Flux quantum states (FQS) of interferometers with up to ten equal Josephson point junctions are characterized in the phase and current plane. Their symmetry properties are derived. Simple formulas are given to design interferometers being equivalent to uniformly distributed Josephson junctions.
The operation of a constant-current quantum interferometer with two Josephson junctions is studied in a system for measuring small changes in a magnetic field with low-frequency modulation of the magnetic flux. Idealized theoretical signal characteristics are found together with their dependence on the operating mode and parameters of a SQUID. These characteristics are used in Pt. II (ref. 12) to determine the minimal detectable change in the magnetic flux, which characterizes the maximal sensitivity of a SQUID.
A single-junction superconducting quantum interferometer with external high-frequency excitation is considered, in which the weak coupling is described within the framework of the resistive model. An analysis for the hysteresis-free state serves to define the parameters characterizing the Josephson junction, including the current as a function of the phase difference at the junction, as well as the interference term in the dissipative component of the current. The theoretical results are compared with experiment to define certain parameters of the Josephson junction and the sign of the interference term.
Several models, both static and dynamic, for calculating the maximum dc Josephson current versus external magnetic field “characteristic” of tunnel junctions of various geometries are described. The static models have the advantage of short computation times; the dynamic models, although slower, yield additional information on circuit-switching times. The dependence of the characteristics on the junction shape is described. The accuracy of a one-dimensional approximation used in the models has been tested experimentally, and theoretically against a two-dimensional approximation. In both cases, the one-dimensional treatment yields quantitatively good agreement provided the inductance of the junction is included in the model. Junctions defined by an oxide “window” of sinusoidal shape (maximum and minimum width at the center and ends, respectively) have a characteristic in which the side lobes are almost completely suppressed. The characteristics of a wide variety of junction shapes, including interferometers having two or more junctions, have been accurately calculated, permitting the design of devices for specific purposes.
Josephson-junction interferometers have previously been proposed as memory devices in which information is stored as a single flux quantum, (SFQ). To investigate the feasibility of making large arrays of SFQ cells suitable for the memory of a cryogenic computer, arrays containing 80 interferometers have been made and measured. The prime objective was to determine the distribution of the dc Josephson current i1 within the arays and to compare it with the design value required for successful operation of all cells in high density arrays. The results show that a substantial fraction of the arrays has standard deviations in i1 less than the maximum allowable, thus demonstrating for the first time that such a memory can be made with present technology. The fabrication, measurement technique and a detailed analysis of the current distributions on the arrays are presented.