Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2603.16795

Boosted linear-optical measurements on single-rail qubits with unentangled ancillas

Aqil Sajjad, Isack Padilla, Saikat Guha

quant-phcs.ITSubmitted Mar 17, 2026• Announced Mar 18, 2026• 1 citation
arXivHTMLPDF

Abstract

Any quantum state of the radiation field, sliced in small non-overlapping space-time bins is a collection of single-rail qubits, each spanning the vacuum and single-photon Fock state of a mode. Quantum logic on these qubits would enable arbitrary measurements on information-bearing light, but is hard due to the lack of strong nonlinearities. With unentangled ancilla single-rail qubits, an $8$-port interferometer and photon detection, we show any single-rail qubit measurement in the $XY$ Bloch plane is realizable with success probability $147/256$, which beats the prior-known $1/2$ limit.

Comments
20 pages, 3 figures

Related papers

Beating the One-Half Limit of Ancilla-Free Linear Optics Bell Measurements

Hussain Zaidi, Peter van Loock

We show that optically encoded two-qubit Bell states can be unambiguously discriminated with a success probability of more than 50% in both single-rail and dual-rail encodings by using active linear-optical resources that include Gaussian squeezing operations. These results are in contrast to the well-known upper bound of 50% for unambiguous discrimination of dual-rail Bell states using passive, static linear optics and arbitrarily many vacuum modes. We present experimentally feasible schemes that improve the success probability to 64.3% in dual-rail and to 62.5% in single-rail for a uniform random distribution of Bell states. Conceptually, this demonstrates that neither interactions that induce nonlinear mode transformations (such as Kerr interactions) nor auxiliary entangled photons are required to go beyond the one-half limit. We discuss the optimality of our single-rail scheme and talk about an application of our dual-rail scheme in quantum communication.

arXiv:1301.2749•Physical Review Letters•Jun 24, 2013•65 citations

Adaptive phase measurements in linear optical quantum computation

Timothy C. Ralph, Austin P. Lund, Howard M. Wiseman

Photon counting induces an effective non-linear optical phase shift in certain states derived by linear optics from single photons. Although this non-linearity is non-deterministic, it is sufficient in principle to allow scalable linear optics quantum computation (LOQC). The most obvious way to encode a qubit optically is as a superposition of the vacuum and a single photon in one mode—so-called ‘single-rail’ logic. Until now this approach was thought to be prohibitively expensive (in resources) compared to ‘dual-rail’ logic where a qubit is stored by a photon across two modes. Here we attack this problem with real-time feedback control, which can realize a quantum-limited phase measurement on a single mode, as has been recently demonstrated experimentally. We show that with this added measurement resource, the resource requirements for single-rail LOQC are not substantially different from those of dual-rail LOQC. In particular, with adaptive phase measurements an arbitrary qubit state can be prepared deterministically .

arXiv:quant-ph/0507192•Journal of Optics B Quantum and Semiclassical Optics•Sep 14, 2005•29 citations

3/4 -Efficient Bell Measurement with Passive Linear Optics and Unentangled Ancillae

Fabian Ewert, Peter van Loock

It is well known that an unambiguous discrimination of the four optically encoded Bell states is possible with a probability of 50% at best, when using static, passive linear optics and arbitrarily many vacuum-mode ancillae. By adding unentangled single-photon ancillae, we are able to surpass this limit and reach a success probability of at least 75%. We discuss the error robustness of the proposed scheme and a generalization to reach a success probability arbitrarily close to 100%.

arXiv:1403.4841•Physical Review Letters•Sep 30, 2014•199 citations

No-go theorem for passive single-rail linear optical quantum computing

Lian-Ao Wu, Philip John Walther, Daniel A. Lidar

Photonic quantum systems are among the most promising architectures for quantum computers. It is well known that for dual-rail photons effective non-linearities and near-deterministic non-trivial two-qubit gates can be achieved via the measurement process and by introducing ancillary photons. While in principle this opens a legitimate path to scalable linear optical quantum computing, the technical requirements are still very challenging and thus other optical encodings are being actively investigated. One of the alternatives is to use single-rail encoded photons, where entangled states can be deterministically generated. Here we prove that even for such systems universal optical quantum computing using only passive optical elements such as beam splitters and phase shifters is not possible. This no-go theorem proves that photon bunching cannot be passively suppressed even when extra ancilla modes and arbitrary number of photons are used. Our result provides useful guidance for the design of optical quantum computers.

arXiv:1107.4646•Scientific Reports•Mar 6, 2013•20 citations

On photonic controlled phase gates

Konrad Kieling, Jeremy L. O’Brien, Jens Eisert

As primitives for entanglement generation, controlled phase gates have a central role in quantum computing. Especially in ideas realizing instances of quantum computation in linear optical gate arrays, a closer look can be rewarding. In such architectures, all effective nonlinearities are induced by measurements. Hence the probability of success is a crucial parameter of such quantum gates. In this paper, we discuss this question for controlled phase gates that implement an arbitrary phase with one and two control qubits. Within the class of post-selected gates in dual-rail encoding with vacuum ancillas, we identify the optimal success probabilities. We construct networks that allow for implementation using current experimental capabilities in detail. The methods employed here appear specifically useful with the advent of integrated linear optical circuits, providing stable interferometers on monolithic structures.

arXiv:0909.2057•New Journal of Physics•Jan 11, 2010•35 citations

Realisation of Quantum Operations using Linear Optics

David Pitkanen

The main topic of this thesis is linear optics and the implementation of quantum operations (measurements, quantum channels, and unitary rotations) on optical systems. \nIn the opening chapter the basic notions needed to understand the rest of the thesis will be explained. \nThese notions include defining a quantum state, measurement, quantum channel and the linear optics tool set. \n \nThe work in this thesis takes both fundamental and practical approaches to studying linear optical networks. \nFor instance in the first chapter a proof is provided that shows that any unitary on a single mode Fock state can be realised with linear optics. \nThe proof is constructive, however the approach to realising the unitary is not suitable for experimental implementation \nbecause it requires complicated ancilla states. \nAs in the KLM proposal the procedure works only stochastically however by allowing the size of the ancilla to grow \nthe probability of failure can be made arbitrarly small. \n \nFurthermore we investigate the realisation of arbitrary channels in a specific encoding that we call a $d$-rail encoding. \nThe only ancilla state that we allow is a vacuum ancilliary state and further restrictions were considered (e.g. photon counting). \nA proof is provided that using these resources only random unitaries can be applied deterministically using linear optics. An expression for the optimal probability of success for realising \nmore general channels with these resources is also discussed. \n \nAs a final topic we also investigate the realisation of a quantum non-demolition measurement onto the dual rail qubit space. \nThe investigation is a blend of both fundamental and practical approaches. \nTo begin we employ a modified KLM-like procedure and show that the scheme can be realised perfectly but stochastically. \nThe probability that the proper measurement is made can be made arbitrarly close to one using a suitably large ancilla state. \nIn addition we consider an existing scheme \\cite{gisin10a} which uses practical sources (two single photon sources) to perform the measurement. \nThe scheme does not realise the true measurement but instead has a free parameter in it which is the transmittiviy of a beamsplitter. The measurement will project onto a space that has a vacuum component. By adjusting the transmittivity of this beamsplitter the vacuum component can be made arbitrarly small but only at the expense of the probability of success of the procedure. \nIn this thesis a modification that can be made to eliminate the vacuum component without changing the sources is introduced. The modification is surprisingly simple and only involves the addition of a single beamsplitter. In the proposal for the original amplifier it was used in simulations for DIQKD that included device imperfections. \nTo show the improvement of our modification these DIQKD simulations are reproduced using the modified amplifier and its results are compared to the results of the original amplifier.

•Oct 4, 2011•0 citations
Any quantum state of the radiation field, sliced in small non-overlapping space-time bins is a collection of single-rail qubits, each spanning the vacuum and single-photon Fock state of a mode. Quantum logic on these qubits would enable arbitrary measurements on information-bearing light, but is hard due to the lack of strong nonlinearities. With unentangled ancilla single-rail qubits, an 888-port interferometer and photon detection, we show any single-rail qubit measurement in the XYXYXY Bloch plane is realizable with success probability 147/256147/256147/256, which beats the prior-known 1/21/21/2 limit.
We show that optically encoded two-qubit Bell states can be unambiguously discriminated with a success probability of more than 50% in both single-rail and dual-rail encodings by using active linear-optical resources that include Gaussian squeezing operations. These results are in contrast to the well-known upper bound of 50% for unambiguous discrimination of dual-rail Bell states using passive, static linear optics and arbitrarily many vacuum modes. We present experimentally feasible schemes that improve the success probability to 64.3% in dual-rail and to 62.5% in single-rail for a uniform random distribution of Bell states. Conceptually, this demonstrates that neither interactions that induce nonlinear mode transformations (such as Kerr interactions) nor auxiliary entangled photons are required to go beyond the one-half limit. We discuss the optimality of our single-rail scheme and talk about an application of our dual-rail scheme in quantum communication.
Photon counting induces an effective non-linear optical phase shift in certain states derived by linear optics from single photons. Although this non-linearity is non-deterministic, it is sufficient in principle to allow scalable linear optics quantum computation (LOQC). The most obvious way to encode a qubit optically is as a superposition of the vacuum and a single photon in one mode—so-called ‘single-rail’ logic. Until now this approach was thought to be prohibitively expensive (in resources) compared to ‘dual-rail’ logic where a qubit is stored by a photon across two modes. Here we attack this problem with real-time feedback control, which can realize a quantum-limited phase measurement on a single mode, as has been recently demonstrated experimentally. We show that with this added measurement resource, the resource requirements for single-rail LOQC are not substantially different from those of dual-rail LOQC. In particular, with adaptive phase measurements an arbitrary qubit state can be prepared deterministically .
Photonic quantum systems are among the most promising architectures for quantum computers. It is well known that for dual-rail photons effective non-linearities and near-deterministic non-trivial two-qubit gates can be achieved via the measurement process and by introducing ancillary photons. While in principle this opens a legitimate path to scalable linear optical quantum computing, the technical requirements are still very challenging and thus other optical encodings are being actively investigated. One of the alternatives is to use single-rail encoded photons, where entangled states can be deterministically generated. Here we prove that even for such systems universal optical quantum computing using only passive optical elements such as beam splitters and phase shifters is not possible. This no-go theorem proves that photon bunching cannot be passively suppressed even when extra ancilla modes and arbitrary number of photons are used. Our result provides useful guidance for the design of optical quantum computers.
As primitives for entanglement generation, controlled phase gates have a central role in quantum computing. Especially in ideas realizing instances of quantum computation in linear optical gate arrays, a closer look can be rewarding. In such architectures, all effective nonlinearities are induced by measurements. Hence the probability of success is a crucial parameter of such quantum gates. In this paper, we discuss this question for controlled phase gates that implement an arbitrary phase with one and two control qubits. Within the class of post-selected gates in dual-rail encoding with vacuum ancillas, we identify the optimal success probabilities. We construct networks that allow for implementation using current experimental capabilities in detail. The methods employed here appear specifically useful with the advent of integrated linear optical circuits, providing stable interferometers on monolithic structures.
The main topic of this thesis is linear optics and the implementation of quantum operations (measurements, quantum channels, and unitary rotations) on optical systems. \nIn the opening chapter the basic notions needed to understand the rest of the thesis will be explained. \nThese notions include defining a quantum state, measurement, quantum channel and the linear optics tool set. \n \nThe work in this thesis takes both fundamental and practical approaches to studying linear optical networks. \nFor instance in the first chapter a proof is provided that shows that any unitary on a single mode Fock state can be realised with linear optics. \nThe proof is constructive, however the approach to realising the unitary is not suitable for experimental implementation \nbecause it requires complicated ancilla states. \nAs in the KLM proposal the procedure works only stochastically however by allowing the size of the ancilla to grow \nthe probability of failure can be made arbitrarly small. \n \nFurthermore we investigate the realisation of arbitrary channels in a specific encoding that we call a ddd-rail encoding. \nThe only ancilla state that we allow is a vacuum ancilliary state and further restrictions were considered (e.g. photon counting). \nA proof is provided that using these resources only random unitaries can be applied deterministically using linear optics. An expression for the optimal probability of success for realising \nmore general channels with these resources is also discussed. \n \nAs a final topic we also investigate the realisation of a quantum non-demolition measurement onto the dual rail qubit space. \nThe investigation is a blend of both fundamental and practical approaches. \nTo begin we employ a modified KLM-like procedure and show that the scheme can be realised perfectly but stochastically. \nThe probability that the proper measurement is made can be made arbitrarly close to one using a suitably large ancilla state. \nIn addition we consider an existing scheme \\cite{gisin10a} which uses practical sources (two single photon sources) to perform the measurement. \nThe scheme does not realise the true measurement but instead has a free parameter in it which is the transmittiviy of a beamsplitter. The measurement will project onto a space that has a vacuum component. By adjusting the transmittivity of this beamsplitter the vacuum component can be made arbitrarly small but only at the expense of the probability of success of the procedure. \nIn this thesis a modification that can be made to eliminate the vacuum component without changing the sources is introduced. The modification is surprisingly simple and only involves the addition of a single beamsplitter. In the proposal for the original amplifier it was used in simulations for DIQKD that included device imperfections. \nTo show the improvement of our modification these DIQKD simulations are reproduced using the modified amplifier and its results are compared to the results of the original amplifier.