Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2004.00334 · PRX Quantum

Large Dispersive Interaction between a CMOS Double Quantum Dot and Microwave Photons

David J. Ibberson, Theodor Lundberg, James A. Haigh, Louis Hutin, Benoît Bertrand, Sylvain Barraud, Chang-Min Lee, Nadia A. Stelmashenko, Giovanni A. Oakes, Laurence Cochrane, Jason W. A. Robinson, M. Vinet, M. Fernando González-Zalba, Lisa A. Ibberson

Published May 5, 2021• 57 citations
arXivHTMLPDF

Abstract

A dual-chip architecture is presented for gate dispersive readout of charge states in quantum electronic devices, which outperforms previous fully-integrated systems and may facilitate scaling of spin-qubits.
DOI
10.1103/prxquantum.2.020315

Related papers

Conditional Dispersive Readout of a CMOS Single-Electron Memory Cell

Simon Schaal, Sylvain Barraud, John J. L. Morton +1 more

For direct interfacing of digital and quantum electronics in quantum computation, mature CMOS technology, with its potential for large-scale integration and data management, offers solutions for control, readout, and fast data processing with large numbers of qubits. The authors combine three likely components of an all-CMOS quantum computer---a quantum-dot transistor, a digital transistor for control, and an rf readout circuit---to yield a single-electron memory cell. The digital transistor locks charge on the quantum-dot gate and allows conditional readout via gate-based rf reflectometry, demonstrating the building blocks for time-multiplexed readout of multiqubit devices.

arXiv:1708.04159•Physical Review Applied•May 10, 2018•29 citations

Development of a Silicon Semiconductor Quantum Dot Qubit with Dispersive Microwave Readout

Edward Henry

Semiconductor quantum dots in silicon demonstrate exceptionally long spin lifetimes as qubits and are therefore promising candidates for quantum information processing. However, control and readout techniques for these devices have thus far employed low frequency electrons, in contrast to high speed temperature readout techniques used in other qubit architectures, and coupling between multiple quantum dot qubits has not been satisfactorily addressed.This dissertation presents the design and characterization of a semiconductor charge qubit based on double quantum dot in silicon with an integrated microwave resonator for control and readout. The 6 GHz resonator is designed to achieve strong coupling with the quantum dot qubit, allowing the use of circuit QED control and readout techniques which have not previously been applicable to semiconductor qubits. To achieve this coupling, this document demonstrates successful operation of a novel silicon double quantum dot design with a single active metallic layer and a coplanar stripline resonator with a bias tee for dc excitation.Experiments presented here demonstrate quantum localization and measurement of both electrons on the quantum dot and photons in the resonator. Further, it is shown that the resonator-qubit coupling in these devices is sufficient to reach the strong coupling regime of circuit QED. The details of a measurement setup capable of performing simultaneous low noise measurements of the resonator and quantum dot structure are also presented here.The ultimate aim of this research is to integrate the long coherence times observed in electron spins in silicon with the sophisticated readout architectures available in circuit QED based quantum information systems. This would allow superconducting qubits to be coupled directly to semiconductor qubits to create hybrid quantum systems with separate quantum memory and processing components.

•Jan 1, 2013•0 citations

Silicon CMOS architecture for a spin-based quantum computer

Menno Veldhorst, H. G. J. Eenink, C. H. Yang +1 more

Recent advances in quantum error correction codes for fault-tolerant quantum computing and physical realizations of high-fidelity qubits in multiple platforms give promise for the construction of a quantum computer based on millions of interacting qubits. However, the classical-quantum interface remains a nascent field of exploration. Here, we propose an architecture for a silicon-based quantum computer processor based on complementary metal-oxide-semiconductor (CMOS) technology. We show how a transistor-based control circuit together with charge-storage electrodes can be used to operate a dense and scalable two-dimensional qubit system. The qubits are defined by the spin state of a single electron confined in quantum dots, coupled via exchange interactions, controlled using a microwave cavity, and measured via gate-based dispersive readout. We implement a spin qubit surface code, showing the prospects for universal quantum computation. We discuss the challenges and focus areas that need to be addressed, providing a path for large-scale quantum computing.

arXiv:1609.09700•Nature Communications•Nov 20, 2017•442 citations

Frequency multiplexing for readout of spin qubits

J. M. Hornibrook, James Colless, Alice Mahoney +5 more

We demonstrate a low loss, chip-level frequency multiplexing scheme for readout of scaled-up spin qubit devices. By integrating separate bias tees and resonator circuits on-chip for each readout channel, we realise dispersive gate-sensing in combination with charge detection based on two radio frequency quantum point contacts. We apply this approach to perform multiplexed readout of a double quantum dot in the few-electron regime and further demonstrate operation of a 10-channel multiplexing device. Limitations for scaling spin qubit readout to large numbers of multiplexed channels are discussed.

arXiv:1312.5064•Applied Physics Letters•Mar 10, 2014•118 citations

Circuit quantum electrodynamics architecture for gate-defined quantum dots in silicon

X. Mi, J. V. Cady, D. M. Zajac +3 more

We demonstrate a hybrid device architecture where the charge states in a double quantum dot (DQD) formed in a Si/SiGe heterostructure are read out using an on-chip superconducting microwave cavity. A quality factor Q = 5400 is achieved by selectively etching away regions of the quantum well and by reducing photon losses through low-pass filtering of the gate bias lines. Homodyne measurements of the cavity transmission reveal DQD charge stability diagrams and a charge-cavity coupling rate gc/2π= 23 MHz. These measurements indicate that electrons trapped in a Si DQD can be effectively coupled to microwave photons, potentially enabling coherent electron-photon interactions in silicon.

arXiv:1610.05571•Applied Physics Letters•Jan 23, 2017•94 citations

Dispersive Readout of a SiMOS Quantum Dot Using a Flip-Chip Integrated Microwave Resonator

Vo Kim Hieu Van, Santiago Serrano, Cédric Bohémier +11 more

Heterogeneous integration provides a promising route to combine semiconductor quantum dot devices and superconducting microwave circuits, while allowing each component to be fabricated using an optimized process flow. Here, we demonstrate a flip-chip integrated platform for dispersive readout of silicon metal-oxide semiconductor (SiMOS) quantum dot devices. A SiMOS double quantum dot chip is bonded to a superconducting aluminum resonator chip using indium bump interconnects to enable microwave coupling to the quantum dot gate. We show that the developed flip-chip process is compatible with cryogenic operation of both the SiMOS device and the superconducting resonator, and demonstrate resonator-based detection of charge transitions in the quantum dot system. The readout signal-to-noise ratio follows a dependence of $\sqrt{t}$ with the integration time, reaching SNR = 1 at an integration time of approximately 0.3 ms. These results establish flip-chip bonding as a viable integration approach for SiMOS quantum dot devices operating at both dc and microwave frequencies, with potential applications for resonator-based techniques such as spin-photon coupling.

arXiv:2607.14559•Jul 16, 2026•1 citation
For direct interfacing of digital and quantum electronics in quantum computation, mature CMOS technology, with its potential for large-scale integration and data management, offers solutions for control, readout, and fast data processing with large numbers of qubits. The authors combine three likely components of an all-CMOS quantum computer---a quantum-dot transistor, a digital transistor for control, and an rf readout circuit---to yield a single-electron memory cell. The digital transistor locks charge on the quantum-dot gate and allows conditional readout via gate-based rf reflectometry, demonstrating the building blocks for time-multiplexed readout of multiqubit devices.
Semiconductor quantum dots in silicon demonstrate exceptionally long spin lifetimes as qubits and are therefore promising candidates for quantum information processing. However, control and readout techniques for these devices have thus far employed low frequency electrons, in contrast to high speed temperature readout techniques used in other qubit architectures, and coupling between multiple quantum dot qubits has not been satisfactorily addressed.This dissertation presents the design and characterization of a semiconductor charge qubit based on double quantum dot in silicon with an integrated microwave resonator for control and readout. The 6 GHz resonator is designed to achieve strong coupling with the quantum dot qubit, allowing the use of circuit QED control and readout techniques which have not previously been applicable to semiconductor qubits. To achieve this coupling, this document demonstrates successful operation of a novel silicon double quantum dot design with a single active metallic layer and a coplanar stripline resonator with a bias tee for dc excitation.Experiments presented here demonstrate quantum localization and measurement of both electrons on the quantum dot and photons in the resonator. Further, it is shown that the resonator-qubit coupling in these devices is sufficient to reach the strong coupling regime of circuit QED. The details of a measurement setup capable of performing simultaneous low noise measurements of the resonator and quantum dot structure are also presented here.The ultimate aim of this research is to integrate the long coherence times observed in electron spins in silicon with the sophisticated readout architectures available in circuit QED based quantum information systems. This would allow superconducting qubits to be coupled directly to semiconductor qubits to create hybrid quantum systems with separate quantum memory and processing components.
Recent advances in quantum error correction codes for fault-tolerant quantum computing and physical realizations of high-fidelity qubits in multiple platforms give promise for the construction of a quantum computer based on millions of interacting qubits. However, the classical-quantum interface remains a nascent field of exploration. Here, we propose an architecture for a silicon-based quantum computer processor based on complementary metal-oxide-semiconductor (CMOS) technology. We show how a transistor-based control circuit together with charge-storage electrodes can be used to operate a dense and scalable two-dimensional qubit system. The qubits are defined by the spin state of a single electron confined in quantum dots, coupled via exchange interactions, controlled using a microwave cavity, and measured via gate-based dispersive readout. We implement a spin qubit surface code, showing the prospects for universal quantum computation. We discuss the challenges and focus areas that need to be addressed, providing a path for large-scale quantum computing.
We demonstrate a low loss, chip-level frequency multiplexing scheme for readout of scaled-up spin qubit devices. By integrating separate bias tees and resonator circuits on-chip for each readout channel, we realise dispersive gate-sensing in combination with charge detection based on two radio frequency quantum point contacts. We apply this approach to perform multiplexed readout of a double quantum dot in the few-electron regime and further demonstrate operation of a 10-channel multiplexing device. Limitations for scaling spin qubit readout to large numbers of multiplexed channels are discussed.
We demonstrate a hybrid device architecture where the charge states in a double quantum dot (DQD) formed in a Si/SiGe heterostructure are read out using an on-chip superconducting microwave cavity. A quality factor Q = 5400 is achieved by selectively etching away regions of the quantum well and by reducing photon losses through low-pass filtering of the gate bias lines. Homodyne measurements of the cavity transmission reveal DQD charge stability diagrams and a charge-cavity coupling rate gc/2π= 23 MHz. These measurements indicate that electrons trapped in a Si DQD can be effectively coupled to microwave photons, potentially enabling coherent electron-photon interactions in silicon.
Heterogeneous integration provides a promising route to combine semiconductor quantum dot devices and superconducting microwave circuits, while allowing each component to be fabricated using an optimized process flow. Here, we demonstrate a flip-chip integrated platform for dispersive readout of silicon metal-oxide semiconductor (SiMOS) quantum dot devices. A SiMOS double quantum dot chip is bonded to a superconducting aluminum resonator chip using indium bump interconnects to enable microwave coupling to the quantum dot gate. We show that the developed flip-chip process is compatible with cryogenic operation of both the SiMOS device and the superconducting resonator, and demonstrate resonator-based detection of charge transitions in the quantum dot system. The readout signal-to-noise ratio follows a dependence of t\sqrt{t}t​ with the integration time, reaching SNR = 1 at an integration time of approximately 0.3 ms. These results establish flip-chip bonding as a viable integration approach for SiMOS quantum dot devices operating at both dc and microwave frequencies, with potential applications for resonator-based techniques such as spin-photon coupling.