Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

AIP conference proceedings

Polarized atomic hydrogen beam studies in the Michigan ultra-cold jet

R. S. Raymond

Published Jan 1, 2000• 0 citations
Publisher

Abstract

Studies of an ultra-cold jet of polarized hydrogen atoms are described. This atomic beam is formed by the acceleration of cold (0.3 K) atoms emerging from a region of high magnetic field (12 T). The maximum measured density was about 1012 atoms cm−3. The beam’s full width half maximum size was less than 4 mm.
DOI
10.1063/1.1345343

Related papers

The ultra-cold polarized hydrogen jet project

R. S. Raymond, Donald G. Crabb, T. Roser +2 more

Research is described on a jet of polarized atomic hydrogen.Atoms in the two lower hyperfine states are trapped at 0.4 k in a 5 T magnetic field.Microwaves at 140 GHz then drive transitions to the upper hyperfine states and these atoms are expelled from the field to form the beam.Atoms have been trapped, transitions driven, and atoms detected outside the trapping field, but preliminary measurements are not fully understood.Studies are continuing.Work is continuing to test the applicability of cryogenic atomic physics techniques to the production of dense polarized atomic hydrogen beams.At high magnetic fields (5 T) and low temperatures (0.5 k), the magnetic energy of a hydrogen atom, approximately #, • B, is considerably higher than the thermal energy, kT.When cold atoms approach a high magnetic field, atoms in the two upper hyperfme states see a potential hill and are repulsed.Atoms in the two lower hyperfine states see a potential well, are attracted in, thermalize by hitting cold walls and are trapped.These trapped atoms are then irradiated with microwaves of the proper frequency (approximately 140 GHz for a 5 T field) to drive transition to one of the upper hyperflne states.These flipped atoms, now on a potential hill, are accelerated out of the field to form the beam.

AIP conference proceedings•Jan 1, 1989•0 citations

Ultra-cold methods of atomic hydrogen electron spin separation

V. G. Luppov, William A. Kaufman, Alan D. Krisch

Two ultra-cold methods of atomic hydrogen electron spin separation for polarized jet targets and sources will be described and compared. Both of them use a helium-film coated cell at 300 mK located in a high magnetic field. The first one, microwave driven extraction, uses a 212 GHz microwave system and 7.5 T magnetic field with a high uniformity ({Delta}B/B{approx} 10{sup {minus}5}). The second method employs the gradient of a high magnetic field for the state separation and beam formation. Experimental results from the two methods will be presented.

Bulletin of the American Physical Society•Apr 1, 1995•0 citations

Progress on the Michigan-MIT Ultra-Cold Polarized Hydrogen Jet

R. S. Raymond, T. Roser

Springer eBooks•Jan 1, 1991•0 citations

Continuous, dense, highly collimated sodium beam

W. DeGraffenreid, Jaime Ramirez-Serrano, Y.-M. Liu +1 more

We have developed a slow, highly collimated, and bright sodium atom beam suitable for orientation and alignment studies in cold collisions. A combination of transverse-optical collimation, longitudinal cooling, rapid decoupling from the longitudinal cooling cycle, and a final “optical-force extrusion” stage produces an atom density of 1×1010 cm−3 within a beam-divergence solid angle of 2×10−6 sr. Rapid Zeeman-cooler decoupling results in a narrow laboratory velocity distribution of 5 m/s full width at half maximum and a cold binary intrabeam collision temperature of 4 mK.

Review of Scientific Instruments•Oct 1, 2000•17 citations

A high-intensity cold atom source

Michael Borysow

Presented in this thesis is the design and characterization of a new, high-flux source of cold atoms based on continuous, post-nozzle injection of lithium atoms into a cryogenic, supersonic helium jet. To date, experiments have been performed with lithium injection fractions up to [approximately equal to]10⁻⁶, where fluorescence spectroscopy reveals successful capture and thermalization of lithium atoms within the helium jet. The observed lithium beam copropagates with the helium jet and has a temperature of less than 10 mK, a brightness of 1.1x10¹⁹ m⁻² s⁻¹ sr⁻¹, and a brilliance of 3.1x10²⁰ m⁻² s⁻¹ sr⁻¹. Lithium atoms contained within a solid angle of [approximately equal to]0.018 sr are good candidates for future magnetic extraction. This results in a potentially capturable lithium flux of 1.1x10¹² s⁻¹, comparable to the existing record for a cold atomic beam. Also presented is preliminary data showing lithium fluorescence nearly 1 m downstream, demonstrating that the cold lithium beam can be successfully extracted from the seeding region. Numerical simulations reproduce capture efficiency to within 50%, suggesting that the process is well understood. We believe that successful seeding may be possible at a fraction up to 10⁻⁴. Seeding at this rate could produce an atomic beam with a flux as high as 1.3x10¹⁴ s⁻¹ at a phase-space density up to 1.6x10⁻⁷, corresponding to brightness and brilliance of order 10²² m⁻² s⁻¹ sr⁻¹ and 10²⁴ m⁻² s⁻¹ sr⁻¹ , respectively. If this novel cooling method performs as well at higher incident lithium flux, it could serve as a pump source and pave the way to the realization of the first truly continuous atom laser.

•Aug 1, 2012•0 citations

Spin-polarized hydrogen confined in three and two-dimensions

Isaac F. Silvera

Experimental efforts to produce a Bose Einstein condensed (BEC) gas of spin-polarized atomic hydrogen have been intensely pursued since 1980. Initial efforts studied hydrogen in contact with superfluid helium surfaces. In order to avoid the limiting wall recombination a static magnetic trap was developed which utilizes magnetic barriers to isolate atoms from the van der Wals walls. In this approach traps can be filled to about 10{sup 14} atoms/cm{sup 3} for which the critical temperature is in the region of 20-30 {mu}K. However, approaching BEC conditions, a new instability dominates the behavior. The authors have developed a new type of electromagnetic trap, a microwave (mw) trap in which the trapped atoms are in the ground spin-state so that at low temperature relaxation to a barrier state is strongly suppressed and BEC should be attainable. The shallow mw trap has recently been demonstrated experimentally for the cesium atom. Because the mw trap is so shallow it is necessary to precool the atoms for loading. The authors are constructing a hybrid trap in which the atoms are cooled in a static trap and then transferred to a mw trap where they can be further evaporatively cooled in an effort to achieve BEC.more » This trap should have density limits in the region of 10{sup 16} to 10{sup 17}/cm{sup 3} due to three-body recombination. A second, promising approach is in a 2-D geometry for which in finite sized systems BEC is allowed. Hydrogen atoms are confined to a superfluid helium surface by the absorption potential to form a 2-D gas. Although recombination is an important process on helium surfaces, recently the authors have shown that only a very small fraction of the recombination energy is coupled into the surface. With an appropriate geometry the recombination energy can be removed from the sample region to suppress heating to a negligible level. Furthermore in 2-D a magnetic field can have a maximum so that atoms can be confined to a very small area.« less

Bulletin of the American Physical Society•Apr 1, 1995•0 citations
Research is described on a jet of polarized atomic hydrogen.Atoms in the two lower hyperfine states are trapped at 0.4 k in a 5 T magnetic field.Microwaves at 140 GHz then drive transitions to the upper hyperfine states and these atoms are expelled from the field to form the beam.Atoms have been trapped, transitions driven, and atoms detected outside the trapping field, but preliminary measurements are not fully understood.Studies are continuing.Work is continuing to test the applicability of cryogenic atomic physics techniques to the production of dense polarized atomic hydrogen beams.At high magnetic fields (5 T) and low temperatures (0.5 k), the magnetic energy of a hydrogen atom, approximately #, • B, is considerably higher than the thermal energy, kT.When cold atoms approach a high magnetic field, atoms in the two upper hyperfme states see a potential hill and are repulsed.Atoms in the two lower hyperfine states see a potential well, are attracted in, thermalize by hitting cold walls and are trapped.These trapped atoms are then irradiated with microwaves of the proper frequency (approximately 140 GHz for a 5 T field) to drive transition to one of the upper hyperflne states.These flipped atoms, now on a potential hill, are accelerated out of the field to form the beam.
Two ultra-cold methods of atomic hydrogen electron spin separation for polarized jet targets and sources will be described and compared. Both of them use a helium-film coated cell at 300 mK located in a high magnetic field. The first one, microwave driven extraction, uses a 212 GHz microwave system and 7.5 T magnetic field with a high uniformity ({Delta}B/B{approx} 10{sup {minus}5}). The second method employs the gradient of a high magnetic field for the state separation and beam formation. Experimental results from the two methods will be presented.
We have developed a slow, highly collimated, and bright sodium atom beam suitable for orientation and alignment studies in cold collisions. A combination of transverse-optical collimation, longitudinal cooling, rapid decoupling from the longitudinal cooling cycle, and a final “optical-force extrusion” stage produces an atom density of 1×1010 cm−3 within a beam-divergence solid angle of 2×10−6 sr. Rapid Zeeman-cooler decoupling results in a narrow laboratory velocity distribution of 5 m/s full width at half maximum and a cold binary intrabeam collision temperature of 4 mK.
Presented in this thesis is the design and characterization of a new, high-flux source of cold atoms based on continuous, post-nozzle injection of lithium atoms into a cryogenic, supersonic helium jet. To date, experiments have been performed with lithium injection fractions up to [approximately equal to]10⁻⁶, where fluorescence spectroscopy reveals successful capture and thermalization of lithium atoms within the helium jet. The observed lithium beam copropagates with the helium jet and has a temperature of less than 10 mK, a brightness of 1.1x10¹⁹ m⁻² s⁻¹ sr⁻¹, and a brilliance of 3.1x10²⁰ m⁻² s⁻¹ sr⁻¹. Lithium atoms contained within a solid angle of [approximately equal to]0.018 sr are good candidates for future magnetic extraction. This results in a potentially capturable lithium flux of 1.1x10¹² s⁻¹, comparable to the existing record for a cold atomic beam. Also presented is preliminary data showing lithium fluorescence nearly 1 m downstream, demonstrating that the cold lithium beam can be successfully extracted from the seeding region. Numerical simulations reproduce capture efficiency to within 50%, suggesting that the process is well understood. We believe that successful seeding may be possible at a fraction up to 10⁻⁴. Seeding at this rate could produce an atomic beam with a flux as high as 1.3x10¹⁴ s⁻¹ at a phase-space density up to 1.6x10⁻⁷, corresponding to brightness and brilliance of order 10²² m⁻² s⁻¹ sr⁻¹ and 10²⁴ m⁻² s⁻¹ sr⁻¹ , respectively. If this novel cooling method performs as well at higher incident lithium flux, it could serve as a pump source and pave the way to the realization of the first truly continuous atom laser.
Experimental efforts to produce a Bose Einstein condensed (BEC) gas of spin-polarized atomic hydrogen have been intensely pursued since 1980. Initial efforts studied hydrogen in contact with superfluid helium surfaces. In order to avoid the limiting wall recombination a static magnetic trap was developed which utilizes magnetic barriers to isolate atoms from the van der Wals walls. In this approach traps can be filled to about 10{sup 14} atoms/cm{sup 3} for which the critical temperature is in the region of 20-30 {mu}K. However, approaching BEC conditions, a new instability dominates the behavior. The authors have developed a new type of electromagnetic trap, a microwave (mw) trap in which the trapped atoms are in the ground spin-state so that at low temperature relaxation to a barrier state is strongly suppressed and BEC should be attainable. The shallow mw trap has recently been demonstrated experimentally for the cesium atom. Because the mw trap is so shallow it is necessary to precool the atoms for loading. The authors are constructing a hybrid trap in which the atoms are cooled in a static trap and then transferred to a mw trap where they can be further evaporatively cooled in an effort to achieve BEC.more » This trap should have density limits in the region of 10{sup 16} to 10{sup 17}/cm{sup 3} due to three-body recombination. A second, promising approach is in a 2-D geometry for which in finite sized systems BEC is allowed. Hydrogen atoms are confined to a superfluid helium surface by the absorption potential to form a 2-D gas. Although recombination is an important process on helium surfaces, recently the authors have shown that only a very small fraction of the recombination energy is coupled into the surface. With an appropriate geometry the recombination energy can be removed from the sample region to suppress heating to a negligible level. Furthermore in 2-D a magnetic field can have a maximum so that atoms can be confined to a very small area.« less