Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

STIN

A Far-Infrared Laser Study of Josephson Point Contacts.

David A. Weitz

Published May 1, 1978• 0 citations
OpenAlex

Abstract

The high-frequency behavior of niobium cat-whisker point contacts is studied using radiation from an optically pumped far-infrared (FIR) laser. The FIR molecular laser had a dielectric-waveguide cavity and was pumped by a CO2 laser. The use of capacitive-mesh output couplers is extended throughout the FIR spectrum, between 42 micrometers and 1.2 mm, and have found the optimum grid constants for several lines. At shorter wavelengths, the laser performance was improved by the use of a novel hybrid capacitive-mesh hole output coupler. The coupling of the FIR radiation to the point contact is found to depend in a simple manner on the resistance of the contact. The FIR laser radiation induces constant-voltage steps on the dc I-V curves of our junctions, allowing us to study the high-frequency ac Josephson effect.

Related papers

Point-contact-type Josephson harmonic mixer for frequency measurement of far-infrared lasers

Yukinobu Miki, Eiichi Sakuma, Masanao Morimura

Point-contact-type Josephson junctions have been developed as a harmonic mixer to measure far-infrared (FIR) laser frequencies in a frequency chain up to the infrared region. The junctions were formed by mechanically pressing a niobium wire of 70 μm in diameter with a sharply etched tip against a niobium post of 2 mm in diameter. The voltage-current characteristics of the mixers were investigated under the irradiation of FIR lights from an optically pumped methyl-alcohol laser. The Shapiro steps for FIR lights up to 3.1 THz were observed. The mixing properties of the mixers were studied through harmonic mixing experiments of 50-GHz microwaves and the FIR lights up to the frequency of 3.1 THz. The conversion efficiency of the beat signals to the incident FIR power was found to vary as the — 4th power of the FIR frequency. From the mixing properties, the combination of the critical current Icof the junction and the product IcRnwhere Rnis the normal resistance of the junction, was found important to optimize the mixing performance.

IEEE Transactions on Instrumentation and Measurement•Jun 1, 1987•3 citations

Response of Nb-aSi-Nb junctions to 604 GHz radiation

W. C. Danchi, John U. Free, F. Habbal +2 more

We have measured the response of Nb-aSi-Nb junctions to 604 GHz radiation from an optically pumped far-infrared (FIR) laser source. These rugged and thermally cyclable junctions situated at the midpoint of 180 μm long dipole antennas, were fabricated on oxidized silicon wafers using the Selective Niobium Anodization Process (SNAP). Josephson current densities were\sim 9,000A/cm2, the McCumber parameters βcwere ∼3.5, and the Josephson plasma frequencies\omega_{J}\sim2.5\times10^{12}. On a junction with a normal state resistance of\sim7\Omega, we observed three Josephson steps and one photon-assisted tunneling step. The widths of the Josephson steps were studied as a function of the laser power. An RSJ model computer simulation with a nonlinear quasiparticle conductance and an rf current bias (assumed because of the low junction resistance) is able to account reasonably well for the laser-power dependence of the critical current (zeroth step) and the second step. However, the temperature dependence is more complex, and a discrepancy still exists between the RSJ model calculation and the data for the hysteretic first step.

IEEE Transactions on Magnetics•Mar 1, 1985•3 citations

AC Josephson effect in superconducting niobium nitride tunnel junctions at up to 2.5 THz

M. C. Wicks, P R Haycocks, T. Hori

Shapiro steps have been observed in the I–V characteristics of an NbN tunnel junction illuminated with radiation from an optically pumped far infrared laser. The maximum operating frequency which produced an observable Shapiro step was 2.53 THz. This is a four-fold increase over that previously reported for a thin film Josephson junction. Clear steps were also produced by various laser lines in the frequency range 0.6–1.8 THz.

Electronics Letters•Apr 26, 1990•4 citations

Far Infrared Response of Point-Contact Josephson Junctions

C. C. Grimes, P. L. Richards, S. M. Shapiro

We have measured spectral-response curves of superconducting point contacts suggesting the existence of frequency-dependent Josephson current amplitudes peaking in the vicinity of the energy gap. These point-contact Josephson junctions respond sensitively and with high speed to millimeter and submillimeter radiation. Radiation emitted to free space by one such junction was detected by another junction.

Physical Review Letters•Aug 22, 1966•59 citations

Far infrared frequency response of a Josephson junction in a self-pumped mixer

J.C. Hénaux, G. Vernet, Robert Adde

A continuous measurement of the far-infrared frequency response of a point contact Josephson junction is performed between 0.7 and 2 THz. The response at increasing frequencies present three characteristic regions with variations proportional to f−2, f−4, f−6. They illustrate the losses introduced successively at increasing frequencies by the resistively shunted junction model, the junction RC time constant and the attenuation of the Josephson current above the gap frequency.

Journal of Applied Physics•Dec 1, 1983•4 citations

Terahertz Shapiro Steps in High Temperature SNS Josephson Junctions

Peter A. Rosenthal, Erich N. Grossman

We have studied the far infrared behavior of high -T/sub c/ superconductor-normal metal-superconductor (SNS) microbridges with T/sub c/>85 K and critical current-resistance products (I/sub c/R/sub N/) as high as 10 mV at 4 K. These are the highest I/sub c/R/sub N/ products reported to date for microfabricated Josephson junctions of any material. The junctions were integrated at the feeds of planar log-periodic antennas made from Au thin films. The junctions had dc normal state resistances R/sub N/ between 6 and 38 /spl Omega/, reasonably well matched to the antenna's estimated RF impedance of 53 /spl Omega/. Far infrared laser radiation at 404, 760, and 992 GHz induced distinct Shapiro steps (i.e. constant voltage steps at voltages n(hf/2e), n=1,2,...) in the current voltage characteristics as well as modulation of the critical current. Steps were observed at voltages up to 17 mV and 6 mV, at temperatures of 9 K and 57 K respectively. This corresponds to maximum Josephson oscillation frequencies of 8 and 3 THz at these temperatures. These are the first far infrared measurements performed on high T/sub c/ junctions. Measurements of the power, frequency, and temperature dependence of the Shapiro steps are presented and discussed in the context of a resistively and capacitively shunted junction (RCSJ) model. A value of 4.5 fF for the junction capacitance is inferred from the hysteresis of the slightly underdamped current-voltage characteristics. >

Softwaretechnik-Trends•Apr 1, 1993•0 citations
The high-frequency behavior of niobium cat-whisker point contacts is studied using radiation from an optically pumped far-infrared (FIR) laser. The FIR molecular laser had a dielectric-waveguide cavity and was pumped by a CO2 laser. The use of capacitive-mesh output couplers is extended throughout the FIR spectrum, between 42 micrometers and 1.2 mm, and have found the optimum grid constants for several lines. At shorter wavelengths, the laser performance was improved by the use of a novel hybrid capacitive-mesh hole output coupler. The coupling of the FIR radiation to the point contact is found to depend in a simple manner on the resistance of the contact. The FIR laser radiation induces constant-voltage steps on the dc I-V curves of our junctions, allowing us to study the high-frequency ac Josephson effect.
Point-contact-type Josephson junctions have been developed as a harmonic mixer to measure far-infrared (FIR) laser frequencies in a frequency chain up to the infrared region. The junctions were formed by mechanically pressing a niobium wire of 70 μm in diameter with a sharply etched tip against a niobium post of 2 mm in diameter. The voltage-current characteristics of the mixers were investigated under the irradiation of FIR lights from an optically pumped methyl-alcohol laser. The Shapiro steps for FIR lights up to 3.1 THz were observed. The mixing properties of the mixers were studied through harmonic mixing experiments of 50-GHz microwaves and the FIR lights up to the frequency of 3.1 THz. The conversion efficiency of the beat signals to the incident FIR power was found to vary as the — 4th power of the FIR frequency. From the mixing properties, the combination of the critical current Icof the junction and the product IcRnwhere Rnis the normal resistance of the junction, was found important to optimize the mixing performance.
We have measured the response of Nb-aSi-Nb junctions to 604 GHz radiation from an optically pumped far-infrared (FIR) laser source. These rugged and thermally cyclable junctions situated at the midpoint of 180 μm long dipole antennas, were fabricated on oxidized silicon wafers using the Selective Niobium Anodization Process (SNAP). Josephson current densities were\sim 9,000A/cm2, the McCumber parameters βcwere ∼3.5, and the Josephson plasma frequencies\omega_{J}\sim2.5\times10^{12}. On a junction with a normal state resistance of\sim7\Omega, we observed three Josephson steps and one photon-assisted tunneling step. The widths of the Josephson steps were studied as a function of the laser power. An RSJ model computer simulation with a nonlinear quasiparticle conductance and an rf current bias (assumed because of the low junction resistance) is able to account reasonably well for the laser-power dependence of the critical current (zeroth step) and the second step. However, the temperature dependence is more complex, and a discrepancy still exists between the RSJ model calculation and the data for the hysteretic first step.
We have studied the far infrared behavior of high -T/sub c/ superconductor-normal metal-superconductor (SNS) microbridges with T/sub c/>85 K and critical current-resistance products (I/sub c/R/sub N/) as high as 10 mV at 4 K. These are the highest I/sub c/R/sub N/ products reported to date for microfabricated Josephson junctions of any material. The junctions were integrated at the feeds of planar log-periodic antennas made from Au thin films. The junctions had dc normal state resistances R/sub N/ between 6 and 38 /spl Omega/, reasonably well matched to the antenna's estimated RF impedance of 53 /spl Omega/. Far infrared laser radiation at 404, 760, and 992 GHz induced distinct Shapiro steps (i.e. constant voltage steps at voltages n(hf/2e), n=1,2,...) in the current voltage characteristics as well as modulation of the critical current. Steps were observed at voltages up to 17 mV and 6 mV, at temperatures of 9 K and 57 K respectively. This corresponds to maximum Josephson oscillation frequencies of 8 and 3 THz at these temperatures. These are the first far infrared measurements performed on high T/sub c/ junctions. Measurements of the power, frequency, and temperature dependence of the Shapiro steps are presented and discussed in the context of a resistively and capacitively shunted junction (RCSJ) model. A value of 4.5 fF for the junction capacitance is inferred from the hysteresis of the slightly underdamped current-voltage characteristics. >