In this article, we study the ability of error-correcting quantum codes to increase the fidelity of quantum states throughout a quantum computation. We analyze arbitrary quantum codes that encode all qubits involved in the computation, and we study the evolution of n-qubit fidelity from the end of one application of the correcting circuit to the end of the next application. We assume that the correcting circuit does not introduce new errors, that it does not increase the execution time (i.e. its application takes zero seconds) and that quantum errors are isotropic. We show that the quantum code increases the fidelity of the states perturbed by quantum errors but that this improvement is not enough to justify the use of quantum codes. Namely, we prove that, taking into account that the time interval between the application of the two corrections is multiplied (at least) by the number of qubits n (due to the coding), the best option is not to use quantum codes, since the fidelity of the uncoded state over a time interval n times smaller is greater than that of the state resulting from the quantum code correction.
In this article, we study the ability of error-correcting quantum codes to increase the fidelity of quantum states throughout a quantum computation. We analyze arbitrary quantum codes that encode all qubits involved in the computation, and we study the evolution of n-qubit fidelity from the end of one application of the correcting circuit to the end of the next application. We assume that the correcting circuit does not introduce new errors, that it does not increase the execution time (i.e. its application takes zero seconds) and that quantum errors are isotropic. We show that the quantum code increases the fidelity of the states perturbed by quantum errors but that this improvement is not enough to justify the use of quantum codes. Namely, we prove that, taking into account that the time interval between the application of the two corrections is multiplied (at least) by the number of qubits n (due to the coding), the best option is not to use quantum codes, since the fidelity of the uncoded state over a time interval n times smaller is greater than that of the state resulting from the quantum code correction.
Fault-tolerant protocol assumes the application of error correction after every quantum gate. However, correcting errors is costly in terms of time and number of qubits. Here we demonstrate that quantum error correction (QEC) can be applied significantly less often with only a minimal loss of fidelity. This is done by simulating the implementation of 50 encoded, single-qubit, quantum gates within the [[7,1,3]] QEC code in a noisy, nonequiprobable Pauli error environment with QEC being applied at different intervals. We find that applying QEC after every gate is rarely optimal and even applying QEC only once after all 50 gates sacrifices only a slight amount of fidelity with the benefit of 50-fold saving of resources. In addition, we find that in cases where bit-flip errors are dominant, it is best not to apply QEC at all.
The goal of this work is to analyse the performance of quantum error correction codes in regard to fixing independent errors in several qubits. We say that a quantum code does not fix a quantum computing error if its application does not reduce the variance of the error. We restrict our study to the classical 5−qubit quantum error correcting code (proposed by Laflamme and some collaborators), which is able to correct arbitrary errors in a single qubit and is also fault-tolerant. We show that this code does not fix qubit independent errors, even assuming that the correction circuit does not introduce new errors. We also prove, for qubit independent errors, that if the correction circuit of the 5−qubit quantum code detects an error, then the corrected state has central symmetry and, as a consequence, its variance is maximal. We have been able to obtain these results thanks to the high symmetry of the 5−qubit quantum code. Although the calculations needed to extend our proofs to less symmetric codes seem to be extremely complicated, we nevertheless think that the results obtained for the 5−qubit quantum code reveal a general behavior pattern of quantum error correcting codes against qubit independent errors.
It is important to study the behavior of a t-error-correcting quantum code when the number of errors is greater than t because it is likely that there are also small errors besides t large correctable errors. We estimate the fidelity of a t-error-correcting stabilizer code over a general memoryless channel, allowing more than t errors. We also show that the fidelity can be made arbitrary close to 1 by increasing the code length.
We analyze quantum state preservation in open quantum systems using quantum error-correcting (QEC) codes explicitly embedded in microscopic system-bath models. Rather than assuming abstract quantum channels, we consider multi-qubit registers coupled to bosonic thermal environments, derive a second-order master equation for the reduced dynamics, and use it to benchmark the five-qubit, Steane, and toric codes under local and collective noise. We compute state fidelities as functions of system-bath coupling strength, bath temperatures, and the number of correction cycles. In the low-temperature regime, repeated error correction with the five-qubit code significantly suppresses decoherence and relaxation for weak-to-moderate couplings. In the high-temperature regime, thermal excitations reduce the effectiveness of all codes, although within the parameter range studied, the five-qubit code still yields the highest fidelities among the three codes. For two-qubit Werner states, we identify a critical evolution time associated with an early-time crossover, before which the overhead of QEC does not compensate for the noise-induced degradation; this critical time increases with entanglement, reflecting the greater fragility of strongly entangled states. Overall, our results provide a microscopic master-equation-based framework for benchmarking QEC performance in realistic open-system environments and for assessing code behavior in near-term noisy quantum architectures.
Quantum entanglement is a unique criterion of the quantum realm and an essential tool to secure quantum communication. Ensuring high-fidelity entanglement has always been a challenging task owing to interaction with the hostile channel environment created due to quantum noise and decoherence. Though several methods have been proposed, correcting almost all arbitrary errors is still a gigantic task. As one of the main contributions of this work, a new model for 'large distance communication' has been proposed, which may correct all bit flip errors or other errors quite extensively if proper encoding and subspace measurements are used. To achieve this purpose, at the very first step, the idea of differentiating the 'long-distance communication' and 'short-distance applications' has been introduced. Short-distance is determined by the maximum range of applying unitary control gates by the qubit technology. How the error correcting ability of Quantum codes change for short and long-distance application is investigated in this work, which was not explored in previous literatures as far as we know. At the beginning, we have applied stabilizer formalism and Repetition Code for decoding to distinguish the error correcting ability in long and short distance communication. Particularly for short-distance communication, it has been demonstrated that a 'properly encoded' bell state can identify all the bit flip, or phase flip errors with 100% accuracy theoretically. In contrast, if the bell states are used in long-distance communication, the error-detecting and correcting ability reduces at huge amounts. To increase the fidelity significantly and correct the errors quite extensively for long-distance communication, a new model based on classical communication protocol has been suggested. All the required circuits in these processes have been generalized for arbitrary (even) numbers of ancilla qubits during encoding. Proposed analytical results have also been verified with the Simulation results of IBM QISKIT QASM.
We present a circuit-level simulation of second-generation quantum repeaters with stabilizer-based quantum error correction. We model a two-segment repeater link including encoding, syndrome extraction, decoding, and entanglement swapping, and compare the performance of the single-error-correcting Steane and five-qubit stabilizer codes under different noise scenarios. To that extent, we consider noise sources with incoherent (depolarizing and dephasing) and coherent (systematic over-rotation) errors and incorporate them directly at the circuit level. While the Steane code outperforms the five-qubit code at coherent errors, the five-qubit code achieves higher end-to-end fidelities under incoherent noise in the low-noise regime when a large number of physical qubits is affected by it. At higher noise regimes, employing no code turns out to be the best option. In mixed noise scenarios, we observe moderate cross-effects between the noise classes regarding the error correction performance. We conclude that code selection in second-generation quantum repeaters must be adapted to the dominant physical noise mechanism and that circuit complexity and hardware-aware implementation options influence performance in coherent-error-dominated regimes, providing design insights for error correction in quantum repeaters.