The Xe(L) system is an amplifier with fundamentally different dynamic characteristics from all previously developed laser amplifiers; it represents the conceptual ideal through full utilization of the Kramers–Kronig relations that fundamentally couple the dispersive and absorptive components. The dispersive response of the system, through optimal governance of the power compression, rules the amplification and establishes a minimum gain for the amplifier. Accordingly, the amplification requires a minimum value of the dispersion to be surpassed; the corresponding gain follows automatically. As a leading consequence, since this minimum gain is sufficiently high, the key experimental observation is the uniform presence of saturated amplification signaled by strong spectral hole burning on all transitions exhibiting amplification, including double-vacancy lines. This cardinal signature demonstrates that the amplification is legislated by the saturated gain g s , not the corresponding small signal value g 0 . The chief outcome is that explosive dispersion yields perforce explosive amplification and the efficient generation of maximally bright coherent power.
The Xe(L) system is an amplifier with fundamentally different dynamic characteristics from all previously developed laser amplifiers; it represents the conceptual ideal through full utilization of the Kramers–Kronig relations that fundamentally couple the dispersive and absorptive components. The dispersive response of the system, through optimal governance of the power compression, rules the amplification and establishes a minimum gain for the amplifier. Accordingly, the amplification requires a minimum value of the dispersion to be surpassed; the corresponding gain follows automatically. As a leading consequence, since this minimum gain is sufficiently high, the key experimental observation is the uniform presence of saturated amplification signaled by strong spectral hole burning on all transitions exhibiting amplification, including double-vacancy lines. This cardinal signature demonstrates that the amplification is legislated by the saturated gain g s , not the corresponding small signal value g 0 . The chief outcome is that explosive dispersion yields perforce explosive amplification and the efficient generation of maximally bright coherent power.
The Xe(L) system at ? ~ 2.9 ? uniformly exhibits all of the canonical attributes of a strongly saturated amplifier on the full ensemble of single-vacancy Xeq+ transition arrays (q = 31, 32, 34, 35, 36) that exhibit gain. The key observables are (1) sharp spectral narrowing, (2) the detection of a narrow directed beam (??x200 ?rad), (3) an increase in the amplitude of the emission and the development of an intense output (?106 enhancement) and (4) the observation of deep spectral hole-burning on the inhomogeneously broadened spontaneous emission profile. Experimentally determined by two methods, (a) line narrowing and (b) signal enhancement, the observations for several single-vacancy 3d?2p transitions indicate a range of values for the effective small signal (linear) gain constant given by go25?100 cm?1. Quantitative analysis shows that this result stands in clear conflict with the corresponding upper bound go40?80 cm?1 that is based on available spectroscopic data and estimated with conventional theory. Overall, the observed values deviate substantially from expectations scaled to the spectral density of the measured Xe(L) spontaneous emission profile; they are systematically too high. The most extreme example is the heavily saturated Xe32+ transition at ? = 2.71 ?, a case that fails to reconcile the lower bound of the measured signal strength with the corresponding theoretically predicted maximal value; the former falls above the latter by a factor exceeding 400 giving an enormous gap. Moreover, although saturation is a prominent characteristic of the amplification at ?2.71 ?, as demonstrated by spectral hole-burning, the theoretical upper bound of go given for this transition is far too small for saturation to be reached. The Xe31+ transition at ?2.93 ? exhibits comparably pronounced anomalous behaviour. This double paradox is resolved with the Ansatz that the amplification is governed principally by the saturated gain gs, not the conventionally described small signal value go. This interpretation is further supported by the observation of deep spectral hole-burning, the signature of strong saturation, that occurs uniformly across the spectrum of the spontaneous emission profile. The effective amplification exhibits an anomalously weak dependence on the spectral density; saturation is the rule, not the exception. A lucid manifestation of the saturation is the recording of spectrally resolved x-ray yields on the Xe31+ array that are sufficiently high to produce gross structural damage to the material in the film plane of the spectrograph. The behaviour of the amplifier can be best described as an explosive supersaturated amplification. The source of this exceptionally strong amplification can be traced to the dynamically enhanced radiative response of the excited Xe hollow atom states located in the clusters that are mode coupled to the plasma waveguide forming the amplifying channel.
A coherent optical amplifier is a device that increases the amplitude of an optical field while maintaining its phase. If the optical field at the input to such an amplifier is monochromatic, the output will also be monochromatic, with the same frequency. The output amplitude is increased relative to the input while the phase is unchanged or shifted by a fixed amount. In contrast, an amplifier that increases the intensity of an optical wave without preserving the phase is called an incoherent optical amplifier. This chapter is concerned with coherent optical amplifiers. Such amplifiers are important for various applications; examples include the amplification of weak optical pulses such as those that have traveled through a long length of optical fiber, and the production of highly intense optical pulses such as those required for laser-fusion applications. Furthermore, it is important to understand the principles underlying the operation of optical amplifiers as a prelude to the discussion of optical oscillators. Light transmitted through matter in thermal equilibrium is attenuated rather than amplified. This is because absorption by the large population of atoms in the lower energy level is more prevalent than stimulated emission by the smaller population of atoms in the upper level. An essential ingredient for achieving laser amplification is the presence of a greater number of atoms in the upper energy level than in the lower level, which is clearly a nonequilibrium situation. Achieving such a population inversion requires a source of power to excite (pump) the atoms into the higher energy level. Although the presentation throughout this chapter is couched in terms of “atoms” and “atomic levels,” these appelations are to be more broadly understood as “active medium” and “laser energy levels,” respectively. The properties of an ideal (optical or electronic) coherent amplifier are displayed schematically. Real coherent amplifiers deliver a gain and phase shift that are frequency dependent, typically in the manner illustrated here. The gain and phase shift constitute the amplifier's transfer function. For a sufficiently high input amplitude, furthermore, real amplifiers may exhibit saturation, a form of nonlinear behavior in which the output amplitude fails to increase in proportion to the input amplitude. Saturation introduces harmonic components into the output, provided that the amplifier bandwidth is sufficiently broad to pass them. Real amplifiers also introduce noise, so that a randomly fluctuating component is always present at the output, regardless of the input. An amplifier may therefore be characterized by the following features: ▪ gain; ▪ bandwidth; ▪ phase shift; ▪ power source; ▪ nonlinearity and gain saturation, and ▪ noise We proceed to discuss these characteristics in turn in this chapter. The theory of laser amplification is developed, leading to expressions for the amplifier gain, spectral bandwidth, and phase shift. The mechanisms by which an amplifier power source can achieve a population inversion are examined. Gain saturation and noise in the amplification process, are discussed respectively. This chapter relies on material presented in Chap. 12.
Coherent amplifications of short pulse XeCl lasers are theoretically studied using multi-level Maxwell-Bloch equations including real vibrational-rotational structures of a gain spectrum of XeCl. The model can successfully predict coherent effects such as the quantum beat caused by spectrum overlaptions of several vibrational-rotational transitions involved in the short pulse laser spectrum. Saturation of amplified energy caused by formation of a 2 π-pulse-like pulse. Since a pulse area necessary for the production of a 2π-pulse-like pulse which depletes all the upper state populations accessible to the laser spectrum depends on the laser pulse width, an effective saturation energy is a function of the laser pulse width. When absorption in the amplifier media is not negligible to the small-signal gain, an effective u-pulse-like pulse is generated instead of a 2π-pulse-like pulse. The laser pulse width is shortened by the π or 2π-pulse-like pulse formation, and even shorter pulses than the linear limitation defined by the gain spectrum width can be generated if the amplified pulse intensity becomes very strong.
Introduction In this chapter we will present the theory of spectral gain in optical amplifiers and the related optical power distribution. The concepts are general, as they apply to every optical amplifier configuration, independent of the specific architecture and implementation technology. We will configure the optical amplifying medium as a traveling-wave device, where the optical field undergoes optical amplification as it propagates from the input to the output sections. Generally speaking, optical amplification is achieved by a net stimulated emission process. Referring to a generic section z of infinitesimal thickness dz , optical gain is determined by the imbalance between net stimulated emission and cavity losses, including extrinsic absorption, reflection and radiated fields. As we know from the theory of light amplification in the three-level atomic system presented in Chapter 5, stimulated absorption of photons is governed by the same transition rate as stimulated emission, and is included in the net stimulated emission process. With this in mind, we note the identity between stimulated emission and the stimulated absorption rates, Γ 12 = Γ 21 , and the net stimulated photon term Γ[ j 2 ( t ) – j 1 ( t )] p ( t ) in the rate equation. In order to develop the traveling-wave model, the photon density becomes a function of the longitudinal position 0 ≤ z ≤ L along the amplifier medium. Accordingly, we will set p ( t , z ) as the relative density of stimulated photons per unit volume (0 ≤ p ( t , z ) ≤ 1) at time t and section z . When photons with appropriate energy proceed along the amplifying medium, they are amplified by means of net stimulated emission. At some section z = z 0 , the steady-state photon density P ( z ) can approach the saturation density P sat ( z ).
The triple comparison of (1) single-pulse spectral data, recorded with a CCD-equipped von Hámos spectrometer both axially and transversely; (2) axially measured time-integrated spectra registered on a film and (3) single-pulse x-ray images of the morphology of the self-trapped plasma channel, recorded simultaneously with the single-pulse spectra, establishes several leading characteristics of the saturated amplification observed on the Xe 35+ transition array at λ ≅ 2.86 Å. The chief findings are (α) absolute positive correlation of amplification with the formation of a plasma channel, (β) a perfect spectral match of the amplified transitions in the comparison of axially recorded single-pulse and time-integrated film data and (γ) exact spectral correspondence of both the axially registered single-pulse and time-integrated film data with single-pulse transversely measured spectra exhibiting deep spectral hole burning at the position of the Xe 35+ array.
A photon, unlike an electron, can stimulate an excited atom to emit a second photon into the same electromagnetic mode. This stimulated emission process is the foundation for light amplification and oscillation (i.e., self-generation). Initially, the term LASER referred to Light Amplification by Stimulated Emission of Radiation. Nowadays laser often means Light Oscillation by Stimulated Emission, which should literally be called "LOSER" instead of "LASER." To distinguish the above two devices, the former is called a laser amplifier, the latter a laser oscillator (Siegman 1986). Laser oscillation occurs when the photon generation rate exceeds the photon loss rate in a system. If gain saturation were absent, the photon number in a laser oscillator would diverge in time. In other words, the rate equation for the photon number would acquire an unstable solution above the oscillation threshold. In reality, gain saturation reduces the photon generation rate to the photon loss rate so that the number of photons in the oscillator remains at a finite value.