Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Applied Superconductivity

Heterodyne detector using a SNS junction

A. M. Luiz, L.A.A. Pereira, R. Nicolsky

Published Jun 1, 1997• 8 citations
Publisher

Abstract

We propose new designs for millimeter-wave heterodyne detectors using the negative differential resistance of SNS junctions. The SNS junction may be used as the local oscillator in conventional receivers or a single SNS junction may be simultaneously used as the local oscillator and as the mixer itself, taking advantage of the nonlinearity of the current-voltage characteristic (CVC) of the junction. We calculate CVC curves for high-Tc SNS junctions (YBCO-SNS junctions), which are expressed as a function of T/Tc and other parameters.

DOI
10.1109/77.622226

Related papers

Simulation of conversion gain and reflectivity coefficients in heterodyne detector using a superconductor-normal metal-superconductor junction

A. M. Luiz, Yuri A. Gorelov, R. Nicolsky

We design a millimeter-wave heterodyne receiver using Superconductor-Normal metal-Superconductor (SNS) junction. We simulate its Current-Voltage Characteristics (CVC) as a function of its relevant physical parameters. Performing computer simulations, we use the negative derivative range of its CVC to calculate the conversion gain and reflectivity coefficients of the proposed device. These parameters show that it should be possible to increase the sensitivity of the SNS mixer and a reflection parametric amplifier may be feasible.

IEEE Transactions on Applied Superconductivity•Jun 1, 1999•2 citations

Superconductor-normal metal-superconductor junctions for signal amplification and harmonic multiplication

V. Soares, A. M. Luiz, R. Nicolsky

We report signal amplification and harmonic multiplication processes based on the nonlinear current-voltage characteristics (CVC) displayed by superconductor-normal metal-superconductor (SNS) junctions. Such junctions may exhibit a negative differential resistance at low voltages, the so called low-voltage-negative-differential-resistance (LVNDR) effect. This effect is due to the quantum mechanical multiple Andreev reflection mechanism in very clean systems and is stable against a bias voltage. Therefore, it is in principle possible to use these junctions as an active element in a variety of circuit applications such as oscillators, amplifiers or mixers, in the microwave and millimeter-wave range.

IEEE Transactions on Magnetics•Jan 1, 1999•3 citations

Microwave Generation using a SNS Junction

Adir M Luiz, R. Nicolsky

It has been shown recently that the current-voltage characteristic of a metallic (non-tunneling) Josephson junction could exhibit a negative differential resistance at low voltages, as a predictable and reproducible effect. This letter shows an alternative procedure to generate non-Josephson microwaves (in the cm and mm range) taking advantage of this effect. It is shown that, instead of obtaining harmonic oscillations with the AC Josephson effect, it is possible to generate microwaves using the averaged IVC (current-voltage characteristics) of a SNS junction (a Josephson junction which exhibits no tunneling and has no hysteresis in the IVC).

Japanese Journal of Applied Physics•Jun 1, 1991•8 citations

Millimeter- and submillimeter-wave negative resistance SNS mixers

Toshiaki Matsui, Hiroshi Ohta

We have studied negative-resistance mixers both theoretically and experimentally. The current carried by the bound quasi-particles in the N-region of a mesoscopic SNS weak-link has a dc and cosine components. Current transport in the SNS weak-links is affected by bias-voltages in many experiments. The I-V curves often show complex structures including negative differential resistance which cannot be understood by the simple RSJ model. Supercurrent is directly affected both by the bias voltage and the density of states at the energy gap of superconductor. The supercurrent by the Multiple-Andreev-Reflection is considerably changed across subharmonic gap voltages because of the singularity of the density of state of superconductor near the energy gap. We have done mixer experiment of SNS weak-links and have observed IF peaks at subgap voltages which are caused by the negative differential resistance.

IEEE Transactions on Applied Superconductivity•Jun 1, 1999•4 citations

Superconducting detectors for submillimeter-wave astronomy

Eric E. Bloemhof

Sensitive heterodyne receivers are being built at ever higher frequencies with superconducting (SIS) junctions as the first mixer. These devices have extremely sharp non-linearities in their current-voltage characteristics as a result of quantum-mechanical tunneling of electrons across thin insulating barriers. The low energy scale set by the magnitude of the superconducting energy gap implies very low local oscillator power requirements for heterodyne operation. Some general system design considerations for astrophysical receivers are reviewed. These principles are illustrated by discussing two specific applications: a 230 GHz SIS receiver recently installed as a facility instrument at the Swedish-ESO submillimeter telescope in Chile, and the broader receiver requirements of the 6-antenna submillimeter array (SMA), an interferometer now being designed at the Harvard-Smithsonian Center for Astrophysics. The SMA will require receivers at frequencies as high as 820 GHz, and will place some unique demands on detector performance.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Jul 15, 1993•0 citations

NBN JOSEPHSON AND TUNNEL JUNCTIONS FOR SPACE THZ OBSERVATION AND SIGNAL PROCESSING

Romano Setzu, N. Hadacek, Vincent Larrey +2 more

ABSTRACT: Active superconducting circuits based on picoseconds switching, i.e. THz oscillating, Josephson tunnel junctions are expected to find a large domain of applications in spatial sub-millimeter wave and FIR detectors as well as in satellite based wideband signal and data processors. In the first case SIS (superconductor-insulator-superconductor) tunnel junctions are required, while in the second case SNS (superconductor-normal metal-superconductor) self-shunted junctions are preferred. We present the advantages of the nitride junction technology currently developed at CEA-Grenoble, based on high-performance MTS (medium temperature superconductor) NbN films in both SIS and SNS junctions. In the SIS case the device performances rely on a sputter deposited and post-annealed, only 0.5-0.7 nm thick, dielectric MgO barrier. This leads to junctions with a Josephson critical current in the range of 10-25 kA/cm, and a large superconducting energy gap (> 5 meV) associated with a low sub-gap quasi-particle leakage current. These parameters are suitable for low “noise temperature ” heterodyne mixers, local oscillators, and integrated receivers in the 0.8 to 1.4 THz frequency range. In the SNS case, a new

•Jul 13, 2005•1 citation
We propose new designs for millimeter-wave heterodyne detectors using the negative differential resistance of SNS junctions. The SNS junction may be used as the local oscillator in conventional receivers or a single SNS junction may be simultaneously used as the local oscillator and as the mixer itself, taking advantage of the nonlinearity of the current-voltage characteristic (CVC) of the junction. We calculate CVC curves for high-Tc SNS junctions (YBCO-SNS junctions), which are expressed as a function of T/Tc and other parameters.
We design a millimeter-wave heterodyne receiver using Superconductor-Normal metal-Superconductor (SNS) junction. We simulate its Current-Voltage Characteristics (CVC) as a function of its relevant physical parameters. Performing computer simulations, we use the negative derivative range of its CVC to calculate the conversion gain and reflectivity coefficients of the proposed device. These parameters show that it should be possible to increase the sensitivity of the SNS mixer and a reflection parametric amplifier may be feasible.
We report signal amplification and harmonic multiplication processes based on the nonlinear current-voltage characteristics (CVC) displayed by superconductor-normal metal-superconductor (SNS) junctions. Such junctions may exhibit a negative differential resistance at low voltages, the so called low-voltage-negative-differential-resistance (LVNDR) effect. This effect is due to the quantum mechanical multiple Andreev reflection mechanism in very clean systems and is stable against a bias voltage. Therefore, it is in principle possible to use these junctions as an active element in a variety of circuit applications such as oscillators, amplifiers or mixers, in the microwave and millimeter-wave range.
It has been shown recently that the current-voltage characteristic of a metallic (non-tunneling) Josephson junction could exhibit a negative differential resistance at low voltages, as a predictable and reproducible effect. This letter shows an alternative procedure to generate non-Josephson microwaves (in the cm and mm range) taking advantage of this effect. It is shown that, instead of obtaining harmonic oscillations with the AC Josephson effect, it is possible to generate microwaves using the averaged IVC (current-voltage characteristics) of a SNS junction (a Josephson junction which exhibits no tunneling and has no hysteresis in the IVC).
We have studied negative-resistance mixers both theoretically and experimentally. The current carried by the bound quasi-particles in the N-region of a mesoscopic SNS weak-link has a dc and cosine components. Current transport in the SNS weak-links is affected by bias-voltages in many experiments. The I-V curves often show complex structures including negative differential resistance which cannot be understood by the simple RSJ model. Supercurrent is directly affected both by the bias voltage and the density of states at the energy gap of superconductor. The supercurrent by the Multiple-Andreev-Reflection is considerably changed across subharmonic gap voltages because of the singularity of the density of state of superconductor near the energy gap. We have done mixer experiment of SNS weak-links and have observed IF peaks at subgap voltages which are caused by the negative differential resistance.
Sensitive heterodyne receivers are being built at ever higher frequencies with superconducting (SIS) junctions as the first mixer. These devices have extremely sharp non-linearities in their current-voltage characteristics as a result of quantum-mechanical tunneling of electrons across thin insulating barriers. The low energy scale set by the magnitude of the superconducting energy gap implies very low local oscillator power requirements for heterodyne operation. Some general system design considerations for astrophysical receivers are reviewed. These principles are illustrated by discussing two specific applications: a 230 GHz SIS receiver recently installed as a facility instrument at the Swedish-ESO submillimeter telescope in Chile, and the broader receiver requirements of the 6-antenna submillimeter array (SMA), an interferometer now being designed at the Harvard-Smithsonian Center for Astrophysics. The SMA will require receivers at frequencies as high as 820 GHz, and will place some unique demands on detector performance.
ABSTRACT: Active superconducting circuits based on picoseconds switching, i.e. THz oscillating, Josephson tunnel junctions are expected to find a large domain of applications in spatial sub-millimeter wave and FIR detectors as well as in satellite based wideband signal and data processors. In the first case SIS (superconductor-insulator-superconductor) tunnel junctions are required, while in the second case SNS (superconductor-normal metal-superconductor) self-shunted junctions are preferred. We present the advantages of the nitride junction technology currently developed at CEA-Grenoble, based on high-performance MTS (medium temperature superconductor) NbN films in both SIS and SNS junctions. In the SIS case the device performances rely on a sputter deposited and post-annealed, only 0.5-0.7 nm thick, dielectric MgO barrier. This leads to junctions with a Josephson critical current in the range of 10-25 kA/cm, and a large superconducting energy gap (> 5 meV) associated with a low sub-gap quasi-particle leakage current. These parameters are suitable for low “noise temperature ” heterodyne mixers, local oscillators, and integrated receivers in the 0.8 to 1.4 THz frequency range. In the SNS case, a new