Linear-optical realizations of Bell state measurement (BSM) on two single-photon qubits succeed with probability
ps no higher than 0.5. However, predetection quadrature squeezing, i.e., quantum noise limited phase sensitive amplification, in the usual linear-optical BSM circuit, can yield ${p}_{s}\ensuremath{\approx}0.643$. The ability to achieve
ps>0.5 has been found to be critical in resource-efficient realizations of linear-optical quantum computing and all-photonic quantum repeaters. Yet, the aforesaid value of
ps>0.5 is not known to be the maximum achievable using squeezing, thereby leaving it open whether close-to-
100 efficient BSM might be achievable using squeezing as a resource. In this paper, we report insights on why squeezing-enhanced BSM achieves
ps>0.5. Using this, we show that the previously reported ${p}_{s}\ensuremath{\approx}0.643$ at single-mode squeezing strength
r=0.6585---for unambiguous state discrimination (USD) of all four Bell states---is an experimentally unachievable point result, which drops to ${p}_{s}\ensuremath{\approx}0.59$ with the slightest change in
r. We, however, show that squeezing-induced boosting of
ps with USD operation is still possible over a continuous range of
r, with an experimentally achievable maximum occurring at
r=0.5774, achieving ${p}_{s}\ensuremath{\approx}0.596$. Finally, deviating from USD operation, we explore a trade space between
ps, the probability with which the BSM circuit declares a ``success,'' versus the probability of error
pe, the probability of an input Bell state being erroneously identified given the circuit declares a success. Since quantum error correction could correct for some
pe>0, this tradeoff may enable better quantum repeater designs by potentially increasing the entanglement generation rates with
ps exceeding what is possible with traditionally studied USD operation of BSMs.
Bell-state projections serve as a fundamental basis for most quantum communication and computing protocols today. However, with current Bell-state measurement schemes based on linear optics, only two of four Bell states can be identified, which means that the maximum success probability of this vital step cannot exceed 50%. Here, we experimentally demonstrate a scheme that amends the original measurement with additional modes in the form of ancillary photons, which leads to a more complex measurement pattern, and ultimately a higher success probability of 62.5%. Experimentally, we achieve a success probability of (57.9 ± 1.4)%, a substantial improvement over the conventional scheme. With the possibility of extending the protocol to a larger number of ancillary photons, our work paves the way toward more efficient realizations of quantum technologies based on Bell-state measurements.
Bell measurements, which allow entanglement between uncorrelated distant particles, play a central role in quantum communication. Indeed sharing, measuring and creating entanglement lie at the core of various protocols, such as entanglement swapping and quantum teleportation. While for optical qubit systems a Bell measurement can be implemented using only linear components, the same result is no longer true for high-dimensional states, where one has to consider either ancillary photons or nonlinear processes. Here, inspired by the latter approach, we propose a protocol for high-dimensional quantum teleportation based on nonlinear techniques. Moreover, we discuss the practical implementation of our proposed setup in the case of path-encoded qutrits, where nonlinear effects arise from sum-frequency generation. Finally, we compute the fidelity between quantum states to benchmark the validity of our model under the presence of crosstalk noise. Our approach is deterministic, scalable and does not rely on the use of auxiliary photons, thus paving the way towards the practical implementation of quantum networks based on nonlinear effects.
The use of higher-dimensional photonic encodings (qudits) instead of two-dimensional encodings (qubits) can improve the loss tolerance and reduce the computational resources of photonic-based quantum information processing. To harness this potential, efficient schemes for entangling operations such as the high-dimensional generalization of a linear optics Bell measurement will be required. We show how an efficient high-dimensional entangled state analyzer can be implemented with a linear optics interferometer and auxiliary photonic states. The degree of entanglement of the auxiliary state is much less than in previous protocols as quantified by an exponentially smaller Schmidt rank. In addition, the auxiliary state only occupies a single spatial mode, allowing it to be generated deterministically from a single quantum emitter coupled to a small qubit register. The reduced complexity of the auxiliary states results in a high robustness to imperfections and we show that auxiliary states with fidelities above 0.9 for qudit dimensions 4 can be generated in the presence of qubit error rates on the order of 10%. This paves the way for experimental demonstrations with current hardware.
Quantum information processing using linear optics is challenging due to the limited set of deterministic operations achievable without using complicated resource-intensive methods. While techniques such as the use of ancillary photons can enhance the information processing capabilities of linear optical systems, they are technologically demanding. Therefore, determining the constraints posed by linear optics and optimizing linear optical operations for specific tasks under those constraints, without the use of ancillae, can facilitate their potential implementation. Here, we consider the task of unambiguously discriminating between Bell-like states using linear optics and without the use of ancillary photons. This is a basic problem relevant in diverse settings, for example, in the measurement of the output of an entangling quantum circuit or for entanglement swapping at a quantum repeater station. While it is known that exact Bell states of two qubits can be discriminated with an optimal success probability of 50%, we find, surprisingly, that for Bell-like states the optimal probability can be only 25%. We analyze a set of Bell-like states in terms of their distinguishability, entanglement as measured by concurrence, and parameters of the beam-splitter network used for unambiguous discrimination. Further, we provide the linear optical configuration comprising single-photon detectors and beam splitters with input-state-dependent parameters that achieves optimal discrimination in the Bell-like case.
High-quality photonic Bell state measurements (BSMs) enable scalable universal quantum computing and long distance quantum communication. However, when implemented with linear optics, BSMs are fundamentally probabilistic, introducing substantial hardware overheads and limiting noise tolerance in photonic quantum computing architectures. Nonlinear interactions at the single-photon level can overcome these limitations by enabling near-deterministic photon-photon gates. Here, we demonstrate a passive photon-sorting circuit based on the induced nonlinearity arising from photon scattering in a solid-state quantum emitter. The scattering is implemented in a directional waveguide-emitter coupling interface and embedded on-chip into a linear optical circuit, through which we demonstrate sorting of one- and two-photon components with a success probability of 62%. We find that the current system can enable BSMs with a 57% post-selected success probability without ancillary photons, exceeding the linear-optical limit of 50%, and can be readily improved to >65% with design optimisations.