Noise-biased qubits are a promising route toward significantly reducing the hardware overhead associated with quantum error correction. The squeezed-cat code, a nonlocal encoding in phase space based on squeezed coherent states, is an example of a noise-biased (bosonic) qubit with exponential error bias. Here we propose and analyze the error correction performance of a dissipatively stabilized squeezed-cat qubit. We find that for moderate squeezing the bit-flip error rate gets significantly reduced in comparison with the ordinary cat qubit while leaving the phase-flip rate unchanged. Additionally, we find that the squeezing enables faster and higher-fidelity gates.
Noise-biased qubits are a promising route toward significantly reducing the hardware overhead associated with quantum error correction. The squeezed-cat code, a nonlocal encoding in phase space based on squeezed coherent states, is an example of a noise-biased (bosonic) qubit with exponential error bias. Here we propose and analyze the error correction performance of a dissipatively stabilized squeezed-cat qubit. We find that for moderate squeezing the bit-flip error rate gets significantly reduced in comparison with the ordinary cat qubit while leaving the phase-flip rate unchanged. Additionally, we find that the squeezing enables faster and higher-fidelity gates.
Stabilized cat qubits that possess biased noise channel with bit-flip errors exponentially smaller than phase-flip errors. Together with a set of bias-preserving (BP) gates, cat qubits are a promising candidate for realizing hardware efficient quantum error correction and fault-tolerant quantum computing. Compared to dissipatively stabilized cat qubits, the Kerr cat qubits can in principle support faster gate operations with higher gate fidelity, benefiting from the large energy gap that protects the code space. However, the leakage of the Kerr cats can increase the minor type of errors and compromise the noise bias. Both the fast implementation of gates and the interaction with environment can lead to such detrimental leakage if no sophisticated controls are applied. In this work, we introduce new fine-control techniques to overcome the above obstacles for Kerr cat qubits. To suppress the gate leakage, we use the derivative-based transition suppression technique to design derivative-based controls for the Kerr BP gates. We show that the fine-controlled gates can simultaneously have high gate fidelity and high noise bias and when applied to concatenated quantum error correction, can not only improve the logical error rate but also reduce resource overhead. To suppress the environment-induced leakage, we introduce colored single-photon dissipation, which can continuously cool the Kerr cats and suppress the minor errors while not enhancing the major errors.
Dissipatively stabilized cat qubits provide a promising route toward fault-tolerant quantum computation, exhibiting exponential suppression of bit-flip errors with increasing phase-space separation of the logical states, while incurring only a linear increase in phase-flip errors. Existing implementations rely on engineered two-photon dissipation via nonlinear coupling to a lossy environment, an approach largely confined to superconducting platforms and limited by spurious decay channels and finite dissipation rates. Here, we propose a fundamentally different stabilization paradigm based on repeated interactions with an auxiliary two-level system mediated by a quadratic Hamiltonian, enabling dissipative stabilization without reservoir engineering. Our approach overcomes key limitations of existing schemes and is compatible with a wider class of experimental platforms. Furthermore, it preserves the noise bias and extends to squeezed cat qubits, rendering single-photon loss errors partially correctable.
Cat qubits, a type of bosonic qubit encoded in a harmonic oscillator, can exhibit an exponential noise bias against bit-flip errors with increasing mean photon number. Here, we focus on cat qubits stabilized by two-photon dissipation, where pairs of photons are added and removed from a harmonic oscillator by an auxiliary, lossy buffer mode. This process requires a large loss rate and strong nonlinearities of the buffer mode that must not degrade the coherence and linearity of the oscillator. In this work, we show how to overcome this challenge by coloring the loss environment of the buffer mode with a multipole filter and optimizing the circuit to take into account additional inductances in the buffer mode. Using these techniques, we achieve near-ideal enhancement of cat-qubit bit-flip times with increasing photon number, reaching over 0.1 s with a mean photon number of only 4. Concurrently, our cat qubit remains highly phase coherent, with phase-flip times corresponding to an effective lifetime of T 1 , eff ≃ 70 μ s , comparable with the bare oscillator lifetime. We achieve this performance even in the presence of an ancilla transmon, used for reading out the cat-qubit states, by engineering a tunable oscillator-ancilla dispersive coupling. Furthermore, the low nonlinearity of the harmonic oscillator mode allows us to perform pulsed cat-qubit stabilization, an important control primitive, where the stabilization can remain off for a significant fraction (e.g., two-thirds) of a 3 μ s cycle without degrading bit-flip times. These advances are important for the realization of scalable error correction with cat qubits, where large noise bias and low phase-flip error rate enable the use of hardware-efficient outer error-correcting codes.
Qubits with strongly biased noise, in which phase-flip errors are orders of magnitude more frequent than bit-flips, arise both naturally, as in electron and nuclear spins, and by engineering, as in stabilized cat qubits. This noise structure holds the promise of reducing the daunting hardware overhead of fault-tolerant quantum computing, but exploiting it requires physical operations that do not convert frequent phase-flips into rare bit-flips. In this review, we analyze the most prominent fault-tolerant protocols for biased-noise qubits, organized according to the available set of such bias-preserving operations. When this set is restricted to the CZ gate together with preparation and measurement in the X basis, we show that the complexity of the required syndrome extraction gadgets essentially cancels the benefit of the noise bias: at experimentally relevant error rates, one may as well ignore the bias and rely on standard error correction designed for depolarizing noise. The situation changes drastically when a bias-preserving CX gate is available: the hierarchy of errors can then be reflected in the structure of the code, with frequent phase-flips corrected by a dedicated high-threshold code and rare bit-flips by concatenation with a high-rate code. The same hierarchy also enables hardware-efficient preparation of magic states. Finally, as a bias-preserving CX is forbidden in naturally biased platforms and challenging in engineered ones, we present a measurement-based architecture in which a high-fidelity quantum non-demolition readout of multi-qubit Pauli Z operators takes its place, extending these overhead reductions to a much broader range of physical platforms.
To solve problems of practical importance1,2, quantum computers probably need to incorporate quantum error correction, in which a logical qubit is redundantly encoded in many noisy physical qubits3–5. The large physical-qubit overhead associated with error correction motivates the search for more hardware-efficient approaches6–18. Here, using a superconducting quantum circuit19, we realize a logical qubit memory formed from the concatenation of encoded bosonic cat qubits with an outer repetition code of distance d = 5 (ref. 10). A stabilizing circuit passively protects cat qubits against bit flips20–24. The repetition code, using ancilla transmons for syndrome measurement, corrects cat qubit phase flips. We study the performance and scaling of the logical qubit memory, finding that the phase-flip correcting repetition code operates below the threshold. The logical bit-flip error is suppressed with increasing cat qubit mean photon number, enabled by our realization of a cat-transmon noise-biased CX gate. The minimum measured logical error per cycle is on average 1.75(2)% for the distance-3 code sections, and 1.65(3)% for the distance-5 code. Despite the increased number of fault locations of the distance-5 code, the high degree of noise bias preserved during error correction enables comparable performance. These results, where the intrinsic error suppression of the bosonic encodings enables us to use a hardware-efficient outer error-correcting code, indicate that concatenated bosonic codes can be a compelling model for reaching fault-tolerant quantum computation. Bosonic qubits can be engineered to feature intrinsic protection against certain kinds of errors, which makes quantum error correction across many bosonic qubits possible with less overhead.
Cat qubits can exhibit strong noise bias due to their exponentially enhanced bit-flip times and only polynomially reduced phase-flip times with increasing photon number, which makes them attractive candidates for hardware-efficient quantum error correction. However, it is difficult to maintain this strong noise bias in logical operations such as CNOT gates between cats. Here, we propose a coherent CNOT gate scheme between two dissipative cats that preserves the exponential noise bias. The proposed gate relies only on unitary operations, which avoids the non-idealities associated with many existing gate schemes that rely on engineered dissipations. Assuming good component lifetimes and precise nonlinearity engineering, the proposed gate can enable logical memory in the megaquop regime (logical error rates < 10^-6) with a distance-7 repetition code consisting of 13 cat qubits.