Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1210.3089 · Physical Review B

Backaction dephasing by a quantum dot detector

Toshihiro Kubo, 康弘 都倉

Published Oct 4, 2013• 2 citations
arXivHTMLPDF

Abstract

We derive an analytical expression for the backaction dephasing rate, which characterizes the disturbance induced by coupling with an environment containing a quantum dot detector (QDD). In this paper, we show in an explicit form that the charge noise induces backaction dephasing. In equilibrium, this backaction dephasing induced by the charge noise can be explained as a relaxation by an inelastic electron-electron scattering in Fermi-liquid theory. Unlike the quantum point contact, the backaction dephasing rate increases or decreases with the bias at low bias and finite-temperature condition. This behavior depends on the QDD energy level with respect to the Fermi energy and the asymmetry of the QDD coupling to the reservoirs. In the high bias voltage regime, the dephasing rate becomes insensitive to the bias because of the saturation of the charge noise.

DOI
10.1103/physrevb.88.155402

Related papers

Anderson Orthogonality as Measurement Backaction in Coupled Quantum Dots

Will Grant, Sarath Sankar, Elena Cornick +9 more

Measurement perturbs a quantum system by coupling it to external degrees of freedom, but detector backaction depends on the physical mechanism of measurement itself. In solid-state devices, detectors driven far from equilibrium to enable faster measurements produce backaction that can often be understood as classical noise. However, a strong measurement can also induce backaction from quantum many-body correlations in the detector that are intrinsic to the measurement, even without shot noise. Here, we probe this near-equilibrium backaction through the effect of a quantum-dot charge sensor on tunnelling between a second quantum dot and its reservoirs. The measurement realizes the Anderson Orthogonality Catastrophe (AOC): electrons in the detector leads reorganize in response to an abrupt change in local scattering potential, suppressing resonant tunnelling while enabling inelastic processes that exchange energy with the detector. Changing the detector energy level tunes the AOC backaction from negligible to dominant in the tunnelling dynamics. More broadly, these results establish detector-induced many-body correlations as a controllable influence on quantum dynamics.

arXiv:2608.06550•Aug 6, 2026•2 citations

Inelastic Backaction due to Quantum Point Contact Charge Fluctuations

Carolyn Young, Aashish A. Clerk

We study theoretically transitions of a double quantum-dot qubit caused by nonequilibrium charge fluctuations in a nearby quantum point contact (QPC) used as a detector. We show that these transitions are related to the fundamental Heisenberg backaction associated with the measurement, and use the uncertainty principle to derive a lower bound on the transition rates. We also derive simple expressions for the transition rates for the usual model of a QPC as a mesoscopic conductor, with screening treated at the RPA level. Finally, numerical results are presented which demonstrate that the charge noise and shot noise backaction mechanisms can be distinguished in QPCs having nonadiabatic potentials. The enhanced sensitivity of the charge noise to the QPC potential is explained in terms of interference contributions similar to those which cause Friedel oscillations.

arXiv:0910.4942•Physical Review Letters•May 4, 2010•28 citations

Using a Quantum Dot as a High-Frequency Shot Noise Detector

Eugen Onac, Franck Balestro, L. H. Willems van Beveren +3 more

We present the experimental realization of a quantum dot (QD) operating as a high-frequency noise detector. Current fluctuations produced in a nearby quantum point contact (QPC) ionize the QD and induce transport through excited states. The resulting transient current through the QD represents our detector signal. We investigate its dependence on the QPC transmission and voltage bias. We observe and explain a quantum threshold feature and a saturation in the detector signal. This experimental and theoretical study is relevant in understanding the backaction of a QPC used as a charge detector.

arXiv:cond-mat/0604608•Physical Review Letters•May 1, 2006•135 citations

Telegraph Noise in Coupled Quantum Dot Circuits Induced by a Quantum Point Contact

D. Taubert, Michel Pioro-Ladrière, D. Schröer +3 more

Charge detection utilizing a highly biased quantum point contact has become the most effective probe for studying few electron quantum dot circuits. Measurements on double and triple quantum dot circuits is performed to clarify a back action role of charge sensing on the confined electrons. The quantum point contact triggers inelastic transitions, which occur quite generally. Under specific device and measurement conditions these transitions manifest themselves as bounded regimes of telegraph noise within a stability diagram. A nonequilibrium transition from artificial atomic to molecular behavior is identified. Consequences for quantum information applications are discussed.

arXiv:0801.4002•Physical Review Letters•May 2, 2008•45 citations

Controlled Dephasing and Measurement Efficiency via Quantum Dot Detector

Gyong Luck Khym, Youngnae Lee, Kicheon Kang

We study charge detection and controlled dephasing of a mesoscopic system via a quantum dot detector (QDD), where the mesoscopic system and the QDD are capacitively coupled. The QDD is considered to have coherent resonant tunnelling via a single level. It is found that the dephasing rate is proportional to the square of the conductance of the QDD for the Breit-Wigner model, showing that the dephasing is completely different from the shot noise of the detector. The measurement rate, on the other hand, shows a dip near the resonance. Our findings are peculiar especially for a symmetric detector in the following aspect: The dephasing rate is maximum at resonance of the QDD where the detector conductance is insensitive to the charge state of the mesoscopic system. As a result, the efficiency of the detector shows a dip and vanishes at resonance, in contrast to the single-channel symmetric non-resonant detector that has always a maximum efficiency. We find that this difference originates from a very general property of the scattering matrix: The abrupt phase change exists in the scattering amplitudes in the presence of the symmetry, which is insensitive to the detector current but {\em stores} the information of the quantum state of the mesoscopic system.

arXiv:cond-mat/0601535•Journal of the Physical Society of Japan•Jun 8, 2006•10 citations

Evaluating charge noise acting on semiconductor quantum dots in the circuit quantum electrodynamics architecture

J. Basset, Anna Stockklauser, D.-D. Jarausch +6 more

We evaluate the charge noise acting on a GaAs/GaAlAs based semiconductor double quantum dot dipole-coupled to the voltage oscillations of a superconducting transmission line resonator. The in-phase (I) and the quadrature (Q) components of the microwave tone transmitted through the resonator are sensitive to charging events in the surrounding environment of the double dot with an optimum sensitivity of 8.5×10−5 e/Hz. A low frequency 1/f type noise spectrum combined with a white noise level of 6.6×10−6 e2/Hz above 1 Hz is extracted, consistent with previous results obtained with quantum point contact charge detectors on similar heterostructures. The slope of the 1/f noise allows to extract a lower bound for the double-dot charge qubit dephasing rate which we compare to the one extracted from a Jaynes-Cummings Hamiltonian approach. The two rates are found to be similar emphasizing that charge noise is the main source of dephasing in our system.

arXiv:1405.3085•Applied Physics Letters•Aug 11, 2014•34 citations
We derive an analytical expression for the backaction dephasing rate, which characterizes the disturbance induced by coupling with an environment containing a quantum dot detector (QDD). In this paper, we show in an explicit form that the charge noise induces backaction dephasing. In equilibrium, this backaction dephasing induced by the charge noise can be explained as a relaxation by an inelastic electron-electron scattering in Fermi-liquid theory. Unlike the quantum point contact, the backaction dephasing rate increases or decreases with the bias at low bias and finite-temperature condition. This behavior depends on the QDD energy level with respect to the Fermi energy and the asymmetry of the QDD coupling to the reservoirs. In the high bias voltage regime, the dephasing rate becomes insensitive to the bias because of the saturation of the charge noise.
Measurement perturbs a quantum system by coupling it to external degrees of freedom, but detector backaction depends on the physical mechanism of measurement itself. In solid-state devices, detectors driven far from equilibrium to enable faster measurements produce backaction that can often be understood as classical noise. However, a strong measurement can also induce backaction from quantum many-body correlations in the detector that are intrinsic to the measurement, even without shot noise. Here, we probe this near-equilibrium backaction through the effect of a quantum-dot charge sensor on tunnelling between a second quantum dot and its reservoirs. The measurement realizes the Anderson Orthogonality Catastrophe (AOC): electrons in the detector leads reorganize in response to an abrupt change in local scattering potential, suppressing resonant tunnelling while enabling inelastic processes that exchange energy with the detector. Changing the detector energy level tunes the AOC backaction from negligible to dominant in the tunnelling dynamics. More broadly, these results establish detector-induced many-body correlations as a controllable influence on quantum dynamics.
We study theoretically transitions of a double quantum-dot qubit caused by nonequilibrium charge fluctuations in a nearby quantum point contact (QPC) used as a detector. We show that these transitions are related to the fundamental Heisenberg backaction associated with the measurement, and use the uncertainty principle to derive a lower bound on the transition rates. We also derive simple expressions for the transition rates for the usual model of a QPC as a mesoscopic conductor, with screening treated at the RPA level. Finally, numerical results are presented which demonstrate that the charge noise and shot noise backaction mechanisms can be distinguished in QPCs having nonadiabatic potentials. The enhanced sensitivity of the charge noise to the QPC potential is explained in terms of interference contributions similar to those which cause Friedel oscillations.
We present the experimental realization of a quantum dot (QD) operating as a high-frequency noise detector. Current fluctuations produced in a nearby quantum point contact (QPC) ionize the QD and induce transport through excited states. The resulting transient current through the QD represents our detector signal. We investigate its dependence on the QPC transmission and voltage bias. We observe and explain a quantum threshold feature and a saturation in the detector signal. This experimental and theoretical study is relevant in understanding the backaction of a QPC used as a charge detector.
Charge detection utilizing a highly biased quantum point contact has become the most effective probe for studying few electron quantum dot circuits. Measurements on double and triple quantum dot circuits is performed to clarify a back action role of charge sensing on the confined electrons. The quantum point contact triggers inelastic transitions, which occur quite generally. Under specific device and measurement conditions these transitions manifest themselves as bounded regimes of telegraph noise within a stability diagram. A nonequilibrium transition from artificial atomic to molecular behavior is identified. Consequences for quantum information applications are discussed.
We study charge detection and controlled dephasing of a mesoscopic system via a quantum dot detector (QDD), where the mesoscopic system and the QDD are capacitively coupled. The QDD is considered to have coherent resonant tunnelling via a single level. It is found that the dephasing rate is proportional to the square of the conductance of the QDD for the Breit-Wigner model, showing that the dephasing is completely different from the shot noise of the detector. The measurement rate, on the other hand, shows a dip near the resonance. Our findings are peculiar especially for a symmetric detector in the following aspect: The dephasing rate is maximum at resonance of the QDD where the detector conductance is insensitive to the charge state of the mesoscopic system. As a result, the efficiency of the detector shows a dip and vanishes at resonance, in contrast to the single-channel symmetric non-resonant detector that has always a maximum efficiency. We find that this difference originates from a very general property of the scattering matrix: The abrupt phase change exists in the scattering amplitudes in the presence of the symmetry, which is insensitive to the detector current but {\em stores} the information of the quantum state of the mesoscopic system.
We evaluate the charge noise acting on a GaAs/GaAlAs based semiconductor double quantum dot dipole-coupled to the voltage oscillations of a superconducting transmission line resonator. The in-phase (I) and the quadrature (Q) components of the microwave tone transmitted through the resonator are sensitive to charging events in the surrounding environment of the double dot with an optimum sensitivity of 8.5×10−5 e/Hz. A low frequency 1/f type noise spectrum combined with a white noise level of 6.6×10−6 e2/Hz above 1 Hz is extracted, consistent with previous results obtained with quantum point contact charge detectors on similar heterostructures. The slope of the 1/f noise allows to extract a lower bound for the double-dot charge qubit dephasing rate which we compare to the one extracted from a Jaynes-Cummings Hamiltonian approach. The two rates are found to be similar emphasizing that charge noise is the main source of dephasing in our system.