting cases for the theoretical predictions of the line polarization are considered.

•Jan 1, 1991•0 citations
The efficiency of evaporative cooling, which is used for the creation of a Bose-Einstein condensate, depends strongly on the number of particles at the start of the evaporation. A high efficiency can be reached by filling the magneto-optical trap with a large number of atoms and subsequently transferring these atoms to the magnetic trap as efficiently as possible. In our case (for sodium) this efficiency is limited to 1∕31∕31∕3, because the magnetic substates of the F=1F=1F=1 state, which is used in the trapping process, are equally populated. This limit can be overcome by spin-polarizing the sample before the transfer. For sodium atoms, however, the improvement is very small when it is done in a small magnetic field due to the large number of optical transitions in combination with the high optical density. In this paper, we describe spin-polarizing sodium atoms in a high magnetic field. The transfer efficiency is increased by a factor of 2. The high magnetic field makes the process also more robust against variations in the magnetic field, the laser frequency, and the polarization of the laser beam.
The resonant excitation of the sodium D2 transition by laser radiation was investigated experimentally in this thesis. Line polarization measurement of the resonance fluorescence was employed to investigate the excitation process. The sodium atoms, which were collimated in a very narrow beam, were excited by a monochromatic laser beam with the frequency tuned to resonance with the 32S 112(F=2) - 32P312 hyperfine transition. The direction of the laser beam was perpendicular to the atomic beam and the fluorescence photons were detected along a direction perpendicular to both the laser and atomic beams. The experimental measurements were performed to determine the effect due to the variation of the laser intensity and frequency on the line polarization. A theoretical expression of the line polarization as a function of density matrix elements of the upper excited hyperfine sub -states was derived. A full quantum electrodynamic theory was used to derive an atomic operator equation of motion which was needed to calculate atomic operator elements. These elements then yielded the corresponding density matrix elements. The experimental results and the theoretical modelling were in a good agreement. The first experimental results for the line polarization of the highly excited states, 42D512 and 42D312, are also presented. The use of two lasers enabled these highly excited states to be excited. The line polarization of the fluorescence for transitions from the 4D level down to lower states is derived in terms of the density matrix elements of the upper excited states. Two limiting cases for the theoretical predictions of the line polarization are considered.