Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Lasers and Electro-Optics Society Annual Meeting (LEOS)

Fundamental limits to the wavelength measurement of optical signals

David J. F. Cooper, P. W. E. Smith

Published Aug 23, 2004• 1 citation
Publisher

Abstract

The fundamental limits for measuring the wavelength of optical signals is derived. The analysis provides a lower bound for any measurement apparatus. It is found that the lower limit depends on the optical power available for measurement, the statistical properties of the measured light and on the spectral distribution of the signal. Experimental measurements performed by the authors and presented by others are consistent with the limit.

DOI
10.1109/leos.2003.1251736

Related papers

Limits in wavelength measurement of optical signals

David J. F. Cooper, Peter W. E. Smith

We determine the maximum accuracy in the wavelength measurement of finite-bandwidth optical signals. The limit is dependent on the spectral and coherence properties of the optical signal and on the available optical power. We also investigate the effect of finite measurement resolution in the wavelength measurement.

Journal of the Optical Society of America B•Apr 29, 2004•11 citations

Fundamental Limit to Linear One-Dimensional Slow Light Structures

David A. B. Miller

Using a new general approach to limits in optical structures that counts orthogonal waves generated by scattering, we derive an upper limit to the number of bits of delay possible in one-dimensional slow light structures that are based on linear optical response to the signal field. The limit is essentially the product of the length of the structure in wavelengths and the largest relative change in dielectric constant anywhere in the structure at any frequency of interest. It holds for refractive index, absorption, or gain variations with arbitrary spectral or spatial form. It is otherwise completely independent of the details of the structure's design, and does not rely on concepts of group velocity or group delay.

arXiv:0710.3575•Physical Review Letters•Nov 15, 2007•101 citations

Secure practical indoor optical wireless communications using quantum key distribution

Lee, Vincent, Dominic C. O'Brien

Quantum Key Distribution (QKD) can guarantee security for practical indoor optical wireless environments. The key challenges are to mitigate artificial lighting and ambient light at the receiver. A new spectral region for QKD is proposed and an ideal QKD link model is simulated with experimental ambient light power measurements. Simulation, modelling, and analysis indicates that the carbon dioxide and water absorption band (1370 nm) is a new wavelength region for QKD operation in indoor optical wireless environments. For a feasible QKD link, approximately 20 dB of signal to noise ratio (SNR) is required and a maximum quantum bit error rate (QBER) of 11% when using the BB84 protocol. Links in the new spectral region with a FOV of several degrees are feasible, depending on available components.

arXiv:1908.07951•Aug 19, 2019•0 citations

Quantum Limit to Precision of Wavelength Determination

G. R. Hanes

The precision of wavelength determination is ultimately limited by noise arising from the quantum nature of light and light detection. Expressions are derived for the limiting precision attainable by various interferometers and conventional spectrometers in terms of parameters characterizing the instruments, the source, and the detector. A comparison of five different instruments shows the superiority of the interferometers and indicates that they are divided into three classes, according to the role played by the half-width of the radiation from the source.

Applied Optics•May 1, 1963•9 citations

Practical performance limits on optical frequency transfer over fiber optic links

Paul A. Williams, William C. Swann, Nathan R. Newbury

We present theory and experiment quantifying the limitations to stable transport of optical frequencies over optical fiber. These are fundamental fiber noise, propagation delay, bidirectional propagation and system noise in the measurement interferometers.

Conference on Lasers and Electro-Optics•May 1, 2008•0 citations

Green InGaN LED-based quantum random number generation compatible with silicon avalanche photodiodes

Ivan A. Kotov, Heming Lin, Wenqing Niu +4 more

Random number generation is a fundamental task for modern cryptography, secure communications, and stochastic computing. Quantum random number generators (QRNGs) provide inherently unpredictable data derived from quantum physical processes and therefore offer stronger security guarantees than classical approaches. However, some optical QRNGs rely on blue light-emitting diodes (LEDs), which suffer from reduced spectral matching with commonly used silicon avalanche photodiodes (APDs). This mismatch restricts the achievable signal-to-noise ratio (SNR) and limits the extractable quantum entropy. Here, we demonstrate a spontaneous emission-based QRNG employing a green InGaN LED coupled to a silicon APD. The improved spectral overlap between the emitted light and the APD responsivity results in a significantly higher SNR than with previously reported blue LEDs operating at similar electrical power levels. The measured signal is first filtered with a high-pass filter to suppress low-frequency noise, then randomness is extracted using the SHAKE256 hash function. A detailed statistical and spectral analysis is performed to evaluate the extractable entropy of the generated data. A physically reasonable estimation yields a quantum entropy generation rate of 2.78 Gbit/s. These results establish longer-wavelength nitride-based LEDs as a more suitable entropy source for QRNG systems, using inexpensive and widely available silicon photodiodes.

Optics Express•Apr 6, 2026•1 citation
The fundamental limits for measuring the wavelength of optical signals is derived. The analysis provides a lower bound for any measurement apparatus. It is found that the lower limit depends on the optical power available for measurement, the statistical properties of the measured light and on the spectral distribution of the signal. Experimental measurements performed by the authors and presented by others are consistent with the limit.
Using a new general approach to limits in optical structures that counts orthogonal waves generated by scattering, we derive an upper limit to the number of bits of delay possible in one-dimensional slow light structures that are based on linear optical response to the signal field. The limit is essentially the product of the length of the structure in wavelengths and the largest relative change in dielectric constant anywhere in the structure at any frequency of interest. It holds for refractive index, absorption, or gain variations with arbitrary spectral or spatial form. It is otherwise completely independent of the details of the structure's design, and does not rely on concepts of group velocity or group delay.
Quantum Key Distribution (QKD) can guarantee security for practical indoor optical wireless environments. The key challenges are to mitigate artificial lighting and ambient light at the receiver. A new spectral region for QKD is proposed and an ideal QKD link model is simulated with experimental ambient light power measurements. Simulation, modelling, and analysis indicates that the carbon dioxide and water absorption band (1370 nm) is a new wavelength region for QKD operation in indoor optical wireless environments. For a feasible QKD link, approximately 20 dB of signal to noise ratio (SNR) is required and a maximum quantum bit error rate (QBER) of 11% when using the BB84 protocol. Links in the new spectral region with a FOV of several degrees are feasible, depending on available components.
The precision of wavelength determination is ultimately limited by noise arising from the quantum nature of light and light detection. Expressions are derived for the limiting precision attainable by various interferometers and conventional spectrometers in terms of parameters characterizing the instruments, the source, and the detector. A comparison of five different instruments shows the superiority of the interferometers and indicates that they are divided into three classes, according to the role played by the half-width of the radiation from the source.
Random number generation is a fundamental task for modern cryptography, secure communications, and stochastic computing. Quantum random number generators (QRNGs) provide inherently unpredictable data derived from quantum physical processes and therefore offer stronger security guarantees than classical approaches. However, some optical QRNGs rely on blue light-emitting diodes (LEDs), which suffer from reduced spectral matching with commonly used silicon avalanche photodiodes (APDs). This mismatch restricts the achievable signal-to-noise ratio (SNR) and limits the extractable quantum entropy. Here, we demonstrate a spontaneous emission-based QRNG employing a green InGaN LED coupled to a silicon APD. The improved spectral overlap between the emitted light and the APD responsivity results in a significantly higher SNR than with previously reported blue LEDs operating at similar electrical power levels. The measured signal is first filtered with a high-pass filter to suppress low-frequency noise, then randomness is extracted using the SHAKE256 hash function. A detailed statistical and spectral analysis is performed to evaluate the extractable entropy of the generated data. A physically reasonable estimation yields a quantum entropy generation rate of 2.78 Gbit/s. These results establish longer-wavelength nitride-based LEDs as a more suitable entropy source for QRNG systems, using inexpensive and widely available silicon photodiodes.