Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Advances in Optical and Mechanical Technologies for Telescopes and Instrumentation IV

Crossing the diffraction limit with an optical amplifier

Gal Gumpel, Erez N. Ribak

Published Dec 10, 2020• 0 citations
Publisher

Abstract

Heisenberg's uncertainty principle tells us that it’s impossible to determine simultaneously the position of a photon crossing a telescope's aperture as well as the angle of its momentum. A new technique suggests to overcome the diffraction limit via optical amplification. A number of entangled photons, created by amplification of a single photon, behaves as a single quantum system with respect to the uncertainty principle. Unfortunately, spontaneous emission contributes noise and negates the possible gain from this stimulated emission. The spontaneous photons guarantee the uncertainty principle. Thus the problem of low resolution is replaced by the problem of low SNR. The detection of spontaneous photons follows the same Poisson statistics in time and space. However, the stimulated photons are spatially and temporally coherent with the incoming photons. A pixel with additional hidden thermal signal will slightly modify the Poisson statistics, and only within the diffraction pattern of the photon packets. We characterise the average number of spontaneous photons in all pixels, and subtract it from the stimulated photons. This algorithm is applied on simulated detection events of an amplified signal. The reconstructed image is resolved beyond the limit of the same optical system in the absence of amplification. We produced a number of samples of a wide-band solid-state dye (DCM within PMMA), because the expected number of (stellar) photons is small, and a solid-state dye is easier to handle compared to a dye solution. Initial results with a white light source and a laser pump depict the parameters of the method.

DOI
10.1117/12.2559434

Related papers

Optical amplification for astronomical imaging at higher resolution

Gal Gumpel, Erez N. Ribak

Heisenberg’s uncertainty principle tells us that it is impossible to determine simultaneously the position of a photon crossing a telescope’s aperture and its momentum. Super-resolution imaging techniques rely on modification of the observed sample or on entangling photons. In astronomy, we have no access to the object, but resolution may be improved by optical amplification. Unfortunately, spontaneous emission contributes noise and negates the possible gain from stimulated emissions. We show that it is possible to increase the weight of the stimulated photons by considering photon statistics and observe an improvement in resolution. Most importantly, we demonstrate a method that can apply for all imaging purposes.

arXiv:2103.13073•Journal of the Optical Society of America B•Mar 23, 2021•7 citations

Beyond the diffraction limit via optical amplification

Aglaé N. Kellerer, Erez N. Ribak

In a previous article [Astron. Astrophys.561, A118 (2014)], we suggested a method to overcome the diffraction limit behind a telescope. We discuss and extend recent numerical simulations and test whether it is indeed possible to use photon amplification to enhance the angular resolution of a telescope or a microscope beyond the diffraction limit. An essential addition is the proposal to select events with an above-average ratio of stimulated to spontaneous photons. The analysis shows that the diffraction limit of a telescope is surpassed by a factor of 10 for an amplifier gain of 200, if the analysis is restricted to a tenth of the incoming astronomical photons. A gain of 70 is sufficient with a hundredth of the photons. More simulations must be performed to account for the bunching of spontaneous photons.

arXiv:1604.06928•Optics Letters•Jul 5, 2016•21 citations

Beyond the Quantum Optical Diffraction Limit

Erez N. Ribak, Gal Gumpel

To circumvent Heisenberg’s uncertainty principle, we multiplied the number of white light photons using a dye. With larger wave-packets, the resolution is improved, as if with a larger aperture, but longer integration times are necessary.

Imaging and Applied Optics•Jan 1, 2022•0 citations

Breaking the diffraction limit using fluorescence quantum coherence

Wenwen Li, Zhongyang Wang

The classical optical diffraction limit can be overcome by exploiting the quantum properties of light in several theoretical studies; however, they mostly rely on an entangled light source. Recent experiments have demonstrated that quantum properties are preserved in many fluorophores, which makes it possible to add a new dimension of information for super-resolution fluorescence imaging. Here, we developed a statistical quantum coherence model for fluorescence emitters and proposed a new super-resolution method using fluorescence quantum coherence in fluorescence microscopy. In this study, by exploiting a single-photon avalanche detector (SPAD) array with a time-correlated single-photon-counting technique to perform spatial-temporal photon statistics of fluorescence coherence, the subdiffraction-limited spatial separation of emitters is obtained from the determined coherence. We numerically demonstrate an example of two-photon interference from two common fluorophores using an achievable experimental procedure. Our model provides a bridge between the macroscopic partial coherence theory and the microscopic dephasing and spectral diffusion mechanics of emitters. By fully taking advantage of the spatial-temporal fluctuations of the emitted photons as well as coherence, our quantum-enhanced imaging method has the significant potential to improve the resolution of fluorescence microscopy even when the detected signals are weak.

Optics Express•Mar 21, 2022•6 citations

Correlations in single photon amplification : stimulated versus spontaneous processes

A. Heidmann, Serge Reynaud

We study temporal correlations between photons going out an optical amplifier (stimulated emission amplification) when the input consists of a single photon. It is shown that this amplifier thus appears not at all as a « photon cloner » but rather as a noise source statistically independent from the input field (spontaneous emission noise).

Journal de physique•Jan 1, 1984•8 citations

Quantum noise in photonics

CHARLES H. HENRY, Rudolf F. Kazarinov

The basic equations governing noise phenomena are derived from first principles and applied to examples in optical communications. Quantum noise arises from two sources, the momentum fluctuations of electrons at optical frequencies and the uncertainty-related fluctuations of the electromagnetic field. Shot noise results from the beating of the noise sources with the signal field. In high-gain amplifiers, the spontaneous-emission noise dominates shot noise and results in a noise figure of at least 3 dB. It is shown explicitly how, at high power, both the laser field and the laser noise source become classical. The increase in noise in lasers with open cavities is not due to enhanced spontaneous emission as once thought, but to single-pass amplification. The noise fields and spontaneous currents have Gaussian distributions, while nonlasing modes have exponential photon-number distributions. Low-frequency intensity fluctuations arise from the electric current driving the laser and can be sub-Poissonian, in contrast to shot noise, which has a Poissonian distribution. The calculational tools are a wave equation for the field operator and a rate equation for the carrier-number operator, each containing spontaneous current noise sources. The correlation functions of these sources are determined by the fluctuation-dissipation theorem. [S0034-6861(96)00503-X]

Reviews of Modern Physics•Jul 1, 1996•218 citations
Heisenberg's uncertainty principle tells us that it’s impossible to determine simultaneously the position of a photon crossing a telescope's aperture as well as the angle of its momentum. A new technique suggests to overcome the diffraction limit via optical amplification. A number of entangled photons, created by amplification of a single photon, behaves as a single quantum system with respect to the uncertainty principle. Unfortunately, spontaneous emission contributes noise and negates the possible gain from this stimulated emission. The spontaneous photons guarantee the uncertainty principle. Thus the problem of low resolution is replaced by the problem of low SNR. The detection of spontaneous photons follows the same Poisson statistics in time and space. However, the stimulated photons are spatially and temporally coherent with the incoming photons. A pixel with additional hidden thermal signal will slightly modify the Poisson statistics, and only within the diffraction pattern of the photon packets. We characterise the average number of spontaneous photons in all pixels, and subtract it from the stimulated photons. This algorithm is applied on simulated detection events of an amplified signal. The reconstructed image is resolved beyond the limit of the same optical system in the absence of amplification. We produced a number of samples of a wide-band solid-state dye (DCM within PMMA), because the expected number of (stellar) photons is small, and a solid-state dye is easier to handle compared to a dye solution. Initial results with a white light source and a laser pump depict the parameters of the method.
Heisenberg’s uncertainty principle tells us that it is impossible to determine simultaneously the position of a photon crossing a telescope’s aperture and its momentum. Super-resolution imaging techniques rely on modification of the observed sample or on entangling photons. In astronomy, we have no access to the object, but resolution may be improved by optical amplification. Unfortunately, spontaneous emission contributes noise and negates the possible gain from stimulated emissions. We show that it is possible to increase the weight of the stimulated photons by considering photon statistics and observe an improvement in resolution. Most importantly, we demonstrate a method that can apply for all imaging purposes.
In a previous article [Astron. Astrophys.561, A118 (2014)], we suggested a method to overcome the diffraction limit behind a telescope. We discuss and extend recent numerical simulations and test whether it is indeed possible to use photon amplification to enhance the angular resolution of a telescope or a microscope beyond the diffraction limit. An essential addition is the proposal to select events with an above-average ratio of stimulated to spontaneous photons. The analysis shows that the diffraction limit of a telescope is surpassed by a factor of 10 for an amplifier gain of 200, if the analysis is restricted to a tenth of the incoming astronomical photons. A gain of 70 is sufficient with a hundredth of the photons. More simulations must be performed to account for the bunching of spontaneous photons.
The classical optical diffraction limit can be overcome by exploiting the quantum properties of light in several theoretical studies; however, they mostly rely on an entangled light source. Recent experiments have demonstrated that quantum properties are preserved in many fluorophores, which makes it possible to add a new dimension of information for super-resolution fluorescence imaging. Here, we developed a statistical quantum coherence model for fluorescence emitters and proposed a new super-resolution method using fluorescence quantum coherence in fluorescence microscopy. In this study, by exploiting a single-photon avalanche detector (SPAD) array with a time-correlated single-photon-counting technique to perform spatial-temporal photon statistics of fluorescence coherence, the subdiffraction-limited spatial separation of emitters is obtained from the determined coherence. We numerically demonstrate an example of two-photon interference from two common fluorophores using an achievable experimental procedure. Our model provides a bridge between the macroscopic partial coherence theory and the microscopic dephasing and spectral diffusion mechanics of emitters. By fully taking advantage of the spatial-temporal fluctuations of the emitted photons as well as coherence, our quantum-enhanced imaging method has the significant potential to improve the resolution of fluorescence microscopy even when the detected signals are weak.
The basic equations governing noise phenomena are derived from first principles and applied to examples in optical communications. Quantum noise arises from two sources, the momentum fluctuations of electrons at optical frequencies and the uncertainty-related fluctuations of the electromagnetic field. Shot noise results from the beating of the noise sources with the signal field. In high-gain amplifiers, the spontaneous-emission noise dominates shot noise and results in a noise figure of at least 3 dB. It is shown explicitly how, at high power, both the laser field and the laser noise source become classical. The increase in noise in lasers with open cavities is not due to enhanced spontaneous emission as once thought, but to single-pass amplification. The noise fields and spontaneous currents have Gaussian distributions, while nonlasing modes have exponential photon-number distributions. Low-frequency intensity fluctuations arise from the electric current driving the laser and can be sub-Poissonian, in contrast to shot noise, which has a Poissonian distribution. The calculational tools are a wave equation for the field operator and a rate equation for the carrier-number operator, each containing spontaneous current noise sources. The correlation functions of these sources are determined by the fluctuation-dissipation theorem. [S0034-6861(96)00503-X]