Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optics Letters

Laser cooling of lithium using relay chirp cooling

C. C. Bradley, J. G. Story, J. J. Tollett, J. Chen, Nicholas W. M. Ritchie, Randall G. Hulet

Published Mar 1, 1992• 19 citations
Publisher

Abstract

We demonstrate a chirp-cooling technique that uses a laser with multiple FM sidebands to slow lithium atoms from initial velocities of as much as 1880 m/s to final velocities near zero. Compared with the use of a single sideband, this multisideband technique significantly reduces FM bandwidth requirements and provides a greater flux of slowed atoms.

DOI
10.1364/ol.17.000349

Related papers

A laser diode system and its use in a laser cooling experiment

C. C. Bradley

A system to control and stabilize the output of visible laser diodes was developed and used to measure the velocity distribution of lithium atoms in a laser cooling experiment. Circuitry was designed and built for controlling the diode temperature and current, and optical feedback from a grating was used to further tune the laser and to narrow its lineshape. In the experiment, atoms from a thermal lithium beam were slowed to near zero velocity using a multi-frequency relay chirp technique.

•Jan 1, 1992•0 citations

Laser cooling and trapping of rubidium

Christopher D. Wallace, Timothy T. Grove, T. Dinneen +2 more

We have laser cooled an atomic beam of rubidium with diode lasers and have used these slow atoms to load a magneto-optical trap. The cooling is performed with the frequency-chirp method,1,2 in which the laser's frequency is ramped linearly (by the injection currant) to maintain resonance with the decelerating atoms. Two synchronously chirped lasers are required to prevent optical hyperfine pumping of the ground state. The chirp typically covers 500 MHz in 10 ms. At the end of each ramp, the resulting velocity distribution is measured with a pulsed probe laser. By varying the end point of the chirp, we are able to obtain slow atoms with average velocities ranging from 200 to −50 m/s. The widths of the velocity distributions are measured to be approximately 40 m/s. This relatively large width results from the inherent linewidth (~30 MHz) of the free-running diode lasers used for both cooling and probing.

Quantum Electronics and Laser Science Conference•May 12, 1991•0 citations

Formation of a beam of cold atoms by laser frequency tuning

Yu. Rozhdestvensky, Anton K. Vershovskii, E A Ageichik +1 more

We report the possibility of producing a beam of slow atoms with a characteristic velocity of ∼ 1 m s − 1 by the ‘chirp’ method, namely, cooling by variable-frequency radiation. Method modifications are considered, which substantially reduce dimensions of the slower, the width of the longitudinal velocity distribution of the atomic beam, and the area of its cross section. The modified method of laser radiation frequency tuning for cooling rubidium atoms is mathematically simulated.

Quantum Electronics•Oct 11, 2016•0 citations

Laser cooling and slowing of CaF molecules

Valentina Zhelyazkova, Anne Cournol, Thomas E. Wall +5 more

We demonstrate slowing and longitudinal cooling of a supersonic beam of CaF molecules using counterpropagating laser light resonant with a closed rotational and almost-closed vibrational transition. A group of molecules are decelerated by about 20 m/s by applying light of a fixed frequency for 1.8 ms. Their velocity spread is reduced, corresponding to a final temperature of about 300 mK. The velocity is further reduced by chirping the frequency of the light to keep it in resonance as the molecules slow down.

arXiv:1308.0421•Physical Review A•May 16, 2014•305 citations

Manipulating atomic velocities using diode lasers

Richard N. Watts, Carl Wieman

We have used counterpropagating radiation from a diode laser to cool and stop a beam of cesium atoms. The laser frequency was chirped to keep it in resonance with the slowing atoms. The same laser was used to probe the resulting velocity distributions. We have cooled more than 1010 atoms/sec to a temperature of 1 K. This is an extremely simple and inexpensive way to manipulate atomic velocities and has a wide range of possible applications.

Optics Letters•May 1, 1986•86 citations

Manipulating atomic velocities using diode lasers

Richard N. Watts, Carl Wieman

We have used counterpropagating radiation from a diode laser to cool and stop a beam of cesium atoms. The laser frequency was chirped to keep it in resonance with the slowing atoms. The same laser was used to probe the resulting velocity distributions. We have cooled more than 10 10 atoms/sec to a temperature of 1 K. This is an extremely simple and inexpensive way to manipulate atomic velocities and has a wide range of possible applications.

WORLD SCIENTIFIC eBooks•Jan 1, 2008•0 citations
We demonstrate a chirp-cooling technique that uses a laser with multiple FM sidebands to slow lithium atoms from initial velocities of as much as 1880 m/s to final velocities near zero. Compared with the use of a single sideband, this multisideband technique significantly reduces FM bandwidth requirements and provides a greater flux of slowed atoms.
We have laser cooled an atomic beam of rubidium with diode lasers and have used these slow atoms to load a magneto-optical trap. The cooling is performed with the frequency-chirp method,1,2 in which the laser's frequency is ramped linearly (by the injection currant) to maintain resonance with the decelerating atoms. Two synchronously chirped lasers are required to prevent optical hyperfine pumping of the ground state. The chirp typically covers 500 MHz in 10 ms. At the end of each ramp, the resulting velocity distribution is measured with a pulsed probe laser. By varying the end point of the chirp, we are able to obtain slow atoms with average velocities ranging from 200 to −50 m/s. The widths of the velocity distributions are measured to be approximately 40 m/s. This relatively large width results from the inherent linewidth (~30 MHz) of the free-running diode lasers used for both cooling and probing.
We demonstrate slowing and longitudinal cooling of a supersonic beam of CaF molecules using counterpropagating laser light resonant with a closed rotational and almost-closed vibrational transition. A group of molecules are decelerated by about 20 m/s by applying light of a fixed frequency for 1.8 ms. Their velocity spread is reduced, corresponding to a final temperature of about 300 mK. The velocity is further reduced by chirping the frequency of the light to keep it in resonance as the molecules slow down.