Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

European Quantum Electronics Conference (EQEC)

Quantum state discrimination via linear optics and continuous photon counting

Masahiro Takeoka, Masahide Sasaki, Peter van Loock, Norbert Lütkenhaus

Published Jan 18, 2006• 0 citations
Publisher

Abstract

In this paper, an expansion of the formulae to check whether one can implement a step via linear optics and photon counting was derived, to the limit of continuous photon counting, The limit that the coupling between the signal and measurement apparatus is infinitesimal at each step and the number of the step is infinitely large was discussed. As an example, a specific case where the states to be discriminated are single-mode states and any nonclassical ancillas are excluded.

DOI
10.1109/eqec.2005.1567490

Related papers

Projective measurements via linear optics and photon detectors

Masahiro Takeoka

The possibility of implementing a given photonic projective measurement with linear optics and photon detectors is discussed. This problem can be viewed as a single-shot discrimination of orthogonal pure quantum states. It is particularly shown that any two orthogonal states can be perfectly discriminated using only linear optics, photon counting, coherent ancillary states, and feedforward. This means that one can construct any binary projective measurement with these means, but without any nonclassical ancillary state. The statement holds in the asymptotic limit of a large number of these physical resources. To extend this result, we also address the problem of discriminating a simple set of three orthogonal states.

Optics and Spectroscopy•Jul 1, 2007•2 citations

Discrimination of quantum states with linear optics and continuous photon counting

Masahiro Takeoka

We investigate a systematic method of implementation of given measurements with linear optics and continuous measurement. We revisit the so-called Dolinar receiver, which is a quasi-physical model attaining the minimum error discrimination of binary coherent states, and show that it can be derived without heuristic assumptions. Our approach also can be applied to various kinds of measurements.

Optics and Spectroscopy•Sep 1, 2005•1 citation

Binary Projective Measurement via Linear Optics and Photon Counting

Masahiro Takeoka, Masahide Sasaki, Norbert Lütkenhaus

We investigate the implementation of binary projective measurements with linear optics. This problem can be viewed as a single-shot discrimination of two orthogonal pure quantum states. We show that any two orthogonal states can be perfectly discriminated using only linear optics, photon counting, coherent ancillary states, and feedforward. The statement holds in the asymptotic limit of a large number of these physical resources.

arXiv:quant-ph/0603074•Physical Review Letters•Jul 26, 2006•41 citations

Stabilizer formalism in linear optics and application to Bell-state discrimination

Yamazaki, Tomohiro, Rikizo Ikuta, Takashi Yamamoto

We propose a framework to analyze linear optical circuits based on an analogy with stabilizer formalism in quantum circuits, which provides efficiently computable formulas related to state discriminations. Hence, we analyze a Bell-state discrimination scheme with linear optics and ancillary single photons. With an increasing number of ancilla photons, the success probability of Bell-state discrimination has a maximum of $\frac{403}{512} \simeq 0.787$ at $28$ ancilla photons. By contrast, the corresponding two-qubit measurement asymptotically approaches a maximally entangling measurement.

arXiv:2301.06551•Jan 16, 2023•4 citations

Linear optics and the problem of Bell-like state discrimination

Jatin Ghai, Sibasish Ghosh

A linear optics-based scheme to implement various quantum information processing tasks is of paramount importance due to its ease of implementation and low noise. Many information-theoretic tasks depend on the successful discrimination of Bell states. A no-go theorem states that it is not possible to perfectly discriminate among the four Bell states when the measurement apparatus is restricted to linear optical elements. The success probability is only $50\%$. Using extra resources such as hyperentanglement, ancillary entanglement, and even a minimum amount of non-linearity, complete Bell-state discrimination can be achieved. The success probability for Bell-like state discrimination is only $25\%$. Bell-like states are non-maximally entangled two-qubit states that resemble Bell states in structure but have unequal Schmidt coefficients. We find that this can be boosted to $50\%$ using hyperentanglement, where extra ancillary degrees of freedom (DOF) of photons, such as polarization, momentum, or OAM, are also entangled along with the system DOF. This contrasts with Bell-state discrimination, where $100\%$ can be achieved. Furthermore, we find that using correlations in the photons' arrival times, all four Bell states can be distinguished with $100\%$ success probability, while for Bell-like state discrimination, it increases only to $37.5\%$ from $25\%$. We observe a similar contrast when using ancillary entangled photons. While the success probability for discriminating all four Bell states increases as $1-\frac{1}{2^N}$, where $N$ is the number of ancillary photon pairs, for Bell-like states, it depends on the state parameters and can be less than $25\%$ in some cases. Also, adding further ancillary photons decreases the success probability. We then show that using non-linear gadgets, namely SFG, $100\%$ success probability can be achieved even for Bell-like state discrimination.

quant-pharXiv:2402.00832•Feb 2, 2024•0 citations

SINGLE-PHOTON DETECTION AND RECONSTRUCTION (TOMOGRAPHY) OF OPTICAL-FIELD STATES

Masahiro Takeoka

The possibility of implementing a given photonic projective measurement with linear optics and photon detectors is discussed. This problem can be viewed as a single-shot discrimination of orthogonal pure quantum states. It is particularly shown that any two orthogonal states can be perfectly discriminated using only linear optics, photon counting, coherent ancillary states, and feedforward. This means that one can construct any binary projective measurement with these means, but without any nonclassical ancillary state . The state- ment holds in the asymptotic limit of a large number of these physical resources. To extend this result, we also address the problem of discriminating a simple set of three orthogonal states.

•Jan 1, 2007•0 citations
In this paper, an expansion of the formulae to check whether one can implement a step via linear optics and photon counting was derived, to the limit of continuous photon counting, The limit that the coupling between the signal and measurement apparatus is infinitesimal at each step and the number of the step is infinitely large was discussed. As an example, a specific case where the states to be discriminated are single-mode states and any nonclassical ancillas are excluded.
The possibility of implementing a given photonic projective measurement with linear optics and photon detectors is discussed. This problem can be viewed as a single-shot discrimination of orthogonal pure quantum states. It is particularly shown that any two orthogonal states can be perfectly discriminated using only linear optics, photon counting, coherent ancillary states, and feedforward. This means that one can construct any binary projective measurement with these means, but without any nonclassical ancillary state. The statement holds in the asymptotic limit of a large number of these physical resources. To extend this result, we also address the problem of discriminating a simple set of three orthogonal states.
We propose a framework to analyze linear optical circuits based on an analogy with stabilizer formalism in quantum circuits, which provides efficiently computable formulas related to state discriminations. Hence, we analyze a Bell-state discrimination scheme with linear optics and ancillary single photons. With an increasing number of ancilla photons, the success probability of Bell-state discrimination has a maximum of 403512≃0.787\frac{403}{512} \simeq 0.787512403​≃0.787 at 282828 ancilla photons. By contrast, the corresponding two-qubit measurement asymptotically approaches a maximally entangling measurement.
A linear optics-based scheme to implement various quantum information processing tasks is of paramount importance due to its ease of implementation and low noise. Many information-theoretic tasks depend on the successful discrimination of Bell states. A no-go theorem states that it is not possible to perfectly discriminate among the four Bell states when the measurement apparatus is restricted to linear optical elements. The success probability is only 50%50\%50%. Using extra resources such as hyperentanglement, ancillary entanglement, and even a minimum amount of non-linearity, complete Bell-state discrimination can be achieved. The success probability for Bell-like state discrimination is only 25%25\%25%. Bell-like states are non-maximally entangled two-qubit states that resemble Bell states in structure but have unequal Schmidt coefficients. We find that this can be boosted to 50%50\%50% using hyperentanglement, where extra ancillary degrees of freedom (DOF) of photons, such as polarization, momentum, or OAM, are also entangled along with the system DOF. This contrasts with Bell-state discrimination, where 100%100\%100% can be achieved. Furthermore, we find that using correlations in the photons' arrival times, all four Bell states can be distinguished with 100%100\%100% success probability, while for Bell-like state discrimination, it increases only to 37.5%37.5\%37.5% from 25%25\%25%. We observe a similar contrast when using ancillary entangled photons. While the success probability for discriminating all four Bell states increases as 1−12N1-\frac{1}{2^N}1−2N1​, where NNN is the number of ancillary photon pairs, for Bell-like states, it depends on the state parameters and can be less than 25%25\%25% in some cases. Also, adding further ancillary photons decreases the success probability. We then show that using non-linear gadgets, namely SFG, 100%100\%100% success probability can be achieved even for Bell-like state discrimination.
The possibility of implementing a given photonic projective measurement with linear optics and photon detectors is discussed. This problem can be viewed as a single-shot discrimination of orthogonal pure quantum states. It is particularly shown that any two orthogonal states can be perfectly discriminated using only linear optics, photon counting, coherent ancillary states, and feedforward. This means that one can construct any binary projective measurement with these means, but without any nonclassical ancillary state . The state- ment holds in the asymptotic limit of a large number of these physical resources. To extend this result, we also address the problem of discriminating a simple set of three orthogonal states.