Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Physical Review Letters

Far Infrared Response of Point-Contact Josephson Junctions

C. C. Grimes, P. L. Richards, S. M. Shapiro

Published Aug 22, 1966• 59 citations
Publisher

Abstract

We have measured spectral-response curves of superconducting point contacts suggesting the existence of frequency-dependent Josephson current amplitudes peaking in the vicinity of the energy gap. These point-contact Josephson junctions respond sensitively and with high speed to millimeter and submillimeter radiation. Radiation emitted to free space by one such junction was detected by another junction.

DOI
10.1103/physrevlett.17.431

Related papers

Far infrared detection by Josephson junctions

Chi Kong So

A group at Bell Telephone Laboratories has reported using superconducting point contacts that show zerovoltage Josephson current as “sensitive, broadband, high-speed detectors of millimeter and submillimeter radiation.” The work was done by C. C. Grimes, P. L. Richards and S. Shapiro and reported in Physical Review Letters 17, 431 (1966).

Physics Today•Nov 1, 1966•0 citations

Far infrared frequency response of a Josephson junction in a self-pumped mixer

J.C. Hénaux, G. Vernet, Robert Adde

A continuous measurement of the far-infrared frequency response of a point contact Josephson junction is performed between 0.7 and 2 THz. The response at increasing frequencies present three characteristic regions with variations proportional to f−2, f−4, f−6. They illustrate the losses introduced successively at increasing frequencies by the resistively shunted junction model, the junction RC time constant and the attenuation of the Josephson current above the gap frequency.

Journal of Applied Physics•Dec 1, 1983•4 citations

Correlation between Types of Junction and Submillimeter-Wave Responses in Point-Contact Josephson Junctions

Seizo Morita, Takashi Noguchi, Satoru Takaki +4 more

It has been found that point-contact Josephson junctions can be clearly classified into bridge-type and tunnel-type by introducing new parameters characterizing their I-V curves. Nearly-ideal tunnel-type junctions with Nb–SuO x –Sn (Film) point-contacts were obtained. Tunnel-type junctions showed larger gap energies than bridge-type junctions in Nb–SnO x –Sn and Nb–NbO x –NbN point-contacts. The submillimeter-wave responses were measured in Nb–Nb point-contacts, and it was found that the contacts with the best performance were bridge-type junctions with a sharp gap structure; tunnel-type junctions showed rather bad performance. On irradiation with laser light, the center of the Shapiro step moved to the lower-current side in bridge-type junctions but to the higher-current side in tunnel-type junctions. These differences can be explained by differences in the heating effects between bridge-type and tunnel-type junctions.

Japanese Journal of Applied Physics•Jan 1, 1982•6 citations

Far infrared detection with Josephson junctions. Final report

C. K. So, William O. Hamilton

The response of Josephson junctions to microwave and far infrared radiation was studied. Junctions are formed by pressing a Nb or Nb-Ti pointed wire onto a Nb thin film which in turn is pressed against the open end of a waveguide. Electromagnetic radiation is applied through the back of the film so that only the wave magnetic field is coupled to the junctions. The change of the dc Josephson current is monitored at different levels of microwave power over a frequency range from 22GHz to 105GHz. The dependence of the responsivity of these current on film thickness over a range from 50 A to 500 A was studied. The observed responsivity agrees very well with that predicted by theory. Higher responsivity is observed for thinner films and lower microwave frequencies.

•Dec 1, 1976•0 citations

High-Frequency Response of Josephson Point Contacts

Helmut Kanter, F. L. Vernon

For a current-driven Josephson junction shunted by an Ohmic resistance, the dc voltage response and impedance to external high-frequency currents is calculated with a second-order perturbation method based on the unperturbed solution for the time evolution of the voltage as given by Aslamazov and Larkin. The response is proportional to signal power and has three characteristic-frequency regions depending on whether the internal self-generated Josephson frequency, ω0, is larger than, equal to, or smaller than the signal frequency, ω. For ω0< or >ω the response could be expressed by easily observable parameters of the dc voltage-current characteristics. This permits comparison of the predictions with experimental results obtained on point-contact junctions whose dc characteristics were only approximately represented by the simple model chosen for analysis. For ω0≪ω the response is found to be proportional to (i) the slope of the dc characteristic, (ii) the inverse square of the applied frequency, (iii) the inverse battery current in terms of the critical current, and (iv) the voltage amplitude of the inherent Josephson oscillations. For ω0≫ω ``classical'' detection proportional to curvature is obtained. For ω0∼ω resonance detection occurs, which depends to a considerable degree on fluctuations of the average contact voltage. These predictions are in reasonable agreement with experiments in which point-contact junctions were illuminated with klystron radiation at 10 and 90 GHz. Evidence is presented that the voltage fluctuations limiting the resonance response are the result of noise generated in the junction. Comparison of the noise-equivalent power expected from the simple model with measured results suggests that parasitic elements, such as shunt capacity, are not negligible at 90 GHz.

Journal of Applied Physics•Jul 1, 1972•101 citations

Detection mechanisms in superconducting point contacts at frequencies of 44 times the energy gap

Donald G. McDonald, F. R. Petersen, J. D. Cupp +2 more

We have performed mixing experiments with CO2 lasers in the 9 to 11 μm wavelength band using superconducting point contacts. The experiments involve difference frequencies ranging from 19 MHz to 106 GHz. The mixing mechanism definitely appears to require the superconducting state since the beat signal amplitude decreases by as much as 60 dB as the bath temperature is raised through the superconducting transition temperature. At least three conceptually distinguishable mechanisms may be involved in the observed response. These include : (1) a conventional Josephson response, (2) a thermally modulated Josephson response, and (3) a single particle tunneling response. The usual signature of a Josephson interaction is one or more current steps in the I-V curve. Steps, the first of which should be at 67 mV, are not observed in these experiments. However, we do not feel that is a definitive test for the mixing mechanism between two external sources at such high frequencies. In fact, Werthamer's theory of tunnel junctions predicts a large response for these experiments, a response as large as that from two X-band sources, for example. It should be noted, however, that the theory assumes the junction is maintained at a fixed low temperature and whether or not that is the case depends directly on the current density at the contact. Very little is known about the current density at the present time. These experiments emphasize a fact that is usually overlooked in Josephson junction mixing experiments with an external local oscillator. If the contact or tunneling region is sufficiently small, it may be thermally modulated at difference frequencies extending into the microwave range. This effect becomes more likely with increasing applied frequencies, particularly in the infrared. Theoretical modeling for the purpose of calculating ultimate sensitivities of these devices requires a detailed consideration of thermal effects. We fully expect large mixing signals from Josephson junctions even at optical frequencies if thermal effects do not prove to be a limitation.

Revue de Physique Appliquée•Jan 1, 1974•1 citation
We have measured spectral-response curves of superconducting point contacts suggesting the existence of frequency-dependent Josephson current amplitudes peaking in the vicinity of the energy gap. These point-contact Josephson junctions respond sensitively and with high speed to millimeter and submillimeter radiation. Radiation emitted to free space by one such junction was detected by another junction.
It has been found that point-contact Josephson junctions can be clearly classified into bridge-type and tunnel-type by introducing new parameters characterizing their I-V curves. Nearly-ideal tunnel-type junctions with Nb–SuO x –Sn (Film) point-contacts were obtained. Tunnel-type junctions showed larger gap energies than bridge-type junctions in Nb–SnO x –Sn and Nb–NbO x –NbN point-contacts. The submillimeter-wave responses were measured in Nb–Nb point-contacts, and it was found that the contacts with the best performance were bridge-type junctions with a sharp gap structure; tunnel-type junctions showed rather bad performance. On irradiation with laser light, the center of the Shapiro step moved to the lower-current side in bridge-type junctions but to the higher-current side in tunnel-type junctions. These differences can be explained by differences in the heating effects between bridge-type and tunnel-type junctions.
The response of Josephson junctions to microwave and far infrared radiation was studied. Junctions are formed by pressing a Nb or Nb-Ti pointed wire onto a Nb thin film which in turn is pressed against the open end of a waveguide. Electromagnetic radiation is applied through the back of the film so that only the wave magnetic field is coupled to the junctions. The change of the dc Josephson current is monitored at different levels of microwave power over a frequency range from 22GHz to 105GHz. The dependence of the responsivity of these current on film thickness over a range from 50 A to 500 A was studied. The observed responsivity agrees very well with that predicted by theory. Higher responsivity is observed for thinner films and lower microwave frequencies.
For a current-driven Josephson junction shunted by an Ohmic resistance, the dc voltage response and impedance to external high-frequency currents is calculated with a second-order perturbation method based on the unperturbed solution for the time evolution of the voltage as given by Aslamazov and Larkin. The response is proportional to signal power and has three characteristic-frequency regions depending on whether the internal self-generated Josephson frequency, ω0, is larger than, equal to, or smaller than the signal frequency, ω. For ω0< or >ω the response could be expressed by easily observable parameters of the dc voltage-current characteristics. This permits comparison of the predictions with experimental results obtained on point-contact junctions whose dc characteristics were only approximately represented by the simple model chosen for analysis. For ω0≪ω the response is found to be proportional to (i) the slope of the dc characteristic, (ii) the inverse square of the applied frequency, (iii) the inverse battery current in terms of the critical current, and (iv) the voltage amplitude of the inherent Josephson oscillations. For ω0≫ω ``classical'' detection proportional to curvature is obtained. For ω0∼ω resonance detection occurs, which depends to a considerable degree on fluctuations of the average contact voltage. These predictions are in reasonable agreement with experiments in which point-contact junctions were illuminated with klystron radiation at 10 and 90 GHz. Evidence is presented that the voltage fluctuations limiting the resonance response are the result of noise generated in the junction. Comparison of the noise-equivalent power expected from the simple model with measured results suggests that parasitic elements, such as shunt capacity, are not negligible at 90 GHz.
We have performed mixing experiments with CO2 lasers in the 9 to 11 μm wavelength band using superconducting point contacts. The experiments involve difference frequencies ranging from 19 MHz to 106 GHz. The mixing mechanism definitely appears to require the superconducting state since the beat signal amplitude decreases by as much as 60 dB as the bath temperature is raised through the superconducting transition temperature. At least three conceptually distinguishable mechanisms may be involved in the observed response. These include : (1) a conventional Josephson response, (2) a thermally modulated Josephson response, and (3) a single particle tunneling response. The usual signature of a Josephson interaction is one or more current steps in the I-V curve. Steps, the first of which should be at 67 mV, are not observed in these experiments. However, we do not feel that is a definitive test for the mixing mechanism between two external sources at such high frequencies. In fact, Werthamer's theory of tunnel junctions predicts a large response for these experiments, a response as large as that from two X-band sources, for example. It should be noted, however, that the theory assumes the junction is maintained at a fixed low temperature and whether or not that is the case depends directly on the current density at the contact. Very little is known about the current density at the present time. These experiments emphasize a fact that is usually overlooked in Josephson junction mixing experiments with an external local oscillator. If the contact or tunneling region is sufficiently small, it may be thermally modulated at difference frequencies extending into the microwave range. This effect becomes more likely with increasing applied frequencies, particularly in the infrared. Theoretical modeling for the purpose of calculating ultimate sensitivities of these devices requires a detailed consideration of thermal effects. We fully expect large mixing signals from Josephson junctions even at optical frequencies if thermal effects do not prove to be a limitation.