Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2507.11890 · Conference on Lasers and Electro-Optics

Observation of Quantum Noise Reduction in a Raman Amplifier via Quantum Correlation between Atom and Light

Jianmin Wang, Rong Zhu, Yue Li, Z. Y. Ou

Published Nov 13, 2025• 0 citations
arXivHTMLPDF

Abstract

Any amplifier requires coupling to its internal degrees of freedom for energy gain. This coupling introduces extra quantum noise to the output. On the other hand, if the internal degree of the amplifier can be accessed and manipulated, we can manage and even reduce the quantum noise of the amplifier's output. In this Letter, we present an experiment to reduce the quantum noise of a Raman amplifier by preparing the atomic medium in a correlated state with the Stokes light field. We report an observation of quantum noise reduction of more than 3.5 dB in the atomic Raman amplification process. From another perspective, the Raman amplifier at high gain in turn serves as a measurement tool for the quantum correlation between the atom and light. Furthermore, such a scheme, when viewed as a whole, also forms a quantum-entangled atom-light hybrid interferometer that can lead to quantum-enhanced sensors.

DOI
10.1364/cleo_fs.2026.fth4a.1

Related papers

Loss-insensitive quantum noise reduction in a Raman amplifier with coherent feedback

Jianmin Wang, Rong Zhu, Z. Y. Ou

A quantum amplifier usually adds extra noise inevitably through coupling to internal degrees of freedom while amplifying the signal. The introduction of quantum correlations can effectively suppress this extra noise. In this work, we utilize the established quantum correlation between the Stokes field and atomic spin waves in the Raman amplification process to feedback a portion of the Stokes field into the amplifier. This leads to a reduction in quantum noise that is independent of the feedback loss at high gain. A maximum of 6 dB noise reduction is observed. The single-path feedback amplifier is found to be sensitive to the feedback phase, a property that expands its potential for applications in quantum precision measurement, and the general concept can be extended to integrated optics and fiber optic systems.

quant-pharXiv:2602.22567•Feb 27, 2026•1 citation

Observation of Quantum Noise Suppression via Atom-Light Correlations in a Raman Amplifier

Rong Zhu, Jianmin Wang, Yue Li +1 more

We demonstrate 3.5 dB quantum-noise reduction in an atomic Raman amplifier by correlating the input Stokes field with a collective atomic spin wave. At high gain, the output noise also provides an all-optical measure of the atom-light quantum correlation. OCIS codes: 120.0120, 270.0270;

Conference on Lasers and Electro-Optics Pacific Rim (CLEO-PR)•Aug 1, 2026•0 citations

Cancellation of Internal Quantum Noise of an Amplifier by Quantum Correlation

Jia Kong, Florian Hudelist, Z. Y. Ou +1 more

Quantum noise is usually added in an amplification process through the internal degrees of the amplifier. Coupling the squeezed state to the internal degree can suppress the extra noise. Here, we demonstrate another method: when the internal degree of the amplifier is correlated with the input signal via quantum entanglement, quantum destructive interference between the input and the internal degree may result in noise reduction at the amplified output. We achieve a quantum noise reduction of 2.3 dB at the output and an improvement of 4.0±0.2 dB in signal-to-noise ratio during the amplification process with a quantum noise gain of 4.5 dB.

Physical Review Letters•Jul 18, 2013•52 citations

Atom-Light Hybrid Interferometer

Bing Chen, Cheng Qiu, Shuying Chen +4 more

A new type of hybrid atom-light interferometer is demonstrated with atomic Raman amplification processes replacing the beam splitting elements in a traditional interferometer. This nonconventional interferometer involves correlated optical and atomic waves in the two arms. The correlation between atoms and light developed with the Raman process makes this interferometer different from conventional interferometers with linear beam splitters. It is observed that the high-contrast interference fringes are sensitive to the optical phase via a path change as well as the atomic phase via a magnetic field change. This new atom-light correlated hybrid interferometer is a sensitive probe of the atomic internal state and should find wide applications in precision measurement and quantum control with atoms and photons.

Physical Review Letters•Jul 24, 2015•109 citations

Quantum noise reduction in optical amplification

Z. Y. Ou, Silvania F. Pereira, Harry J. Kimble

Quantum fluctuations in optical amplification are investigated with a nondegenerate optical parametric amplifier whose internal idler mode is coupled to a squeezed vacuum. Reductions of the inherent quantum noise of the amplifier are observed with a minimum noise level 0.7 dB below the usual noise level of the amplifier with its internal idler mode in a vacuum state. With a small coherent field as the signal input, the amplified output exhibits an improvement in signal-to-noise ratio of 0.5 dB for the case of a squeezed-vacuum as compared to a vacuum state for the amplifier's internal mode.

Physical Review Letters•May 24, 1993•98 citations

Near quantum-limited phase memory in an optical amplifier

D. T. Smithey, Michael Scott Belsley, K. Wedding +1 more

Probing the quantum noise level with respect to a coherent input has recently received much attention. Several researchers have probed this question by examining the level of external optical input needed to influence the output field of a quantum noise amplifier. For example, it has been found that it takes, on average, about one photon per (temporal) mode to control the phase of the output field of a Raman amplifier.1 A similar result has been seen in optical parametric amplification.2 In contrast to using light to seed the amplification, we have investigated the level of initial molecular coherence needed to control the phase of the output field of a Raman amplifier. Two laser pulses, separated in time, were used to pump a common set of hydrogen molecules producing two Stokes pulses via stimulated Raman scattering. The relative phase of the two Stokes pulses was measured interferometrically. The variance of this relative phase is a direct measure of the memory of the molecular coherence that was induced by the first scattering process. Correlations between the two Stokes phases were observed even after nine molecular dephasing times, when the level of coherence had decayed by a factor of e−9. We show that this extraordinarily long-lived phase memory comes about because a molecular coherence corresponding to order ten vibrational photons per mode is sufficient to influence the phase of the output field.

Annual Meeting Optical Society of America•Jan 1, 1991•0 citations
Any amplifier requires coupling to its internal degrees of freedom for energy gain. This coupling introduces extra quantum noise to the output. On the other hand, if the internal degree of the amplifier can be accessed and manipulated, we can manage and even reduce the quantum noise of the amplifier's output. In this Letter, we present an experiment to reduce the quantum noise of a Raman amplifier by preparing the atomic medium in a correlated state with the Stokes light field. We report an observation of quantum noise reduction of more than 3.5 dB in the atomic Raman amplification process. From another perspective, the Raman amplifier at high gain in turn serves as a measurement tool for the quantum correlation between the atom and light. Furthermore, such a scheme, when viewed as a whole, also forms a quantum-entangled atom-light hybrid interferometer that can lead to quantum-enhanced sensors.
A quantum amplifier usually adds extra noise inevitably through coupling to internal degrees of freedom while amplifying the signal. The introduction of quantum correlations can effectively suppress this extra noise. In this work, we utilize the established quantum correlation between the Stokes field and atomic spin waves in the Raman amplification process to feedback a portion of the Stokes field into the amplifier. This leads to a reduction in quantum noise that is independent of the feedback loss at high gain. A maximum of 6 dB noise reduction is observed. The single-path feedback amplifier is found to be sensitive to the feedback phase, a property that expands its potential for applications in quantum precision measurement, and the general concept can be extended to integrated optics and fiber optic systems.
Quantum noise is usually added in an amplification process through the internal degrees of the amplifier. Coupling the squeezed state to the internal degree can suppress the extra noise. Here, we demonstrate another method: when the internal degree of the amplifier is correlated with the input signal via quantum entanglement, quantum destructive interference between the input and the internal degree may result in noise reduction at the amplified output. We achieve a quantum noise reduction of 2.3 dB at the output and an improvement of 4.0±0.2 dB in signal-to-noise ratio during the amplification process with a quantum noise gain of 4.5 dB.
A new type of hybrid atom-light interferometer is demonstrated with atomic Raman amplification processes replacing the beam splitting elements in a traditional interferometer. This nonconventional interferometer involves correlated optical and atomic waves in the two arms. The correlation between atoms and light developed with the Raman process makes this interferometer different from conventional interferometers with linear beam splitters. It is observed that the high-contrast interference fringes are sensitive to the optical phase via a path change as well as the atomic phase via a magnetic field change. This new atom-light correlated hybrid interferometer is a sensitive probe of the atomic internal state and should find wide applications in precision measurement and quantum control with atoms and photons.
Quantum fluctuations in optical amplification are investigated with a nondegenerate optical parametric amplifier whose internal idler mode is coupled to a squeezed vacuum. Reductions of the inherent quantum noise of the amplifier are observed with a minimum noise level 0.7 dB below the usual noise level of the amplifier with its internal idler mode in a vacuum state. With a small coherent field as the signal input, the amplified output exhibits an improvement in signal-to-noise ratio of 0.5 dB for the case of a squeezed-vacuum as compared to a vacuum state for the amplifier's internal mode.
Probing the quantum noise level with respect to a coherent input has recently received much attention. Several researchers have probed this question by examining the level of external optical input needed to influence the output field of a quantum noise amplifier. For example, it has been found that it takes, on average, about one photon per (temporal) mode to control the phase of the output field of a Raman amplifier.1 A similar result has been seen in optical parametric amplification.2 In contrast to using light to seed the amplification, we have investigated the level of initial molecular coherence needed to control the phase of the output field of a Raman amplifier. Two laser pulses, separated in time, were used to pump a common set of hydrogen molecules producing two Stokes pulses via stimulated Raman scattering. The relative phase of the two Stokes pulses was measured interferometrically. The variance of this relative phase is a direct measure of the memory of the molecular coherence that was induced by the first scattering process. Correlations between the two Stokes phases were observed even after nine molecular dephasing times, when the level of coherence had decayed by a factor of e−9. We show that this extraordinarily long-lived phase memory comes about because a molecular coherence corresponding to order ten vibrational photons per mode is sufficient to influence the phase of the output field.