The dynamical response of a laser to frequency-shifted optical feedback is investigated both theoretically and experimentally. The ultrahigh sensitivity of a class-B laser (i.e., a laser with a cavity damping rate ${\ensuremath{\gamma}}_{c}$ higher than the population damping rate ${\ensuremath{\gamma}}_{1})$ to external light injection is demonstrated by the optical detection of weak optical feedback. Compared to a conventional optical beating, the intensity modulation induced by the coherent interaction between the laser electric field and the frequency-shifted reinjected electric field can be several orders of magnitude higher. This method permits high sensitive interferometry and hence imaging. We call this laser detection technique laser optical feedback imaging (LOFI). When the optical frequency shift is resonant with the laser relaxation frequency, the intracavity amplification of the beating is maximum and the enhancement is given by the laser damping rate ratio ${\ensuremath{\gamma}}_{c}/{\ensuremath{\gamma}}_{1}.$ This amplification is of the order of
106 for a microchip laser. We also show that without optical feedback the strong fluctuations of the laser output power are well described by the Langevin noise process. In a broad range around the laser relaxation frequency the laser quantum noise is also resonantly amplified and is then several orders of magnitude higher than the detector noise. In these conditions, the LOFI is a shot noise limited detection technique. Reflectivity as low as ${10}^{\ensuremath{-}13}$ is then easily detectable with a laser output power of a few milliwatts with a detection bandwidth of 1 kHz. Experimentally, for weak optical feedback the laser fluctuations are principally composed of the LOFI modulation signal at the shifted frequency and of the laser quantum noise amplified at the relaxation frequency. For strong optical feedback, nonlinear effects appear in the laser dynamics. In these conditions, harmonics and parametrics peaks appear in the power spectrum. The LOFI detection system is then saturated.
The laser is the key component in any quantum optics experiment. The performance of a laser can be described by the following parameters: optical power, spatial mode structure, output wavelength, frequency spectrum, and noise spectrum. The spatial properties of the laser beams are determined by the properties of the optical resonator. Lasers are available that produce output beams, which are very close to the theoretical limit. In order to determine the dynamics of the fluctuations of the laser system, a quantum model is required. Diode lasers use the band gap in doped semiconductor materials to produce optical gain directly from an electrical current. The chapter focuses on continuous-wave lasers since they are very common in quantum optics experiments, in precision metrology. It considers the theoretical limits to amplification of quantum limited light and discusses the theory of the non-linear interaction. The chapter discusses the measurement-based quantum amplifiers based on electro-optic feed forward and heralded devices based on photon counting.
Quantum key distribution systems are accessible to an eavesdropper; i.e., the eavesdropper can attack not only quantum states but also the equipment. In the former case, vulnerabilities are removed by fundamental constraints (e.g., no-cloning theorem) or theoretical foundations for their removal exist. In the latter case, vulnerability is determined by the practical implementation of equipment. An attack with laser damage of optical components called laser damage attack can allow the eavesdropper to reduce the attenuation of optical elements and compromise distributed keys. In this work, a method based on neutral optical filters has been described for protection from laser damage attack against optical components. A scheme imitating actions of the eavesdropper in the process of laser damage attack has been presented. An approach has been proposed to calculate the parameters of optical elements after the attack. Processes occurring in samples exposed to intense laser radiation have been analyzed. The analysis of experimental data has indicated the stability and constraints of neutral optical filters used in quantum key distribution systems for protection from laser damage attack.