Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2608.26938

Cavity-assisted homodyne detection with a single photodiode

Jonas Junker

quant-phSubmitted Aug 27, 2026• Announced Aug 28, 2026• 0 citations
arXivHTMLPDF

Abstract

High-frequency squeezed states are important for quantum metrology and information processing, but quadrature measurements at gigahertz frequencies remain challenging. Balanced homodyne detection (BHD), the standard approach, requires closely matched complex transfer functions in both photodetection channels to suppress local-oscillator (LO) noise and maintain a well-defined readout quadrature. This matching becomes increasingly difficult at high bandwidths. Strongly asymmetric single-photodiode homodyne detection avoids this requirement, but achieving high signal efficiency and shot-noise clearance typically requires hundreds of milliwatts of LO power and does not suppress technical LO sidebands. I propose cavity-assisted homodyne detection, in which the quantum field and LO enter separate ports of an impedance-matched traveling-wave cavity. The resonant LO carrier is transmitted to the photodetector, where it beats with off-resonant signal sidebands reflected from the cavity. At the same time, technical LO sidebands outside the cavity linewidth are suppressed. I derive the quantum input-output relations and linearized photocurrent including intracavity loss, and show that near-unity signal-transfer efficiency can be achieved at moderate incident LO power. The cavity linewidth and free spectral range determine the usable detection band.

Comments
12 pages, 4 figures

Related papers

Balanced Homodyne Detector With Independent Phase Control and Noise Detection Branches

JinRong Wang, Wenhui Zhang, Long Tian +4 more

Squeezed state light is a fundamental resource for many quantum optics experiments. Important applications like quantum-enhanced magnetometer and quantum key distribution, require the squeezing level as high as possible. In balanced homodyne detection, the detector output is directly proportional to the noise of the squeezed beam. The detected quadrature is dependent on the relative phase between the squeezed beam and local oscillator. Here, we present a balanced homodyne detector (BHD) with independent phase control and noise detection branches. The independence between the phase control and noise detection branches is experimentally verified, the two branches are independently optimized according to the practical requirements. With the BHD, a bright squeezed light at 1550 nm with quantum noise reduction of 10.3 dB is directly detected. After stabilizing the relative phase between the squeezed states and local oscillator by the phase locking branch of the BHD, the fluctuation of the noise suppression is ±0.2 dB by 1-h testing time.

IEEE Access•Jan 1, 2019•9 citations

Fundamental limits to observations of squeezing via balanced homodyne detection

Samuel L. Braunstein, David D. Crouch

A photodetector's electronic bandwidth is the frequency range over which beats between different frequencies in the input can be observed in the output. The output of a balanced homodyne detector, the prototypical device for detecting squeezed light, consists of beats between a signal to be measured and a local oscillator. Beats between the signal and quantum local-oscillator fluctuations lead to noise that degrades the observed squeezing. Through wide-band calculations, we show that this noise contains contributions from the entire signal bandwidth, even when this bandwidth is orders of magnitude larger than the detector's electronic bandwidth. This allows us to place an upper limit on the total power that can enter the detector's signal port (both signal and extraneous light) within the detector's optical bandwidth in order for a given level of squeezing to be observable.

Physical Review A•Jan 1, 1991•10 citations

Design and simulation of a 300 MHz Balanced Homodyne Detector for quantum photonics

Jiayi Yang

Balanced Homodyne Detection (BHD), introduced in the 1970s, enables highly sensitive detection of phase and amplitude variations in weak light. Initially developed as an advanced optical detection technique, it rapidly became essential in quantum optics for accurately quantifying quadrature components and detecting squeezed states at the shot-noise limit. Today, BHD plays a critical role in diverse fields such as high-precision quantum metrology, gigabit speed optical communications, gravitational wave detection, and large-scale quantum information systems. In this study, a BHD simulation was implemented with a 90 phase difference between the local oscillator and the signal, thus enabling the extraction of the phase quadratureP^component of the optical field.

Advances in Engineering Innovation•Jul 10, 2025•0 citations

Cavity enhanced parametric homodyne detection of a squeezed quantum comb

Yuhang Tian, Xiaocong Sun, Yajun Wang +3 more

A squeezed state with higher-order sidebands is a valuable quantum resource for channel multiplexing quantum communication. However, balanced homodyne detection used in nonclassical light detection has a trade-off performance between the detection bandwidth and clearance, in which the verification of a highly squeezing factor faces a challenge. Here, we construct two optical parametric amplifiers with cavity enhancement; one is for the generation of a -10.5 dB squeezed vacuum state, and the other is for all-optical phase-sensitive parametric homodyne detection. Finally, -6.5 dB squeezing at the carrier with 17 pairs of squeezing sidebands (bandwidth of 156 GHz) is directly and simultaneously observed. In particular, for the cavity-enhanced parametric oscillation and detection processes, we analyze the limiting factors of the detectable bandwidth and measurement deviation from the generated value, which indicates that the length difference and propagation loss between two optical parametric amplifiers should be as small as possible to improve the detection performance. The experimental results confirm our theoretical analysis.

Optics Letters•Dec 20, 2021•8 citations

A Low-Noise Hybrid-Integrated Balanced Homodyne Receiver with 2.5 GHz Bandwidth and 15 dB Quantum Shot Noise Clearance

Yihao Yang, Chao Zeng Cheng, Ruixuan Yang +5 more

The rapid development of continuous-variable quantum communication has driven an increasing demand for high-performance quantum signal processing modules. Among these, the balanced homodyne detector (BHD) has emerged as a leading solution for practical quantum state measurement due to its capability to provide complete quantum mechanical characterization. However, its performance is often constrained by limited bandwidth and high noise levels, primarily due to the reliance on bulk optical components and discrete receiver electronics. The dominant noise source in these systems typically stems from electronic noise, while imbalances in the optical path further degrade the signal-to-noise ratio (SNR) of the BHD. In this work, we present an adjustable integrated optical path to enhance the balance within the BHD system, along with a low-noise transimpedance amplifier (TIA) by employing optoelectronic co-design. Our design achieves a bandwidth of 2.5 GHz, an input-referred noise current of only 2 pA/√Hz in 180 nm CMOS technology, and a measured quantum shot noise clearance of 15 dB generated from a 700 μA photocurrent. This is the maximum quantum shot noise clearance at the same BHD photocurrent reported to date above the GHz bandwidth.

Micromachines•Dec 17, 2025•0 citations

Design and characterization of wideband balanced homodyne detectors for quantum homodyne tomography

Erick Barrios Barocio

This thesis reports the realization and applications of a versatile wideband balanced homodyne detector operating in the time domain and intended for Quantum Optical Tomography. The detector can work with high repetition rate lasers used for the production and measurement of the electric field quadratures of quantum states of light. Full characterization of the detector by shot-noise measurements and by verifying its capability to reconstruct the density matrix and Wigner function of various states of interest is given. By overcoming photodiodes response mismatch, high frequency electronics issues and by choosing an appropriate optical set-up, a high level of common mode suppression (52.4dB) and a low electronic noise gave a shot-to-electronic noise ratio of I3dB for a Local Oscillator with 6.2 x 108 photons-per-pulse on a ~ 100MHz bandwidth. Results for the characterization of a single-photon Fock state are presented. An average efficiency of 56% was obtained for the generation/detection of the state.

•Jan 1, 2012•0 citations
High-frequency squeezed states are important for quantum metrology and information processing, but quadrature measurements at gigahertz frequencies remain challenging. Balanced homodyne detection (BHD), the standard approach, requires closely matched complex transfer functions in both photodetection channels to suppress local-oscillator (LO) noise and maintain a well-defined readout quadrature. This matching becomes increasingly difficult at high bandwidths. Strongly asymmetric single-photodiode homodyne detection avoids this requirement, but achieving high signal efficiency and shot-noise clearance typically requires hundreds of milliwatts of LO power and does not suppress technical LO sidebands. I propose cavity-assisted homodyne detection, in which the quantum field and LO enter separate ports of an impedance-matched traveling-wave cavity. The resonant LO carrier is transmitted to the photodetector, where it beats with off-resonant signal sidebands reflected from the cavity. At the same time, technical LO sidebands outside the cavity linewidth are suppressed. I derive the quantum input-output relations and linearized photocurrent including intracavity loss, and show that near-unity signal-transfer efficiency can be achieved at moderate incident LO power. The cavity linewidth and free spectral range determine the usable detection band.
Squeezed state light is a fundamental resource for many quantum optics experiments. Important applications like quantum-enhanced magnetometer and quantum key distribution, require the squeezing level as high as possible. In balanced homodyne detection, the detector output is directly proportional to the noise of the squeezed beam. The detected quadrature is dependent on the relative phase between the squeezed beam and local oscillator. Here, we present a balanced homodyne detector (BHD) with independent phase control and noise detection branches. The independence between the phase control and noise detection branches is experimentally verified, the two branches are independently optimized according to the practical requirements. With the BHD, a bright squeezed light at 1550 nm with quantum noise reduction of 10.3 dB is directly detected. After stabilizing the relative phase between the squeezed states and local oscillator by the phase locking branch of the BHD, the fluctuation of the noise suppression is ±0.2 dB by 1-h testing time.
A photodetector's electronic bandwidth is the frequency range over which beats between different frequencies in the input can be observed in the output. The output of a balanced homodyne detector, the prototypical device for detecting squeezed light, consists of beats between a signal to be measured and a local oscillator. Beats between the signal and quantum local-oscillator fluctuations lead to noise that degrades the observed squeezing. Through wide-band calculations, we show that this noise contains contributions from the entire signal bandwidth, even when this bandwidth is orders of magnitude larger than the detector's electronic bandwidth. This allows us to place an upper limit on the total power that can enter the detector's signal port (both signal and extraneous light) within the detector's optical bandwidth in order for a given level of squeezing to be observable.
Balanced Homodyne Detection (BHD), introduced in the 1970s, enables highly sensitive detection of phase and amplitude variations in weak light. Initially developed as an advanced optical detection technique, it rapidly became essential in quantum optics for accurately quantifying quadrature components and detecting squeezed states at the shot-noise limit. Today, BHD plays a critical role in diverse fields such as high-precision quantum metrology, gigabit speed optical communications, gravitational wave detection, and large-scale quantum information systems. In this study, a BHD simulation was implemented with a 90 phase difference between the local oscillator and the signal, thus enabling the extraction of the phase quadratureP^component of the optical field.
A squeezed state with higher-order sidebands is a valuable quantum resource for channel multiplexing quantum communication. However, balanced homodyne detection used in nonclassical light detection has a trade-off performance between the detection bandwidth and clearance, in which the verification of a highly squeezing factor faces a challenge. Here, we construct two optical parametric amplifiers with cavity enhancement; one is for the generation of a -10.5 dB squeezed vacuum state, and the other is for all-optical phase-sensitive parametric homodyne detection. Finally, -6.5 dB squeezing at the carrier with 17 pairs of squeezing sidebands (bandwidth of 156 GHz) is directly and simultaneously observed. In particular, for the cavity-enhanced parametric oscillation and detection processes, we analyze the limiting factors of the detectable bandwidth and measurement deviation from the generated value, which indicates that the length difference and propagation loss between two optical parametric amplifiers should be as small as possible to improve the detection performance. The experimental results confirm our theoretical analysis.
The rapid development of continuous-variable quantum communication has driven an increasing demand for high-performance quantum signal processing modules. Among these, the balanced homodyne detector (BHD) has emerged as a leading solution for practical quantum state measurement due to its capability to provide complete quantum mechanical characterization. However, its performance is often constrained by limited bandwidth and high noise levels, primarily due to the reliance on bulk optical components and discrete receiver electronics. The dominant noise source in these systems typically stems from electronic noise, while imbalances in the optical path further degrade the signal-to-noise ratio (SNR) of the BHD. In this work, we present an adjustable integrated optical path to enhance the balance within the BHD system, along with a low-noise transimpedance amplifier (TIA) by employing optoelectronic co-design. Our design achieves a bandwidth of 2.5 GHz, an input-referred noise current of only 2 pA/√Hz in 180 nm CMOS technology, and a measured quantum shot noise clearance of 15 dB generated from a 700 μA photocurrent. This is the maximum quantum shot noise clearance at the same BHD photocurrent reported to date above the GHz bandwidth.
This thesis reports the realization and applications of a versatile wideband balanced homodyne detector operating in the time domain and intended for Quantum Optical Tomography. The detector can work with high repetition rate lasers used for the production and measurement of the electric field quadratures of quantum states of light. Full characterization of the detector by shot-noise measurements and by verifying its capability to reconstruct the density matrix and Wigner function of various states of interest is given. By overcoming photodiodes response mismatch, high frequency electronics issues and by choosing an appropriate optical set-up, a high level of common mode suppression (52.4dB) and a low electronic noise gave a shot-to-electronic noise ratio of I3dB for a Local Oscillator with 6.2 x 108 photons-per-pulse on a ~ 100MHz bandwidth. Results for the characterization of a single-photon Fock state are presented. An average efficiency of 56% was obtained for the generation/detection of the state.