Efficient mid-infrared single-photon detection using superconducting NbTiN nanowires with high time resolution in a Gifford-McMahon cryocooler
Jin Chang, Johannes W. N. Los, Ronan Gourgues, Stephan Steinhauer, Sander N. Dorenbos, Silvania F. Pereira, Hendrik Paul Urbach, Val Zwiller, Iman Esmaeil Zadeh
Shortly after their inception, superconducting nanowire single-photon detectors (SNSPDs) became the leading quantum light detection technology. With the capability of detecting single-photons with near-unity efficiency, high time resolution, low dark count rate, and fast recovery time, SNSPDs outperform conventional single-photon detection techniques. However, detecting lower energy single photons ( < 0.8 eV ) with high efficiency and low timing jitter has remained a challenge. To achieve unity internal efficiency at mid-infrared wavelengths, previous works used amorphous superconducting materials with low energy gaps at the expense of reduced time resolution (close to a nanosecond), and by operating them in complex milliKelvin (mK) dilution refrigerators. In this work, we provide an alternative approach with SNSPDs fabricated from 5 to 9.5 nm thick NbTiN superconducting films and devices operated in conventional Gifford-McMahon cryocoolers. By optimizing the superconducting film deposition process, film thickness, and nanowire design, our fiber-coupled devices achieved > 70 % system detection efficiency (SDE) at 2 μm and sub-15 ps timing jitter. Furthermore, detectors from the same batch demonstrated unity internal detection efficiency at 3 μm and 80% internal efficiency at 4 μm, paving the road for an efficient mid-infrared single-photon detection technology with unparalleled time resolution and without mK cooling requirements. We also systematically studied the dark count rates (DCRs) of our detectors coupled to different types of mid-infrared optical fibers and blackbody radiation filters. This offers insight into the trade-off between bandwidth and DCRs for mid-infrared SNSPDs. To conclude, this paper significantly extends the working wavelength range for SNSPDs made from polycrystalline NbTiN to 1.5–4 μm, and we expect quantum optics experiments and applications in the mid-infrared range to benefit from this far-reaching technology.
Shortly after their inception, superconducting nanowire single-photon detectors (SNSPDs) became the leading quantum light detection technology. With the capability of detecting single-photons with near-unity efficiency, high time resolution, low dark count rate, and fast recovery time, SNSPDs outperform conventional single-photon detection techniques. However, detecting lower energy single photons ( < 0.8 eV ) with high efficiency and low timing jitter has remained a challenge. To achieve unity internal efficiency at mid-infrared wavelengths, previous works used amorphous superconducting materials with low energy gaps at the expense of reduced time resolution (close to a nanosecond), and by operating them in complex milliKelvin (mK) dilution refrigerators. In this work, we provide an alternative approach with SNSPDs fabricated from 5 to 9.5 nm thick NbTiN superconducting films and devices operated in conventional Gifford-McMahon cryocoolers. By optimizing the superconducting film deposition process, film thickness, and nanowire design, our fiber-coupled devices achieved > 70 % system detection efficiency (SDE) at 2 μm and sub-15 ps timing jitter. Furthermore, detectors from the same batch demonstrated unity internal detection efficiency at 3 μm and 80% internal efficiency at 4 μm, paving the road for an efficient mid-infrared single-photon detection technology with unparalleled time resolution and without mK cooling requirements. We also systematically studied the dark count rates (DCRs) of our detectors coupled to different types of mid-infrared optical fibers and blackbody radiation filters. This offers insight into the trade-off between bandwidth and DCRs for mid-infrared SNSPDs. To conclude, this paper significantly extends the working wavelength range for SNSPDs made from polycrystalline NbTiN to 1.5–4 μm, and we expect quantum optics experiments and applications in the mid-infrared range to benefit from this far-reaching technology.
Mid-infrared (MIR) single-photon detection is emerging as an important technology for various applications. Superconducting nanowire single photon detectors (SNSPDs) fabricated with superconducting films with energy gaps of a few meV are natural broadband single-photon detectors. Recently, extending SNSPDs’ operation wavelengths into the MIR region is highly attractive. γ-Nb4N3 has a reduced N content and lower energy gap than the commonly used δ-NbN, making SNSPDs based on γ-Nb4N3 film more sensitive to low energy photons. We report on a Nb4N3-SNSPD based on 62-nm wide nanowire, with an optical absorption enhancement design and an optimized device package for efficient ZBLAN fiber coupling and dark count filtering. The developed device has a unity intrinsic detection efficiency (IDE) in the 1.5–4 µm wavelength region, and the device detection efficiency at 2.95 µm was measured to be 32.5%, with an uncertainty of 12.7%. Furthermore, we reduced the device geometry, and measured 3–10 µm photon response of a device based on 5-nm film and 42-nm nanowire, with an IDE of 95%, 81%, 40%, and 6% for 4.8, 6, 8, and 10 µm, respectively.
Single photon detection advanced rapidly in the last decade. The superconducting nanowire single-photon detector (SNSPD) is an emerging technology, which offers low dark count rates, broadband sensitivity from visible to mid-infrared wavelengths and very high quantum efficiency. All these features are appealing for future emerging applications in remote gas sensing, quantum key distribution and quantum information processing. By enclosing the detector in an optical cavity, tuned to the operating wavelength, the total system detection of the SNSPD is improved. Based on the cavity design, the detector absorption is boosted at the desired experimental wavelength. Devices have been fabricated and tested, in this thesis, with enhanced detection efficiency at near-infrared, infrared and mid-infrared wavelengths. NbTiN detectors fabricated on Ta2O5 / SiO2 distributed Bragg reflectors (DBR) for front-side coupling exhibit a system detection efficiency of ≈ 90% at λ = 940 nm for the best device measured. SNSPDs were also fabricated in NbTiN on metallic mirrors for back-side coupling for 1550 and 2333 nm experimental wavelengths. The first design exhibited a system detection efficiency of ≈ 84.5%, at λ = 1550 nm for the best device measured. The second exhibited low system detection efficiency since the device suffered from unexpectedly high dark count rate mainly due to blackbody radiation at 2.2 K. However, it was possible to measure the timing jitter of this device at 350 mK indicating a FWHM of 84 ps. Another technique to improve the total system detection efficiency of the SNSPD, is by fabricating a hairpin-shaped nanowire atop a single mode waveguide. In this design, photons travel through the waveguide and via evanescent coupling are absorbed in the nanowire. These SNSPD devices have been designed to thread along single mode Si ridge waveguides using a hairpin-shaped nanowire structure, which offers enhanced coupling and absorption efficiency via evanescent coupling. These ultra-thin superconducting MoSi detectors are precisely patterned on top of a single mode Si waveguide (600 nm) with alignment error less than 40 nm. Low temperature electrical and nano-optical characterization was carried out using a two-stage pulse tube (PT) coldhead, using an additional 4He / 3He sorption pump, low vibration characterization of SNSPD devices at 350 mK was carried out. Characterised devices exhibit low dark count rate <5 counts per second and timing jitter of ≈ 83 ps full width half maximum (FWHM) at wavelength (λ) = 1550 nm and at critical current ≈ 30 µA.
Superconducting nanowire single photon detectors (SNSPD) offer excellent performance for infrared single photon detection, combining high efficiency, low timing jitter, low dark count rates and high photon counting rates. Promising application areas for SNSPDs include quantum key distribution, space-to-ground communications and single photon remote sensing [1]. SNSPDs are typically made with ultrathin niobium nitride (NbN) films with thickness 4 nm and a superconducting transition temperature above 9 K. NbN offers high performance in the near infrared but their sensitivity drops at wavelengths beyond 2 um. There is growing interest in potential photon counting applications in the mid infrared domain (for example remote sensing of greenhouse gases in the atmosphere [2]). One way to overcome the wavelength limit in NbN SNSPDs is to use films with a lower superconducting energy gap [3]. Here we report on the study of SNSPDs fabricated with thin films of titanium nitride (TiN). We compare TiN films deposited by atomic layer deposition (ALD) and by magnetron sputtering. The TiN films range in thickness from 5 to 60 nm, with superconducting transition temperatures from ~1 K to 3.5 K. We have analyzed the films via transmission electron microscopy and variable angle spectroscopic ellipsometry. We characterize TiN SNSPDs performance from near to mid-infrared at wavelengths (1-4 um) with fast optical parametric oscillator (OPO) source. We compare the performance of TiN SNSPDs to devices based on other lower gap materials: MoSi, NbTiN, WSi. [1] Natarajan et al Superconductor Science and Technology 25 063001 (2012) [2] Abshire et al Laser Applications to Chemical, Security and Environmental Analysis, (Optical Society of America, 2008) paper LMA4 [3] Verma et al Applied Physics Letters 105 022602 (2014)
We have developed a practical superconducting nanowire single photon detector (SNSPD) system with our superconducting thin films and devices fabrication, optical coupling packaging, and cryogenic technology. The SNSPD devices were fabricated from high-quality niobium nitride (NbN) ultra-thin films that were epitaxially grown on single-crystal MgO substrates, and optical cavity structure were applied for improvement of photo absorption efficiency. The SNSPD system was developed based on a compact Gifford-McMahon (GM) cryocooler, in which SNSPD can operate continuously at temperature of 2.9 K +/- 10 mK with low power consumption without any liquid cryogens. The system detection efficiencies at 1550 nm wavelength (at a 100 Hz dark count rate) were found to be 2.6% for device without optical cavity and 21% for device with optical cavity. The response speed of devices showed maximally 200 MHz with 5 × 5 mm square device, and timing jitter of 100 ps full width at a half maximum (FWHM) was observed.
Superconducting nanowire single-photon detectors are widely used for detecting individual photons across various wavelengths from ultraviolet to near-infrared range. Recently, there has been increasing interest in enhancing their sensitivity to single photons in the mid-infrared spectrum, driven by applications in quantum communication, spectroscopy, and astrophysics. Here, we present our efforts to expand the spectral detection capabilities of U-shaped NbTiN-based superconducting nanowire single-photon detectors, fabricated in a 2-wire configuration on a silicon-on-insulator substrate, into the mid-infrared range. We demonstrate saturated internal detection efficiency extending up to a wavelength of 3.5 μm for a 5 nm thick and 50 nm wide NbTiN nanowire with a dark count rate less than 10 counts per second at 0.9 K and a rapid recovery time of 4.3 ns. The detectors are engineered for integration on waveguides in a silicon-on-insulator platform for compact, multi-channel device applications.
Superconducting nanowire single photon detectors (SNSPDs) have demonstrated advantages over traditional detectors in many fields [1]. Most fiber-coupled SNSPDs are coupled to single mode fibers, limiting their usability for applications where large surface area detectors are needed, for example fluorescence detection and satellite-based quantum communication [2][3]. Other important requirements for many applications are broadband detection efficiency, and low timing jitter [4]. So far, the increased meander length of multimode detectors, and the therefore increased kinetic inductance and number of imperfections due to film inhomogeneities have limited the timing jitter [5]. Moreover, combining low timing jitter with high detection efficiency and low dark count rate in one device is challenging due to the tradeoffs between different properties of SNSPDs [6]. In this paper, we achieved high efficiency and strong saturation over a broad wavelength range with a low timing jitter of 16.99 ps while maintaining a low dark count rate of < 0.2 Hz for an SNSPD coupled to a 50 µm core multimode fiber. To enhance the broadband absorption from 405 nm to 830 nm, detectors were fabricated on an optimized SiO2 cavity and Aluminum mirror. The geometry of the nanowire was also tuned to reach a good internal saturation of efficiency over the visible/NIR range but also to carry high current to get a large signal. Furthermore, a cryogenic readout amplifier was optimized to improve the signal to noise ratio and thus lead to high time resolution. Our devices can be readily used to enable higher resolution and faster quantum optics, bio-imaging, laser ranging and other optical experiments.