Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Chinese Physics B

Dependence of loading time on control parameters in a standard vapour—loaded magneto—optical trap

Yichi Zhang, Jizhou Wu, Yuqing Li, Jie Ma, Lirong Wang, Yanting Zhao, Liantuan Xiao, Suotang Jia

Published Dec 1, 2011• 8 citations
Publisher

Abstract

Loading time is one of the most important dynamic characteristics of a magneto—optical trap. In this paper, we primarily report on a detailed experimental study of the effects of some magneto—optical trap control parameters on loading time, including the background vacuum pressure, the magnetic field gradient, and the intensities of trapping and repumping lasers. We compare the results with previous theoretical and experimental results, and give qualitative analysis. These experimental investigations offer some useful guidelines to control the loading time of magneto—optical traps. The controllable loading time achieved is helpful to enhance the signal-to-noise ratio of photoassociation spectroscopy, which is remarkably improved from 7 to 28.6.

DOI
10.1088/1674-1056/20/12/123701

Related papers

Investigation of dynamics of magneto-optical trap loading by light-induced atom desorption

Zhang Peng-Fei, Gang Li, Yuchi Zhang +4 more

The dynamics of magneto-optical trap loading by light-induced atom desorption (LIAD) are investigated theoretically and experimentally. The loading of the MOT has been described by a theoretical model. We have paid close attention to the background gases which are essentially important for the ultimate vacuum pressure. The experiment is done based on a glass cell and all the results are well in agreement with the theory. The decay process of the background vacuum pressure caused by the untrapped cesium atoms after shutting off the desorption light is explained quantitatively. The LIAD effect is proved to be an effective tool to control the loading of the MOT and the neutral single atoms in experiment.

Acta Physica Sinica•Jan 1, 2010•2 citations

Optimization of the light-induced-fluorescence signals of single atoms and efficient loading of single atoms into a magneto-optical trap

Jieying Wang, Bei Liu, Diao Wen-Ting +3 more

In our experiment, firstly, we carry out the loading of single atoms in the magneto-optical trap (MOT) by increasing the quadrupole magnetic field gradient, improving the background vacuum, and reducing the diameters of the cooling and trapping laser beams. Secondly, we get the single atomic fluorescence signal of a high signal-to-background ratio in the MOT by means of reducing the detuning of cooling light and increasing its intensity appropriately, and using the polarization spectroscopy locking technique to suppress the fluctuations of cooling laser. In addition, with the real-time feedback on quadrupole magnetic field gradient, we demonstrate a probability of loading single atoms in the MOT as high as 98%. We also measure the statistical properties of the single atomic fluorescence which is excited by continuous light in the MOT; the measured second-order correlation is g(2)( = 0) = 0.09.

Acta Physica Sinica•Jan 1, 2014•3 citations

Dependence of number of trapped atoms on the experimental parameters of Rb magneto-optical trap

Kaijun Jiang, Ke Li, Wang Jin +2 more

Our study indicates that the number of trapped Rb atoms in a magneto-optical trap (MOT) strongly depends on the trapping laser intensity and detuning, the repumping laser intensity and the magnetic gradient. We estimate the trapped-atom numbers changing with the trapping laser intensity and detuning, using a two-level system model. The theoretical results are in qualitative agreement with the experimental results. The experimental results also show an obvious dependence of the trapped-atom numbers on repumping laser intensity and the magnetic gradient, which the simple theory cannot account for. These studies are helpful for selecting suitable experimental parameters to achieve larger numbers of cold atoms.

Acta Physica Sinica•Jan 1, 2006•4 citations

Characteristics of single-atom trapping in a magneto-optical trap with a high magnetic-field gradient

Seokchan Yoon, Youngwoon Choi, Sang‐Bum Park +3 more

A quantitative study on characteristics of a magneto-optical trap with a single or a few atoms is presented. A very small number of 85 Rb atoms were trapped in a micron-size magneto-optical trap with a high magnetic-field gradient. In order to find the optimum condition for a single-atom trap, we have investigated how the number of atoms and the size of atomic cloud change as various experimental parameters, such as a magnetic-field gradient and the trapping laser intensity and detuning. The averaged number of atoms was measured very accurately with a calibration procedure based on the single-atom saturation curve of resonance fluorescence. In addition, the number of atoms in a trap could be controlled by suppressing stochastic loading events by means of a real-time active feedback on the magnetic-field gradient.

Journal of Physics Conference Series•Sep 1, 2007•8 citations

Loading an optical dipole trap

S. J. M. Kuppens, Kristan L. Corwin, Kurt W. Miller +2 more

We present a detailed experimental study of the physics involved in transferring atoms from a magneto-optical trap (MOT) to an optical dipole trap. The loading is a dynamical process determined by a loading rate and a density dependent loss rate. The loading rate depends on cooling and the flux of atoms into the trapping volume, and the loss rate is due to excited state collisions induced by the MOT light fields. From this study we found ways to optimize the loading of the optical dipole trap. Key ingredients for maximum loading are found to be a reduction of the hyperfine repump intensity, increased detuning of the MOT light, and a displacement of the optical dipole trap center with respect to the MOT. A factor of 2 increase in the number of loaded atoms is demonstrated by using a hyperfine repump beam with a shadow in it. In this way we load $8\ifmmode\times\else\texttimes\fi{}{10}^{6}{}^{85}\mathrm{Rb}$ atoms into a 1 mK deep optical dipole trap with a waist of $58 \ensuremath{\mu}\mathrm{m},$ which is 40% of the atoms initially trapped in the MOT.

Physical Review A•Jun 13, 2000•192 citations

Loading an optical dipole trap

S. J. M. Kuppens, Kristan L. Corwin, Kurt W. Miller +2 more

We present a detailed experimental study of the physics involved in transferring atoms from a magneto-optical trap (MOT) to an optical dipole trap. The loading is a dynamical process determined by a loading rate and a density dependent loss rate. The loading rate depends on cooling and the flux of atoms into the trapping volume, and the loss rate is due to excited slate collisions induced by the MOT light fields. From this study we found ways to optimize the loading of the optical dipole trap. Key ingredients, for maximum loading are found to be a reduction of the hyperfine repump intensity, increased detuning of the MOT light, and a displacement or the optical dipole trap center with respect to the MOT. A factor of 2 increase in the number of loaded atoms is demonstrated by using a hyperfine repump beam with a shadow n it. In this way we load 8 × 10 6 85 Rb atoms into a 1 mK deep optical dipole trap with a worst of 58 μm, which is 40% of the atoms initially trapped in the MOT.

WORLD SCIENTIFIC eBooks•Jan 1, 2008•0 citations
Loading time is one of the most important dynamic characteristics of a magneto—optical trap. In this paper, we primarily report on a detailed experimental study of the effects of some magneto—optical trap control parameters on loading time, including the background vacuum pressure, the magnetic field gradient, and the intensities of trapping and repumping lasers. We compare the results with previous theoretical and experimental results, and give qualitative analysis. These experimental investigations offer some useful guidelines to control the loading time of magneto—optical traps. The controllable loading time achieved is helpful to enhance the signal-to-noise ratio of photoassociation spectroscopy, which is remarkably improved from 7 to 28.6.
The dynamics of magneto-optical trap loading by light-induced atom desorption (LIAD) are investigated theoretically and experimentally. The loading of the MOT has been described by a theoretical model. We have paid close attention to the background gases which are essentially important for the ultimate vacuum pressure. The experiment is done based on a glass cell and all the results are well in agreement with the theory. The decay process of the background vacuum pressure caused by the untrapped cesium atoms after shutting off the desorption light is explained quantitatively. The LIAD effect is proved to be an effective tool to control the loading of the MOT and the neutral single atoms in experiment.
In our experiment, firstly, we carry out the loading of single atoms in the magneto-optical trap (MOT) by increasing the quadrupole magnetic field gradient, improving the background vacuum, and reducing the diameters of the cooling and trapping laser beams. Secondly, we get the single atomic fluorescence signal of a high signal-to-background ratio in the MOT by means of reducing the detuning of cooling light and increasing its intensity appropriately, and using the polarization spectroscopy locking technique to suppress the fluctuations of cooling laser. In addition, with the real-time feedback on quadrupole magnetic field gradient, we demonstrate a probability of loading single atoms in the MOT as high as 98%. We also measure the statistical properties of the single atomic fluorescence which is excited by continuous light in the MOT; the measured second-order correlation is g(2)( = 0) = 0.09.
Our study indicates that the number of trapped Rb atoms in a magneto-optical trap (MOT) strongly depends on the trapping laser intensity and detuning, the repumping laser intensity and the magnetic gradient. We estimate the trapped-atom numbers changing with the trapping laser intensity and detuning, using a two-level system model. The theoretical results are in qualitative agreement with the experimental results. The experimental results also show an obvious dependence of the trapped-atom numbers on repumping laser intensity and the magnetic gradient, which the simple theory cannot account for. These studies are helpful for selecting suitable experimental parameters to achieve larger numbers of cold atoms.
A quantitative study on characteristics of a magneto-optical trap with a single or a few atoms is presented. A very small number of 85 Rb atoms were trapped in a micron-size magneto-optical trap with a high magnetic-field gradient. In order to find the optimum condition for a single-atom trap, we have investigated how the number of atoms and the size of atomic cloud change as various experimental parameters, such as a magnetic-field gradient and the trapping laser intensity and detuning. The averaged number of atoms was measured very accurately with a calibration procedure based on the single-atom saturation curve of resonance fluorescence. In addition, the number of atoms in a trap could be controlled by suppressing stochastic loading events by means of a real-time active feedback on the magnetic-field gradient.
We present a detailed experimental study of the physics involved in transferring atoms from a magneto-optical trap (MOT) to an optical dipole trap. The loading is a dynamical process determined by a loading rate and a density dependent loss rate. The loading rate depends on cooling and the flux of atoms into the trapping volume, and the loss rate is due to excited state collisions induced by the MOT light fields. From this study we found ways to optimize the loading of the optical dipole trap. Key ingredients for maximum loading are found to be a reduction of the hyperfine repump intensity, increased detuning of the MOT light, and a displacement of the optical dipole trap center with respect to the MOT. A factor of 2 increase in the number of loaded atoms is demonstrated by using a hyperfine repump beam with a shadow in it. In this way we load $8\ifmmode\times\else\texttimes\fi{}{10}^{6}{}^{85}\mathrm{Rb}$ atoms into a 1 mK deep optical dipole trap with a waist of $58 \ensuremath{\mu}\mathrm{m},$ which is 40% of the atoms initially trapped in the MOT.
We present a detailed experimental study of the physics involved in transferring atoms from a magneto-optical trap (MOT) to an optical dipole trap. The loading is a dynamical process determined by a loading rate and a density dependent loss rate. The loading rate depends on cooling and the flux of atoms into the trapping volume, and the loss rate is due to excited slate collisions induced by the MOT light fields. From this study we found ways to optimize the loading of the optical dipole trap. Key ingredients, for maximum loading are found to be a reduction of the hyperfine repump intensity, increased detuning of the MOT light, and a displacement or the optical dipole trap center with respect to the MOT. A factor of 2 increase in the number of loaded atoms is demonstrated by using a hyperfine repump beam with a shadow n it. In this way we load 8 × 10 6 85 Rb atoms into a 1 mK deep optical dipole trap with a worst of 58 μm, which is 40% of the atoms initially trapped in the MOT.