Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Physics Letters

Extraordinary optical gain from silicon implanted with erbium

Manon A. Lourenco, R. Gwilliam, Kevin Peter Homewood

Published Oct 1, 2007• 25 citations
Publisher

Abstract

Here we report on measurements of optical gain at 1.5μm in crystalline silicon. Gain is achieved by the incorporation of the rare earth erbium in silicon. A method was developed to enable the gain measurement in short silicon waveguides. Crucially, gain values obtained are significantly greater than previously supposed. We have measured a lower limit for the optical cross section for Er3+ of 5×10−19cm2, 30 times higher than previously anticipated. Given these higher values, this system now offers a realistic route to the production of electrically pumped silicon optical amplifier and laser devices using standard silicon process technology.

DOI
10.1063/1.2797975

Related papers

Energy transfer in erbium doped optical waveguides based on silicon

Pieter G. Kik

Energy transfer in erbium doped optical waveguides based on silicon This thesis describes the energy transfer processes\noccurring in materials that can be used for the fabrication of silicon compatible optical integrated circuits, operating at 1.54 mm.The thesis consists of three parts: Part I discusses energy transfer in optical waveguide amplifiers on silicon. The waveguide amplifiers use an intra-4f transition of the rare earth ion erbium occurring at 1.54 mm. To achieve significant amplification, high\n Er concentrations (> 10 20 cm -3 ) are required. At these concentrations Er ions can interact, resulting in co-operative\n upconversion, in which one excited Er ion is excited into a higher energy state, while a neighboring Er ion returns to the ground\n state. In Part I this and other gain limiting effects are investigated. In particular, it is shown that the atomic-scale Er distribution\n is of crucial importance for the performance of Er doped waveguide amplifiers. Part II discusses the energy transfer processes\n occurring in Er doped silicon. It is shown that Er in silicon can be excited by electron-hole pair recombination in an\n impurity-Auger effect. This effect may be used to fabricate an electrically pumped Er doped waveguide amplifier. The reverse\n process can also occur: an excited Er ion can de-excite and generate an electron-hole pair in the silicon, due to a non-radiative\n backtransfer process. This process has an efficiency of 70% at room temperature. This observation enables the fabrication of an\n Er doped photo-detector in a Si waveguide operating at 1.54 mm. The performance of such a detector is discussed. Part III\n discusses the interaction between Er and silicon nanocrystals embedded in SiO2. Si nanocrystals efficiently absorb visible light,\n resulting in the generation of quantum confined electron-hole pairs. The electron-hole pairs efficiently transfer energy to Er.\n Due to the energy transfer, the effective Er absorption cross section is five orders of magnitude larger than for direct optical\n excitation. Silicon nanocrystals may thus be used to increase the pumping efficiency of an Er doped waveguide amplifier. It is\n shown that a single nanocrystal can excite ~1 Er ion at a time and that an optical gain of 0.6 dB/cm may be achieved in a typical\n nanocrystal sensitized waveguide amplifier. Due to the broad absorption band of Si nanocrystals, a broad band light source can\n be used as pump source in such a nanocrystal sensitized Er doped waveguide amplifier.

•Sep 18, 2000•11 citations

A theoretical investigation of the optical gain in waveguide based on a silica matrix containing silicon nanograins and doped either withNd3+ or with Er3+ ions

Alexandre Fafin, Julien Cardin, Christian Dufour +1 more

We aim to amplify a signal in a strip loaded waveguide composed by an active silica layer co-doped with silicon nanograins and rare-earth ions deposited on a silica cladding layer and topped by a silica strip. The signal wavelength corresponds to the transition wavelength between two energy levels of a rare earth ions. To achieve an efficient population inversion, the rare earth ions benefit from the indirect excitation via silicon nanograins which show an absorption cross section fourfold higher than the one of rare earth ions. In order to study the influence of the type of rare earth on the optical gain, we consider two rare earth ions : neodymium ions (Nd3+) for a signal wavelength at 1060 nm and erbium ions (Er3+) for a signal wavelength at 1540 nm. The optical gain is simulated using a modified two loops auxiliary-differential equation and finite-difference time-domain (ADE-FDTD) algorithm. Within this new scheme we can compute the steady state levels populations as well as the spatial distribution of the guided field in the waveguide whatever the populations levels lifetime considered. We also calculate the gross gain as well as the net gain by taking into account the experimental background losses. We demonstrate that a significant positive net gain can only be achieved with the Nd3+ doped waveguide up to 30 dB/cm for a pump power density of 10^4 mW/mm².

•May 11, 2015•0 citations

Recent Progress in On-Chip Erbium-Based Light Sources

Bo Wang, Peiqi Zhou, Xingjun Wang

In recent years, silicon photonics has achieved great success in optical communication area. More and more on-chip optoelectronic devices have been realized and commercialized on silicon photonics platform, such as silicon-based modulators, filters and detectors. However, on-chip light sources are still not achieved because that silicon is an indirect bandgap material. To solve this problem, the rare earth element erbium (Er) is considered, which emits light covering 1.5 μm to 1.6 μm and has been widely used in fiber amplifiers. Compared to Er-doped fiber amplifiers (EDFA), the Er ion concentration needs to be more than two orders higher for on-chip Er-based light sources due to the compact size integration requirements. Therefore, the choice of the host material is crucially important. In this paper, we review the recent progress in on-chip Er-based light sources and the advantages and disadvantages of different host materials are compared and analyzed. Finally, the existing challenges and development directions of the on-chip Er-based light sources are discussed.

Applied Sciences•Nov 18, 2022•14 citations

Limit to the erbium ions emission in silicon-rich oxide films by erbium ion clustering

N. Prtljaga, Daniel Navarro‐Urrios, A. Tengattini +8 more

We have fabricated a series of thin (~50 nm) erbium-doped (by ion implantation) silicon-rich oxide films in the configuration that mitigates previously proposed mechanisms for loss of light emission capability of erbium ions. By combining the methods of optical, structural and electrical analysis, we identify the erbium ion clustering as a driving mechanism to low optical performance of this material. Experimental findings in this work clearly evidence inadequacy of the commonly employed optimization procedure when optical amplification is considered. We reveal that the significantly lower erbium ion concentrations are to be used in order to fully exploit the potential of this approach and achieve net optical gain.

Optical Materials Express•Aug 21, 2012•29 citations

Achieving optical gain in waveguide-confined nanocluster-sensitized erbium by pulsed excitation

Gerald M. Miller, Ryan M. Briggs, Harry A. Atwater

We use a rate equation approach to model the conditions for optical gain in nanocluster sensitized erbium in a slot waveguide geometry. We determine the viability of achieving net gain for the range of reported values of the carrier absorption cross section for silicon nanoclusters. After accounting for the local density of optical states modification of the emission rates, we find that gain is impossible in continuous wave pumping due to carrier absorption, regardless of the carrier absorption cross section. We, therefore, propose a pulsed electrical operation scheme which mitigates carrier absorption by taking advantage of the short lifetime of silicon nanoclusters compared to erbium. We show that pulsed excitation of a 10 nm layer achieves a modal gain of 0.9 dB/cm during each pulse. Furthermore this gain can be increased to 2 dB/cm by pumping a 50 nm layer.

Journal of Applied Physics•Sep 15, 2010•23 citations

Erbium-doped Rare-Earth Oxide Thin Film Waveguides for Integrated Quantum Photonic Devices

Xuejun Xu, Masaya Hiraishi, Tomohiro Inaba +7 more

We have developed a low-loss waveguide platform for erbium-doped rare-earth oxide thin films grown on silicon substrate and investigated optical properties of erbium ions in waveguides at cryogenic temperature, aiming for integrated quantum photonic devices.

Conference on Lasers and Electro-Optics Pacific Rim (CLEO-PR)•Jan 1, 2022•0 citations
Here we report on measurements of optical gain at 1.5μm in crystalline silicon. Gain is achieved by the incorporation of the rare earth erbium in silicon. A method was developed to enable the gain measurement in short silicon waveguides. Crucially, gain values obtained are significantly greater than previously supposed. We have measured a lower limit for the optical cross section for Er3+ of 5×10−19cm2, 30 times higher than previously anticipated. Given these higher values, this system now offers a realistic route to the production of electrically pumped silicon optical amplifier and laser devices using standard silicon process technology.
Energy transfer in erbium doped optical waveguides based on silicon This thesis describes the energy transfer processes\noccurring in materials that can be used for the fabrication of silicon compatible optical integrated circuits, operating at 1.54 mm.The thesis consists of three parts: Part I discusses energy transfer in optical waveguide amplifiers on silicon. The waveguide amplifiers use an intra-4f transition of the rare earth ion erbium occurring at 1.54 mm. To achieve significant amplification, high\n Er concentrations (> 10 20 cm -3 ) are required. At these concentrations Er ions can interact, resulting in co-operative\n upconversion, in which one excited Er ion is excited into a higher energy state, while a neighboring Er ion returns to the ground\n state. In Part I this and other gain limiting effects are investigated. In particular, it is shown that the atomic-scale Er distribution\n is of crucial importance for the performance of Er doped waveguide amplifiers. Part II discusses the energy transfer processes\n occurring in Er doped silicon. It is shown that Er in silicon can be excited by electron-hole pair recombination in an\n impurity-Auger effect. This effect may be used to fabricate an electrically pumped Er doped waveguide amplifier. The reverse\n process can also occur: an excited Er ion can de-excite and generate an electron-hole pair in the silicon, due to a non-radiative\n backtransfer process. This process has an efficiency of 70% at room temperature. This observation enables the fabrication of an\n Er doped photo-detector in a Si waveguide operating at 1.54 mm. The performance of such a detector is discussed. Part III\n discusses the interaction between Er and silicon nanocrystals embedded in SiO2. Si nanocrystals efficiently absorb visible light,\n resulting in the generation of quantum confined electron-hole pairs. The electron-hole pairs efficiently transfer energy to Er.\n Due to the energy transfer, the effective Er absorption cross section is five orders of magnitude larger than for direct optical\n excitation. Silicon nanocrystals may thus be used to increase the pumping efficiency of an Er doped waveguide amplifier. It is\n shown that a single nanocrystal can excite ~1 Er ion at a time and that an optical gain of 0.6 dB/cm may be achieved in a typical\n nanocrystal sensitized waveguide amplifier. Due to the broad absorption band of Si nanocrystals, a broad band light source can\n be used as pump source in such a nanocrystal sensitized Er doped waveguide amplifier.
We aim to amplify a signal in a strip loaded waveguide composed by an active silica layer co-doped with silicon nanograins and rare-earth ions deposited on a silica cladding layer and topped by a silica strip. The signal wavelength corresponds to the transition wavelength between two energy levels of a rare earth ions. To achieve an efficient population inversion, the rare earth ions benefit from the indirect excitation via silicon nanograins which show an absorption cross section fourfold higher than the one of rare earth ions. In order to study the influence of the type of rare earth on the optical gain, we consider two rare earth ions : neodymium ions (Nd3+) for a signal wavelength at 1060 nm and erbium ions (Er3+) for a signal wavelength at 1540 nm. The optical gain is simulated using a modified two loops auxiliary-differential equation and finite-difference time-domain (ADE-FDTD) algorithm. Within this new scheme we can compute the steady state levels populations as well as the spatial distribution of the guided field in the waveguide whatever the populations levels lifetime considered. We also calculate the gross gain as well as the net gain by taking into account the experimental background losses. We demonstrate that a significant positive net gain can only be achieved with the Nd3+ doped waveguide up to 30 dB/cm for a pump power density of 10^4 mW/mm².
In recent years, silicon photonics has achieved great success in optical communication area. More and more on-chip optoelectronic devices have been realized and commercialized on silicon photonics platform, such as silicon-based modulators, filters and detectors. However, on-chip light sources are still not achieved because that silicon is an indirect bandgap material. To solve this problem, the rare earth element erbium (Er) is considered, which emits light covering 1.5 μm to 1.6 μm and has been widely used in fiber amplifiers. Compared to Er-doped fiber amplifiers (EDFA), the Er ion concentration needs to be more than two orders higher for on-chip Er-based light sources due to the compact size integration requirements. Therefore, the choice of the host material is crucially important. In this paper, we review the recent progress in on-chip Er-based light sources and the advantages and disadvantages of different host materials are compared and analyzed. Finally, the existing challenges and development directions of the on-chip Er-based light sources are discussed.
We have fabricated a series of thin (~50 nm) erbium-doped (by ion implantation) silicon-rich oxide films in the configuration that mitigates previously proposed mechanisms for loss of light emission capability of erbium ions. By combining the methods of optical, structural and electrical analysis, we identify the erbium ion clustering as a driving mechanism to low optical performance of this material. Experimental findings in this work clearly evidence inadequacy of the commonly employed optimization procedure when optical amplification is considered. We reveal that the significantly lower erbium ion concentrations are to be used in order to fully exploit the potential of this approach and achieve net optical gain.
We use a rate equation approach to model the conditions for optical gain in nanocluster sensitized erbium in a slot waveguide geometry. We determine the viability of achieving net gain for the range of reported values of the carrier absorption cross section for silicon nanoclusters. After accounting for the local density of optical states modification of the emission rates, we find that gain is impossible in continuous wave pumping due to carrier absorption, regardless of the carrier absorption cross section. We, therefore, propose a pulsed electrical operation scheme which mitigates carrier absorption by taking advantage of the short lifetime of silicon nanoclusters compared to erbium. We show that pulsed excitation of a 10 nm layer achieves a modal gain of 0.9 dB/cm during each pulse. Furthermore this gain can be increased to 2 dB/cm by pumping a 50 nm layer.