Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Applied Superconductivity

Optical input/output interface system for Josephson junction integrated circuits

K. Nakahara, Hideyuki Nagaishi, Hiroaki HASEGAWA, S. Kominami, Hirotaka Yamada, T. Nishino

Published Jan 1, 1994• 10 citations
Publisher

Abstract

An optical input/output interface system for a Josephson junction integrated circuit is fabricated and tested. The system consists of a superconducting optical detector, a dc powered Josephson circuit, a dc powered Josephson high voltage circuit, a liquid-He-cooled semiconductor amplifier, and a liquid-He-cooled semiconductor laser. Features of the system are use of an ultrathin NbN film for the optical detector and adoption of the dc powered Josephson circuits for logic operation circuits. Correct optical output signal is detected by a liquid-He-cooled semiconductor photodiode. The optical input/output interface has the advantage of low heat penetration and low crosstalk compared to the interface using conventional coaxial lines. Moreover, dc powered Josephson circuits have an advantage of low crosstalk from power supply lines compared to conventional Josephson circuits, which are driven by ac supply current.>

DOI
10.1109/77.334963

Related papers

Optical data communication between Josephson-junction circuits and room-temperature electronics

Bart Van Zeghbroeck

The feasibility of optical data transmission to and from Josephson junction circuits, using metal-semiconductor-metal (MSM) photodiodes and GaAs/AlGaAs semiconductor laser diodes with sub-mA threshold current, is demonstrated. Standard devices can be used with the exception of a cooled GaAs detector. It is shown that silicon MSM detectors compatible with Josephson junction circuits can be fabricated. While these detectors show large photoconductive effects at room temperature they behave as good-quality photodiodes at low temperatures. Power dissipation in the laser diode scales with temperature while maintaining the modulation frequency. It is also shown that the combination of a laser diode and a photodiode provides the voltage gain needed to interface Josephson-junction circuits with room-temperature electronics. Experimental results on MSM detectors and laser diodes are presented. Expected power dissipation is below 1 mW per input/output (I/O) at a data rate of 1 Gb/s.>

IEEE Transactions on Applied Superconductivity•Mar 1, 1993•15 citations

Optical Responses of Josephson Vortex Flow Transistors under Irradiation of Femtosecond Laser Pulses

Yasushi Doda, Iwao Kawayama, Hironaru Murakami +1 more

We have fabricated Josephson vortex flow transistors (JVFTs) that consist of a parallel array of Josephson junctions and a control current line to apply the external magnetic field at the junctions. We observed modulations of the flow voltage with a DC current input. From these results, we estimated the mutual inductance and the self-inductance, and calculated the operation frequency of the JVFT. Next, femtosecond laser pulses modulated by an optical chopper were irradiated to the Josephson junction array. As a result, we observed an increase in the output voltage in the current-voltage characteristics, and the clear modulation of the output voltage with the same period as the optical chopping rate. These results suggest that a JFVT can operate as an optical input interface for superconducting circuits.

Japanese Journal of Applied Physics•Apr 1, 2007•3 citations

Magneto-optical modulator for the superconducting digital output interface

Roberto Rey-de-Castro

Josephson-junction-based low temperature rapid single flux quantum (RSFQ) superconducting electronics is already a mature technology, which is expected to perform at speeds exceeding 100 GHz [1]. However, the RSFQ technology still lacks a fast enough output interface between its operating circuit temperature T = 4.2 K and the room temperature electronic environment. RSFQ circuits work at liquid helium temperatures and the direct interconnection of these circuits and room temperature circuits using, e.g., copper transmission lines would consume too much of the cooling power [2]. To solve this problem a magneto-optical (MO) output interface has been proposed [3], in which the output current pulse from the RSFQ circuit is converted into an optical pulse and delivered to room temperature readout circuitry via an optical fiber.

Opto-Canada: SPIE Regional Meeting on Optoelectronics, Photonics, and Imaging•Aug 29, 2017•1 citation

An interface circuit for a Josephson-CMOS hybrid digital system

Makoto Suzuki, Masaaki Maezawa, Hidetaka Takato +6 more

For broadband data communication between Josephson and CMOS digital systems, amplification of small Josephson-output signals and synchronization between the systems are important issues. We present an interface circuit for a Josephson-CMOS hybrid digital system. The interface circuit consists of a parallel-in-parallel-out (PIPO) circuit and built-in Josephson-MOS amplifiers. The PIPO circuit, implemented based on 4JL latching logic technology, performs synchronized data transfer between the Josephson and CMOS circuits. The Josephson-MOS amplifiers consists of stacked Josephson junctions (Suzuki stacks) and MOS inverters which are monolithically integrated on a chip. The circuits have been designed, fabricated and tested. We have successfully confirmed correct operation of the circuits.

IEEE Transactions on Applied Superconductivity•Jun 1, 1999•21 citations

Ultrafast, integrable, optics-based interface between superconducting and room-temperature electronics

Chia-Chi Wang, Marc Currie, T.Y. Hsiang

An ultrafast optical interface between superconducting and room-temperature electronics is proposed to take full advantage of high-speed superconducting circuits. We report on the computed and experimental studies of an optical receiving and modulating system that is compatible in processing with the prevailing integrated-superconducting-circuit technology. Planar interdigitated Nb/Si/Nb metal-semiconductor-metal (MSM) photodiodes are demonstrated as optical receivers with resolvable bit-rate as high as 38 Gb/s, and the response of MSM diode was shaped to be a single-flux-quantum pulse to drive Josephson-junction-based circuits. A similar interdigitated structure on a silicon waveguide is proposed to be an ultrafast light-intensity modulator, with its operation based on carrier-density modulation of the optical index of refraction. This field-effect device has insignificant power dissipation, in addition to high speed. A sample modulator with 5-V bias is shown to have a modulation depth of 40% and a bandwidth over 70 GHz.>

IEEE Transactions on Applied Superconductivity•Jun 1, 1995•5 citations

Superconducting Optoelectronic Neurons IV: Transmitter Circuits

Jeffrey M. Shainline, Adam N. McCaughan, Sonia Mary Buckley +2 more

A superconducting optoelectronic neuron will produce a small current pulse upon reaching threshold. We present an amplifier chain that converts this small current pulse to a voltage pulse sufficient to produce light from a semiconductor diode. This light is the signal used to communicate between neurons in the network. The amplifier chain comprises a thresholding Josephson junction, a relaxation oscillator Josephson junction, a superconducting thin-film current-gated current amplifier, and a superconducting thin-film current-gated voltage amplifier. We analyze the performance of the elements in the amplifier chain in the time domain to calculate the energy consumption per photon created for several values of light-emitting diode capacitance and efficiency. The speed of the amplification sequence allows neuronal firing up to at least 20\,MHz with power density low enough to be cooled easily with standard $^4$He cryogenic systems operating at 4.2\,K.

arXiv:1805.01941•May 4, 2018•8 citations
An optical input/output interface system for a Josephson junction integrated circuit is fabricated and tested. The system consists of a superconducting optical detector, a dc powered Josephson circuit, a dc powered Josephson high voltage circuit, a liquid-He-cooled semiconductor amplifier, and a liquid-He-cooled semiconductor laser. Features of the system are use of an ultrathin NbN film for the optical detector and adoption of the dc powered Josephson circuits for logic operation circuits. Correct optical output signal is detected by a liquid-He-cooled semiconductor photodiode. The optical input/output interface has the advantage of low heat penetration and low crosstalk compared to the interface using conventional coaxial lines. Moreover, dc powered Josephson circuits have an advantage of low crosstalk from power supply lines compared to conventional Josephson circuits, which are driven by ac supply current.>
The feasibility of optical data transmission to and from Josephson junction circuits, using metal-semiconductor-metal (MSM) photodiodes and GaAs/AlGaAs semiconductor laser diodes with sub-mA threshold current, is demonstrated. Standard devices can be used with the exception of a cooled GaAs detector. It is shown that silicon MSM detectors compatible with Josephson junction circuits can be fabricated. While these detectors show large photoconductive effects at room temperature they behave as good-quality photodiodes at low temperatures. Power dissipation in the laser diode scales with temperature while maintaining the modulation frequency. It is also shown that the combination of a laser diode and a photodiode provides the voltage gain needed to interface Josephson-junction circuits with room-temperature electronics. Experimental results on MSM detectors and laser diodes are presented. Expected power dissipation is below 1 mW per input/output (I/O) at a data rate of 1 Gb/s.>
We have fabricated Josephson vortex flow transistors (JVFTs) that consist of a parallel array of Josephson junctions and a control current line to apply the external magnetic field at the junctions. We observed modulations of the flow voltage with a DC current input. From these results, we estimated the mutual inductance and the self-inductance, and calculated the operation frequency of the JVFT. Next, femtosecond laser pulses modulated by an optical chopper were irradiated to the Josephson junction array. As a result, we observed an increase in the output voltage in the current-voltage characteristics, and the clear modulation of the output voltage with the same period as the optical chopping rate. These results suggest that a JFVT can operate as an optical input interface for superconducting circuits.
Josephson-junction-based low temperature rapid single flux quantum (RSFQ) superconducting electronics is already a mature technology, which is expected to perform at speeds exceeding 100 GHz [1]. However, the RSFQ technology still lacks a fast enough output interface between its operating circuit temperature T = 4.2 K and the room temperature electronic environment. RSFQ circuits work at liquid helium temperatures and the direct interconnection of these circuits and room temperature circuits using, e.g., copper transmission lines would consume too much of the cooling power [2]. To solve this problem a magneto-optical (MO) output interface has been proposed [3], in which the output current pulse from the RSFQ circuit is converted into an optical pulse and delivered to room temperature readout circuitry via an optical fiber.
For broadband data communication between Josephson and CMOS digital systems, amplification of small Josephson-output signals and synchronization between the systems are important issues. We present an interface circuit for a Josephson-CMOS hybrid digital system. The interface circuit consists of a parallel-in-parallel-out (PIPO) circuit and built-in Josephson-MOS amplifiers. The PIPO circuit, implemented based on 4JL latching logic technology, performs synchronized data transfer between the Josephson and CMOS circuits. The Josephson-MOS amplifiers consists of stacked Josephson junctions (Suzuki stacks) and MOS inverters which are monolithically integrated on a chip. The circuits have been designed, fabricated and tested. We have successfully confirmed correct operation of the circuits.
An ultrafast optical interface between superconducting and room-temperature electronics is proposed to take full advantage of high-speed superconducting circuits. We report on the computed and experimental studies of an optical receiving and modulating system that is compatible in processing with the prevailing integrated-superconducting-circuit technology. Planar interdigitated Nb/Si/Nb metal-semiconductor-metal (MSM) photodiodes are demonstrated as optical receivers with resolvable bit-rate as high as 38 Gb/s, and the response of MSM diode was shaped to be a single-flux-quantum pulse to drive Josephson-junction-based circuits. A similar interdigitated structure on a silicon waveguide is proposed to be an ultrafast light-intensity modulator, with its operation based on carrier-density modulation of the optical index of refraction. This field-effect device has insignificant power dissipation, in addition to high speed. A sample modulator with 5-V bias is shown to have a modulation depth of 40% and a bandwidth over 70 GHz.>
A superconducting optoelectronic neuron will produce a small current pulse upon reaching threshold. We present an amplifier chain that converts this small current pulse to a voltage pulse sufficient to produce light from a semiconductor diode. This light is the signal used to communicate between neurons in the network. The amplifier chain comprises a thresholding Josephson junction, a relaxation oscillator Josephson junction, a superconducting thin-film current-gated current amplifier, and a superconducting thin-film current-gated voltage amplifier. We analyze the performance of the elements in the amplifier chain in the time domain to calculate the energy consumption per photon created for several values of light-emitting diode capacitance and efficiency. The speed of the amplification sequence allows neuronal firing up to at least 20\,MHz with power density low enough to be cooled easily with standard 4^44He cryogenic systems operating at 4.2\,K.