Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Nanotechnology

Modelling single-electron-transistor-based readout in the Kane solid-state quantum computer

Chris I. Pakes, Vincent I. Conrad, J C Ang, F Green, Andrew S. Dzurak, Lloyd C. L. Hollenberg, David N. Jamieson, Robert G. Clark

Published Jan 10, 2003• 5 citations
Publisher

Abstract

The Kane (Kane B E 1998 Nature 393 133) solid-state quantum computer aims to exploit as qubits an array of 31 P nuclear spins embedded in a silicon matrix. A proposed scheme for readout of a qubit spin state relies on measurement of the associated spin state of its donor electron, by attempting to induce and detect, using a single-electron transistor (SET), spin-polarized motion of the electron to an adjacent donor site. The sensitivity required of a SET for detection of sub-surface electronic charge motion in a MOS architecture is examined by simulation of the capacitive coupling of the buried charge to the SET device. It is shown that the SET can support readout of the qubit electronic charge states within the appropriate electron spin relaxation time. This paper presents a novel application of Technology Computer Aided Design, which presents itself as a valuable tool for the design of nanoscale device architectures employing precision electrometry for readout of quantum logic states.

DOI
10.1088/0957-4484/14/2/312

Related papers

Nanoscale single-electron transistor architectures for single spin detection in solid state quantum computer devices

Tilo M. Buehler, R. Brenner, D. J. Reilly +3 more

Single-spin detection will be crucial for solid-state quantum computer architectures in which information is encoded in the spin-state of single nuclear or electron spins. The formidable problem of single-spin detection in a solid can be mapped to a more tractable problem of single-charge detection through spin-dependent electron transfer which may be observed using ultra-sensitive solid-state nanostructure electrometers. Here we describe a readout architecture using single electron transistors (SETs) that can detect the charge-state of two coupled metal dots, which simulates charge transfer in a two-quantum bit (qubit) spin system. This twin-SET architecture allows significant reduction of random charge noise by correlating two detector outputs, reducing the probability of readout errors in the quantum computer.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Nov 19, 2001•0 citations

Modeling of electrostatic gate operations in the Kane solid state quantum computer

Chris I. Pakes, Cameron J. Wellard, David N. Jamieson +5 more

The nuclear spin quantum computer proposed by Kane1 exploits as a qubit array 31P dopants embedded within a silicon matrix. Single-qubit operations are controlled by the application of electrostatic potentials via a set of metallic A gates, situated above the donors, on the silicon surface, that tune the resonance frequency of individual nuclear spins, and a globally applied RF magnetic field that flips spins at resonance. Coupling between qubits is controlled by the application of potentials via a set of J gates, between the donors, that induce an electron-mediated coupling between nuclear spins. We report the results of a study of the electric field and potential profiles arising within the Kane device from typical gate operations. The extent to which a single nuclear spin can be tuned independently of its neighbours, by operation of an associated A-gate, is examined and key design parameters in the Kane architecture are addressed. Implications for current fabrication strategies involving the implantation of 31P atoms are discussed. Solution of the Poisson equation has been carried out by simulation using a TCAD modeling package (Integrated Systems Engineering AG).

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Nov 21, 2001•1 citation

Single-electron transistor architectures for charge motion detection in solid-state quantum computer devices

T M B hler, R. Brenner, D. J. Reilly +3 more

Single-spin detection will be crucial for solid-state quantum computer (QC) architectures in which information is encoded in the spin state of single nuclear or electron spins. The formidable problem of single-spin detection in a solid can be mapped to a more tractable problem of single-charge detection through spin-dependent electron transfer which may be observed using ultrasensitive solid-state nanostructure electrometers. Here we describe a read-out architecture using single-electron transistors (SETs) that can detect the charge state of two coupled metal dots, which simulates charge transfer in a two-quantum-bit (qubit) spin system. This twin-SET architecture allows significant reduction of random charge noise by correlating two detector outputs, reducing the probability of read-out errors in the QC.

Smart Materials and Structures•Sep 20, 2002•3 citations

Correlated charge detection for readout of a solid-state quantum computer

Tilo M. Buehler, D. J. Reilly, R. Brenner +3 more

The single-electron transistor (SET) is a prime candidate for reading out the final state of a qubit in a solid-state quantum computer. Such a measurement requires the detection of subelectron charge motion in the presence of random charging events. We present a detection scheme where the signals from two SETs are cross-correlated to suppress unwanted artifacts due to charge noise. This technique is demonstrated by using the two SETs to detect the charge state of two coupled metal dots, thereby simulating charge transfer and readout in a two-qubit system. These measurements indicate that for comparable buried dopant semiconductor architectures, the minimum measurement time required to distinguish between the two charge states is of the order of 10 ns.

arXiv:cond-mat/0207597•Applied Physics Letters•Jan 23, 2003•43 citations

Multiplexing single electron transistors for application in scalable solid-state quantum computing

Vincent I. Conrad, Andrew D. Greentree, Lloyd C. L. Hollenberg

Single electron transistors (SETs) are nanoscale electrometers of unprecedented sensitivity, and as such have been proposed as readout devices in a number of quantum computer architectures. The authors show that the functionality of a standard SET can be multiplexed so as to operate as both readout device and control gate for solid-state qubit systems based on charge localization and spin-charge transduction. Such multiplexing offers new possibilities for gate density reduction in nanoscale devices, and may therefore play a role in scalable quantum computer architectures.

arXiv:cond-mat/0608652•Applied Physics Letters•Jan 22, 2007•9 citations

A High-Sensitivity Charge Sensor for Silicon Qubits above 1 K

Jonathan Y. Huang, Wee Han Lim, Ross C. C. Leon +6 more

Recent studies of silicon spin qubits at temperatures above 1 K are encouraging demonstrations that the cooling requirements for solid-state quantum computing can be considerably relaxed. However, qubit readout mechanisms that rely on charge sensing with a single-island single-electron transistor (SISET) quickly lose sensitivity due to thermal broadening of the electron distribution in the reservoirs. Here we exploit the tunneling between two quantized states in a double-island single-electron transistor (SET) to demonstrate a charge sensor with an improvement in the signal-to-noise ratio by an order of magnitude compared to a standard SISET, and a single-shot charge readout fidelity above 99% up to 8 K at a bandwidth greater than 100 kHz. These improvements are consistent with our theoretical modeling of the temperature-dependent current transport for both types of SETs. With minor additional hardware overhead, these sensors can be integrated into existing qubit architectures for a high-fidelity charge readout at few-kelvin temperatures.

arXiv:2103.06433•Nano Letters•May 17, 2021•17 citations
The Kane (Kane B E 1998 Nature 393 133) solid-state quantum computer aims to exploit as qubits an array of 31 P nuclear spins embedded in a silicon matrix. A proposed scheme for readout of a qubit spin state relies on measurement of the associated spin state of its donor electron, by attempting to induce and detect, using a single-electron transistor (SET), spin-polarized motion of the electron to an adjacent donor site. The sensitivity required of a SET for detection of sub-surface electronic charge motion in a MOS architecture is examined by simulation of the capacitive coupling of the buried charge to the SET device. It is shown that the SET can support readout of the qubit electronic charge states within the appropriate electron spin relaxation time. This paper presents a novel application of Technology Computer Aided Design, which presents itself as a valuable tool for the design of nanoscale device architectures employing precision electrometry for readout of quantum logic states.
Single-spin detection will be crucial for solid-state quantum computer architectures in which information is encoded in the spin-state of single nuclear or electron spins. The formidable problem of single-spin detection in a solid can be mapped to a more tractable problem of single-charge detection through spin-dependent electron transfer which may be observed using ultra-sensitive solid-state nanostructure electrometers. Here we describe a readout architecture using single electron transistors (SETs) that can detect the charge-state of two coupled metal dots, which simulates charge transfer in a two-quantum bit (qubit) spin system. This twin-SET architecture allows significant reduction of random charge noise by correlating two detector outputs, reducing the probability of readout errors in the quantum computer.
The nuclear spin quantum computer proposed by Kane1 exploits as a qubit array 31P dopants embedded within a silicon matrix. Single-qubit operations are controlled by the application of electrostatic potentials via a set of metallic A gates, situated above the donors, on the silicon surface, that tune the resonance frequency of individual nuclear spins, and a globally applied RF magnetic field that flips spins at resonance. Coupling between qubits is controlled by the application of potentials via a set of J gates, between the donors, that induce an electron-mediated coupling between nuclear spins. We report the results of a study of the electric field and potential profiles arising within the Kane device from typical gate operations. The extent to which a single nuclear spin can be tuned independently of its neighbours, by operation of an associated A-gate, is examined and key design parameters in the Kane architecture are addressed. Implications for current fabrication strategies involving the implantation of 31P atoms are discussed. Solution of the Poisson equation has been carried out by simulation using a TCAD modeling package (Integrated Systems Engineering AG).
Single-spin detection will be crucial for solid-state quantum computer (QC) architectures in which information is encoded in the spin state of single nuclear or electron spins. The formidable problem of single-spin detection in a solid can be mapped to a more tractable problem of single-charge detection through spin-dependent electron transfer which may be observed using ultrasensitive solid-state nanostructure electrometers. Here we describe a read-out architecture using single-electron transistors (SETs) that can detect the charge state of two coupled metal dots, which simulates charge transfer in a two-quantum-bit (qubit) spin system. This twin-SET architecture allows significant reduction of random charge noise by correlating two detector outputs, reducing the probability of read-out errors in the QC.
The single-electron transistor (SET) is a prime candidate for reading out the final state of a qubit in a solid-state quantum computer. Such a measurement requires the detection of subelectron charge motion in the presence of random charging events. We present a detection scheme where the signals from two SETs are cross-correlated to suppress unwanted artifacts due to charge noise. This technique is demonstrated by using the two SETs to detect the charge state of two coupled metal dots, thereby simulating charge transfer and readout in a two-qubit system. These measurements indicate that for comparable buried dopant semiconductor architectures, the minimum measurement time required to distinguish between the two charge states is of the order of 10 ns.
Single electron transistors (SETs) are nanoscale electrometers of unprecedented sensitivity, and as such have been proposed as readout devices in a number of quantum computer architectures. The authors show that the functionality of a standard SET can be multiplexed so as to operate as both readout device and control gate for solid-state qubit systems based on charge localization and spin-charge transduction. Such multiplexing offers new possibilities for gate density reduction in nanoscale devices, and may therefore play a role in scalable quantum computer architectures.
Recent studies of silicon spin qubits at temperatures above 1 K are encouraging demonstrations that the cooling requirements for solid-state quantum computing can be considerably relaxed. However, qubit readout mechanisms that rely on charge sensing with a single-island single-electron transistor (SISET) quickly lose sensitivity due to thermal broadening of the electron distribution in the reservoirs. Here we exploit the tunneling between two quantized states in a double-island single-electron transistor (SET) to demonstrate a charge sensor with an improvement in the signal-to-noise ratio by an order of magnitude compared to a standard SISET, and a single-shot charge readout fidelity above 99% up to 8 K at a bandwidth greater than 100 kHz. These improvements are consistent with our theoretical modeling of the temperature-dependent current transport for both types of SETs. With minor additional hardware overhead, these sensors can be integrated into existing qubit architectures for a high-fidelity charge readout at few-kelvin temperatures.