Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE International Conference on Terahertz Electronics (THz)

A planar SIS mixer for 400-500 GHz

Rudolf Nitsch, Karl Jacobs

Published Nov 27, 2002• 0 citations
Publisher

Abstract

We present a new planar SIS mixer for array applications in the 400-500 GHz range. The mixer consists of a double dipole antenna connnected to a pair of superconducting tunnel junctions by a novel tuning and matching structure. It is mounted in the focal plane of a silicon parabola collimating the broad double dipole beams into beams with f-numbers of /spl ap/13. Four mixers were built in an array configuration on a single substrate and two of them were tested. The receiver DSB noise temperatures are below 300 K in the 456-492 GHz range. The best results are 180 K and 163 K respectively at 473 GHz.

DOI
10.1109/thz.1998.731685

Related papers

A planar quasi-optical SIS receiver suitable for array applications

P. A. Stimson, Robert J. Dengler, Peter H. Siegel +1 more

A novel planar, quasi-optical SIS (superconductor-insulator-superconductor) receiver operating at 230 GHz is described. The receiver consists of a 2*5 array of half-wave dipole antennas with ten niobium-aluminium-oxide-niobium SIS junctions on a quartz dielectric-filled parabola. The 1.2-GHz intermediate frequency is coupled from the mixer via coplanar strip transmission lines and 4:1 balun transformers. The receiver is operated at 4.2 K in a liquid-helium immersion cryostat. Accurate measurements of the performance of single receiver elements are reported. A mixer noise temperature of 148 K DSB, receiver noise temperature of 259 K DSB, and conversion loss of 10 dB into a matched load have been obtained.>

IEEE MTT-S International Microwave Symposium digest•Jan 2, 2003•5 citations

A planar quasi-optical SIS receiver

P. A. Stimson, Robert J. Dengler, Henry George LeDuc +2 more

A planar, quasi-optical SIS (superconductor-insulator-superconductor) receiver operating at 230 GHz is described. The receiver consists of a 2*5 array of half-wave dipole antennas with niobium-aluminum oxide-niobium SIS junctions on a quartz dielectric-filled parabola. The 1.4-GHz intermediate frequency is coupled from the mixer via coplanar strip transmission lines and 4:1 balun transformers. The receiver is operated at 4.2 K in a liquid helium immersion cryostat. Accurate measurements of the performance of single untuned array receiver elements are reported. A mixer noise temperature of 89 K DSB (double sideband), receiver noise temperature of 156 K DSB and conversion loss of 8 dB into a matched load have been obtained. This mixer noise temperature is approximately a factor of two larger than that of current state of the art waveguide mixers using untuned single junctions a the same frequency.>

IEEE Transactions on Microwave Theory and Techniques•Apr 1, 1993•15 citations

A Superconducting Planar Integrated Receiver for the Frequency Range 430-480 GHz

S. V. Shitov, V. P. Koshelets, I.L. Lapitskaya +6 more

A planar receiver comprising a Josephson flux-flow oscillator (FF0), a double dipole antenna and a SIS mixer integrated on a single chip within an area of 3 x 3 mm has been realised in the frequency range of 400-500 GHz. RF tests have been performed at temperatures between 2 K and 4.2 K. A best DSB noise temperature of 595 K 20 K at 465 GHz was obtained for the receiver with the mixer pumped by the FFO. The width of the antenna beam has been measured referred to the input window of the cryostat and was about ± 4 degrees at the power level of about 20 dB. The power consumption of the whole device is estimated to be 20 p.W.

Softwaretechnik-Trends•Mar 1, 1995•1 citation

SIS-mixer development at SRON

J. Mees

Since several years waveguide and planar antenna SIS-mixers for space applications are developed at SRON in orderof ESA. Recent results show excellent mixer performance up to frequencies above the superconducting gap of Nb.Goal is the development of a 1THz-mixer. Best results show a receiver noise temperature of Taw=400K at 720GHz incase of the waveguide mixer and T„„=200K at 490GHz for the double dipole planar antenna mixer. We will presentthe status in the development of SIS-junctions, integrated tuning network, mixers and mounts.

International Conference on Infrared, Millimeter, and Terahertz Waves (IRMMW-THz)•Aug 30, 1993•0 citations

Sis-mixers around the gap frequency

J. Mees

Since several years waveguide and planar antenna mixers with Nb-tunnel junctions are developed at the Space Research Organization Netherlands (SRON) for space applications. Recent results show excellent mixing performance up to frequencies above the superconducting gap of Nb. Goal is the development of an 1THz-mixer. Best results show a receiver noise temperature of Tps,-----310K at 708GHz for a waveguide mixer and TE,s„---200K at 480GHz for a double dipole planar antenna mixer. Due to on-chip tuning structures we obtained bandwidths up to 150GHz. We will present the current status in the development of SIS-junctions, integrated tuning network and mixers.

International Conference on Millimeter and Submillimeter Waves and Applications 1994•Jan 1, 1994•1 citation

A 100-GHz fixed-tuned waveguide SIS mixer exhibiting broad bandwidth and very low noise temperature

Sheng-Gai Shi, Takashi Noguchi, Junji Inatani

This paper presents design and performance data for a 100-GHz waveguide superconductor-insulator-superconductor (SIS) mixer, which is incorporated with a twin-junction device (i.e., two identical junctions connected in parallel through a tuning inductance) and a fixed-tuned broad-band waveguide mixer mount. The 100-GHz mixer is actually developed as a prototype of the 500-GHz one. The constructed 100-GHz SIS receiver results in an overall receiver noise temperature (DSB) of less than 40 K over the frequency range from 80-120 GHz, with a minimum value of just 20 K that is four times as large as the quantum limit (i.e., 4/spl planck//spl omega//k). Such a performance is comparable or even superior to those of the best mechanically tunable waveguide SIS receivers at the same frequency band. In addition, some interesting mixing behaviors related to this two-junction device are described in detail.

IEEE Transactions on Applied Superconductivity•Jan 1, 1997•22 citations
We present a new planar SIS mixer for array applications in the 400-500 GHz range. The mixer consists of a double dipole antenna connnected to a pair of superconducting tunnel junctions by a novel tuning and matching structure. It is mounted in the focal plane of a silicon parabola collimating the broad double dipole beams into beams with f-numbers of /spl ap/13. Four mixers were built in an array configuration on a single substrate and two of them were tested. The receiver DSB noise temperatures are below 300 K in the 456-492 GHz range. The best results are 180 K and 163 K respectively at 473 GHz.
A novel planar, quasi-optical SIS (superconductor-insulator-superconductor) receiver operating at 230 GHz is described. The receiver consists of a 2*5 array of half-wave dipole antennas with ten niobium-aluminium-oxide-niobium SIS junctions on a quartz dielectric-filled parabola. The 1.2-GHz intermediate frequency is coupled from the mixer via coplanar strip transmission lines and 4:1 balun transformers. The receiver is operated at 4.2 K in a liquid-helium immersion cryostat. Accurate measurements of the performance of single receiver elements are reported. A mixer noise temperature of 148 K DSB, receiver noise temperature of 259 K DSB, and conversion loss of 10 dB into a matched load have been obtained.>
A planar, quasi-optical SIS (superconductor-insulator-superconductor) receiver operating at 230 GHz is described. The receiver consists of a 2*5 array of half-wave dipole antennas with niobium-aluminum oxide-niobium SIS junctions on a quartz dielectric-filled parabola. The 1.4-GHz intermediate frequency is coupled from the mixer via coplanar strip transmission lines and 4:1 balun transformers. The receiver is operated at 4.2 K in a liquid helium immersion cryostat. Accurate measurements of the performance of single untuned array receiver elements are reported. A mixer noise temperature of 89 K DSB (double sideband), receiver noise temperature of 156 K DSB and conversion loss of 8 dB into a matched load have been obtained. This mixer noise temperature is approximately a factor of two larger than that of current state of the art waveguide mixers using untuned single junctions a the same frequency.>
A planar receiver comprising a Josephson flux-flow oscillator (FF0), a double dipole antenna and a SIS mixer integrated on a single chip within an area of 3 x 3 mm has been realised in the frequency range of 400-500 GHz. RF tests have been performed at temperatures between 2 K and 4.2 K. A best DSB noise temperature of 595 K 20 K at 465 GHz was obtained for the receiver with the mixer pumped by the FFO. The width of the antenna beam has been measured referred to the input window of the cryostat and was about ± 4 degrees at the power level of about 20 dB. The power consumption of the whole device is estimated to be 20 p.W.
Since several years waveguide and planar antenna SIS-mixers for space applications are developed at SRON in orderof ESA. Recent results show excellent mixer performance up to frequencies above the superconducting gap of Nb.Goal is the development of a 1THz-mixer. Best results show a receiver noise temperature of Taw=400K at 720GHz incase of the waveguide mixer and T„„=200K at 490GHz for the double dipole planar antenna mixer. We will presentthe status in the development of SIS-junctions, integrated tuning network, mixers and mounts.
Since several years waveguide and planar antenna mixers with Nb-tunnel junctions are developed at the Space Research Organization Netherlands (SRON) for space applications. Recent results show excellent mixing performance up to frequencies above the superconducting gap of Nb. Goal is the development of an 1THz-mixer. Best results show a receiver noise temperature of Tps,-----310K at 708GHz for a waveguide mixer and TE,s„---200K at 480GHz for a double dipole planar antenna mixer. Due to on-chip tuning structures we obtained bandwidths up to 150GHz. We will present the current status in the development of SIS-junctions, integrated tuning network and mixers.
This paper presents design and performance data for a 100-GHz waveguide superconductor-insulator-superconductor (SIS) mixer, which is incorporated with a twin-junction device (i.e., two identical junctions connected in parallel through a tuning inductance) and a fixed-tuned broad-band waveguide mixer mount. The 100-GHz mixer is actually developed as a prototype of the 500-GHz one. The constructed 100-GHz SIS receiver results in an overall receiver noise temperature (DSB) of less than 40 K over the frequency range from 80-120 GHz, with a minimum value of just 20 K that is four times as large as the quantum limit (i.e., 4/spl planck//spl omega//k). Such a performance is comparable or even superior to those of the best mechanically tunable waveguide SIS receivers at the same frequency band. In addition, some interesting mixing behaviors related to this two-junction device are described in detail.