arXiv:2610.04063
Energy-filtered readout preserves gap-enhanced sensing in interacting quantum dots
Shirwan Abdullah
Abstract
A small excitation gap makes a quantum dot a sensitive probe of a weak electric field, but the charge detector that reads the probe can also excite it. We ask how much of this gap enhancement survives continuous readout, for two interacting electrons tuned through a confinement-driven crossover in a gate-defined quantum dot, using a weak-coupling, stationary two-level model. The answer depends on the energy structure of the detector, not only on its noise. A quantum point contact measures more strongly at higher bias, but once the bias energy exceeds the gap it also excites the probe. When this back-action dominates the probe's own relaxation, the optimised mean-current information rate grows only as the inverse of the gap. A sensor quantum dot with a narrow level instead reaches full measurement strength at a bias below the gap, where, for a non-interacting detector and to second order in the coupling, it cannot excite the probe at zero temperature. This energy-filtered readout keeps the inverse-square gap dependence of the quantum Fisher information, down to a gap set by the detector's level width and the electron temperature. Through such a detector the interacting pair gives about three times the information rate of a single electron with the same gap and detector, compared with 1.6-1.7 in the quantum Fisher information, for both contact and Coulomb-type interactions. These different gap dependences, and the different optimal biases of the two detectors, can be tested by bias and gate sweeps on suitably tuned charge-sensed double dots.
AI Summary
The paper asks whether small-gap enhancement of electric-field sensing survives continuous charge-detector back-action. It studies two interacting electrons near a confinement-driven crossover in a one-dimensional quantum dot, using configuration-interaction calculations and a stationary, weak-coupling two-level model. Quantum-point-contact and non-interacting resonant-level sensor-dot readouts are compared through the Fisher information rate of the time-averaged current. When detector-induced transitions dominate intrinsic relaxation, a point contact with bias-homogeneous noise gives an optimised information rate $\mathcal F_m\propto\Delta^{-1}$, rather than the ground-state QFI scaling $\Delta^{-2}$. A sensor dot of width $\Gamma\ll\Delta$ can reach its measurement strength at $\Gamma\lesssim eV<\Delta$, where detector-induced excitation vanishes at zero temperature to second order in coupling. It then retains $\mathcal F_m\propto\Delta^{-2}$ above a linewidth- and temperature-dependent floor. Scaling arguments and numerical bias optimisation establish these regimes; an inverse-gap full-record scaling is also derived for a specified Gaussian-noise observation model. At a matched gap of $181\,\mu\mathrm{eV}$, the interacting pair provides approximately three times the mean-current information rate of one electron through sensor-dot readout, versus a QFI ratio of 1.67. Contact and Coulomb-type interactions give similar ratios. Numerical sensor-dot floors span $17$–$44\,\mu\mathrm{eV}$ at 10 mK and $96$–$121\,\mu\mathrm{eV}$ at 100 mK for the widths tested. Limitations include the one-dimensional probe, incomplete strong-interaction convergence, omitted higher-state populations at some point-contact optima, and unquantified coherence, memory and static-renormalisation corrections. Interacting-detector effects, realistic phonon back-action and driven radio-frequency readout are not established.
Written by gpt-6.1-sol from the paper's full text. Automated: it can be wrong.
- Comments
- 17 pages, 5 figures