Transmon qubit readout fidelity at the threshold for quantum error correction without a quantum-limited amplifier
Liangyu Chen, Hang-Xi Li, Yong Lu, Christopher Warren, Christian Križan, Sandoko Kosen, Marcus Rommel, Shahnawaz Ahmed, Amr Osman, Janka Biznárová, Anita Fadavi Roudsari, Benjamin Lienhard, M. Caputo, Kestutis Grigoras, Leif Grönberg, Joonas Govenius, Anton Frisk Kockum, Per Delsing, Jonas Bylander, Giovanna Tancredi
Abstract High-fidelity and rapid readout of a qubit state is key to quantum computing and communication, and it is a prerequisite for quantum error correction. We present a readout scheme for superconducting qubits that combines two microwave techniques: applying a shelving technique to the qubit that reduces the contribution of decay error during readout, and a two-tone excitation of the readout resonator to distinguish among qubit populations in higher energy levels. Using a machine-learning algorithm to post-process the two-tone measurement results further improves the qubit-state assignment fidelity. We perform single-shot frequency-multiplexed qubit readout, with a 140 ns readout time, and demonstrate 99.5% assignment fidelity for two-state readout and 96.9% for three-state readout–without using a quantum-limited amplifier.
Abstract High-fidelity and rapid readout of a qubit state is key to quantum computing and communication, and it is a prerequisite for quantum error correction. We present a readout scheme for superconducting qubits that combines two microwave techniques: applying a shelving technique to the qubit that reduces the contribution of decay error during readout, and a two-tone excitation of the readout resonator to distinguish among qubit populations in higher energy levels. Using a machine-learning algorithm to post-process the two-tone measurement results further improves the qubit-state assignment fidelity. We perform single-shot frequency-multiplexed qubit readout, with a 140 ns readout time, and demonstrate 99.5% assignment fidelity for two-state readout and 96.9% for three-state readout–without using a quantum-limited amplifier.
The realization of fault-tolerant quantum computing requires the execution of quantum error-correction (QEC) schemes, to mitigate the fragile nature of qubits. In this context, to ensure the success of QEC, a protocol capable of implementing both qubit reset and leakage reduction is highly desirable together with the ability to perform fast and high-fidelity readout of the qubit s’ quantum states. In this thesis, we tackle both these challenges in an architecture consisting of fixed-frequency transmon qubits pair-wise coupled via tunable couplers. We demonstrate a readout scheme that combines two microwave techniques: applying a shelving technique to the qubits that reduces the contribution of decay error during readout, and a two-tone excitation of the readout resonators to distinguish among qubits’ populations in higher energy levels. We perform single-shot frequency-multiplexed qubit readout, with a 140 ns readout time, and demonstrate 99.5% assignment fidelity for two-state readout and 96.9% for three-state readout - without using a quantum-limited amplifier. We also demonstrate a reset scheme that is fast, unconditional, and achieves fidelities well above 99%, thus enabling fixed-frequency qubit architectures as future implementations of fault-tolerant quantum computers. Our reset protocol uses the tunable couplers to transfer any undesired qubits’ excitation to the readout resonators of the qubits, from which this excitation decays into the feedline. In total, the combination of qubit reset, leakage reduction, and coupler reset takes only 83 ns to complete. This reset protocol also provides a means to both reduce QEC cycle runtime and improve algorithmic fidelity on quantum processors.
Single-shot readout of a quantum state is an essential component in building a large-scale quantum processor, and reducing the readout error is the key challenge. To achieve a high signal-to-noise ratio, quantum-limited low-noise amplifiers such as Josephson parametric amplifiers are typically used. However, a high-fidelity single-shot readout method without a parametric amplifier would be advantageous, as it would reduce system complexity. In this paper, we present a high-fidelity result of frequency-multiplexed, high-power single-shot readout for superconducting qubitswithoutusing a parametric amplifier. We achieved a high readout fidelity of 98.3% with a 400 ns pulse and confirmed that the high-power readout can be used in tomography of an entangled state. We have demonstrated the potential usefulness of this technique in characterizing the final quantum state at the end of quantum operations in a superconducting quantum processor.
The accurate measurement of quantum two-level objects (qubits) is crucial for developing quantum computers. Over the last decade, the measure of choice for benchmarking readout routines for superconducting qubits has been assignment fidelity; however, this method only focuses on the preparation of computational basis states and therefore does not provide a complete characterization of the readout. Here, we expand the focus to the use of detector tomography to fully characterize multiqubit readout of superconducting transmon qubits. The impact of different readout parameters on the rate of information extraction is studied using quantum-state reconstruction infidelity as a proxy. The results are then compared with assignment fidelities, showing good agreement for separable two-qubit states. We therefore propose the rate of infidelity convergence as a validation tool for assignment fidelity and a more comprehensive benchmark for single- and multiqubit readout optimization. To make the best use of experimental resources, we investigate the most efficient distribution of a limited shot budget between detector tomography and state reconstruction within the context of single- and two-qubit experiments. To address the growing interest in three-qubit gates and test the scalability of the validation tool, we perform three-qubit quantum-state tomography that goes beyond conventional readout-error-mitigation methods and find a factor-of-30 reduction in quantum infidelity. Our results demonstrate that qubit readout correlations are not induced by a significantly reduced state distinguishability. Consequently, correlation coefficients can serve as a valuable tool in qubit readout optimization.
Driving a low-dissipation, non-linear system periodically can destabilize it by exciting indirect resonances, which occur whenever an integer multiple of the drive frequency matches an integer combination of the system's mode frequencies. Avoiding such resonances is a central design constraint across physics and engineering, from radio-frequency ion traps to particle accelerators. Remarkably, the measurement of quantum bits based on superconducting circuits has so far remained limited by non-linear resonances. Measurements of qubit states are customarily performed in a regime where the frequency of the microwave readout tone is comparable to that of the circuit. In that case, the drive excites resonances that eject the qubit from its computational subspace. This limits the readout power and hence the achievable measurement fidelity. We show that a readout tone with frequency much larger than that of the circuit circumvents this problem by exponentially suppressing the resonances. Using a readout tone with frequency 12 times larger than that of our transmon qubit, we achieve a quantum non-demolition measurement fidelity of 99.931±0.003%, with an error an order of magnitude smaller than the previous record. Under these conditions, the probability of leakage to non-computational states per readout is 0.018±0.002%.
The interaction between a qubit and its environment can be engineered such that one error channel dominates over all others, resulting in noise bias. This property enables error correction codes to focus on the dominant error type, thereby significantly reducing the number of physical systems required for fault-tolerant quantum computation. However, engineering noise bias typically introduces complexity at the physical system level, which decreases its usefulness by limiting scalability. Here, we introduce and experimentally realize a noise-biased qubit in a standard transmon-readout resonator circuit, one of the most common superconducting architectures, by only adding a single microwave tone. We encode the qubit in the transmon ∣g⟩- and ∣f⟩-states, and engineer a frequency-selective gain channel that counteracts single-photon loss errors between the computational states. We demonstrate an order-of-magnitude enhancement in relaxation time compared to the ∣g⟩−∣e⟩ encoding, conceding only a factor-of-two decrease in the echo-coherence time. Furthermore, we show that this qubit is compatible with fast, high-fidelity operations. Our results open a path towards using this system as a simple building-block for hardware-efficient quantum error detection and correction schemes.
Qubit measurements are central to quantum information processing.In the field of superconducting qubits, standard readout techniques are limited not only by the signal-to-noise ratio, but also by state relaxation during the measurement.In this work, we demonstrate that the limitation due to relaxation can be suppressed by using the many-level Hilbert space of superconducting circuits: In a multilevel encoding, the measurement is corrupted only when multiple errors occur.Employing this technique, we show that we can directly resolve transmon gate errors at the level of one part in 10 3 .Extending this idea, we apply the same principles to the measurement of a logical qubit encoded in a bosonic mode and detected with a transmon ancilla, implementing a proposal by Hann et al. [Phys. Rev. A 98, 022305 (2018)].Qubit state assignments are made based on a sequence of repeated readouts, further reducing the overall infidelity.This approach is quite general, and several encodings are studied; the codewords are more distinguishable when the distance between them is increased with respect to photon loss.The trade-off between multiple readouts and state relaxation is explored and shown to be consistent with the photon-loss model.We report a logical assignment infidelity of 5.8 × 10 -5 for a Fock-based encoding and 4.2 × 10 -3 for a quantum error correction code (the S ¼ 2, N ¼ 1 binomial code).Our results not only improve the fidelity of quantum information applications, but also enable more precise characterization of process or gate errors.