Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2509.26071 · Nano Letters

Harnessing the Diamond–Air Interface as an Efficient Photon Antenna for Solid-State Emitters

Paul Weinbrenner, Aina Lopez Benet, İdil Gözel, Friedemann Reinhard

Published Jan 14, 2026• 1 citation
arXivHTMLPDF

Abstract

Extracting photons from defect centers is challenging due to the high refractive index of typical substrates. For nitrogen-vacancy centers in diamond, reaching saturation count rates above 2.5 × 10 5 counts/s so far requires nanofabricated optics, such as diamond waveguides or solid immersion lenses. Here, we present an experimental and theoretical study of defect center emission at unmodified planar dielectric surfaces by quantitative back-focal-plane imaging and analytical modeling. Our results indicate that photon count rates approaching those of nanofabricated optics can also be achieved by oil-immersion optics. This is due to a dielectric antenna effect, which directs the majority of the emission into the substrate within a narrow angle window suitable for back-side collection. By quantification of the collection efficiency of back-side detection, our work also enables a novel measurement method for the quantum efficiency of shallow defect centers. Its result challenges established values. Possible reasons for the discrepancy are discussed.

DOI
10.1021/acs.nanolett.5c04935

Related papers

Strongly enhanced photon collection from diamond defect centers under microfabricated integrated solid immersion lenses

John Patrick Hadden, J. P. Harrison, A. C. Stanley‐Clarke +5 more

The efficiency of photon collection from optically active defect centers in bulk diamond is greatly reduced by refraction at the diamond-air interface. We report on the fabrication and measurement of a geometrical solution to the problem; integrated solid immersion lenses (SILs) etched directly into the surface of diamond. An increase of a factor of 10 was observed in the saturated count-rate from a single negatively charged nitrogen-vacancy (NV−) within a 5 μm diameter SIL compared with NV−’s under a planar surface in the same crystal. Such a system is potentially scalable and easily adaptable to other defect centers in bulk diamond.

arXiv:1006.2093•Applied Physics Letters•Dec 13, 2010•297 citations

A cavity-based optical antenna for color centers in diamond

Philipp Fuchs, Thomas Jung, Michael Kieschnick +2 more

An efficient atom–photon interface is a key requirement for the integration of solid-state emitters, such as color centers in diamond, into quantum technology applications. As other solid-state emitters, however, their emission into free space is severely limited due to the high refractive index of the bulk host crystal. In this work, we present a planar optical antenna based on two silver mirrors coated on a thin single crystal diamond membrane, forming a planar Fabry–Pérot cavity that improves the photon extraction from single tin vacancy (SnV) centers and their coupling to an excitation laser. Upon numerical optimization of the structure, we find theoretical enhancements in the collectible photon rate by a factor of 60 as compared to the bulk case. As a proof-of-principle demonstration, we fabricate single crystal diamond membranes with sub-μm thickness and create SnV centers by ion implantation. Employing off-resonant excitation, we show a sixfold enhancement of the collectible photon rate, yielding up to half a million photons per second from a single SnV center. At the same time, we observe a significant reduction of the required excitation power in accordance with theory, demonstrating the functionality of the cavity as an optical antenna. Due to its planar design, the antenna simultaneously provides similar enhancements for a large number of emitters inside the membrane. Furthermore, the monolithic structure provides high mechanical stability and straightforwardly enables operation under cryogenic conditions as required in most spin–photon interface implementations.

arXiv:2105.10249•APL Photonics•Aug 1, 2021•19 citations

A compact and simple photonic nano-antenna for efficient photon extraction from nitrogen vacancy centers in bulk diamond

Niko Nikolay, Günter Kewes, Oliver J. Benson

Enhancing the collection efficiency of single emitters via dielectric antennas is a common approach in research dealing with solid-state quantum light sources. Current design concepts often suffer from a large footprint, quenching or a complex fabrication process. Here we report on another design where the Kerker effect is used to collimate emission from a nitrogen vacancy (NV) center. The structure discussed here is an easy to fabricate cylindrical protrusion made from diamond on top of a diamond substrate with NVs incorporated into its center. We optimize the structure with respect to application in quantum information processing and quantum sensing and find an up to 15 times higher photon extraction.

arXiv:1704.08951•Apr 28, 2017•2 citations

Towards quantum information processing with diamond color centers

Amir H. Karamlou

The DiVincenco requirements summarize the key properties that quantum systems should have to be useful for quantum computing.The work in this thesis focuses on one of the leading solid-state quantum systems, the nitrogen vacancy (NV) center in diamond.The NV has emerged as an excellent quantum sensor, in which quantum logic techniques can significantly improve performance.However, a remaining problem concerns the rate and fidelity of NV spin measurement.To address this problem in this thesis we first propose and theoretically demonstrate a scheme for spatially robust state-selective transitions with over 99.9% fidelity between different spin states in zero-field splitting.Furthermore, another central challenge tackled in this work is the efficient collection of the emitter's fluorescence.Optical antennas are appealing as they offer directional emission together with spontaneous emission rate enhancement across a broad emitter spectrum.We introduce and optimize metal-dielectric nanoantenna designs recessed into a diamond substrate and aligned with quantum emitters.We analyze trade-offs between external quantum efficiency, collection efficiency, Purcell factor, and overall collected photon rate.This analysis shows that an optimized metal-dielectric hybrid structure can increase the collected photon rate from a nitrogen vacancy center by over two orders of magnitude compared to a bare emitter.As a result, these metal-dielectric antennas should enable single-shot electron spin measurements of NV centers at room temperature.

•Jan 1, 2018•0 citations

Nitrogen‐Vacancy Emission from Nanodiamond: Size, Depth, and Surroundings

Harini Hapuarachchi, Francesco Campaioli, Jared H. Cole +2 more

ABSTRACT The negatively charged nitrogen‐vacancy (NV) center in diamond is a leading solid‐state quantum emitter, offering spin‐photon interfaces over a wide temperature range with applications from electromagnetic sensing to bioimaging. While NV centers in bulk diamond are well understood, embedding them in nanodiamond (ND) introduces complexities from size, NV location, and NV polarizations. NVs in ND show altered fluorescence properties, including longer lifetimes, lower quantum efficiency, and higher sensitivity to dielectric surroundings, which arise from radiative suppression, surface‐induced non‐radiative decay, and escape inefficiency at the diamond‐background interface. Prior models typically addressed isolated aspects, such as dielectric contrast or surface quenching, without integrating full quantum‐optical NV behavior with classical electrodynamics. We present a hybrid framework coupling rigorous electromagnetic simulations with a quantum‐optical NV model including phonon sideband dynamics. NV emission is found to depend strongly on ND size, NV position, and surrounding refractive index. Our results explain observations such as shallow NVs in water‐coated ND appearing brighter than deeper ones in air. This integrated model provides a unified framework for realistic NV in ND emission scenarios and informs the design of efficient NV‐based sensors and quantum devices, advancing understanding of quantum emitter photophysics in nanoscale crystals.

arXiv:2508.08565•Annalen der Physik•Dec 8, 2025•3 citations

Additive solid immersion lenses for enhanced collection efficiency of shallow NV centers by pulsed laser deposition and structurization of high-k amorphous oxides

Michael S. Bar, Nicole Raatz, Max Kneiss +3 more

The negatively charged nitrogen-vacancy ($\mathrm{NV}^-$) defect in diamond can be used for quantum information processing via the readout of the radiative decay of the excited state into the ground state. The large refractive index mismatch of diamond and air causes low photon extraction efficiency due to total internal reflection losses. Here, we investigate the photon extraction numerically and report additive solid immersion lenses (SILs) consisting of the high-k dielectric yttria-stabilized-zirconia (YSZ) for surface modification and enhanced light extraction of shallow implanted nitrogen-vacancy centers. We demonstrate an average increase of 63% in saturation intensity using a scalable bottum up room temperature pulsed laser deposition and photolithography structurization process. The average necessary laser intensity for saturation is reduced by 33% by the SILs.

cond-mat.mtrl-sciCross-listedarXiv:2610.01183•Oct 2, 2026•0 citations
Extracting photons from defect centers is challenging due to the high refractive index of typical substrates. For nitrogen-vacancy centers in diamond, reaching saturation count rates above 2.5 × 10 5 counts/s so far requires nanofabricated optics, such as diamond waveguides or solid immersion lenses. Here, we present an experimental and theoretical study of defect center emission at unmodified planar dielectric surfaces by quantitative back-focal-plane imaging and analytical modeling. Our results indicate that photon count rates approaching those of nanofabricated optics can also be achieved by oil-immersion optics. This is due to a dielectric antenna effect, which directs the majority of the emission into the substrate within a narrow angle window suitable for back-side collection. By quantification of the collection efficiency of back-side detection, our work also enables a novel measurement method for the quantum efficiency of shallow defect centers. Its result challenges established values. Possible reasons for the discrepancy are discussed.
The efficiency of photon collection from optically active defect centers in bulk diamond is greatly reduced by refraction at the diamond-air interface. We report on the fabrication and measurement of a geometrical solution to the problem; integrated solid immersion lenses (SILs) etched directly into the surface of diamond. An increase of a factor of 10 was observed in the saturated count-rate from a single negatively charged nitrogen-vacancy (NV−) within a 5 μm diameter SIL compared with NV−’s under a planar surface in the same crystal. Such a system is potentially scalable and easily adaptable to other defect centers in bulk diamond.
An efficient atom–photon interface is a key requirement for the integration of solid-state emitters, such as color centers in diamond, into quantum technology applications. As other solid-state emitters, however, their emission into free space is severely limited due to the high refractive index of the bulk host crystal. In this work, we present a planar optical antenna based on two silver mirrors coated on a thin single crystal diamond membrane, forming a planar Fabry–Pérot cavity that improves the photon extraction from single tin vacancy (SnV) centers and their coupling to an excitation laser. Upon numerical optimization of the structure, we find theoretical enhancements in the collectible photon rate by a factor of 60 as compared to the bulk case. As a proof-of-principle demonstration, we fabricate single crystal diamond membranes with sub-μm thickness and create SnV centers by ion implantation. Employing off-resonant excitation, we show a sixfold enhancement of the collectible photon rate, yielding up to half a million photons per second from a single SnV center. At the same time, we observe a significant reduction of the required excitation power in accordance with theory, demonstrating the functionality of the cavity as an optical antenna. Due to its planar design, the antenna simultaneously provides similar enhancements for a large number of emitters inside the membrane. Furthermore, the monolithic structure provides high mechanical stability and straightforwardly enables operation under cryogenic conditions as required in most spin–photon interface implementations.
Enhancing the collection efficiency of single emitters via dielectric antennas is a common approach in research dealing with solid-state quantum light sources. Current design concepts often suffer from a large footprint, quenching or a complex fabrication process. Here we report on another design where the Kerker effect is used to collimate emission from a nitrogen vacancy (NV) center. The structure discussed here is an easy to fabricate cylindrical protrusion made from diamond on top of a diamond substrate with NVs incorporated into its center. We optimize the structure with respect to application in quantum information processing and quantum sensing and find an up to 15 times higher photon extraction.
The DiVincenco requirements summarize the key properties that quantum systems should have to be useful for quantum computing.The work in this thesis focuses on one of the leading solid-state quantum systems, the nitrogen vacancy (NV) center in diamond.The NV has emerged as an excellent quantum sensor, in which quantum logic techniques can significantly improve performance.However, a remaining problem concerns the rate and fidelity of NV spin measurement.To address this problem in this thesis we first propose and theoretically demonstrate a scheme for spatially robust state-selective transitions with over 99.9% fidelity between different spin states in zero-field splitting.Furthermore, another central challenge tackled in this work is the efficient collection of the emitter's fluorescence.Optical antennas are appealing as they offer directional emission together with spontaneous emission rate enhancement across a broad emitter spectrum.We introduce and optimize metal-dielectric nanoantenna designs recessed into a diamond substrate and aligned with quantum emitters.We analyze trade-offs between external quantum efficiency, collection efficiency, Purcell factor, and overall collected photon rate.This analysis shows that an optimized metal-dielectric hybrid structure can increase the collected photon rate from a nitrogen vacancy center by over two orders of magnitude compared to a bare emitter.As a result, these metal-dielectric antennas should enable single-shot electron spin measurements of NV centers at room temperature.
ABSTRACT The negatively charged nitrogen‐vacancy (NV) center in diamond is a leading solid‐state quantum emitter, offering spin‐photon interfaces over a wide temperature range with applications from electromagnetic sensing to bioimaging. While NV centers in bulk diamond are well understood, embedding them in nanodiamond (ND) introduces complexities from size, NV location, and NV polarizations. NVs in ND show altered fluorescence properties, including longer lifetimes, lower quantum efficiency, and higher sensitivity to dielectric surroundings, which arise from radiative suppression, surface‐induced non‐radiative decay, and escape inefficiency at the diamond‐background interface. Prior models typically addressed isolated aspects, such as dielectric contrast or surface quenching, without integrating full quantum‐optical NV behavior with classical electrodynamics. We present a hybrid framework coupling rigorous electromagnetic simulations with a quantum‐optical NV model including phonon sideband dynamics. NV emission is found to depend strongly on ND size, NV position, and surrounding refractive index. Our results explain observations such as shallow NVs in water‐coated ND appearing brighter than deeper ones in air. This integrated model provides a unified framework for realistic NV in ND emission scenarios and informs the design of efficient NV‐based sensors and quantum devices, advancing understanding of quantum emitter photophysics in nanoscale crystals.
The negatively charged nitrogen-vacancy (NV−\mathrm{NV}^-NV−) defect in diamond can be used for quantum information processing via the readout of the radiative decay of the excited state into the ground state. The large refractive index mismatch of diamond and air causes low photon extraction efficiency due to total internal reflection losses. Here, we investigate the photon extraction numerically and report additive solid immersion lenses (SILs) consisting of the high-k dielectric yttria-stabilized-zirconia (YSZ) for surface modification and enhanced light extraction of shallow implanted nitrogen-vacancy centers. We demonstrate an average increase of 63% in saturation intensity using a scalable bottum up room temperature pulsed laser deposition and photolithography structurization process. The average necessary laser intensity for saturation is reduced by 33% by the SILs.