Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Physics Letters

Laser frequency offset locking using electromagnetically induced transparency

S. C. Bell, D. Heywood, J. D. White, J. D. Close, Robert E Scholten

Published Apr 23, 2007• 63 citations
Publisher

Abstract

The authors have used an electromagnetically induced transparency resonance in rubidium as a dispersive reference to lock the relative frequency of two lasers to the atomic ground-state hyperfine splitting. The beat frequency between the two lasers directly generates a microwave signal at 3.036GHz (Rb85) or 6.835GHz (Rb87). High bandwidth (600kHz) feedback was achieved with only low-frequency (10MHz) electronics using the frequency modulation sideband method. The spectral width of the microwave beat frequency was reduced to less than 1kHz. The technique offers a convenient and low-cost method suitable for many topical two-frequency experiments, including coherent population trapping, slow light, lasing without inversion, and Raman sideband cooling.

DOI
10.1063/1.2734471

Related papers

Laser frequency stabilizations using electromagnetically induced transparency

Han Seb Moon, Lim Lee, Kyoung-Dae Kim +1 more

We present two techniques to lock a laser frequency on an atomic transition line by using an electromagnetically induced transparency (EIT) signals, which give optical and electric feedback. We employed these methods to the D2 line of Rb87 atoms. Spectral characteristics of subnatural linewidth EIT allow us to improve frequency stability. By optical feedback of EIT signals, we were able to obtain locking bandwidths of 12 MHz, while frequency stability was 5×10−13 at best after 100 s of integration using a frequency modulation technique.

Applied Physics Letters•Apr 12, 2004•48 citations

A tunable dual-frequency rubidium Faraday laser

Xiaomin Qin, Zijie Liu, Zhiyang Wang +7 more

Dual-frequency (DF) lasers with specific frequency intervals have crucial applications in geometric measurement, optical microwave generation, quantum precision measurement, etc. Here, we report a 780 nm DF rubidium Faraday laser, with two modes’ frequencies corresponding to the 85 Rb and 87 Rb D 2 transitions. The microwave signal generated from the two laser modes’ beat has a linewidth of 671 Hz and is tunable from 4.7–4.95 GHz to 5.94–6.7 GHz by adjusting the diode current. Moreover, we use modulation transfer spectroscopy to lock one of the laser modes to the 87 Rb hyperfine transition, and the frequency stability improves nearly an order of magnitude. The noise characteristics are also measured, where the phase noise is suppressed over 25 dB at 100 Hz offset compared to the microwave signal generated by two single-mode lasers’ heterodyne beat. This 780 nm DF rubidium Faraday laser has two coherent modes with frequencies related to Rb transitions, which provides a promising and convenient method for compact atomic physics applications, such as coherent population trapping clocks, atom gravimeters, and so on.

Optics & Laser Technology•Jun 26, 2025•4 citations

High precision 6.8GHz phase locking of coherent laser beams for optical lattice experiment

Xun Ding, Linlin Sang, Chen Zhang +2 more

With the optical phase lock loop (OPLL) we made, we can achieve phase locking at frequency differences ranging from 0.5GHz to 7.5 GHz. This OPLL is fully applicable in atomic physics experiments, mostly in coherent lasers frequency locking. Two kinds of modulation modes were brought to ensure the frequency range and precision: the fast feedback current as the injection current and the slow feedback current to adjust the piezo-electric transducer. This device has been put into an optical lattice platform to lock a laser used for cooling and trapping atoms. The beat signal has a -3dB band width of 1Hz at 6.834GHz, corresponding to the hyperfine splitting of the ground state 87Rb atom.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Dec 31, 2013•2 citations

Passive atomic frequency standard based on coherent population trapping in ^87Rb using injection-locked lasers

Han Seb Moon, Sang Eon Park, Young‐Ho Park +2 more

We present a microwave frequency standard based on coherent population trapping (CPT) in the 87Rb D1 line. The CPT spectrum is obtained using two Raman lasers with a 6.8 GHz frequency offset by injection locking of a master laser to a slave laser. We have constructed an atomic clock employing a 5 cm long Rb vapor cell confined with 6.67 kPa neon buffer gas at 70 °C. Using this system, we improve the CPT contrast through the elimination of undesired off-resonant fields created by the direct modulation method. We measured the frequency shift of the CPT signal as a function of the temperature of the Rb cell and estimated it to be approximately 1.3 ×10−9/K. The frequency of a 10 MHz crystal oscillator has been stabilized to the CPT spectrum between the two ground states in 87Rb. The relative frequency stability is approximately 2.3×10−12 for an average time of 68 s.

Journal of the Optical Society of America B•Nov 1, 2006•23 citations

Advances in chip-scale atomic frequency references at NIST

Svenja A. Knappe, Vishal Shah, Alan S. Brannon +5 more

Coherent population trapping (CPT) resonances usually exhibit contrasts below 10% when interrogated with frequency modulated lasers. We discuss a relatively simple way to increase the resonance contrast to nearly 100% generating an additional light field through a nonlinear four-wave mixing interaction in the atomic vapor.1 A similar method can also be used to create a beat signal at the CPT resonance frequency that can injection-lock a low-power microwave oscillator at 3.4 GHz directly to the atomic resonance.2 This could lead to chip-scale atomic clocks (CSACs) with improved performance. Furthermore, we introduce a miniature microfabricated saturated absorption spectrometer3 that produces a signal for locking a laser frequency to optical transitions in alkali atoms. The Rb absorption spectra are comparable to signals obtained with standard table-top setups, although the rubidium vapor cell has an interior volume of only 1 mm3 and the volume of the entire spectrometer is around 0.1 cm3.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Aug 29, 2007•9 citations

Generation of frequency correlated laser beams via optical means

Prem Kumar, Seng‐Tiong Ho

Generation of frequency correlated laser beams is of importance in various applications, in particular, for extending the frequency of the laser Raman microwave clock1 into the millimeter region where acoustooptic methods are not available. We propose and demonstrate an all-optical technique for such a purpose. The technique is based on the recently observed Raman-shifted oscillation2 that occurs when a three-level atomic system of Λ type is optically pumped and placed in a ring cavity. Our initial experiments are performed in sodium vapor pumped by a cw ring dye laser. Raman-shifted oscillation, detuned from the pump laser by 1.772 GHz which is the ground state hyperfine splitting of sodium, occurs in the wings of the Doppler broadened D1 line. This Raman-shifted oscillation is demonstrated to be highly frequency correlated with the pumping laser when the two are heterodyned on a fast photodetector. In our experiments the heterodyne beat signal at 1.772 GHz had a linewidth as low as 17 kHz, whereas the pumping laser has a rms frequency fluctuation of 300 kHz. The beat signal stays narrowband when the pumping laser is unlocked from the reference cavity increasing its rms frequency fluctation to ~10MHz.

Annual Meeting Optical Society of America•Jan 1, 1985•0 citations
The authors have used an electromagnetically induced transparency resonance in rubidium as a dispersive reference to lock the relative frequency of two lasers to the atomic ground-state hyperfine splitting. The beat frequency between the two lasers directly generates a microwave signal at 3.036GHz (Rb85) or 6.835GHz (Rb87). High bandwidth (600kHz) feedback was achieved with only low-frequency (10MHz) electronics using the frequency modulation sideband method. The spectral width of the microwave beat frequency was reduced to less than 1kHz. The technique offers a convenient and low-cost method suitable for many topical two-frequency experiments, including coherent population trapping, slow light, lasing without inversion, and Raman sideband cooling.
We present two techniques to lock a laser frequency on an atomic transition line by using an electromagnetically induced transparency (EIT) signals, which give optical and electric feedback. We employed these methods to the D2 line of Rb87 atoms. Spectral characteristics of subnatural linewidth EIT allow us to improve frequency stability. By optical feedback of EIT signals, we were able to obtain locking bandwidths of 12 MHz, while frequency stability was 5×10−13 at best after 100 s of integration using a frequency modulation technique.
Dual-frequency (DF) lasers with specific frequency intervals have crucial applications in geometric measurement, optical microwave generation, quantum precision measurement, etc. Here, we report a 780 nm DF rubidium Faraday laser, with two modes’ frequencies corresponding to the 85 Rb and 87 Rb D 2 transitions. The microwave signal generated from the two laser modes’ beat has a linewidth of 671 Hz and is tunable from 4.7–4.95 GHz to 5.94–6.7 GHz by adjusting the diode current. Moreover, we use modulation transfer spectroscopy to lock one of the laser modes to the 87 Rb hyperfine transition, and the frequency stability improves nearly an order of magnitude. The noise characteristics are also measured, where the phase noise is suppressed over 25 dB at 100 Hz offset compared to the microwave signal generated by two single-mode lasers’ heterodyne beat. This 780 nm DF rubidium Faraday laser has two coherent modes with frequencies related to Rb transitions, which provides a promising and convenient method for compact atomic physics applications, such as coherent population trapping clocks, atom gravimeters, and so on.
With the optical phase lock loop (OPLL) we made, we can achieve phase locking at frequency differences ranging from 0.5GHz to 7.5 GHz. This OPLL is fully applicable in atomic physics experiments, mostly in coherent lasers frequency locking. Two kinds of modulation modes were brought to ensure the frequency range and precision: the fast feedback current as the injection current and the slow feedback current to adjust the piezo-electric transducer. This device has been put into an optical lattice platform to lock a laser used for cooling and trapping atoms. The beat signal has a -3dB band width of 1Hz at 6.834GHz, corresponding to the hyperfine splitting of the ground state 87Rb atom.
We present a microwave frequency standard based on coherent population trapping (CPT) in the 87Rb D1 line. The CPT spectrum is obtained using two Raman lasers with a 6.8 GHz frequency offset by injection locking of a master laser to a slave laser. We have constructed an atomic clock employing a 5 cm long Rb vapor cell confined with 6.67 kPa neon buffer gas at 70 °C. Using this system, we improve the CPT contrast through the elimination of undesired off-resonant fields created by the direct modulation method. We measured the frequency shift of the CPT signal as a function of the temperature of the Rb cell and estimated it to be approximately 1.3 ×10−9/K. The frequency of a 10 MHz crystal oscillator has been stabilized to the CPT spectrum between the two ground states in 87Rb. The relative frequency stability is approximately 2.3×10−12 for an average time of 68 s.
Coherent population trapping (CPT) resonances usually exhibit contrasts below 10% when interrogated with frequency modulated lasers. We discuss a relatively simple way to increase the resonance contrast to nearly 100% generating an additional light field through a nonlinear four-wave mixing interaction in the atomic vapor.1 A similar method can also be used to create a beat signal at the CPT resonance frequency that can injection-lock a low-power microwave oscillator at 3.4 GHz directly to the atomic resonance.2 This could lead to chip-scale atomic clocks (CSACs) with improved performance. Furthermore, we introduce a miniature microfabricated saturated absorption spectrometer3 that produces a signal for locking a laser frequency to optical transitions in alkali atoms. The Rb absorption spectra are comparable to signals obtained with standard table-top setups, although the rubidium vapor cell has an interior volume of only 1 mm3 and the volume of the entire spectrometer is around 0.1 cm3.
Generation of frequency correlated laser beams is of importance in various applications, in particular, for extending the frequency of the laser Raman microwave clock1 into the millimeter region where acoustooptic methods are not available. We propose and demonstrate an all-optical technique for such a purpose. The technique is based on the recently observed Raman-shifted oscillation2 that occurs when a three-level atomic system of Λ type is optically pumped and placed in a ring cavity. Our initial experiments are performed in sodium vapor pumped by a cw ring dye laser. Raman-shifted oscillation, detuned from the pump laser by 1.772 GHz which is the ground state hyperfine splitting of sodium, occurs in the wings of the Doppler broadened D1 line. This Raman-shifted oscillation is demonstrated to be highly frequency correlated with the pumping laser when the two are heterodyned on a fast photodetector. In our experiments the heterodyne beat signal at 1.772 GHz had a linewidth as low as 17 kHz, whereas the pumping laser has a rms frequency fluctuation of 300 kHz. The beat signal stays narrowband when the pumping laser is unlocked from the reference cavity increasing its rms frequency fluctation to ~10MHz.