Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2311.05496 · Physical Review A

Bypassing thermalization timescales in temperature estimation using prethermal probes

Nicholas Anto-Sztrikacs, Harry J. D. Miller, Ahsan Nazir, Dvira Segal

Published Jun 27, 2024• 12 citations
arXivHTMLPDF

Abstract

The authors consider time as a resource in thermometry. Noninvasive equilibrium probes are limited by their slow equilibration time. To overcome this deficiency, the authors introduce prethermal temperature probes, making use of the long-lived metastable states of systems with quasidegenerate excited states. Prethermal probes are shown to surpass corresponding equilibrium probes in terms of effective thermal sensitivity, opening avenues for rapid thermometry.

DOI
10.1103/physreva.109.l060201

Related papers

Individual Quantum Probes for Optimal Thermometry

Luis Alfonso Correa, Mohammad Mehboudi, Gerardo Adesso +1 more

The unknown temperature of a sample can be estimated with minimal disturbance by putting it in thermal contact with an individual quantum probe. If the interaction time is sufficiently long so that the probe thermalizes, the temperature can be read-out directly from its steady state. Here we prove that the optimal quantum probe, acting as a thermometer with maximal thermal sensitivity, is an effective two-level atom with a maximally degenerate excited state. When the total interaction time is insufficient to produce full thermalization, we optimize the estimation protocol by breaking it down into sequential stages of probe preparation, thermal contact, and measurement. We observe that frequently interrogated probes initialized in the ground state achieve the best performance. For both fully and partly thermalized thermometers, the sensitivity grows significantly with the number of levels, though optimization over their energy spectrum remains always crucial.

arXiv:1411.2437•Physical Review Letters•Jun 5, 2015•311 citations

Anomaly to Resource: The Mpemba Effect in Quantum Thermometry

Pritam Chattopadhyay, Jonas F. G. Santos, Avijit Misra

Quantum thermometry provides a key capability for nanoscale devices and quantum technologies, but most existing strategies rely on probes initialized near equilibrium. This equilibrium paradigm imposes intrinsic limitations: sensitivity is tied to long-time thermalization and often cannot be improved in fast, noisy, or nonstationary settings. In contrast, the \textit{Mpemba effect}, the counterintuitive phenomenon where hotter states relax faster than colder ones, has mostly been viewed as a thermodynamic anomaly. Here, we bridge this gap by proving that Mpemba-type inversions generically yield a finite-time enhancement of the quantum Fisher information (QFI) for temperature estimation, thereby converting an anomalous relaxation effect into a concrete metrological resource. Through explicit analyses of two-level and $Λ$-level probes coupled to bosonic baths, we show that nonequilibrium initializations can transiently outperform both equilibrium strategies and colder states, realizing a \emph{metrological Mpemba effect}. Our results establish anomalous relaxation as a general design principle for nonequilibrium quantum thermometry, enabling ultrafast and nanoscale sensing protocols that exploit, rather than avoid, transient dynamics.

quant-pharXiv:2601.05046•Physical Review Letters•Jan 9, 2026•13 citations

Prethermalization

Jürgen Berges, Sz. Borsányi, CHRISTOF WETTERICH

Prethermalization of the equation of state and the kinetic temperature to their equilibrium values occurs on time scales dramatically shorter than the thermal equilibration time. This is a crucial ingredient for the understanding of collisions of heavy nuclei or other nonequilibrium phenomena in complex quantum and classical many body systems. We also compare the chemical equilibration time with other characteristic time scales.

arXiv:hep-ph/0403234•Physical Review Letters•Sep 28, 2004•505 citations

Probe thermometry with continuous measurements

Julia Boeyens, Björn Annby-Andersson, Pharnam Bakhshinezhad +5 more

Abstract Temperature estimation plays a vital role across natural sciences. A standard approach is provided by probe thermometry, where a probe is brought into contact with the sample and examined after a certain amount of time has passed. In situations where, for example, preparation of the probe is non-trivial or total measurement time of the experiment is the main resource that must be optimized, continuously monitoring the probe may be preferred. Here, we consider a minimal model, where the probe is provided by a two-level system coupled to a thermal reservoir. Monitoring thermally activated transitions enables real-time estimation of temperature with increasing accuracy over time. Within this framework we comprehensively investigate thermometry in both bosonic and fermionic environments employing a Bayesian approach. Furthermore, we explore adaptive strategies and find a significant improvement on the precision. Additionally, we examine the impact of noise and find that adaptive strategies may suffer more than non-adaptive ones for short observation times. While our main focus is on thermometry, our results are easily extended to the estimation of other environmental parameters, such as chemical potentials and transition rates.

arXiv:2307.13407•New Journal of Physics•Nov 21, 2023•14 citations

Thermometric machine for ultraprecise thermometry of low temperatures

Ivan Henao, Karen V. Hovhannisyan, Raam Uzdin

Thermal equilibrium states are exponentially hard to distinguish at very low temperatures, making equilibrium quantum thermometry in this regime a formidable task. We present a thermometric scheme that circumvents this limitation, by using a two-level probe that does not thermalize with the sample whose temperature is measured. This is made possible thanks to a suitable interaction that couples the probe to the sample and to an auxiliary thermal bath known to be at a higher temperature. Provided a reasonable upper bound on the temperature of the sample, the resulting 'thermometric machine' drives the probe towards a steady state whose signal-to-noise ratio can achieve values as high as $\mathcal{O}(1/T)$. We also characterize the transient state of the probe and numerically illustrate an extreme reduction in the number of measurements to attain a given precision, as compared to optimal measurements on a thermalized probe.

arXiv:2108.10469•Aug 24, 2021•6 citations

Sequential-measurement thermometry with quantum many-body probes

Yaoling Yang, Víctor Montenegro, Abolfazl Bayat

Measuring the temperature of a quantum system is an essential task in almost all aspects of quantum technologies. Theoretically, an optimal strategy for thermometry often requires measuring energy, which demands full accessibility over the entire system as well as a complex entangled measurement basis. In this paper, we take a different approach and show that single-qubit sequential measurements in the computational basis not only allow for precise thermometry of a many-body system, but may also achieve precision beyond the thermometry capacity of the probe at equilibrium, given by the Cram\'er-Rao bound. Thus, using consecutive single-qubit measurements of the probe out of equilibrium is, in most cases, very beneficial, as it achieves lower-temperature uncertainties and avoids demanding energy measurements when compared with probes at thermal equilibrium. To obtain such precision, the time between the two subsequent measurements should be smaller than the thermalization time so that the probe never thermalizes. Therefore, the nonequilibrium dynamics of the system continuously imprint information about temperature in the state of the probe. To demonstrate the generality of our findings, we consider thermometry in both spin chains and the Jaynes-Cummings model.

arXiv:2403.10084•Physical Review Applied•Aug 27, 2024•13 citations
The authors consider time as a resource in thermometry. Noninvasive equilibrium probes are limited by their slow equilibration time. To overcome this deficiency, the authors introduce prethermal temperature probes, making use of the long-lived metastable states of systems with quasidegenerate excited states. Prethermal probes are shown to surpass corresponding equilibrium probes in terms of effective thermal sensitivity, opening avenues for rapid thermometry.
The unknown temperature of a sample can be estimated with minimal disturbance by putting it in thermal contact with an individual quantum probe. If the interaction time is sufficiently long so that the probe thermalizes, the temperature can be read-out directly from its steady state. Here we prove that the optimal quantum probe, acting as a thermometer with maximal thermal sensitivity, is an effective two-level atom with a maximally degenerate excited state. When the total interaction time is insufficient to produce full thermalization, we optimize the estimation protocol by breaking it down into sequential stages of probe preparation, thermal contact, and measurement. We observe that frequently interrogated probes initialized in the ground state achieve the best performance. For both fully and partly thermalized thermometers, the sensitivity grows significantly with the number of levels, though optimization over their energy spectrum remains always crucial.
Quantum thermometry provides a key capability for nanoscale devices and quantum technologies, but most existing strategies rely on probes initialized near equilibrium. This equilibrium paradigm imposes intrinsic limitations: sensitivity is tied to long-time thermalization and often cannot be improved in fast, noisy, or nonstationary settings. In contrast, the \textit{Mpemba effect}, the counterintuitive phenomenon where hotter states relax faster than colder ones, has mostly been viewed as a thermodynamic anomaly. Here, we bridge this gap by proving that Mpemba-type inversions generically yield a finite-time enhancement of the quantum Fisher information (QFI) for temperature estimation, thereby converting an anomalous relaxation effect into a concrete metrological resource. Through explicit analyses of two-level and ΛΛΛ-level probes coupled to bosonic baths, we show that nonequilibrium initializations can transiently outperform both equilibrium strategies and colder states, realizing a \emph{metrological Mpemba effect}. Our results establish anomalous relaxation as a general design principle for nonequilibrium quantum thermometry, enabling ultrafast and nanoscale sensing protocols that exploit, rather than avoid, transient dynamics.
Abstract Temperature estimation plays a vital role across natural sciences. A standard approach is provided by probe thermometry, where a probe is brought into contact with the sample and examined after a certain amount of time has passed. In situations where, for example, preparation of the probe is non-trivial or total measurement time of the experiment is the main resource that must be optimized, continuously monitoring the probe may be preferred. Here, we consider a minimal model, where the probe is provided by a two-level system coupled to a thermal reservoir. Monitoring thermally activated transitions enables real-time estimation of temperature with increasing accuracy over time. Within this framework we comprehensively investigate thermometry in both bosonic and fermionic environments employing a Bayesian approach. Furthermore, we explore adaptive strategies and find a significant improvement on the precision. Additionally, we examine the impact of noise and find that adaptive strategies may suffer more than non-adaptive ones for short observation times. While our main focus is on thermometry, our results are easily extended to the estimation of other environmental parameters, such as chemical potentials and transition rates.
Thermal equilibrium states are exponentially hard to distinguish at very low temperatures, making equilibrium quantum thermometry in this regime a formidable task. We present a thermometric scheme that circumvents this limitation, by using a two-level probe that does not thermalize with the sample whose temperature is measured. This is made possible thanks to a suitable interaction that couples the probe to the sample and to an auxiliary thermal bath known to be at a higher temperature. Provided a reasonable upper bound on the temperature of the sample, the resulting 'thermometric machine' drives the probe towards a steady state whose signal-to-noise ratio can achieve values as high as O(1/T)\mathcal{O}(1/T)O(1/T). We also characterize the transient state of the probe and numerically illustrate an extreme reduction in the number of measurements to attain a given precision, as compared to optimal measurements on a thermalized probe.
Measuring the temperature of a quantum system is an essential task in almost all aspects of quantum technologies. Theoretically, an optimal strategy for thermometry often requires measuring energy, which demands full accessibility over the entire system as well as a complex entangled measurement basis. In this paper, we take a different approach and show that single-qubit sequential measurements in the computational basis not only allow for precise thermometry of a many-body system, but may also achieve precision beyond the thermometry capacity of the probe at equilibrium, given by the Cram\'er-Rao bound. Thus, using consecutive single-qubit measurements of the probe out of equilibrium is, in most cases, very beneficial, as it achieves lower-temperature uncertainties and avoids demanding energy measurements when compared with probes at thermal equilibrium. To obtain such precision, the time between the two subsequent measurements should be smaller than the thermalization time so that the probe never thermalizes. Therefore, the nonequilibrium dynamics of the system continuously imprint information about temperature in the state of the probe. To demonstrate the generality of our findings, we consider thermometry in both spin chains and the Jaynes-Cummings model.