Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Limiting characteristics of a superconducting quantum interferometer. I. Signal characteristic

Eugene I. Butikov, S.P. Feofilov

Published Nov 1, 1980• 0 citations
OpenAlex

Abstract

The operation of a constant-current quantum interferometer with two Josephson junctions is studied in a system for measuring small changes in a magnetic field with low-frequency modulation of the magnetic flux. Idealized theoretical signal characteristics are found together with their dependence on the operating mode and parameters of a SQUID. These characteristics are used in Pt. II (ref. 12) to determine the minimal detectable change in the magnetic flux, which characterizes the maximal sensitivity of a SQUID.

Related papers

Limiting characteristics of a superconducting quantum interferometer. II. Signal-to-noise ratio

Eugene I. Butikov, S.P. Feofilov

In the approximation of small fluctuations, the spectral density of intrinsic thermal noise limiting the maximal sensitivity of a constant-current SQUID is found in the low-frequency region. The dependence of the signal-to-noise ratio on the SQUID parameters and operating conditions of an interferometer with low-frequency magnetic flux modulation is studied. Estimates are given for the smallest detectable magnetic flux corresponding to optimal operating conditions of a SQUID.

Soviet physics. Technical physics•Nov 1, 1980•0 citations

Limit characteristics of two-junction magnetic flux detector

Victor I. Danilov, K. K. Likharev, O. Sniguiriev +1 more

The sensitivity of a two-Josephson-junction interferometer as a magnetic flux detector (dc SQUID) is estimated. The minimum value of the basic SQUID characteristic-noise equivalent temperature δT = (δΦ)2/kBL appears to be as low as for the best rf SQUID mode:(\deltaT)_{\min}/(\Deltaf)\cong 3 T/f_{o}. HereTis an operating temperature, fois a characteristic frequency of the Josephson junctions and\Deltafis a post-detector bandwidth. For a typical value of SQUID inductance L this limit corresponds to flux sensitivity of the order of 10-7Φo/Hz1/2.

IEEE Transactions on Magnetics•Jan 1, 1977•8 citations

Superconducting single-junction interferometers with small critical currents

Paul K. Hansma

A simple theory of the superconducting single-junction interferometer (ac Squid) becomes possible if the critical current of the single junction is small relative to Φ0/LR, where Φ0=h/2e is one flux quantum and LR is the inductance of the interferometer loop. This theory predicts a magnetic flux sensitivity which has the same dependence on interferometer parameters as the existing theories for higher critical currents. In contrast to those theories, however, the present theory predicts that the maximum flux sensitivity will be achieved off resonance. Theoretical predictions for comparison with experiment are displayed as a function of the normalized difference between the operating frequency ω and the resonant frequency ω0.

Journal of Applied Physics•Sep 1, 1973•56 citations

On limiting magnetic field sensitivity of superconducting quantum interferometer with two Josephson junctions

С. И. Бондаренко

On limiting magnetic field sensitivity of superconducting quantum interferometer with two Josephson junctions was published in SQUID - Superconducting Quantum Interference Devices and their Applications on page 297.

De Gruyter eBooks•Dec 31, 1977•0 citations

dc SQUID's I–V Characteristics and Its Bias Modes

Yi Zhang, Hui Dong, Hans-Joachim Krause +2 more

The physics of a DC Superconducting QUantum Interference Device (SQUID) involves two phenomena: flux quantization and Josephson tunneling. This chapter describes how to measure and understand a SQUID's I–V characteristics. It also describes how to realize an ideal current source for biasing a SQUID and how to set up a practical voltage source to operate a SQUID in voltage bias mode. To study a DC SQUID's features, the first step is to obtain its I–V characteristics. In contrast to the I–V characteristics of the resistor or the diode, those of the SQUID are modulated by the applied flux but are limited within two flux states of integer and half-integer. An ideal current source is characterized by an internal resistance approaching infinity, compared to the SQUID's dynamic resistance. There are only two realized concepts for the SQUID operation in voltage bias mode.

Wiley eBooks•May 29, 2020•0 citations

Nonlocal superconducting quantum interference device

Taewan Noh, Andrew Kindseth, Venkat Chandrasekhar

Superconducting quantum interference devices (SQUIDs) that incorporate two superconductor/insulator/superconductor (SIS) Josephson junctions in a closed loop form the core of some of the most sensitive detectors of magnetic and electric fields currently available. SQUIDs in these applications are typically operated with a finite voltage which generates microwave radiation through the ac Josephson effect. This radiation may impact the system being measured. We describe here a SQUID in which the Josephson junctions are formed from strips of normal metal (N) in good electrical contact with the superconductor (S). Such SNS SQUIDs can be operated under a finite voltage bias with performance comparable or potentially better than conventional SIS SQUIDs. However, they also permit a mode of operation that is based on the unusual interplay of quasiparticle currents and supercurrents in the normal metal of the Josephson junction. The method allows measurements of the flux dependence of the critical current of the SNS SQUID without applying a finite voltage bias across the SNS junction, enabling sensitive flux detection without generating microwave radiation.

arXiv:2011.06667•Physical review. B./Physical review. B•Aug 4, 2021•13 citations
The operation of a constant-current quantum interferometer with two Josephson junctions is studied in a system for measuring small changes in a magnetic field with low-frequency modulation of the magnetic flux. Idealized theoretical signal characteristics are found together with their dependence on the operating mode and parameters of a SQUID. These characteristics are used in Pt. II (ref. 12) to determine the minimal detectable change in the magnetic flux, which characterizes the maximal sensitivity of a SQUID.
The sensitivity of a two-Josephson-junction interferometer as a magnetic flux detector (dc SQUID) is estimated. The minimum value of the basic SQUID characteristic-noise equivalent temperature δT = (δΦ)2/kBL appears to be as low as for the best rf SQUID mode:(\deltaT)_{\min}/(\Deltaf)\cong 3 T/f_{o}. HereTis an operating temperature, fois a characteristic frequency of the Josephson junctions and\Deltafis a post-detector bandwidth. For a typical value of SQUID inductance L this limit corresponds to flux sensitivity of the order of 10-7Φo/Hz1/2.
A simple theory of the superconducting single-junction interferometer (ac Squid) becomes possible if the critical current of the single junction is small relative to Φ0/LR, where Φ0=h/2e is one flux quantum and LR is the inductance of the interferometer loop. This theory predicts a magnetic flux sensitivity which has the same dependence on interferometer parameters as the existing theories for higher critical currents. In contrast to those theories, however, the present theory predicts that the maximum flux sensitivity will be achieved off resonance. Theoretical predictions for comparison with experiment are displayed as a function of the normalized difference between the operating frequency ω and the resonant frequency ω0.
The physics of a DC Superconducting QUantum Interference Device (SQUID) involves two phenomena: flux quantization and Josephson tunneling. This chapter describes how to measure and understand a SQUID's I–V characteristics. It also describes how to realize an ideal current source for biasing a SQUID and how to set up a practical voltage source to operate a SQUID in voltage bias mode. To study a DC SQUID's features, the first step is to obtain its I–V characteristics. In contrast to the I–V characteristics of the resistor or the diode, those of the SQUID are modulated by the applied flux but are limited within two flux states of integer and half-integer. An ideal current source is characterized by an internal resistance approaching infinity, compared to the SQUID's dynamic resistance. There are only two realized concepts for the SQUID operation in voltage bias mode.
Superconducting quantum interference devices (SQUIDs) that incorporate two superconductor/insulator/superconductor (SIS) Josephson junctions in a closed loop form the core of some of the most sensitive detectors of magnetic and electric fields currently available. SQUIDs in these applications are typically operated with a finite voltage which generates microwave radiation through the ac Josephson effect. This radiation may impact the system being measured. We describe here a SQUID in which the Josephson junctions are formed from strips of normal metal (N) in good electrical contact with the superconductor (S). Such SNS SQUIDs can be operated under a finite voltage bias with performance comparable or potentially better than conventional SIS SQUIDs. However, they also permit a mode of operation that is based on the unusual interplay of quasiparticle currents and supercurrents in the normal metal of the Josephson junction. The method allows measurements of the flux dependence of the critical current of the SNS SQUID without applying a finite voltage bias across the SNS junction, enabling sensitive flux detection without generating microwave radiation.