Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Chinese Physics

Basic properties of an rf SQUID involving two Josephson junctions connected in series

Bo Mao, Tan Zhong-Kui, Meng Shu-Chao, Dai Yuan-Dong, Furen Wang

Published Jul 29, 2004• 9 citations
Publisher

Abstract

We have studied the basic characteristics of a radio frequency superconducting quantum interference device (rf SQUID) involving two Josephson junctions connected in series, the case for the widely used grain boundary junction (GBJ) rf SQUID. It is found that the SQUID properties are determined mainly by the weaker junction when the critical current of the weaker junction is much lower than that of the other junction. Otherwise, the effect of the other junction is not negligible. We also find that only when the hysteresis parameter β is less than 1−α, where α is the critical current ratio of the two junctions, will the SQUID operate in the nonhysteretic mode.

DOI
10.1088/1009-1963/13/8/008

Related papers

Intrinsic flux noise level of an rf SQUID involving two Josephson junctions connected in series

Bo Mao, Dai Yuan-Dong, Furen Wang

The time-dependent characteristics of a radio frequency superconducting quantum interference device (rf SQUID) involving two Josephson junctions connected in series are studied. First the dynamics of the total flux is given. Then the intrinsic flux noises in both nonhysteretic and hysteretic modes are investigated. The result shows that it is necessary to properly reduce the critical current ratio of the two junctions for low intrinsic noise level. When the critical current ratio is properly reduced, the intrinsic flux noise level of a two-junction rf SQUID is generally close to or slightly larger than that of a single junction rf SQUID, but no more than one order-of-magnitude.

Chinese Physics•Jan 27, 2005•3 citations

Experimental study of amplitude–frequency characteristics of high-transition-temperature radio frequency superconducting quantum interference devices

Xian-Lin Zeng, Y. Zhang, Boris Chesca +3 more

We measured the amplitude–frequency characteristics of radio frequency superconducting quantum interference devices (rf SQUIDs) over a temperature range between 65 and 79 K. Using the expressions derived from the recently developed rf SQUID theory, valid also at large thermal fluctuations, we determined from these data the basic parameters of high-transition-temperature superconductor (HTS) rf SQUIDs. These parameters were: (a) the high-frequency coupling coefficient between the rf SQUID and the tank circuit resonator, k, (b) the SQUIDs hysteretic parameter, β, (c) the critical current of the Josephson junction, Ic, (d) its normal resistance, Rn, and (e) its noise parameter, Γ. We found a good agreement with the values of β(Ic) and Rn determined directly after destructively opening the SQUID loop. In accordance with the theoretical predictions, our experimental results show that at large thermal fluctuation levels (T≅77 K), rf SQUIDs with large loop inductance operate in nonhysteretic mode up to β values exceeding 3. Furthermore, we have shown that the optimal energy sensitivity is attained in the nonhysteretic mode at a value of β distinctly higher than 1. A quantitative comparison of white noise predicted by the theory with that obtained from the experiment showed a reasonable agreement. We also discussed the contribution of the phase information to the SQUID’s signal and noise at optimum operation conditions, when a mixer was used as a signal detector.

Journal of Applied Physics•Dec 1, 2000•14 citations

Peculiarities of radio frequency YBa2Cu3O7−x superconducting quantum interference device response with a finite amplitude of the second harmonic in the current-phase relationship

Evgeni V. Il’ichev

The signal properties of radio frequency (rf) (SQUIDs) based on YBa2Cu3O7−x symmetrical 30° and asymmetrical 45° grain-boundary Josephson junctions have been experimentally investigated. Both amplitude as well as phase detection have been used to read out the SQUID output signal. Comparison of the SQUID output signals to each other is given. It is shown that peculiarities of the rf SQUID response of SQUIDs with a 45° grain-boundary Josephson junction are consistent with an unconventional current-phase relation (CPR) of the Josephson junction, namely, the CPR contains a finite amplitude of the second harmonic.

Applied Physics Letters•Nov 20, 2000•0 citations

Impedance of radio-frequency-biased resistive superconducting quantum interference devices

Robert J. Soulen, Deborah van Vechten

We have measured with high accuracy (100 ppm) and high precision (5--10 ppm) the impedance of a rf-driven resistive superconducting quantum interference device (SQUID) as a function of the amplitude and frequency of the radio-frequency (rf) bias, as a function of the current bias, and as a function of several other circuit parameters. We have developed the coupled differential equations for the resistive SQUID and for the rf tank circuit. The fit of the solutions of these equations to the data for nonhysteretic junctions is excellent. We were unable to develop solutions for the hysteretic case and thus simply present examples of typical data obtained in order to illustrate the differences with the nonhysteretic case. The relationship of this study to noise thermometry using resistive SQUID's is indicated.

Physical review. B, Condensed matter•Jul 1, 1987•13 citations

Radio frequency pumped superconducting quantum interference devices with two quantization loops

G.S. Krivoy, H. Koch

Conventional rf SQUIDs (superconducting quantum interference devices) consist of a superconducting loop interrupted by one weak link, and when read out via a tank circuit they produce output signals in the order of a few tens of microvolts. When the single weak link is replaced by a dc SQUID (a superconducting loop with two junctions) a so-called double quantization loop SQUID is formed. In this paper it is shown theoretically, and supported experimentally with thin-film devices of three different designs, that the general behaviour can be explained by a simplified picture of the fixed critical current of the single junction of the rf SQUID being replaced by an effective critical current of a dc SQUID loop that is varied by the applied magnetic flux (i.e., we have a rf SQUID with a variable β parameter). A more detailed analysis of the experimental data and the theory of this novel device reveals its interesting nonlinear character and shows the deviations from this simple picture. It is demonstrated experimentally that output signals in the order of ≥1 mV can be obtained with a suitable read-out mode for the tank circuit, a clear advantage when compared to conventional rf SQUIDs. With respect to dc SQUIDs, the coupling to integrated planar input coils will be unproblematic since no microwave resonances should occur in the structures.

Journal of Applied Physics•Aug 15, 1993•16 citations

CHARACTERISTICS IN AN RF SUPERCONDUCTING QUANTUM INTERFERENCE DEVICE AS A FUNCTION OF APPLIED MAGNETIC FLUX : SYSTEMATIC CALCULATIONS II

強志 青地, 修二 戎, 正一 永田

Characteristic feature in superconducting quantum interference device (rf-SQUID) is shown on the basis of the analysis of the foregoing paper. The behavior will be given in detail. The parameter β = (2πLIo)/ф₀ changes gradually the characteristic feature,here I₀ is the critical current of the junction,L is the self -inductance of the ring and ф₀ is the flux quantum. Abrupt transitions between two adjacent quantum states are clearly shown in the regime β > l. The results of the systematic calculations of the characteristics in the rf-SQUID are presented over the range of β = 0.20 to 2π.

室蘭工業大学研究報告 理工編•Nov 1, 1992•0 citations
We have studied the basic characteristics of a radio frequency superconducting quantum interference device (rf SQUID) involving two Josephson junctions connected in series, the case for the widely used grain boundary junction (GBJ) rf SQUID. It is found that the SQUID properties are determined mainly by the weaker junction when the critical current of the weaker junction is much lower than that of the other junction. Otherwise, the effect of the other junction is not negligible. We also find that only when the hysteresis parameter β is less than 1−α, where α is the critical current ratio of the two junctions, will the SQUID operate in the nonhysteretic mode.
The time-dependent characteristics of a radio frequency superconducting quantum interference device (rf SQUID) involving two Josephson junctions connected in series are studied. First the dynamics of the total flux is given. Then the intrinsic flux noises in both nonhysteretic and hysteretic modes are investigated. The result shows that it is necessary to properly reduce the critical current ratio of the two junctions for low intrinsic noise level. When the critical current ratio is properly reduced, the intrinsic flux noise level of a two-junction rf SQUID is generally close to or slightly larger than that of a single junction rf SQUID, but no more than one order-of-magnitude.
We measured the amplitude–frequency characteristics of radio frequency superconducting quantum interference devices (rf SQUIDs) over a temperature range between 65 and 79 K. Using the expressions derived from the recently developed rf SQUID theory, valid also at large thermal fluctuations, we determined from these data the basic parameters of high-transition-temperature superconductor (HTS) rf SQUIDs. These parameters were: (a) the high-frequency coupling coefficient between the rf SQUID and the tank circuit resonator, k, (b) the SQUIDs hysteretic parameter, β, (c) the critical current of the Josephson junction, Ic, (d) its normal resistance, Rn, and (e) its noise parameter, Γ. We found a good agreement with the values of β(Ic) and Rn determined directly after destructively opening the SQUID loop. In accordance with the theoretical predictions, our experimental results show that at large thermal fluctuation levels (T≅77 K), rf SQUIDs with large loop inductance operate in nonhysteretic mode up to β values exceeding 3. Furthermore, we have shown that the optimal energy sensitivity is attained in the nonhysteretic mode at a value of β distinctly higher than 1. A quantitative comparison of white noise predicted by the theory with that obtained from the experiment showed a reasonable agreement. We also discussed the contribution of the phase information to the SQUID’s signal and noise at optimum operation conditions, when a mixer was used as a signal detector.
The signal properties of radio frequency (rf) (SQUIDs) based on YBa2Cu3O7−x symmetrical 30° and asymmetrical 45° grain-boundary Josephson junctions have been experimentally investigated. Both amplitude as well as phase detection have been used to read out the SQUID output signal. Comparison of the SQUID output signals to each other is given. It is shown that peculiarities of the rf SQUID response of SQUIDs with a 45° grain-boundary Josephson junction are consistent with an unconventional current-phase relation (CPR) of the Josephson junction, namely, the CPR contains a finite amplitude of the second harmonic.
We have measured with high accuracy (100 ppm) and high precision (5--10 ppm) the impedance of a rf-driven resistive superconducting quantum interference device (SQUID) as a function of the amplitude and frequency of the radio-frequency (rf) bias, as a function of the current bias, and as a function of several other circuit parameters. We have developed the coupled differential equations for the resistive SQUID and for the rf tank circuit. The fit of the solutions of these equations to the data for nonhysteretic junctions is excellent. We were unable to develop solutions for the hysteretic case and thus simply present examples of typical data obtained in order to illustrate the differences with the nonhysteretic case. The relationship of this study to noise thermometry using resistive SQUID's is indicated.
Conventional rf SQUIDs (superconducting quantum interference devices) consist of a superconducting loop interrupted by one weak link, and when read out via a tank circuit they produce output signals in the order of a few tens of microvolts. When the single weak link is replaced by a dc SQUID (a superconducting loop with two junctions) a so-called double quantization loop SQUID is formed. In this paper it is shown theoretically, and supported experimentally with thin-film devices of three different designs, that the general behaviour can be explained by a simplified picture of the fixed critical current of the single junction of the rf SQUID being replaced by an effective critical current of a dc SQUID loop that is varied by the applied magnetic flux (i.e., we have a rf SQUID with a variable β parameter). A more detailed analysis of the experimental data and the theory of this novel device reveals its interesting nonlinear character and shows the deviations from this simple picture. It is demonstrated experimentally that output signals in the order of ≥1 mV can be obtained with a suitable read-out mode for the tank circuit, a clear advantage when compared to conventional rf SQUIDs. With respect to dc SQUIDs, the coupling to integrated planar input coils will be unproblematic since no microwave resonances should occur in the structures.
Characteristic feature in superconducting quantum interference device (rf-SQUID) is shown on the basis of the analysis of the foregoing paper. The behavior will be given in detail. The parameter β = (2πLIo)/ф₀ changes gradually the characteristic feature,here I₀ is the critical current of the junction,L is the self -inductance of the ring and ф₀ is the flux quantum. Abrupt transitions between two adjacent quantum states are clearly shown in the regime β > l. The results of the systematic calculations of the characteristics in the rf-SQUID are presented over the range of β = 0.20 to 2π.