Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE MTT-S International Microwave Symposium digest

A planar quasi-optical SIS receiver suitable for array applications

P. A. Stimson, Robert J. Dengler, Peter H. Siegel, Henry George LeDuc

Published Jan 2, 2003• 5 citations
Publisher

Abstract

A novel planar, quasi-optical SIS (superconductor-insulator-superconductor) receiver operating at 230 GHz is described. The receiver consists of a 2*5 array of half-wave dipole antennas with ten niobium-aluminium-oxide-niobium SIS junctions on a quartz dielectric-filled parabola. The 1.2-GHz intermediate frequency is coupled from the mixer via coplanar strip transmission lines and 4:1 balun transformers. The receiver is operated at 4.2 K in a liquid-helium immersion cryostat. Accurate measurements of the performance of single receiver elements are reported. A mixer noise temperature of 148 K DSB, receiver noise temperature of 259 K DSB, and conversion loss of 10 dB into a matched load have been obtained.>

DOI
10.1109/mwsym.1992.188275

Related papers

A planar quasi-optical SIS receiver

P. A. Stimson, Robert J. Dengler, Henry George LeDuc +2 more

A planar, quasi-optical SIS (superconductor-insulator-superconductor) receiver operating at 230 GHz is described. The receiver consists of a 2*5 array of half-wave dipole antennas with niobium-aluminum oxide-niobium SIS junctions on a quartz dielectric-filled parabola. The 1.4-GHz intermediate frequency is coupled from the mixer via coplanar strip transmission lines and 4:1 balun transformers. The receiver is operated at 4.2 K in a liquid helium immersion cryostat. Accurate measurements of the performance of single untuned array receiver elements are reported. A mixer noise temperature of 89 K DSB (double sideband), receiver noise temperature of 156 K DSB and conversion loss of 8 dB into a matched load have been obtained. This mixer noise temperature is approximately a factor of two larger than that of current state of the art waveguide mixers using untuned single junctions a the same frequency.>

IEEE Transactions on Microwave Theory and Techniques•Apr 1, 1993•15 citations

A prototype quasi-optical SIS array receiver

P. A. Stimson, Robert J. Dengler, Henry George LeDuc +1 more

We report measurements on a prototype SIS array receiver consisting of a ten-element dipole antenna array with half square micron niobium SIS junctions. The mixer array is a completely planar, integrated device mounted on the front surface of a quartz-filled parabolic reflector. The ten mixer elements are switched into a single IF filter-amplifier chain. Results at 230 GHz show receiver noise temperatures as low as 75 K DSB, with 120 K being a typical value.>

IEEE MTT-S International Microwave Symposium digest•Dec 17, 2002•1 citation

MM wave quasioptical SIS mixers

Qing Hu, C. A. Mears, P. L. Richards +1 more

The authors have tested the performance of planar SIS (superconductor-insulator-superconductor) mixers with log-periodic antennas at near millimeter and submillimeter wave frequencies from 90 to 360 GHz. The large omega R/sub N/C product ( approximately 10 at 90 GHz) of the Nb/NbO/sub x//Pb-In-Au junctions requires an integrated inductive tuning element to resonate the junction capacitance at the operating frequencies. Two types of integrated tuning element were used which were designed with the aid of measurements using a Fourier transform spectrometer. Preliminary results indicate that the tuning elements can give very good mixer performance up to at least 200 GHz. An inductive wire in parallel with a 5-junction array gives a minimum mixer noise temperature of 115 K (DSB) at 90 GHz with a FWHM (full width at half maximum) bandwidth of 8 GHz. An open-ended microstrip stub in parallel with a single junction gives minimum mixer noise temperatures at 150 and 200 K (DSB) near 90 and 180 GHz with FWHM bandwidths of 4 and 3 GHz, respectively. The relatively high mixer noise temperatures compared to those of waveguide SIS mixers in a similar frequency range are attributed mainly to the losses in the optical system.>

IEEE Transactions on Magnetics•Mar 1, 1989•32 citations

A planar SIS mixer for 400-500 GHz

Rudolf Nitsch, Karl Jacobs

We present a new planar SIS mixer for array applications in the 400-500 GHz range. The mixer consists of a double dipole antenna connnected to a pair of superconducting tunnel junctions by a novel tuning and matching structure. It is mounted in the focal plane of a silicon parabola collimating the broad double dipole beams into beams with f-numbers of /spl ap/13. Four mixers were built in an array configuration on a single substrate and two of them were tested. The receiver DSB noise temperatures are below 300 K in the 456-492 GHz range. The best results are 180 K and 163 K respectively at 473 GHz.

IEEE International Conference on Terahertz Electronics (THz)•Nov 27, 2002•0 citations

Quasi-optical log-periodic antenna SIS mixers for the 100 GHz band

Yoshinori Uzawa, Taiichiro Noguchi, Akira Kawakami +1 more

We designed and tested a quasi-optical SIS mixer that incorporates a substrate lens for the 100 GHz band. The mixer uses a planar self-complementary log-periodic antenna with an integrated tuning circuit. The antenna has a frequency independent impedance of around over several octaves. The tuning circuit consists of two SIS junctions connected in parallel through a superconducting stripline inductor for tuning out the junction capacitances and a impedance transformer for matching the junction resistance to the antenna impedance. The SIS junctions are and have an area of and a current density of . The IF output from the mixer is brought out in a balanced way at each edge of the antenna, and is coupled to a cooled low-noise amplifier through a balun transformer by using a hybrid coupler. A double-sideband receiver noise temperature less than 130 K was measured from 85 to 110 GHz. The best noise temperature was 90 K at 101 GHz, which is the same as for waveguide receivers.

Superconductor Science and Technology•Apr 1, 1996•5 citations

A dual-polarized quasi-optical SIS mixer at 550 GHz

Goutam Chattopadhyay, D. Miller, Henry George LeDuc +1 more

In this paper, we describe the design, fabrication, and the performance of a low-noise dual-polarized quasi-optical superconductor-insulator-superconductor (SIS) mixer at 550 GHz. The mixer utilizes a novel cross-slot antenna on a hyperhemispherical substrate lens, two junction tuning circuits, niobium trilayer junctions, and an IF circuit containing a lumped element 180/spl deg/ hybrid. The antenna consists of an orthogonal pair of twin-slot antennas, and has four feed points, two for each polarization. Each feed point is coupled to a two-junction SIS mixer. The 180/spl deg/ IF hybrid is implemented using a lumped element/microstrip circuit located inside the mixer block. Fourier transform spectrometer measurements of the mixer frequency response show good agreement with computer simulations. The measured co-polarized and cross-polarized patterns for both polarizations also agree with the theoretical predictions. The noise performance of the dual-polarized mixer is excellent giving uncorrected receiver noise temperature of better than 115 K (double sideband) at 528 GHz for both the polarizations.

IEEE Transactions on Microwave Theory and Techniques•Jan 1, 2000•26 citations
A novel planar, quasi-optical SIS (superconductor-insulator-superconductor) receiver operating at 230 GHz is described. The receiver consists of a 2*5 array of half-wave dipole antennas with ten niobium-aluminium-oxide-niobium SIS junctions on a quartz dielectric-filled parabola. The 1.2-GHz intermediate frequency is coupled from the mixer via coplanar strip transmission lines and 4:1 balun transformers. The receiver is operated at 4.2 K in a liquid-helium immersion cryostat. Accurate measurements of the performance of single receiver elements are reported. A mixer noise temperature of 148 K DSB, receiver noise temperature of 259 K DSB, and conversion loss of 10 dB into a matched load have been obtained.>
A planar, quasi-optical SIS (superconductor-insulator-superconductor) receiver operating at 230 GHz is described. The receiver consists of a 2*5 array of half-wave dipole antennas with niobium-aluminum oxide-niobium SIS junctions on a quartz dielectric-filled parabola. The 1.4-GHz intermediate frequency is coupled from the mixer via coplanar strip transmission lines and 4:1 balun transformers. The receiver is operated at 4.2 K in a liquid helium immersion cryostat. Accurate measurements of the performance of single untuned array receiver elements are reported. A mixer noise temperature of 89 K DSB (double sideband), receiver noise temperature of 156 K DSB and conversion loss of 8 dB into a matched load have been obtained. This mixer noise temperature is approximately a factor of two larger than that of current state of the art waveguide mixers using untuned single junctions a the same frequency.>
The authors have tested the performance of planar SIS (superconductor-insulator-superconductor) mixers with log-periodic antennas at near millimeter and submillimeter wave frequencies from 90 to 360 GHz. The large omega R/sub N/C product ( approximately 10 at 90 GHz) of the Nb/NbO/sub x//Pb-In-Au junctions requires an integrated inductive tuning element to resonate the junction capacitance at the operating frequencies. Two types of integrated tuning element were used which were designed with the aid of measurements using a Fourier transform spectrometer. Preliminary results indicate that the tuning elements can give very good mixer performance up to at least 200 GHz. An inductive wire in parallel with a 5-junction array gives a minimum mixer noise temperature of 115 K (DSB) at 90 GHz with a FWHM (full width at half maximum) bandwidth of 8 GHz. An open-ended microstrip stub in parallel with a single junction gives minimum mixer noise temperatures at 150 and 200 K (DSB) near 90 and 180 GHz with FWHM bandwidths of 4 and 3 GHz, respectively. The relatively high mixer noise temperatures compared to those of waveguide SIS mixers in a similar frequency range are attributed mainly to the losses in the optical system.>
We present a new planar SIS mixer for array applications in the 400-500 GHz range. The mixer consists of a double dipole antenna connnected to a pair of superconducting tunnel junctions by a novel tuning and matching structure. It is mounted in the focal plane of a silicon parabola collimating the broad double dipole beams into beams with f-numbers of /spl ap/13. Four mixers were built in an array configuration on a single substrate and two of them were tested. The receiver DSB noise temperatures are below 300 K in the 456-492 GHz range. The best results are 180 K and 163 K respectively at 473 GHz.
We designed and tested a quasi-optical SIS mixer that incorporates a substrate lens for the 100 GHz band. The mixer uses a planar self-complementary log-periodic antenna with an integrated tuning circuit. The antenna has a frequency independent impedance of around over several octaves. The tuning circuit consists of two SIS junctions connected in parallel through a superconducting stripline inductor for tuning out the junction capacitances and a impedance transformer for matching the junction resistance to the antenna impedance. The SIS junctions are and have an area of and a current density of . The IF output from the mixer is brought out in a balanced way at each edge of the antenna, and is coupled to a cooled low-noise amplifier through a balun transformer by using a hybrid coupler. A double-sideband receiver noise temperature less than 130 K was measured from 85 to 110 GHz. The best noise temperature was 90 K at 101 GHz, which is the same as for waveguide receivers.
In this paper, we describe the design, fabrication, and the performance of a low-noise dual-polarized quasi-optical superconductor-insulator-superconductor (SIS) mixer at 550 GHz. The mixer utilizes a novel cross-slot antenna on a hyperhemispherical substrate lens, two junction tuning circuits, niobium trilayer junctions, and an IF circuit containing a lumped element 180/spl deg/ hybrid. The antenna consists of an orthogonal pair of twin-slot antennas, and has four feed points, two for each polarization. Each feed point is coupled to a two-junction SIS mixer. The 180/spl deg/ IF hybrid is implemented using a lumped element/microstrip circuit located inside the mixer block. Fourier transform spectrometer measurements of the mixer frequency response show good agreement with computer simulations. The measured co-polarized and cross-polarized patterns for both polarizations also agree with the theoretical predictions. The noise performance of the dual-polarized mixer is excellent giving uncorrected receiver noise temperature of better than 115 K (double sideband) at 528 GHz for both the polarizations.