Initial experimental results on a superconducting-qubit reset based on photon-assisted quasiparticle tunneling
Vasilii Sevriuk, Wei Liu, Jami Rönkkö, Hao Hsu, Fabian Marxer, Timm Mörstedt, Matti Partanen, Jukka Räbinä, M. Venkatesh, Juho Hotari, Leif Grönberg, Johannes Heinsoo, Tianyi Li, Jani Tuorila, K. W. Chan, Juha Hassel, Kuan Yen Tan, Mikko Möttönen
We present here our recent results on qubit reset scheme based on a quantum-circuit refrigerator (QCR). In particular, we use the photon-assisted quasiparticle tunneling through a superconductor–insulator–normal-metal–insulator–superconductor junction to controllably decrease the energy relaxation time of the qubit during the QCR operation. In our experiment, we use a transmon qubit with dispersive readout. The QCR is capacitively coupled to the qubit through its normal-metal island. We employ rapid, square-shaped QCR control voltage pulses with durations in the range of 2–350 ns and a variety of amplitudes to optimize the reset time and fidelity. Consequently, we reach a qubit ground-state probability of roughly 97% with 80-ns pulses starting from the first excited state. The qubit state probability is extracted from averaged readout signal, where the calibration is based on Rabi oscillations, thus not distinguishing the residual thermal population of the qubit.
We present here our recent results on qubit reset scheme based on a quantum-circuit refrigerator (QCR). In particular, we use the photon-assisted quasiparticle tunneling through a superconductor–insulator–normal-metal–insulator–superconductor junction to controllably decrease the energy relaxation time of the qubit during the QCR operation. In our experiment, we use a transmon qubit with dispersive readout. The QCR is capacitively coupled to the qubit through its normal-metal island. We employ rapid, square-shaped QCR control voltage pulses with durations in the range of 2–350 ns and a variety of amplitudes to optimize the reset time and fidelity. Consequently, we reach a qubit ground-state probability of roughly 97% with 80-ns pulses starting from the first excited state. The qubit state probability is extracted from averaged readout signal, where the calibration is based on Rabi oscillations, thus not distinguishing the residual thermal population of the qubit.
The initialization of superconducting qubits is one of the essential techniques for the realization of quantum computation. In previous research, initialization above 99% fidelity has been achieved at 280 ns. Here, we demonstrate the rapid initialization of a superconducting qubit with a quantum circuit refrigerator (QCR). Photon-assisted tunneling of quasiparticles in the QCR can temporally increase the relaxation time of photons inside the resonator and helps release energy from the qubit to the environment. Experiments using this protocol have shown that 99% of initialization time is reduced to 200 ns. This initialization time depends strongly on the relaxation rate of the resonator, and faster initialization is possible by reducing the resistance of the QCR, which limits the on:off ratio, and by strengthening the coupling between the QCR and the resonator.
We propose a quantum-circuit refrigerator (QCR) based on photon-assisted quasiparticle tunneling through a single normal-metal–insulator–superconductor (NIS) junction. In contrast to previous studies with multiple junctions and an additional charge island for the QCR, we directly connect the NIS junction to an inductively shunted electrode of a superconducting microwave resonator making the device immune to low-frequency charge noise. At low characteristic impedance of the resonator and parameters relevant to a recent experiment, we observe that a semiclassical impedance model of the NIS junction reproduces the bias voltage dependence of the QCR-induced damping rate and frequency shift. For high characteristic impedances, we derive a Born–Markov master equation and use it to observe significant non-linearities in the QCR-induced dissipation and frequency shift. We further demonstrate that, in this regime, the QCR can be used to initialize the linear resonator into a non-thermal state even in the absence of any microwave drive.
Previous studies of photon-assisted tunneling through normal-metal–insulator–superconductor junctions have exhibited potential for providing a convenient tool to control the dissipation of quantum-electric circuits in situ. However, the current literature on such a quantum-circuit refrigerator (QCR) does not present a detailed description for the charge dynamics of the tunneling processes or the phase coherence of the open quantum system. Here, we derive a master equation describing both quantum-electric and charge degrees of freedom, and discover that typical experimental parameters of low temperature and yet lower charging energy yield a separation of time scales for the charge and quantum dynamics. Consequently, the minor effect of the different charge states can be taken into account by averaging over the charge distribution. We also consider applying an ac voltage to the tunnel junction, which enables control of the decay rate of a superconducting qubit over four orders of magnitude by changing the drive amplitude; we find an order-of-magnitude drop in the qubit excitation in 40 ns and a residual reset infidelity below 10−4. Furthermore, for the normal island, we consider the case of charging energy and single-particle level spacing large compared to the superconducting gap, i.e., a quantum dot. Although the decay rates arising from such a dot QCR appear low for use in qubit reset, the device can provide effective negative damping (gain) to the coupled microwave resonator. The Fano factor of such a millikelvin microwave source may be smaller than unity, with the latter value being reached close to the maximum attainable power.
In a quantum computation scheme, such as recycling a qubit, the initialization of the qubit is always required. At present, the initialization of the qubit is one of the bottlenecks in such computation, and high fidelity and fast initialization still remain important research subjects. In this study, by coupling a SINIS (superconductor–insulator–normal metal–insulator–superconductor) junction to a coupled system consisting of a qubit and a resonator, a photon is removed from the resonator by single-photon-assisted tunneling, and the effective relaxation rate of the resonator is increased. In addition, by applying an |e,0⟩−|f,0⟩ drive pulse and an |f,0⟩−|g,1⟩ drive pulse to the qubit, the energy of the qubit is rapidly transferred to the resonator to realize high-speed initialization. The present simulation shows that the qubit can be initialized with 99% fidelity in 80 ns and 99.9% in 137 ns when the electron temperature of the normal metal of the SINIS junction is 10 mK. The simulation also shows that the relaxation time of the qubit is about 13% longer when the resonator is interposed between the SINIS junction and the qubit than when the SINIS junction is directly coupled to the qubit.
For larger-scale quantum information processing, qubit reset plays an important role, as the coherent times for qubits are limited. However, previous schemes require either long reset times or a complex pulse calibration technique, leading to low efficiency in qubit reset. Here, we propose a fast and simple reset protocol for superconducting transmon qubits based on the coupler-coupled qubits architecture. In this setup, a mixing pulse is used to transfer the qubit excitation to the combined excitation of a low-qulity coupler and readout resonator, which will quickly decay to their respectively ground states, leading to efficient qubit reset to the ground state. Our numerical results show that the residual population of the qubit’s excited state can be suppressed to 0.04% within 28 ns; the reset time will be 283 ns if photon depletion of the readout resonator is required. Thus, our protocol provides a promising way for the high-efficiency superconducting qubit reset.
Abstract The recent progress in direct active cooling of the quantum‐electric degrees of freedom in engineered circuits, or quantum‐circuit refrigeration is reviewed. In 2017, the discovery of a quantum‐circuit refrigerator (QCR) based on photon‐assisted tunneling of quasiparticles through normal‐metal–insulator–superconductor junctions inspired a series of experimental studies demonstrating the following main properties: i) the direct‐current (dc) bias voltage of the junction can change the QCR‐induced damping rate of a superconducting microwave resonator by orders of magnitude and give rise to nontrivial Lamb shifts, ii) the damping rate can be controlled in nanosecond time scales, and ii) the dc bias can be replaced by a microwave excitation, the amplitude of which controls the induced damping rate. Theoretically, it is predicted that state‐of‐the‐art superconducting resonators and qubits can be reset with an infidelity lower than 10−4 in tens of nanoseconds using experimentally feasible parameters. A QCR‐equipped resonator has also been demonstrated as an incoherent photon source with an output temperature above 1 K yet operating at millikelvin. This source has been used to calibrate cryogenic amplification chains. In the future, the QCR may be experimentally used to quickly reset superconducting qubits, and hence assist in the great challenge of building a practical quantum computer.