Superconducting quantum interferometers with operating temperatures of up to 17°K have been fabricated from thin films of Nb3Sn and NbN by means of photolithographic and argon ion etching techniques.
Superconducting Hot-electron Bolometric (HE.B) mixers employing thin films ofNbN have become the devices of choice for heterodyne detection at tera,hertz frequen- cies. HEB mixers are inherently insensitive to the bandgap frequency of the superconducting material used in the device, in contrast to SIS mixers,. We have developed a fabrication pro- cess for thin NbN films at the National Institute of Standards and Technology in Boulder, CO. A two-fold approach can be taken. The first is to maximize the critical temperature of the superconducting device by growing thicker films at the expense of IF bandwidth, whereas the second approach focuses on maximizing the IF bandwidth at the expense of the critical tem- perature. So far, we have developed a film-deposition process utilizing our DC reactive mag- netron sputtering chamber. By current-biasing the RF plasma in a mixture of Ar and N2, while using a Nb target, we can control the film stoichiometry and produce films with thicknesses of 5 nm. The films are deposited on MgO substrates that are heated to about 800 °C during depo- sition. A typical critical temperature (TO is about 10 K and the transition width is very small (0.5 K). The films are evaluated by measuring their superconducting characteristics as well as their thickness and surface roughness by means of AFM analysis. Phonon-cooled HEB devices are fabricated from the films to study their performance as HEB mixers. The device fabrication process at UMass/Amherst involves lift-off lithography of the antenna (gold), and Reactive ion etching (R1E) or wet etching of the NbN. The I-V char- acteristics and noise temperatures of the devices were measured in order to determine their quality for PHEB applications.
A novel process suitable for fabricating superconducting circuitry based on the all refractory material NbN is described. In this process, an in-situ trilayer film composed of NbN/MgO/NbN is used to fabricate Josephson tunnel junctions. Reactive ion etching processes are used to delineate devices and pattern insulators and metallizations. Fabricated junctions have yielded good tunneling characteristics with reasonable current density uniformity and reproducibility. Devices with gap voltages close to 5mV have been achieved for high quality junctions. In addition to the trilayer, there are two wiring layers, two resistor depositions, and two insulation layers, constituting a full NbN based fabrication technology. Using this process, we fabricated and successfully tested thin film DC SQUID and time domain reflectometer (TDR) circuits. Preliminary measurements suggest that the critical temperature of these circuits is well within the operating temperature of commercial two-stage closed cycle refrigerators.
Low-Temperature Stabilization of δ-NbN Superconducting Thin Films through Energy-Selective Ion Beam Sputtering
Achieving high-quality superconducting thin films at low temperatures is a central challenge for scalable quantum device integration and Complementary Metal-Oxide-Semiconductor (CMOS)-compatible fabrication. Here, we demonstrate a room-temperature magnetron sputtering approach for synthesizing niobium nitride (NbN) thin films using a novel energy-selective ion source that enables independent control of ion energy and ion flux. This capability provides a powerful route to precisely tailor surface kinetics and crystallization pathways, overcoming longstanding limitations in stabilizing high-quality NbN at reduced temperatures. The resulting films were characterized by superconducting transport measurements, X-ray diffraction, X-ray photoelectron spectroscopy, and transmission electron microscopy. Compared with conventional reactive sputtering, ion beam-assisted growth yields a substantial narrowing of the transition width at the superconducting temperature, indicating improved phase purity and electronic homogeneity. Furthermore, this work introduces energy-selective ion control as a general, non-equilibrium route to stabilize metastable superconducting phases at low temperatures, offering a new design paradigm for thin-film quantum materials.