Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Appendix: Limits on the use of heterodyning and amplification in optical interferometry

Bernard F. Burke

Published Nov 1, 1992• 0 citations
OpenAlex

Abstract

The development of optical fibers, lasers, and mixers at optical frequencies has offered the hope that active methods can contribute to optical interferometry. Heterodyning, in particular, looks attractive, even though bandwidths are narrower than one would like at present; one might expect this limitation to lessen as technology develops. That expectation, unfortunately, is not likely to benefit interferometry at optical wavelengths because of the intervention of quantum mechanics and the second law of thermodynamics, as Burke (1985a) pointed out. So much 'second quantization' noise is generated that only at infrared frequencies, somewhere in the 10-100 micron range, can one look forward to heterodyning in any realistic sense. The reason is easily understood. Every amplifier, in the quantum limit, works by stimulated emission, even though this basic truth is not obvious at radio frequencies. This means that there must be spontaneous emission occurring within every amplifier, and Strandberg (1957) showed that this implied a limiting noise temperature, T sub N = h nu/k, for any amplifier. Burke (1969) used this result to demonstrate that, if it were not for this quantum noise, the VLBI method would allow one to tell which slit a photon went through before forming an interference pattern, thus violating basic tenants of quantum mechanics. In essence, the second quantization condition Delta N Delta phi greater than or = 1 saves one from paradox. One can state the conclusion simply: any amplifier produces approximately one photon per Hertz of bandwidth. In optical interferometry, one will certainly want bandwidth in the 10(exp 12) to 10(exp 14) Hz range, and that implies an intolerable cacophony of noise photons. Only at infrared frequencies can one tolerate the quantum noise, where the natural noise background may be high and the mixers are not as efficient as one would hope for. The crossover at present is about 10 or 20 microns, but the boundary will shift to longer wavelengths as noise performance improves. One might guess that ultimately a wavelength of about 100 microns will mark the limit of useful amplification and heterodyning in astronomical aperture synthesis interferometry.

Related papers

High Frequency Optical Heterodyne Spectroscopy

M. Ducloy, J. J. Snyder

The progress over the last few years in the field of sub-Doppler saturated absorption spectroscopy has been greatly assisted by the development of new techniques for increasing sensitivity1-5. For many laboratory situations it is now routinely possible to achieve signal-to-noise ratios and sensitivities very near the quantum limit imposed by the fundamental statistical fluctuations (shot noise) of the probe laser beam.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Oct 19, 1983•1 citation

Heterodyne detection at near-infrared wavelengths with a superconducting NbN hot-electron bolometer mixer

Yury Lobanov, Michael Shcherbatenko, Alexander Shurakov +12 more

We report on the development of a highly sensitive optical receiver for heterodyne IR spectroscopy at the communication wavelength of 1.5 μm (200 THz) by use of a superconducting hot-electron bolometer. The results are important for the resolution of narrow spectral molecular lines in the near-IR range for the study of astronomical objects, as well as for quantum optical tomography and fiber-optic sensing. Receiver configuration as well as fiber-to-detector light coupling designs are discussed. Light absorption of the superconducting detectors was enhanced by nano-optical antennas, which were coupled to optical fibers. An intermediate frequency (IF) bandwidth of about 3 GHz was found in agreement with measurements at 300 GHz, and a noise figure of about 25 dB was obtained that was only 10 dB above the quantum limit.

Optics Letters•Mar 5, 2014•15 citations

Defining the Standard Quantum Limit of Heterodyne between a Continuous Wave Laser and an Optical Frequency Comb

Eugene Tsao, Noah Lordi, Alexander J. Lind +3 more

Optical clocks employ heterodyne between a laser and a frequency comb, yet the quantum description of this measurement is unknown. We define measurement operators and the standard quantum limit, and demonstrate progress reaching this limit.

Quantum 2.0 Conference and Exhibition•Jan 1, 2023•0 citations

Highly customized 1010 nm, ns-pulsed Yb-doped fiber amplifier as a key tool for on-demand single-photon generation

Oliver de Vries, Marco Plötner, Florian Christaller +9 more

The development of highly customized technical devices is a decisive feature of technically complex setups, as frequently observed in quantum experiments. This paper describes the development and realization of an Yb-doped all-fiber amplifier system designed for such a special application, more specifically, an on-demand single-photon source based on four-wave mixing with rubidium Rydberg atoms. The laser is capable of generating bandwidth-limited configurable nanosecond pulses up to peak powers of >100 W and with pulse repetition frequencies (PRF) between 50 Hz and 1 MHz at selectable wavelengths (1008-1024 nm). Especially the amplification of the 1010 nm reference seed at the lower edge of the amplification range for Yb-based fibers is challenging and tends to produce amplified spontaneous emission (ASE) at higher wavelengths. To achieve high ASE suppression, particularly at low pulse repetition frequencies, two acousto-optical modulators (AOM) are utilized both for pulse picking and for temporal filtering. The synchronization between pulse repetition frequency and AOM driver signal allows pulse amplitude fluctuations to be kept below 1%, while ASE is suppressed by at least 85 dB (PRF = 1 MHz) and 65 dB (PRF = 1 kHz).

Optics Express•May 15, 2020•9 citations

Crossing the diffraction limit with an optical amplifier

Gal Gumpel, Erez N. Ribak

Heisenberg's uncertainty principle tells us that it’s impossible to determine simultaneously the position of a photon crossing a telescope's aperture as well as the angle of its momentum. A new technique suggests to overcome the diffraction limit via optical amplification. A number of entangled photons, created by amplification of a single photon, behaves as a single quantum system with respect to the uncertainty principle. Unfortunately, spontaneous emission contributes noise and negates the possible gain from this stimulated emission. The spontaneous photons guarantee the uncertainty principle. Thus the problem of low resolution is replaced by the problem of low SNR. The detection of spontaneous photons follows the same Poisson statistics in time and space. However, the stimulated photons are spatially and temporally coherent with the incoming photons. A pixel with additional hidden thermal signal will slightly modify the Poisson statistics, and only within the diffraction pattern of the photon packets. We characterise the average number of spontaneous photons in all pixels, and subtract it from the stimulated photons. This algorithm is applied on simulated detection events of an amplified signal. The reconstructed image is resolved beyond the limit of the same optical system in the absence of amplification. We produced a number of samples of a wide-band solid-state dye (DCM within PMMA), because the expected number of (stellar) photons is small, and a solid-state dye is easier to handle compared to a dye solution. Initial results with a white light source and a laser pump depict the parameters of the method.

Advances in Optical and Mechanical Technologies for Telescopes and Instrumentation IV•Dec 10, 2020•0 citations

Low noise amplification of an optically carried microwave signal: application to atom interferometry

Thomas Lévèque, A. Gauguet, Walid Chaibi +1 more

arXiv:1003.0266•Applied Physics B•Jun 14, 2010•14 citations
The development of optical fibers, lasers, and mixers at optical frequencies has offered the hope that active methods can contribute to optical interferometry. Heterodyning, in particular, looks attractive, even though bandwidths are narrower than one would like at present; one might expect this limitation to lessen as technology develops. That expectation, unfortunately, is not likely to benefit interferometry at optical wavelengths because of the intervention of quantum mechanics and the second law of thermodynamics, as Burke (1985a) pointed out. So much 'second quantization' noise is generated that only at infrared frequencies, somewhere in the 10-100 micron range, can one look forward to heterodyning in any realistic sense. The reason is easily understood. Every amplifier, in the quantum limit, works by stimulated emission, even though this basic truth is not obvious at radio frequencies. This means that there must be spontaneous emission occurring within every amplifier, and Strandberg (1957) showed that this implied a limiting noise temperature, T sub N = h nu/k, for any amplifier. Burke (1969) used this result to demonstrate that, if it were not for this quantum noise, the VLBI method would allow one to tell which slit a photon went through before forming an interference pattern, thus violating basic tenants of quantum mechanics. In essence, the second quantization condition Delta N Delta phi greater than or = 1 saves one from paradox. One can state the conclusion simply: any amplifier produces approximately one photon per Hertz of bandwidth. In optical interferometry, one will certainly want bandwidth in the 10(exp 12) to 10(exp 14) Hz range, and that implies an intolerable cacophony of noise photons. Only at infrared frequencies can one tolerate the quantum noise, where the natural noise background may be high and the mixers are not as efficient as one would hope for. The crossover at present is about 10 or 20 microns, but the boundary will shift to longer wavelengths as noise performance improves. One might guess that ultimately a wavelength of about 100 microns will mark the limit of useful amplification and heterodyning in astronomical aperture synthesis interferometry.
We report on the development of a highly sensitive optical receiver for heterodyne IR spectroscopy at the communication wavelength of 1.5 μm (200 THz) by use of a superconducting hot-electron bolometer. The results are important for the resolution of narrow spectral molecular lines in the near-IR range for the study of astronomical objects, as well as for quantum optical tomography and fiber-optic sensing. Receiver configuration as well as fiber-to-detector light coupling designs are discussed. Light absorption of the superconducting detectors was enhanced by nano-optical antennas, which were coupled to optical fibers. An intermediate frequency (IF) bandwidth of about 3 GHz was found in agreement with measurements at 300 GHz, and a noise figure of about 25 dB was obtained that was only 10 dB above the quantum limit.
The development of highly customized technical devices is a decisive feature of technically complex setups, as frequently observed in quantum experiments. This paper describes the development and realization of an Yb-doped all-fiber amplifier system designed for such a special application, more specifically, an on-demand single-photon source based on four-wave mixing with rubidium Rydberg atoms. The laser is capable of generating bandwidth-limited configurable nanosecond pulses up to peak powers of >100 W and with pulse repetition frequencies (PRF) between 50 Hz and 1 MHz at selectable wavelengths (1008-1024 nm). Especially the amplification of the 1010 nm reference seed at the lower edge of the amplification range for Yb-based fibers is challenging and tends to produce amplified spontaneous emission (ASE) at higher wavelengths. To achieve high ASE suppression, particularly at low pulse repetition frequencies, two acousto-optical modulators (AOM) are utilized both for pulse picking and for temporal filtering. The synchronization between pulse repetition frequency and AOM driver signal allows pulse amplitude fluctuations to be kept below 1%, while ASE is suppressed by at least 85 dB (PRF = 1 MHz) and 65 dB (PRF = 1 kHz).
Heisenberg's uncertainty principle tells us that it’s impossible to determine simultaneously the position of a photon crossing a telescope's aperture as well as the angle of its momentum. A new technique suggests to overcome the diffraction limit via optical amplification. A number of entangled photons, created by amplification of a single photon, behaves as a single quantum system with respect to the uncertainty principle. Unfortunately, spontaneous emission contributes noise and negates the possible gain from this stimulated emission. The spontaneous photons guarantee the uncertainty principle. Thus the problem of low resolution is replaced by the problem of low SNR. The detection of spontaneous photons follows the same Poisson statistics in time and space. However, the stimulated photons are spatially and temporally coherent with the incoming photons. A pixel with additional hidden thermal signal will slightly modify the Poisson statistics, and only within the diffraction pattern of the photon packets. We characterise the average number of spontaneous photons in all pixels, and subtract it from the stimulated photons. This algorithm is applied on simulated detection events of an amplified signal. The reconstructed image is resolved beyond the limit of the same optical system in the absence of amplification. We produced a number of samples of a wide-band solid-state dye (DCM within PMMA), because the expected number of (stellar) photons is small, and a solid-state dye is easier to handle compared to a dye solution. Initial results with a white light source and a laser pump depict the parameters of the method.