Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Magnetics

Dayem-Martin (SIS tunnel junction) mixers for low noise heterodyne receivers

Tom G. Phillips, D. P. Woody, G. J. Dolan, Ronald Earle Miller, RICHARD A. LINKE

Published Jan 1, 1981• 52 citations
Publisher

Abstract

Superconducting thin film tunnel junctions of small area (.1 \rightarrow 1μm2) have properties which make them suitable for high frequency (≳100 GHz) heterodyne receivers. Both pair and single quasiparticle tunneling is present in these devices, but it is found that the mixing due to the pair effect is apparently excessively noisy, whereas the single quasiparticle effect has a low noise character which gives hope for near quantum limited performance. The physical effect involved is photon assisted quasiparticle tunneling and was first observed by Dayem and Martin[1]. We have made laboratory tests at 115 and 230 GHz which gave single side band (SSB) mixer noise temperatures of 60 and 300 K respectively. Also we have fabricated a 90-140 GHz receiver for the Caltech Owens Valley Radio Observatory which has an overall receiver noise temperature of about 300 K (SSB).

DOI
10.1109/tmag.1981.1060994

Related papers

A Superconducting Tunnel Junction Receiver for 230 GHz

Edmund C. Sutton

The performance of superconducting tunnel junctions as high-frequency receivers is discussed. Low-noise mixing in superconductor insulator-superconductor (SIS) quasi-particle tunnel junctions has been seen for frequencies up to 400 GHz. Such mixers have the significant advantage of small local-oscillator power requirements. A receiver has been constructed which has a single-sideband (SSB) receiver noise temperature of 305 K at 241 GHz.

IEEE Transactions on Microwave Theory and Techniques•Jan 1, 1983•59 citations

Low-noise submillimeter-wave NbTiN superconducting tunnel junction mixers

Jonathan H. Kawamura, Jian Chen, David Miller +5 more

We have developed a low-noise 850 GHz superconductor–insulator–superconductor quasiparticle mixer with NbTiN thin-film microstrip tuning circuits and hybrid Nb/AlN/NbTiN tunnel junctions. The mixer uses a quasioptical configuration with a planar twin-slot antenna feeding a two-junction tuning circuit. At 798 GHz, we measured an uncorrected double-sideband receiver noise temperature of TRX=260 K at 4.2 K bath temperature. This mixer outperforms current Nb SIS mixers by a factor of nearly 2 near 800 GHz. The high-gap frequency and low loss at 800 GHz make NbTiN an attractive material with which to fabricate tuning circuits for SIS mixers. NbTiN mixers can potentially operate up to the gap frequency, 2Δ/h∼1.2 THz.

Applied Physics Letters•Dec 20, 1999•81 citations

Quasiparticle heterodyne mixing in SIS tunnel junctions

P. L. Richards, T. M. Shen, R. Harris +1 more

The rapid onset of quasiparitcle tunneling current in superconductor-insulator-superconductor (Josephson) junctions at voltages above 2Δ/e is being used for millimeter-wave heterodyne mixing. Junctions with a 2-μm diameter and RN=50 Ω have little capacitive shunting at the signal frequency of 36 GHz. Because there is no series resistance, residual capacitance can be tuned out. Double sideband conversion efficiencies of 0.32 and mixer noise temperatures as low as TM⩽7 K=4hν/k have been observed. The results are compared with shot-noise-limited mixer theory. Photon-assisted tunneling effects are seen which indicate the approach to photon-noise-limited operation.

Applied Physics Letters•Mar 1, 1979•163 citations

Low-noise 115-GHz mixing in superconducting oxide-barrier tunnel junctions

G. J. Dolan, Tom G. Phillips, D. P. Woody

Small-area (≲1 μm2) oxide-barrier tunnel junctions have been made of thermally cyclable superconducting Pb alloys for use as high-frequency mixers. A single-sideband mixer noise temperature of <100 K has been achieved at 115 GHz. This result was achieved in the quasiparticle (classical) mixing mode.

Applied Physics Letters•Mar 1, 1979•138 citations

A low noise 230 GHz heterodyne receiver employing 0.25- mu m/sup 2/ area Nb-AlO/sub x/-Nb tunnel junctions

J. Kooi, M. Chan, Tom G. Phillips +2 more

The authors report recent results for a full-height rectangular waveguide mixer with an integrated IF matching network. Two 0.25 mu m/sup 2/ Nb-AlO/sub x/-Nb superconducting-insulating-superconducting (SIS) tunnel junctions with a current density of approximately=8500 A/cm/sup 2/ and omega RC of approximately=2.5 at 230 GHz have been tested. One of these quasiparticle tunnel junctions is currently being used at the Caltech Submillimeter Observatory in Hawaii. Detailed measurement of the receiver noise have been made from 200-290 GHz for both junctions at 4.2 K. The lowest receiver noise temperatures were recorded at 239 GHz, measuring 48 K DSB at 4.2 K and 40 K DSB at 2.1 K. The 230-GHz receiver incorporates a one-octave-wide integrated low-pass filter and matching network which transforms the pumped IF junction impedance to 50 Omega over a wide range of impedances.>

IEEE Transactions on Microwave Theory and Techniques•May 1, 1992•39 citations

Heterodyne Detection with Superconducting Tunnel Diodes

Michael J. Wengler

Heterodyne receivers based on superconductor-insulator-superconductor (SIS) tunnel diodes are the most sensitive available for near-millimeter wavelengths. Since the late seventies, receivers based on SISs have been used for millimeter band observations at radio observatories around the world. The work described here was carried out with the elusive goal in mind of developing ideal SIS receivers for radioastronomy. This thesis describes one researcher's path towards this goal. In the first chapter, a basic description of SIS diodes, their interaction with radiation, and heterodyne detection are given. The important detailed results of J. R. Tucker's tunnel diode heterodyne theory are described, since subsequent chapters rely on Tucker's work quite heavily. Throughout this introductory chapter, extremely simple (by comparison with the algebraic theoretical results) physical models are used to describe superconductivity, SISs, photon-assisted tunneling, and heterodyne detection. It is the author's experience that these physical models can be used to derive correct theoretical results, long before these results are proved rigorously. The second chapter presents a fully quantum mechanical theory of heterodyne detection with diodes. This theory was developed because Tucker's theory for tunnel diodes predicts a greater mixer sensitivity than is possible considering Heisenberg's uncertainty principle for radiation. Tucker does not quantize the radiation incident on the SIS, although his treatment of the isolated tunnel diode is completely quantum mechanical. In chapter 2, the quantization of radiation is carried out for heterodyne diode detectors. The formalism is shown to obey quantum limits on sensitivity. Finally, an ideal SIS mixer is shown to have noise properties identical to those of optical mixers based on ideal photodiodes. In possession of an apparently complete theory for SIS mixers, the third chapter presents a sampling of numerical results from that theory. Four different non-ideal tunnel diodes are used for these calculations so that a quantitative feel for the importance of diode quality can be achieved. The effects of dc and LO bias, signal and image source admittance, frequency of operation, and junction quality are all explored. This information will be useful for the proper engineering of SIS mixers. Finally, the fully optimized performance of the four tunnel diodes is presented as frequency is varied. It is shown that reasonably good quality lead-alloy SISs should behave like photodiodes up to frequencies as high as 1500 GHz. Finally, chapter 4 presents a prototype open-structure SIS mixer. Measurements in the laboratory show this mixer to be quite sensitive for signal frequencies from 115 to 761 GHz. Unlike all other SIS receivers, in which the diode is mounted across a waveguide, this mixer relies on the bowtie-on-quartz antenna structure, which has been investigated by D. B. Rutledge and his students. This difference is essential to the multi-octave spectral coverage of this mixer. It is probable that waveguide designs will never achieve good results above 500 GHz, and as of now, there are no SIS-waveguide mixers which operate well above 300 GHz. Tests at the Owens Valley Radio Observatory verify the suitablility of this mixer for radioastronomy, but these tests have been limited to frequencies of 260 GHz and lower.

•Feb 9, 2007•2 citations
Superconducting thin film tunnel junctions of small area (.1 \rightarrow 1μm2) have properties which make them suitable for high frequency (≳100 GHz) heterodyne receivers. Both pair and single quasiparticle tunneling is present in these devices, but it is found that the mixing due to the pair effect is apparently excessively noisy, whereas the single quasiparticle effect has a low noise character which gives hope for near quantum limited performance. The physical effect involved is photon assisted quasiparticle tunneling and was first observed by Dayem and Martin[1]. We have made laboratory tests at 115 and 230 GHz which gave single side band (SSB) mixer noise temperatures of 60 and 300 K respectively. Also we have fabricated a 90-140 GHz receiver for the Caltech Owens Valley Radio Observatory which has an overall receiver noise temperature of about 300 K (SSB).
We have developed a low-noise 850 GHz superconductor–insulator–superconductor quasiparticle mixer with NbTiN thin-film microstrip tuning circuits and hybrid Nb/AlN/NbTiN tunnel junctions. The mixer uses a quasioptical configuration with a planar twin-slot antenna feeding a two-junction tuning circuit. At 798 GHz, we measured an uncorrected double-sideband receiver noise temperature of TRX=260 K at 4.2 K bath temperature. This mixer outperforms current Nb SIS mixers by a factor of nearly 2 near 800 GHz. The high-gap frequency and low loss at 800 GHz make NbTiN an attractive material with which to fabricate tuning circuits for SIS mixers. NbTiN mixers can potentially operate up to the gap frequency, 2Δ/h∼1.2 THz.
The rapid onset of quasiparitcle tunneling current in superconductor-insulator-superconductor (Josephson) junctions at voltages above 2Δ/e is being used for millimeter-wave heterodyne mixing. Junctions with a 2-μm diameter and RN=50 Ω have little capacitive shunting at the signal frequency of 36 GHz. Because there is no series resistance, residual capacitance can be tuned out. Double sideband conversion efficiencies of 0.32 and mixer noise temperatures as low as TM⩽7 K=4hν/k have been observed. The results are compared with shot-noise-limited mixer theory. Photon-assisted tunneling effects are seen which indicate the approach to photon-noise-limited operation.
The authors report recent results for a full-height rectangular waveguide mixer with an integrated IF matching network. Two 0.25 mu m/sup 2/ Nb-AlO/sub x/-Nb superconducting-insulating-superconducting (SIS) tunnel junctions with a current density of approximately=8500 A/cm/sup 2/ and omega RC of approximately=2.5 at 230 GHz have been tested. One of these quasiparticle tunnel junctions is currently being used at the Caltech Submillimeter Observatory in Hawaii. Detailed measurement of the receiver noise have been made from 200-290 GHz for both junctions at 4.2 K. The lowest receiver noise temperatures were recorded at 239 GHz, measuring 48 K DSB at 4.2 K and 40 K DSB at 2.1 K. The 230-GHz receiver incorporates a one-octave-wide integrated low-pass filter and matching network which transforms the pumped IF junction impedance to 50 Omega over a wide range of impedances.>
Heterodyne receivers based on superconductor-insulator-superconductor (SIS) tunnel diodes are the most sensitive available for near-millimeter wavelengths. Since the late seventies, receivers based on SISs have been used for millimeter band observations at radio observatories around the world. The work described here was carried out with the elusive goal in mind of developing ideal SIS receivers for radioastronomy. This thesis describes one researcher's path towards this goal. In the first chapter, a basic description of SIS diodes, their interaction with radiation, and heterodyne detection are given. The important detailed results of J. R. Tucker's tunnel diode heterodyne theory are described, since subsequent chapters rely on Tucker's work quite heavily. Throughout this introductory chapter, extremely simple (by comparison with the algebraic theoretical results) physical models are used to describe superconductivity, SISs, photon-assisted tunneling, and heterodyne detection. It is the author's experience that these physical models can be used to derive correct theoretical results, long before these results are proved rigorously. The second chapter presents a fully quantum mechanical theory of heterodyne detection with diodes. This theory was developed because Tucker's theory for tunnel diodes predicts a greater mixer sensitivity than is possible considering Heisenberg's uncertainty principle for radiation. Tucker does not quantize the radiation incident on the SIS, although his treatment of the isolated tunnel diode is completely quantum mechanical. In chapter 2, the quantization of radiation is carried out for heterodyne diode detectors. The formalism is shown to obey quantum limits on sensitivity. Finally, an ideal SIS mixer is shown to have noise properties identical to those of optical mixers based on ideal photodiodes. In possession of an apparently complete theory for SIS mixers, the third chapter presents a sampling of numerical results from that theory. Four different non-ideal tunnel diodes are used for these calculations so that a quantitative feel for the importance of diode quality can be achieved. The effects of dc and LO bias, signal and image source admittance, frequency of operation, and junction quality are all explored. This information will be useful for the proper engineering of SIS mixers. Finally, the fully optimized performance of the four tunnel diodes is presented as frequency is varied. It is shown that reasonably good quality lead-alloy SISs should behave like photodiodes up to frequencies as high as 1500 GHz. Finally, chapter 4 presents a prototype open-structure SIS mixer. Measurements in the laboratory show this mixer to be quite sensitive for signal frequencies from 115 to 761 GHz. Unlike all other SIS receivers, in which the diode is mounted across a waveguide, this mixer relies on the bowtie-on-quartz antenna structure, which has been investigated by D. B. Rutledge and his students. This difference is essential to the multi-octave spectral coverage of this mixer. It is probable that waveguide designs will never achieve good results above 500 GHz, and as of now, there are no SIS-waveguide mixers which operate well above 300 GHz. Tests at the Owens Valley Radio Observatory verify the suitablility of this mixer for radioastronomy, but these tests have been limited to frequencies of 260 GHz and lower.